Chrysler - 300C :: 2005 - Hesitation Between 1000 And 2000 RPMs
Mar 1, 2016
I have a 2005 Chrysler 300C ( original owner )Mileage 172,000 and I take care of my car. I use full synthetic oil and change it every 5000 miles. I noticed a hesitation between 1000 and 2000 RPM's. It disappears after 2000 RPM's. The Chrysler dealer kept doing repairs and claimed the problem was gone and it is still there. The dealer did a full tune up, induction service and also replaced the EGR valve, gasket and seal. The problem gets worse in higher mountain altitudes.
View 3 Replies
Advertisement
I have an '05 Chrysler 300C AWD with approximately 65k miles. The transmission makes a distinct clunking sound when downshifting and I am seeking advice about the cause and solution. For example, I live on a hill and when I slow down at the bottom of the hill the car will downshift and there is a clunking sound. This happens frequently when I am slowing down. In the past year the transmission quit 3x, in all cases the car would start and operate fine but would not go into gear - it would idle but nothing would happen when I put it in gear. The first two times the dealer kept the car for several days and made various adjustments and the car eventually worked again. The third time the Torque Converter was replaced, but the clunking noise continues.
View 3 Replies
What would casue a clicking noise (like a sewing machine)under acceleration for the first several miles on a cold morning (50 degrees or below, we live in Louisiana)? Car is 2006 Chrysler 300C with 5.7L Hemi motor, 90,000 miles, all lifters replaced last summer - noise was apparent before new lifters. Dealership is stumped - they do not believe it is a problem with new lifters.
View 3 Replies
Reconditioned engine 5,000 miles ago. Last maintenance check at dealer found nothing wrong. 2000 Honda CRV.
View 4 Replies
So lately my 2000 Jetta GLS hasn't been running that smooth I can tell when I'm changing gearing and when I start the car and the car idles around 1000 RPMs. I think it may be the engine miss firing because some times I can feel the car shaking but I have no check engine light. Lucky... Also the coolant is leaking idk what the exact problem is but everywhere I go there is a puddle of coolant under my car.
View 2 Replies
I have a 05 gli I just put a k04 turbo on. It runs on stock ecu but I have been told that's not the problem. When I start the car the rpm's spike to around 3 grand then slowly drop to normal idle rpm's when it gets under 1000 rpms the car starts to shake and idle hard. Idk what it is Cel is on and read misfires in 3 of 4 cylinders but checked plugs and everything they r fine. I'm thinking maybe vacuum leak or something along those lines.
View 6 Replies
I leased a 2015 Honda CR-V AWD LX on March 11, 2015. The following day I noticed a rough vibration/shuddering/chattering that appeared to be coming from the transmission when the rpms ranged between 1,000 and 2,000. The roughness was evident at any speed (mpgs) when the tachometer reading was between the previously stated range. The service technician reported feeling the same roughness, but noted that the problem was characteristic of the CRV with a CVT transmission. On Tuesday March 17, I went back to the dealer and discussed the problem with the service manager. He also stated that he was aware of that particular problem and that it was peculiar to the 2015 CRV with the CVT transmission. He took my car for a test drive and admitted feeling the chattering. It was also evident to me as I sat in the passenger’s seat. He then took out another new CRV and it too exhibited the same characteristics.
View 18 Replies
My V8 is "sputtering" between 1000 - 2000 RPMs. Not only can you feel it, but you can see the tachometer bounce up and down as well. No problems accelerating or putting the engine under load - it's only between that RPM range where there seems to be hesitation. The car is not giving any fault codes, and I just recently had all plugs and coils changed. (The car ran great for 2000 miles following the plug and coil change.) It started on a road trip, and I took it to the local dealer. They thought it was bad gas. (I've since run several tank fulls through it...)
My suspicion is a mass air flow meter beginning to go, but until it triggers a fault, I can't say for sure. The dealer wants to check the MAFs values and to do a fuel tank pressure test to see if it's the fuel pump. I do have the Real Driver warranty, but they will not cover investigative costs. I'm not too excited about throwing money to test a bunch of different things.
View 12 Replies
I recently got the EGR system in my 1998 Rav4 working (replaced VSV) after driving with it non-functioning for several years. Without the system functioning, the engine ran great, but fuel efficiency suffered. Now, when the engine is warm only, the engine knocks and lugs between 1000 and 2000RPMs. This usually occurs right when I shift into 2nd gear. There are no engine trouble codes.
View 8 Replies
I have a 2000 b5 wagon with a 2.8 5spd with 200k on it .... Its slammed on coils and i get this squealing in reverse i dont know what it is i just rebuilt the front end ie control arms... also have a nasty vibration from 1000rpms to 3000 rpms could that be engine mounts/snub mount?
View 7 Replies
I have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 Replies
My 2005 2.7L 6 cylinder Sebring with 100800 miles that was running fine just started jerking on me last week. It runs fine untill I get it up to 2750RPMs. Its like its getting gas, then not getting gas and jerks forward all in less than a second and then again, and again and again, until I drop the RPMs back down. Any clue on what I should be looking for?
View 4 Replies
So,I have a mk4 GTI vr6 . I've got an idle that moves about 25 rmps up and down. As well as the throttle hesitation between 2.000 and 3500 rpms only at mid throttle. Has a kinda new maf. That I cleaned. clean THrottle body kinda new coil pack and wires , new plugs. Tried a lot it all worked but it's still there.
View 11 Replies
I have a 2001 F150with the V6 motor, automatic transmission and 73k miles. It has begun having hesitation/missing problems at low rpm, 1000-1800 or so, and it feels like the engine shuts off for a fraction of a second. At idle and above that range it seems to run fine. Also, it only happens in Drive and when the engine is fully warned up - it does not do it when cold or in Neutral. Uphill, downhill, doesn't matter. There are no OBD codes. The spark plugs, air filter and MAF sensor have been replaced recently. I have OBD scantool on my laptop, but have not been able to use it yet.
View 1 Replies
2012 SEL... Experiencing High Idle (1000 rpms) when the AC is ON. When I power the AC system OFF... the idle comes down to 700-800rpms. Then I power the AC back ON and it stays for the rest of my trip. Restart the car, and it's back to 1000 rpms with the AC on.
View 2 Replies
My 2001 BMW 325Ci has an occasional "surging" idle problem. When coming to a stop or at idle, the engine will rev between 500 and 1000 rpm's. Sometimes it will correct the problem and idle normally, or keeps surging until it eventually stalls. When restarted it works fine. Tried fuel injector treatment, fuel stabilizer treatment, and replaced thermostat. Still surges about 50% of the time. Had it to a dealer, and computer says its running fine.
View 1 Replies
I have a 1997 Saturn SL1 with 100k. Every so often the RPMs will drop by 500-1000 or so for a second and then come back up to normal. This happens both when stopped at a light and while accelerating, and doesn't seem to happen predictably. I've already changed the filters and cleaned out the IAC, without any success. I've sprayed the obvious connection points in hopes of locating a potential vacuum leak, also without any luck. Other ways to locate a potential vacuum leak that wouldn't be overly time-intensive?
View 7 Replies
I have a pretty bad flex pipe leak on my 20th. Would this leak cause a very rough idle almost stalling when I come to a complete stop. The Idle fluctuates from almost stalling to 1000rpms.
View 1 Replies
Noticed this morning I was idling at 1000 rpms and was wondering if that's normal or a little high?
View 5 Replies
I have a 2009 Corolla and anytime the car is idling and it drops below 1000 RPMS there is an extremely annoying ticking sound, it goes away when I put it in Neutral or the AC is on because it idles higher.
View 7 Replies
My mother has a '04 Santa Fe 3.5. Her automobile makes a rattling/grinding sound when around 1000rpms/idle. However, the sound disappears when accelerating and drives like a charm. The sound returns once again around 1000rmps at idle or stop. I have changed the oil pan, replaced oil and filter and even put in a new battery. I'm not an aficionado when it comes to Hyundais (Subaru driver here).Car also has 180k miles.
View 6 Replies
