Chrysler - Cirrus :: 1998 Not Starting / Mild Thud Followed By Brief Hissing Sound When Turn The Key
Jul 29, 2011
My 98 Cirrus (V6 automatic) is not starting. The battery is working fine and it lights up everything...the wipers, headlight, the turn signals etc.... But when I turn on the ignition...nothing. I hear a mild thud followed by a brief hissing sound when I turn the key from the 1 position to the 2 position (referring to a 0-1-2-ignition key positions)...like "thuh...sssssss." It seems it comes from the underside of the car. Then when I turn from the second key position to start the engine, I get no response at all. I tried putting the gear in park / N...but no difference.
The weird thing is, approx 15 min before I attempted to start the car, I had to drive the car across the parking lot. It ran fine at that time. Could it be a fried starter motor?
View 7 Replies
Advertisement
After replacing the battery and starter...as well as replacing the alternator (bench tested good), I'm still greeted with one 'thud' when attempting to turn the engine over. The battery light is one in the dash. I've been through this scenario with more than a couple vehicles that haven't started in the past. I do the normal check the battery, wires, alternator, fuses, and starter. Somewhere along that line...it always fixes the issue. Not so here. I have to admit that I'm at a loss at the moment.
2001 F-150 5.4L
115k
Replaced starter
Replaced batter
Alternator bench tested good
View 2 Replies
2000 Chrysler Cirrus 2.5 V6, 84,300 miles. Twice, after sitting out a day or 2 in wet weather, it was very, very difficult to start. Each time, it didn't fire at all, but then did finally start after 4 or 5 tries and ran fine.
Tried spraying water everywhere under the hood, while it was running, but got no miss or other symptom. After then sitting a day or 2 in the garage, it started and ran fine the first 2-3 miles, then started stumbling/missing and stalled at a light. It restarted and continued to stumble/miss before running fine after another 1-3 miles. Changed the distributor cap and repeated the same test, getting same result. Also checked fuel pressure--it's on the money, building specified pressure and holding as expected. No check engine light or other symptom and no relevant codes.
View 7 Replies
I have a '97 Chrysler Cirrus that won't start on it's own without being jump started. Once jump started it runs fine, but then the next time you go to start it the battery is drained again. My highly uneducated guess is that I need to replace the alternator. Am I on the right track? I replaced the battery and the problem persisted.
View 7 Replies
My car died while driving on the highway. The mechanic said it was the distributor, but also that the fuel pump wasn't working. When he replaced the distributor, the car works, no fuel pump problem. Does the fuel pump shut off when the engine dies or is this going to be another problem down the road? 2000 Chrysler Cirrus Lxi...
View 1 Replies
1997 6 cylinder Chrysler Cirrus 162,000 miles. My car will randomly and unpredictably go into limp mode. I suddenly find myself in second gear while my engine is revving at high speed (3000-5000 RPMs) in order to maintain velocity. The check engine light comes on immediately, but usually switches off after 2-3 days maximum, and typically less than that. If I pull over, and turn off the engine, it re-sets, allowing me to start the car, and continue my journey, shifting normally.
Additional pertinent information:
• it happens more often when the weather is warm
• it has happened while traveling down the highway at 65 mph (scary!)
• at times, the shift into second is so abrupt, it feels as though I have been rear-ended
• once, while in a traffic jam and moving at about 20 mph, I hit a pot hole and the engine started revving at 3000, with no change of gears
• a couple of times, rather than throwing me into second, it has seemed to throw me into neutral, with the familiar high revs, but absolutely no power with increased pressure on the gas pedal
• it is happening with increased frequency i.e. I have had to stop as many as six times during an 16 mile trip.
• Recurring computer codes: P0140, P0141, P0700, P0765, P1494
04/2011 replace right front cam sealFront engine mountReplace front valve cover gasket w/tube sealsFront bank spark plugs & wires (3 platinum plugs)Transmission flush
05/2011 cylinder #5 misfireReplace rear valve cover gasket & tube seals3 platinum plugs (leaky power steering pump fouled the plugs)
05/2011 recall work #C45 floor shifter ignition/park interlockPush rod trans- shifter
09/2012 transmission shift solenoid
10/2012 6 new plugs & wires Plenum gasketDistributor capEGR valve gasket
There has been other service work done during this time period, but (I think) I have included only that which may relate to the transmission. I am so frustrated, and my mechanic is stumped. He has referred me to either a transmission shop, or a Chrysler dealer. After hearing my account of the problems over the phone, the head mechanic at the dealership suggested that it’s time for me to get a new car.
View 2 Replies
I have a 97 Chrysler Cirrus, and have been driving it for about 5 months. The other day, as I was driving, the speedometer stopped working. It did that one time before, but started back working. However, this time, it still is not working and I have no idea how fast/slow I am going. Often, my car has little glitches where you have to lock/unlock the door a certain way or it does not work right. Everybody jokes that my car has OCD! Also, once you crank the car, you have to turn the key back halfway or certain things don't work- like the clock, wipers, turn signals, etc. I don't know if this is related to the speedometer situation or not. The last time the speedometer stopped working, I had the AC on and a cassette tape in the deck; I was trying to hit the rewind button, but kind of accidentally pushed between fast-forward and rewind, and that is when the speedometer stopped working. I am not sure this is related. Do you know if my car has a sensor or a cable for the speedometer? Is this something that can be easily and inexpensively fixed?
View 1 Replies
I have a 1997 Cirrus. The ABS light came on about 2 weeks ago -- this is after i drive about 30 yards. The brakes seem to be operation ok and when the light does come on there is no bell or chime sounds to indicate something is wrong. ALSO, the RPM gauge just started to not work. Occasionally it may operate correctly but most of the time it just sits on zero. What the fault or faults are?
View 1 Replies
I started having problems with my '99 Cirrus last month, it would randomly stall while driving or while in idle. With no check engine light or any other tell tale signs of a problem. I'm not entirely knowledgeable about how the entirety of the car's systems function, though I new I should check my fuel system. I wasn't getting any fuel to the engine whatsoever, so I replaced the fuel filter because when I got it off and looked at it it was clear it was bad. Then I put it all back together to try and run it and it continued to stall.
Thinking it must be the fuel pump at this point I dropped the fuel tank and replaced it. It ran for about 35 miles before the same problem started happening again. So I checked all the fuses, and relays and just to be safe replaced all the relays related to the fuel pump, and fuel system and i even replaced the auto shutdown relay. The car continued to have the same problem, so I did some research and found out it could be a dirty throttle body so I cleaned it even though it wasn't that dirty, and checked my air filter for how clean it was and it was clean. The car still continues to stall in idle and while driving.
View 7 Replies
I own a cirrus 2000 which lately have been giving me trouble. I took it to a mechanic for tune up and ended up having a lot of issues. At the moment I am having a lot of rattle or hard driving. The car shakes alot and recently I took it for a diagnostic and the result was P0303 and P0305 and vacuum leak. What causes this problem and how can I get it fixed?
View 5 Replies
I have a 1998 Chrysler Concorde with 67,600K. The engine is starting to stall shortly after driving a few miles with no warning other than the engine light coming on. I can put the car in neutral and it will start right up and run just fine. The engine temperature is fine.
View 1 Replies
There is an air leak and hissing sound at the connection of the master cylinder to the brake booster. Brake pedal travels nearly to the floorboard before engaging the brake. What is the problem and how can I fix it myself? (Special note: the brake fluid was very low and is now topped off to the maximum level . Adding the brake fluid caused very little change to the brake pedal travel.)
View 5 Replies
My Concorde LXI 1998 been having this problem lately for couple of times a week. It sometimes dies in the middle of the road and I have to turn it on by pressing on the gas continuously. So, it shows the oil leak sign and it doesn't crank up. I crank my car by just pressing on the gas few times. I have attached the link of the video in here : [URL] ....
View 6 Replies
I have a 2005 nissan maxima that won't start. I have a new starter and battery. When I turn the key everything in the car comes on except for the car (it also makes no sound when you turn the key). I checked to see if it was the ignition switch by bridging the connection on the starter with a screw driving. The starter comes on but the car wont start. It tried starting it in neutral (still doesn't work). It's not the security because the light turns off when you try to start it.
View 19 Replies
I was told by the dealership that the battery was bad and needed to be replaced ( which I did) I went out to my car this morning and had the same problem. When I turn the key nothing happens. When I turn the key you hear a click but that is it.
View 3 Replies
Why doesn't my 98 Ford Crown Vic Police package turn over when it is hot outside and the car is hot? Winter time, I never have the issue. When the outside temp hits the upper 70s or more, and I drive for a little bit, turn the car off it will not start or even turn over. The lights come on like normal. I wait 15-30 minutes, it fires right up. I have replaced the starter/solenoid, battery, battery terminals, ignition relay.
98 crown vic police-4.6 liter Coil-on-plug,electronic timing,182,000 miles
View 10 Replies
So recently after new tires installed and alignment done (1 month ago) I noticed a squeak/creaking sound while driving (0-40MPH) if i turn my wheel right a little it will squeak. It sound like its coming from the right side rear wheel. Prior to tire/alignment i had my brakes changed and resurfaced the rotors (2 months ago). My car is a 2013 chrysler 200. I noticed the noise a day after the alignment but not sure if it was happening after the brakes.
View 19 Replies
My 1998 Honda accord coupe 3.0 has 225 k miles has a new sending unit, fuel pump, main relay, ignition switch, and spark plugs. I cannot find the source of why my car will not start I replaced these things on my car due to car didn't want start. Then it was fine every time I would turn a corner or drive it rpms would drop like I was running out of gas then it would die now it will not start.
I have checked all fuses. I have read in forums that this could take a lot of money to fix only because no one knows the source of why its not starting. I am a disabled female that is just trying too have a running vehicle and can't figure out why it won't start. It has a new battery but won't hold a charge. Had charged it from my friends car for 25 minutes it gave it enough juice to put it in neutral and push it in the driveway with another car.
View 19 Replies
I have a 1998 Ford Ranger, 3.0 4X4. Purchased in early 2002 with a clunking problem which has not gotten worse or better. When I take off it is a heavy double 'clunking' like something shifting and the settling. I have had 4 mechanics look at it, have changed the front u joint and have had the motor and transmission mounts checked but the mounts are OK. Can't figure this out. I talked to a person at a local car parts store and he mentioned that it could involve the 'yoke' and that it just might need to be greased but he was just guessing.
View 9 Replies
I have a 98 Toyota sienna and it has started making a thud noise and skipping a bit when accelerating or going up even a slight incline. I have been told everything from it needs new plugs/wires to a new transmission. Could these cause similar problems?
View 12 Replies
So I changed my fuel filter a while back and I've been noticing a very mild knocking sound whenever I go over a bump. I didn't have access to a lift when I was doing this, so I attempted it with the car on the ground (worst idea ever - there wasn't enough ground clearance for me to even fit my head under there...). Everything is hooked back up as I thought it was originally (car runs fine), but now that I think about it I'm wondering if there's a bracket above the filter that should be secured within the hose clamp, along with the filter & the plastic piece that attaches to the filter. And if so, any tricks as to how I can secure the hose clamp to the bracket without having to remove the filter all over again? I had no way of telling whether or not there was a bracket... I could hardly see as it was and was more concerned about not damaging the fuel line clips.
View 4 Replies
