Chevrolet - Traverse :: 2012 - How To Remove Turn Signal Switch
Jan 2, 2016
Any link I can go on to see how to remove turn signal switch on 2012 chevy traverse????
View 5 RepliesAny link I can go on to see how to remove turn signal switch on 2012 chevy traverse????
View 5 RepliesThinking about getting a used Camry. Is there any issues with any of the years in the seventh generation Camry? What are some of your likes and dislikes of your car? For example I have been told that on the sixth generation Camry you have to remove the bumper to change the turn signal bulb. I have never had to deal with this, just what I have been told.
View 14 RepliesWas wondering how to remove the turn signal bulbs in the OEM LED taillights.. Ordered Some new bulbs and decided to see how hard it was to change out. Removed taillight and located socket the contained the bulb. Looks like it should twist to unlock but only turns a little. looks like it wants to turn counter clockwise.
View 2 RepliesI have had a few times when my 2013 Chevy Traverse LT suddenly jumped to a low gear while quickly slowing down, causing the RPMs to jump up to 4-5000 RPMs. It remains in that gear until I am practically stopped. Is this normal?
View 15 Repliesneeded to replace the turn signal switch on my 91 caprice. when reassembling i could not seem to get the steering locking mech to engage the way it should. I would like a diagram or photo illustration of the correct position of those parts.
View 7 RepliesI have a 2003 W8 wagon and my front turn signal bulb went out. I need to replace it, but am having some problems. I removed the high beam cover to get to the turn signal socket, but I am having problem removing the socket. I was able to turn the socket slightly and was hoping I could just pull it back, unfortunately it doesn't seem to want to move. Is there a trick to remove the turn signal socket so I can remove the bulb? I don't want to force anything in fear of breaking something. there has to be a way.
View 1 RepliesIm switching out the bulbs on the front turn signal light today, I reach my fat little fingers in there and can barely pull off the wire harness that goes into the back of it. When I did this the wire coverings on all three wires just disintegrated I would guess from the heat inside the headlight. Wel there's a short from where they are touching and my signals don't work at all. my question is I can hardly even reach my fingers down in there too remove that wiring harness ( which is the shortest wire ive ever seen) is it necessary for me to remove the grill the front bumper and each headlight in order to access the wires better?
View 5 RepliesI've taken my Traverse in to the shop twice now and they can't seem to find the problem - it misses going up gentle grades, especially when on cruise control and higher speeds. First they said timing belt, then spark plug wire, but it's happening again and I'm about to take it back in. The last time they test drove it and they said they couldn't duplicate the symptoms but I think they didn't take it out for long enough of a test.
View 4 RepliesMy wife's 2010 Chevy Traverse has 85,000 miles, and has run great over the years. The past 4 or 5 times we filled up the tank, the vehicle won't start right afterward. It turns over, but seems like it's either flooded or starved of fuel. Then, after a few tries it gets going and starts up fine until the next fill-up. The "Check Engine" light has not come on during this. At least one time it was way down on gas, and at least one of the times it had almost a quarter tank - same result. I called 2 of my repair buddies and they don't have the answer.
View 3 RepliesGot this weird problem that the turn signal switch clicks by itself, randomly. And it gets worse these couple days. So I decide to take it apart to take a look.
Cleaned it up and it works like new now.
Took some photos .....
I want to replace a turn signal switch, to an electronic one for my 2008 elentra se. Where it is and if I have to take off the cover underneath the steering wheel to find the switch?
View 1 RepliesI have a problem with turn signal. When I switch it on it blinks one or two times, and then stops. It is for both directions. Where might be a problem? The switch or relay?
View 4 RepliesMy 2011 Traverse makes a slight humming noise when operating. Chevrolet says the steering gear is leaking. Need a new steering gear and pump. Also said it is not covered under the powertrain warranty. Our personal mechanic says it should be covered. In April they replaced the steering gear housing kit free of charge. I am an idiot when it comes to figuring out what is supposed to be covered. Why would the steering gear housing kit be covered but not the steering gear? Why would a 2011 have problems with the steering gear? I drive like a granny. Have about 62,000 miles on it.
View 3 RepliesNew owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
Started truck, used windshield washer and noticed High Beam Indicator was lit on dash. Headlight switch not on. Drove to Ford dealer, turned off truck, high beams would not shut off. Dealer replaced the Turn Signal/wiper/High beam switch assembly. Dealer had one in stock. Service manager said they have replaced a few of these Switches. So if your High Beams come on without the headlight switch on you cannot turn them off even if you shut off and exit truck. Also the "You left your lights on warning chime" does not sound when you exit truck.
View 14 RepliesI have a 2002 ford f150 I changed the turn signal switch and now the theft light is on and it won't start...
View 1 RepliesLooking for a tutorial on how to remove the multi-function switch? I have the, seemingly, common issue of wipers not turning off. I bought the new switch, but don't see how to get it out without taking the whole steering wheel off. I can't get to the screws on it at all. I got the plastic covers off, but can't see how to get the switch out.
View 3 RepliesExample, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
For a little over a month now, the front left turn signal has gone out at least once a week. I have been continuing to buy new bulbs for it, and it would run for a few days, then quit on me again. Just today, it happened again, I replaced the bulb, but this time it still isn't working. Ive tried clearing some of the crud off of the inside of the socket, but nothing seems to be working, and now im down a turn signal.
View 1 RepliesMy daughter recently bought a 2004 chevy malibu. she had it checked by a mechanic, who said it was a decent car for the price. the turn signal does not work when she has the brake on.
View 4 RepliesI am having an electrical problem with my front right turn signal I have not been able to chase down.
The symptoms are when the headlights are on, either manually or automatically from the daylight sensor, the front right turn signal will not flash, and I get the double speed clicking as if there were a burned out bulb. However, when it is daylight out and the headlights are in daytime running light mode, the turn signal works fine, 95% of the time. Occasionally when the headlights are off the turn signal will not work either.
I have replaced the headlights casing and bulbs, and tried rebuilding the pig tail harness as well.