Chrysler - Pacifica :: 2006 - Engine Rev Up And Speedometer Will Jump As High As 30 Mph
Apr 20, 2016
I drive a 2006 Pacifica and lately the engine has been causing me some grief. When I am in park, neutral, or in gear but stopped, the engine will sometimes rev up and my speedometer will jump accordingly sometimes as high as 30 mph. My first thought was that it might be a transmission issue, but I'm not a car mechanic so I don't know much along the lines of what to check or do. The model is an automatic 3.5L
View 1 Replies
Advertisement
I have a Chrysler pacifica 2006 .Later in 2009 I had a problem ( 'tapping noise' coming from the engine). I took the car to the dealer, since at that time I still have warranty (39,000 miles). They changed: 18 arms (6 of each type) 8 dowel pin, belt and the lifters. Last year I started hearing the same noise again. The car was with 56,000 miles. I thought it should be under the warranty (service done), but it wasn't. So I decided to have the dealership servicing the repair. This time the part changed was only one. The receipt says they changed the 'arm-inlet and exhaust valve'. Guess what ? the noise still there and they say they won't open the car without me paying for the diagnosis ( many hour of labor for sure!).What can I do?
View 1 Replies
So my Pacifica, after a long road trip around a year and a half ago, had it's check engine light come on. The meter read P0305, which is cylinder 5 misfire. When I got home, my local trusted mechanic replaced the coil and wire. Since then, the same misfire has occurred at least 4 times, and 3 of which he replaced the same parts (free warranty swap of the parts). The last time, he was determined that it wasn't simply the parts going bad. I concur. It has now lasted roughly a month and the light is back on with the same code. The spans have been as little as a week between leaving the shop and the light coming back on. I personally don't feel the car riding rougher than normal, but my wife does. I don't smell gas, have odd colored exhaust, or any other issue. The only other thing, which idk if it's related, is a clicking noise from the engine, which quickens with revving, perhaps the risers. What else could it be? I read that Chrysler's go to is a valve spring retainer lock and a MAP sensor that accompanies it.
View 19 Replies
I own a 2006 Chrysler Pacifica and during cold winter months ALL my windows ice-up significantly on the interior. To the point it is clearly a safety issue. Visibility is 0 due to the frost. I have to have the defrost on high at all times just to keep the front windshield clear, which results in making the cabin EXTREMELY uncomfortable (too hot)...for the driver and passenger. The floor mats are not saturated with water, I have NO wet towels in the car...etc. This has been happing from day one and the dealer, well...same old story...they say it's caused by my floor mats and there is nothing wrong....BUT this is NOT normal. I can send a video that shows the issue if you would like.
View 5 Replies
We have a 2006 Pacifica which as of recent has been slow to warm in the cabin, especially after a couple hour rest (oddly enough, it warms faster after sitting overnight). Also, when checking the fluids, we noticed that the coolant reservoir was just about empty. We added more 50/50 HOAT coolant, maybe 40-50 oz to get it normal cool engine level. This was done when the engine was cold. My wife noticed that the engine has been running warmer than normal. Normal is maybe a quarter the way up on the temp gauge, where it was around the halfway point, still far from the red zone but not its normal level.
This symptom has been going on for maybe a week. After adding additional coolant, the level stayed where we filled it as the engine warmed up. The heater warmed up to a normal level from what I can tell (it is 30 degrees warmer than last week) so it didn't start with a freezing cabin. I haven't seen any leaking of coolant, since I'm sure I would notice a hot pink puddle under the car. This is pretty typical or the sign of something major. It has around 80k miles on it.
View 2 Replies
We just purchased a 2004 Chrysler Pacifica with 21,000 miles. However the EVIC system does not come on. I understand you need to remove the dashboard to change the fuse, which is soldered onto the circuit board. So we need to purchase circuit board to replace a fuse??
View 3 Replies
My 2004 Pacifica (130k miles) was left parked for 2 weeks while we were away. Upon return it didn't wqnt to back out of the parking spot. After about 1/2 revolution the wheels made a clanking sound and hung up. Rolling back and forth freed things up enough to drive the car to the mechanic (about 40 miles). And after the first mile or so everything seemed to go back to normal, with no absolutely signs of anything not wanting to turn smoothly.. The mechanic thought that the problem had been that the brakes were sticking due to the car being unused and said nothing needed to be done. However, upon examination he found that we could use new front brakes and 2 motor mounts. He said that the need for brakes and motor mounts was due to normal wear and tear, and was not related to the wheels hanging up issue.
But now, immediately after installation of 2 new front rotors and pads and 2 new motor mounts there is a vibration/shudder when braking from anything more than 20-30 mph, which was never there before. The shudder is rapid and sometimes pronounced like going over the warning groves cut into the edges of pavement on the interstate. He thinks that this may be a sign that there is a driveshaft issue, and dismisses it as due to an out of round rotor since they are new. I don't know what to think. By the way, he has always been an excellent mechanic, with a great reputation and loyal following.
View 4 Replies
My a/c has worked just fine until about 30 minutes ago. Now, there is nothing coming out of the vents in the front, but plenty is coming out of the rear vents. What could this mean?
View 4 Replies
2005 Chrysler Pacifica TouringWhen pressing on the brakes at speeds over 25 the steering wheel wobbles. I have had this problem in the past and it has been diagnosed as warped discs. They have been turned and it fixes it for a while then it comes back and again warped discs. I have had the discs replaced but it has come back time after time.
Just had it checked out and they are saying it again, warped discs and this time cannot be turned need to be replaced but they also showed me I need new lower arms.
What do the lower arms do? And if I do not replace them will I have the same problem later with the front discs getting warped?
View 1 Replies
2007 Pacifica with 4.0 will not fill unless you dribble the fuel into the tank. I have cleared the vent hose and know it is clean. Do I need to change the Carbon Filter and Solenoid/Evaporation Valve on the Front of the Carbon Filter?
View 7 Replies
I am considering purchasing a 2004 Chrysler Pacifica. It seems to be in excellent shape except for one thing--it makes a very noticeable creaking noise. The noise is coming from the front end and seems to only appear at very slow speeds (like in parking lots). The seller told me up front about the noise, and explained that it didn't start until he had someone "jerk" him out of a snowdrift in Colorado. He says that was about 4 years ago. He tells me he has had the front end aligned, he has had two motor mounts replaced and has had either the tie rods, or the tie rod ends (I'm not sure which) replaced, but the noise is still there. He claims mechanics can't find anything else wrong with it, and they assure him it is safe to drive.
View 4 Replies
Have a 99 chrysler t&c. The engine seems to be in good shape an starts reliably if the battery is not dead, even at 10f below. The problem is that every once in a while the battery looses the charge for an unknown reason . The car turns over slowly and the solenoid chatters in and out. Happens several times a month; I've started carrying a spare battery with a fair amount of reserve capacity and 4 ga. cables. Even then, it is iffy as to whether the car will start. It cranks slowly and the solenoid may still drop out.
This has happened even over a short period of time such a s grocery shopping.
I researched one of those lithium battery packs that can be inserted into the cigarette lighter. My understanding is that the emergency pack has to recharge the main battery for some time. It makes sense that you don't want to run starting current through the aux. voltage outlet.
Should I be letting the spare battery recharge the main battery for a few or more minutes?
View 4 Replies
My speedometer is stopped working... I am driving and it will usually stay at zero, but it will jump time to time for example..
I took a video to explain it better with great detail, as you can see I am doing like 50mph, but my speedometer says other wise.
[URL] .....
View 10 Replies
Ok everytime I am stopped at a light or even when my car is in park, my speedometer begins to jump up and down, usually it will jus eventually stop, yesterday the engine started to rev then the car just shut off while I'm just sitting at a light, then my headlights began darken right before it shuts off. What could the problem. 2008 Chevy Cobalt
View 7 Replies
I have a '97 Chrysler Cirrus that won't start on it's own without being jump started. Once jump started it runs fine, but then the next time you go to start it the battery is drained again. My highly uneducated guess is that I need to replace the alternator. Am I on the right track? I replaced the battery and the problem persisted.
View 7 Replies
I have a 2004 Sebring my check engine light is on and the RMP's are really high while Im driving. What could be going on?
View 11 Replies
I have a 2000 Ford Ranger, 5spd with 3.0 v6. The speedometer will jump around or quit about half the time whenever you push the brake pedal or use the turn signals. I've cleaned all the grounds I can find including taking the battery cables off the clamps and cleaning them, and I had to clean all the fuses (inside box and outside box) because most of them were corroded. It still does it. Occasionally, I'll hear a buzzing/crackling noise like electricity arcing when I use the brakes or the turn signals which sounds like it's coming from the left side of the dashboard.
I took off panels and the fuse box, but I don't see any sign of arcing. Also, the noise only occurs when the truck is actually moving, never when it's sitting still. Also, the engine has a slight flutter at an idle. I hooked up a computer, and the O2 sensors were erratically jumping between rich and lean, so I replaced all of them. It says Insufficient EGR flow detected, so I did put a new EGR valve on and cleared the codes, but it still reads the same. And lastly, the computer refuses to finish either of its diagnostic tests. I've tried the Koeo and the koer tests, and neither will complete.
View 2 Replies
2001 PSD ... Had speedometer jump 20 km's (12mph) while stopped with foot on the brake? This has been happening on my 2001 PSD intermittently for the last couple months.
View 1 Replies
I have a 2001 Chrysler Town and Country w/ 3.8L engine and 196,000 miles. Several years ago the transmission was rebuilt. Since then the speedometer was off 1-2 mph at 65 mph. I recently bought new tires and now the speedometer is off 2-3 mph at 65 mph. My question is: How do you calibrate the speedometer? I know all about the reset for a bouncing/stuck needle. That does not calibrate the scale. I've read about gear replacement and found the Hyper-Tech calibration programmer (which is not available for the 2001 T&C).
View 5 Replies
Thought this would be a fairly straight forward fix of making sure that the transmission fluid was full with no air in it, as well as a few other things to try.
Well, I've run out of things I can reliably try right now. Replaced the output sensor on the transmission, filled the transmission fluid with the proper type, read error outputs. (boy was that odd, you have to turn the key three times in a certain way and it blinks codes out at you)
The error readouts point to an Oxygen sensor, and the speed sensor. The oxygen sensor I could care less about at the moment, as I can't really reliably drive the car in first gear. Once it shifts, then I'll fix that, otherwise its wasted money as I won't be driving anyways.
None of my local mechanics have a machine to read or program this thing by the way, so that is kind of out of the question.
View 8 Replies
I have a 97 Chrysler Cirrus, and have been driving it for about 5 months. The other day, as I was driving, the speedometer stopped working. It did that one time before, but started back working. However, this time, it still is not working and I have no idea how fast/slow I am going. Often, my car has little glitches where you have to lock/unlock the door a certain way or it does not work right. Everybody jokes that my car has OCD! Also, once you crank the car, you have to turn the key back halfway or certain things don't work- like the clock, wipers, turn signals, etc. I don't know if this is related to the speedometer situation or not. The last time the speedometer stopped working, I had the AC on and a cassette tape in the deck; I was trying to hit the rewind button, but kind of accidentally pushed between fast-forward and rewind, and that is when the speedometer stopped working. I am not sure this is related. Do you know if my car has a sensor or a cable for the speedometer? Is this something that can be easily and inexpensively fixed?
View 1 Replies
