Chevy - Malibu :: 2011 Will Not Shift Out Of First Gear Into Reverse - CEL Came On
Jan 2, 2015
I have a 2011 Chevy Malibu, with a little over 100k miles on it. A couple weeks ago it started acting a little funny when I would shift into reverse after starting it after sitting for a while. I thought it might have been due to temperature as it didn't do it after the car had warmed up or when it was warmer out.
Yesterday it started acting up really bad, will not shift out of first gear, and will not shift into reverse, and the check engine light came on. I was able to get it up to O'Reilly's to get the codes. It came back with 2 separate codes.
P0700 - Transmission Control Module (TCM) Requested MIL IlluminationP0776 - Clutch Pressure Control (PC) Solenoid - Stuck Off
The guy there seemed to think that the second code was probably caused by the first one, and most likely the TCM needs replaced. It makes sense to me, but before I head down this path I want to get some input, as it is a little over $300 for the part.
View 10 Replies
Advertisement
I have a 2007 Chevy Malibu with around 190000 miles on it. Recently, first thing in the morning then I start driving, that car will not shift into 2nd gear for a bit. The engine will rev up the 2000 RPM and stay there. After a while it will finally shift. The fact that the engine stays revved that high for that long makes me nervous.
View 9 Replies
I have a 2001 chevy cavalier, the base 2.2 model with a 5 speed manual transmission.
I can't shift into 1st, 3rd, or 5th gear. On occasion I can get into 1st but it pops out almost instantly. I have the shift boot up, it looks like the shifter won't go far enough to click into gear for the top 3 gears.
2nd and 4th don't have any issues, reverse works as well though can sometimes be more difficult than usual.
View 1 Replies
I have a problem with my 1998 Chevrolet Blazer. It won't go in reverse, but will go into gear going forward. I don't know whats wrong or what the cause is.
View 2 Replies
I have a 98 Chevy truck with a 4L60E. It has no second gear. I was sitting in park for about 10 minutes with the engine running, then put it in drive and it never shifted into second. It felt like it went straight to 3rd. I played with it manually until I figured out I had reverse, 1st, 3rd, 4th and torque converter lockup, just no second gear. My acceleration rate was medium and when I reach about 27-28 mph it would shift from 1st into 3rd. It has 230K on it so I rebuilt it with all the typical parts - frictions, steels, band, sun shell etc., still no second. I then pulled the pan back off and replaced the spacer plate and put in a shift kit. While I had it down I put a corvette servo in and did an air check. It worked fine. I could feel the band tighten.
Both the 1-2 and 2-3 solenoids checked good at 23 ohms. I swapped their positions to see if it would make a difference. I also checked to make sure the 1-2 accumulator piston wasn't stuck in its bore, the spring was new from the shift kit. It was fine. Put it back together...still no second gear. When I originally pulled the pan off for the rebuild, the pan was free of any debris and was very clean. I then drove it a couple of miles to a local transmission shop. They put their scan tool on it and drove it around the block. There were no codes and the ECM was calling for second gear. It doesn't sound mechanical since almost all the parts have been replaced, rebuilt or inspected that affect the 1-2 shift. It sounds electrical. Is there anything I have missed?
View 14 Replies
My dad's 1996 Chevy Silverado will not shift into hi gear. The truck starts up fine and he can drive it but for some reason it won't shift into hi gear. Him and I are clueless as to why it won't. He has a 1996 Chevy Silverado, 6.5 liter V-8 automatic transmission, and its a diesel. We really want to fix the truck ourselves so we are trying to avoid taking it to a shop.
View 2 Replies
It is an automatic. (1999 Malibu) . Is it possible for a car to start but the gear shift to be frozen?
View 5 Replies
I have a 2011 Jetta 5 spd, was driving today and suddenly I could not shift in 4th, 5th or reverse. This is the first time this as happen, I have never had any issues with the far. I don't know much about transmissions. The clutch seems to be working fine as I can shift with ease from 1st, 2nd, and 3rd.
View 3 Replies
So my Malibu overheated for the first time, and note it just won't start up..
View 16 Replies
Long story: I have a 2005 Chevy Malibu base. About more than a month ago I was driving home from work my car stalled about 3 times. I was able to finally get home I checked the oil and to my shock there was none. I quickly put some in and my car started just fine didn't stall again. I drove it the next day nothing. Then the day after that I drove it to Walmart on the way back it stalled like 7 times and after that last time it wouldn't turn on. I got it towed to a shop where my car remained for over a month. The crank position sensor was replaced, the battery, and the ignition switch. I was told it was fixed, picked it up drove it to a town 30 minutes away it was fine, then drove it back it started stalling every 5 minutes.
Managed to take it back to the shop, they couldn't figure out why it was shutting off so they got a second opinion at a Chevy dealership nearby and they replaced the ignition control module. I picked up my car drove it around for awhile and the check engine light came on I was near pepboys they checked the code which said I needed to get the catalytic converter check/replaced. So I drove my car home. Next day drove it all day it stayed on, thought my problem was solved. Then that evening turned it on and within a few minutes the engine shut off and now it won't start at all. The mechanics that I took it to obviously don't know what the issue is nor do the mechanics at Chevy. It is not the fuel pump that's one things that can be crossed out. Or is my car done and should be junked?
View 8 Replies
i have a 2005 chevy malibu classic. a few months ago it started sputtering when we would try to crank it and would take several tries before it would run, then it stopped. So far we have replaced the fuel filter, fuel pump, fuel pressure regulator, idle air control valve and crankshaft sensor, and it still wont stay running when you try to give it the gas, it dies....
View 4 Replies
2003 Chevy Malibu 3.1 temperature gauge stopped working last night, this morning having trouble starting, no check engine light fans do turn on have heat, replaced the coolant temperature sensor but gauge still not working?
View 1 Replies
Car Stats: 2005 Chevy Malibu, Automatic
Just recently while driving my car at a normal speed...(Like 55mph wanted to speed up gradually to 60mph) ..I will push the accelerator and my car wont go any faster. It will act like it is switching to passing gear and then the engine will rev up, the car will lurch forward and then it will finally take off. The RPM's also will increase and then suddenly drop back down to normal.
Also I think this is related to the problem. .... but... when I put the car in the low gear to where I can manually shift it to first second and third. It used to automatically be in the 1st gear... but now it will show up in the third gear and you cannot shift into any other gear.
View 9 Replies
My son called me today to pick him up. His 98 S10 would shift into gear but wouldn't go forward or into reverse. New clutch 6 months ago, hoping something simple like low gear oil or worse?
View 1 Replies
Buying a vr4 this weekend with dr650 turbos... The only problem with car is when you shift into reverse it grinds and won't go into gear, I'm thinking its the reverse synchro?
View 2 Replies
So the other day was driving my car... And he said reverse quit working. I'm nowhere near my car right now, but it sounds like the same thing that it had done for me a few times. Basically, the gear shift won't go into the slot for reverse, and even first is hard to get into sometimes. Sometimes it works and sometimes it doesn't... My car's a 337 with an O2M transmission.
View 3 Replies
Today while backing into a spot at work (parked on a flat surface) my 2011 Sonata GLS automatic tranny, when I went to shift the car in reverse felt a big jerk and rather loud noise from shifting.... Haven't heard it since.... I think this happened to me once before many months ago... also on a side note why do I hear a almost a crunching noise when I am steering the car in reverse... I just had my car in for a oil change too.. I'm the only driver and owner of the car it has about 42k on the odometer.
View 17 Replies
I have a 2008 Chevy Malibu LTZ and last week I noticed a revving noise like a fan or something whenever I accelerated from a stop and turned left. Continues throughout the turn and stops when going straight. Doesn't happen on a right turn. Also happens on a windy road when turning left more sharply than just a gradual turn.
Also just noticed this in stop and go traffic. When accelerating slightly and letting off there will be a short grinding/clicking noise that lasts 2-3 seconds or sometimes until I hit the accelerator again.
View 3 Replies
I have a 2003 Chevy Malibu LS. Occasionally, my theft system light will come on when I start my car. I usually have to wait 10 minutes until it deactivates. I don't understand why it does this!
image.jpeg2448x3264 1.3 MB
View 4 Replies
I was pulling into my driveway. I put the car in park, but when i went to get out of the car, it started to roll forward. When I finally got it stopped, I tried to shift it, and it wouldn't shift to any spot. Then it became stuck in between Park and Reverse. I can't move the gear shift.
View 1 Replies
I have a 2005 Ford Focus Man Trans, and am having issues getting it into first gear and into reverse. This happens most often when the car is cold. I am kind of wondering what it may mean before I take it in to have the issue fixed. It has 65 thou miles on it and I would think that I don't need a new trans already?
View 8 Replies
