The problem is that both sides blink fast the left one used to blink normally sometimes and fast again all the lightbulbs work and are not led i found the problem on the right side : in the front the side light blinks but the drl doesnt blink with it now both sides blink fast. What my problems might be? What part of the car i should check ?
View 3 RepliesRhe problem is that both sides blink fast the left one used to blink normally sometimes and fast again. All the light bulbs work and are not led. I found the problem on the right side : in the front the side light blinks but the drl doesn't blink with it. Now both sides blink fast. What part of the car i should check ?
View 3 RepliesI made the conversion of the regular bulbs to led ( stops, position, turn signals ) but I have fast blinking in turn signals. I know that the led has fewer electric resistance than the regular bulbs so the car takes this like a damaged bulb.
I know two possibilities:
1- A resistance for each one of the led to confuse the system.
2 - Changing the electronic relay
I don't know which one is better. I need a resistance for each bulb? which relay is the appropriate one for this car (there's a lot of references on the internet and I can't find the relay in the hood's car).
I have a 1998 or 1997 Honda Accord and just noticed the other day that my left turn signal was blinking faster than normal. Now I know that this would denote a burnt lightbulb but I got out of my car to see if one wasn't working on my left side. All of my lights seem to be "on" but the left side turn signals are flashing faster than normal. Also I did hit a speed bump at app. 40 mph the other day.
View 4 RepliesI have a 2002 (not 2001) Chevy Venture and recently replaced the left rear (drivers side) tail light circuit board. I replaced it with a genuine GM part, and when I connected the wire harness to the circuit board and screwed the tail light assembly back in place, everything works properly for say a half hour or so, then I usually get the fast blinking left turn signal (like a bulb is out). Also, both turn signals come on solid when I hit the brake. A lot of times, if I turn off the ignition and turn it back on, I'll get the Service Traction System warning and Traction Off lights in the dash. If I take the assembly apart and push down on the wire harness and put it back together, everything works well for a short time again, but it usually reverts back to the above. It seems to be a loose connection and I thought about some kind of loctite to keep everything in place. Someone also casually mentioned a dielectric grease, which sounds like it would be better.
View 8 RepliesA few weeks ago, I went out to my car & the remote opener would not work. So I opened the door with the key. I went to start the car & it would not start. I got absolutely nothing. I also then could not get the key back out of the ignition. It would not even turn back to the original position. My father get the car started with a jump, but since then my car radio does not work. I also do not hear any noise when using the turn signals. They work, but no "blinking" sound. I tried to research this thinking maybe you have to "reset" the radio after a power "outage" but have been unable to find anything on how to do this. My husband recently passed away and I'm feeling a little lost when it comes to issues with my car. Where I can find some info?
View 4 RepliesI just changed the multi-function switch on my 2001 PT Cruiser, because someone suggested it since my turn signals were not blinking or clicking. The turn signals come on, but do not blink or make that clicking sound at all. They just stay on. The hazards do not blink or click either. Lights and all work fine. It's just the turn signals and hazards that do not. What else controls the clicking and blinking of the turn signals and flashers. Could it be the relay that's inside the multi-function switch? I'm almost 100% sure we checked all the fuses, but I could be missing something.
View 1 RepliesThe turn signals stop blinking after a few blinks on my 2001.5 Passat 4Motion. There are no burned out bulbs, no aftermarket lighting, nor any aftermarket audio. The problem also happens when using the emergency flashers. The lights will blink for as little as two or as many as 15 blinks and then just stop. Is this a relay switch? Where is it? Can I get to it without taking the dang dash out of the car?
View 4 RepliesMy 2001 Chevy Venture van is accelerating on it's own and is now overheating. The heater works, the AC works but the defrost doesn't. I can be at a dead stop, put it in drive and it starts going on it's own, even up a hill. It's also developed a 'knock' or 'jump' with it automatically shits gears. I simply cannot afford a new engine, we did that last year when it overheated and blew the gaskets.
View 2 RepliesI have a 2001 chevy venture (254,000 miles) that has me baffled. It has been a great van but it started about a month ago sputtering and bucking and numerous times shutting off. Most times the engine light would NOT come on. It would get the hiccoughs and start bucking like someone learning to drive a stick shift for the first time. Once it sputtered hard enough to throw off the serpentine belt. I put a new timing belt on it last year when I redone the intake manifold gasket. Now its not shutting off but it has only about half the power it should and the engine light is starting to come on more often.
It bogs down and then it will try to go then bog down again. The engine light blinks for about 20 seconds then stops and goes out. When the engine light is on and stays on the code most often says system too lean, and a egr flow insufficient. It does have a vacuum leak in the hose going to the egr. Have ordered that, hasn't come in yet. Gas mileage is horrible. I have done new plugs, fuel filter and cleaned the K&N air filter. Someone suggested the catalytic converter. I dumped in a bottle of 'Cata-cleanse' from Autozone. No difference. A friend of mine had a venture doing the exact same thing. It was in the shop for 6mo with no luck. But his straightened out on its own and is running good now. I really don't feel like waiting 6mo to see if this will straighten out.
My 2001 Chevy Venture stalls after driving it approximately 15 minutes and won't start for about 20-30 minutes, then same problem occurs. I've had the following parts replaced to date, with no success.
AIR FILTER
ENGINE CONTROL SYSTEM
IGNITION MODULE
FUEL PUMP AND WIRING
2001 Chevy Venture: Pins to 2nd fan in 4 pin connector burned and melting to connector. Fan seemed to work when wiggling connector. Bypassed connector and now does not work unless A/C is turned on Full Speed. Is connector important? What controls fans? Computer controlled? Seems to be larger gauge wire in one side than the other.
View 2 RepliesThe fact :
- 136400 miles on a '03 Venture.
- Run on 5 cylinder for 1 minute after crank. After run fine on 6 cylinders.
- Engine coolant is leaking but I dont know where : there's no smell like a defective IMG.
I get a noticable "P0304: Misfire cylinder #4" with CES blinking under accelerating.
The cylinder #4 is the front middle one : the easiest to check and access. BTW i change plugs, wire and coil and still the same symptoms.
Fuel injector ?
I did my research and it turns out I need a relay switch for my blinkers. these bulbs are bright but flash too fast..
How do the relay switches work, what do i plug them into and do I need one relay switch per blinker?
My '99 F150 is having wiring issues. It started with a left flasher being fast and the rear bulb not working. I put in new bulb and that didn't fix it. Then I realized that I also had no tail lights. The reverse lights are good and the brake lights work too.
So far I have searched for and repaired suspicious splices done by PO, added a ground wire that was cut off from the trailer wiring harness, checked every fuse that I could with an ohmmeter and I pulled the multi function switch and tested it with an ohmmeter also. It tested fine but I did find one of the female pin connectors had pulled out of the harness. I managed to get it back in and seemed to click into place alright. Somewhere over the course of all that I now have both sides of my flashers fast and still no tail lights. Good news is that I haven't broken my brake lights or reverse lights yet.
Could I have a bad flasher relay? Earlier in the process I did have my 4 way flashers working correctly and a couple times I even had the turn signals going. Now, none of the rear blinking lights work but the front ones go 90 to nothing and I still have no tail lights. My truck does have the auto lamp thing.
I just bought some LED blinkers for my tail lights and after I installed them, I'm getting a fast blinker thing like my lights are out. I know that LEDs don't draw as much power but is there anyway to fix this? Also, if I buy the Valenti tail lights that are LEDS, will I have that issue with them?
View 13 RepliesMy check engine lights been on forever, like every VW, but now it's blinking fast, and the car isn't running right. It's messed up AGAIN, it's running really bad, like misfiring and not making power. It's shaky feeling in the throttle and power, almost like it's going to stall but it doesn't. What the problem is?
View 5 RepliesI bought a 1998 F250 5.4 XLT, 4x4, automatic gear shifting, electric 4x4 HI/LO switch. I'm living up on a hill and when I drove back home last time there was snow and I had to use 4x4 all the way up back home. 4x4 worked fine. I parked the truck and switched of 4x4.
But when I started the truck next time and switched in a gear the 4x4 dash light started blinking. But different to many post I read so far the 4x4 dash light is not just blinking 6 times every 2 minutes, it is blinking constantly very fast (double time of flasher) as soon as I switch in a gear, even without moving the car. The dash light is blinking regardingless to the position of the 4x4 switch. I realized that interior lamp is flashing in same rythm as the 4x4 dash light.
When I shift from 2HI to 4HI 4WD does not engage but it sounds like shift motor on transfer case is doing something. When I switch to 4LO 4WD does not engage either but the gear reduction works. I noticed that when I drive downhill and put on brakes the 4x4 dash light stops blinking for short.
What might be the problem?
What I tested so far:
- All fuses (under dash and under hood) are okay
- Relays under the hood (they switch when I connect them to 12V)
- Switched heating mode selector to panel. Air comes out of panel. Then switched on 4x4 and air comes still out of panel. Not switching to window. So vacuum pump system should be okay as well, right?
- disconnected car battery for a while. Reconnected, started engine, put in a gear and 4x4 dash light was NOT blinking any more. But as soon as I drove a few meters it started blinking again.
- When I drive the speed indicator works as well. So shouldn't be the rear speed sensor, right?
What else can I test?
I just recently replaced my front driver blinker and the replacement worked for about 5 days then it stopped working and the turn arrow started blinking fast again like when it was broken. I had to replace it cause a rock broke it before now I don't know whats wrong.
View 3 RepliesI have a 1997 vw cabrio. I'm having problems with my signal lights. They start blinking super fast or not at all. When they do work if I hit the brake they stop working until I release the brake.
View 6 RepliesLeft the truck sitting for a couple of months while working out of town. I bought this truck used with only 1 key. We rebuilt the engine and had noise issues so we don't want to drive it much until this is resolved. I went out to start the truck to move it and it would not start. It had cranked right up the week before. Now it just spins over and the theft light blinks rapidly. I've check all the door locks.
When I called a Ford dealership all the service guy would tell me is that it's going to have a new key made and I have to have the title on the truck to get it done. AND, I have to have the truck towed to a dealership to fix the problem of it not starting... The battery drained down so I took it out and charged it... only thing I can possibly think of is a low battery or maybe somebody tried to steal it while I was out of town and messed up something.