Chevrolet - Tahoe :: 1996 - Lock Or Seize During Cranking / Slight Grinding Noise When Normally Starting
Jan 4, 2014
Have a 1996 Chevy Tahoe (305) Engine having engine cranking problems. It makes a slight grinding noise when normally starting. But sometimes it the noise is loud and seems to lock or seize during cranking. I tried shimming it without success, the gear even stuck in the flywheel. I had the starter rebuilt when the bendix stopped engaging the flywheel. I bought this PU second hand and the flywheel cover had been removed as if this truck has had existing starter problems. Also the flywheel teeth look ok.
View 3 Replies
Advertisement
I have a 2001 Chevy Tahoe, and for the past couple of years, I have been having an incredibly frustrating issue with my car. When I go to turn the key, it sounds as if it is about to turn on (ie the engine is about to turn over and it sounds normal) then right before it catches, it will start clicking, the noise sounds like the battery is dead. When it first started happening, I called AAA, however by the time they reached me, the car had started again. Now when it occurs, I wait 10-15 minutes and it will start- every time. I have had it in to 4-5 different car repair shops, however no one can seem to figure out what it is. I have had the battery replaced, and several other things altered, etc, however nothing seems to fix the problem. I am not sure where to go from here, I was informed to check the fuel pump and/or filter yesterday- it happened twice on me yesterday as well.
View 3 Replies
I have a 1996 Chevy Tahoe (5.7L, 185k miles) that I think is misfiring. What typically happens is a shuddering at about 50-55mph while in 4th gear (though to a lesser degree, it will shudder at speeds above that too) and lightly accelerating or keeping speed on a small incline (~5-10% grade). During this time, there is no change on the tach. My check engine light is not on. Spark plugs and wires are new. The problem occurs while using 93 octane fuel. The shuddering is never noticeable in gears 1, 2 or 3, and is not noticeable at full throttle. I replaced the fuel pump about 6 years ago.
I brought it to the transmission shop, but was told that isn't where the problem lies. Second, I took it to a mechanic. He told me that he couldn't pin-point the cylinder, as there were no codes to unveil the problem.
My question is what are the causes I should look for, and how can I address them short of an engine overhaul? I recently read for the first time about Seafoam, and I'm intrigued.
View 9 Replies
I have a slight leak at the front differential and drive shaft. It is nothing major and I don't even notice a oil slick under the truck when it sits for a longer period of time.
View 7 Replies
I have fairly new brakes on my 97 Chevy Tahoe with 202,000+ miles. For the last several months when I come to a stop, sometimes the brakes make a grinding sound (or 'boy-yoi-yong' sound- it's hard to tell) and the brake pedal feels like it 'slips' although the brakes do always stop the car. The brake don't always do this but it happens at least once or twice a day. Sometimes the problems is very mild, other times it's very noticeable. have it checked by two mechanics and they can't get the brakes to misbehave so they can't find the problem. All they did was flush the brake fluid twice and tell me it MIGHT be the master cylinder or the ABS system. My husband got laid off from his job and I am disabled. We can't afford to start fixing everything the mechanics THINK might be wrong with the brakes.
View 3 Replies
Grinding noise in front end, replaced caliper, bearing, brakes and cv joint...
View 5 Replies
So I'm new to the all time awd car thing. I came from a 4x4 truck which 4x4 was never engaged on pavement or in tight cornering. When maneuvering my is250 awd in tight spots ie. parking lots and the front wheels are at full lock in either forward or reverse there is a slight binding/grinding feeling or faint noise. Is this normal on an awd car or Lexus specific??? Did a quick search and didn't find much about this issue. I'm pretty sure its not tire rub.....stock set up.
View 10 Replies
I drive a 2004 chevy Tahoe and have had this problem for about 8 months. It started out very faint and occasional, but has now escalated to loud and consistent. So it ONLY happens when turning right. I've tried to replicate it when turning left and had no success. It happens when I am turning fairly hard at a decent speed. ex. Pulling into my driveway. I've already checked the wheel bearings and Ball joints.
Another thing is that the ABS light is on sometimes when i start the car and comes on every time i turn the steering wheel all the way to the right. It also has a problem where it will shake almost uncontrollably when driving at 65+MPH after hitting a bump or sometimes just randomly on a smooth surface. We just got new tires and balanced them. It did the same with the previous set we had. I know I'm asking for a lot, but where to start?
View 14 Replies
i've got a 2000 chevy impala 3.4 v6 E. runs great once it starts, but lately that takes a lot of cranking. it's getting spark. it's got a new alternator, battery, starter, plugs and wires (and i checked for spark already) I think it's a fuel issue but don't know where to start looking because it has no other problems. there's no smoke or noises, no misfires, or hesitations. i put in a new fuel filter. i have heard that it could be the fuel pressure regulator or maybe even a leak in the line that's causing it to not get pressure. i can't hear any sort of fuel pump sound (maybe i'm deaf) is there a way to check this without a gauge? i simply don't have one and don't have the money to take it to a shop. p.s. i recently replaced both o2 sensors, but i can't see how that would effect the starting. pump, hose, regulator, fuse?
View 4 Replies
I have a 1982 Chevy C30 pickup with an ignition problem. When it's really cold out, 15 degrees or colder, it won't start. When I turn the key, it feels like I'm turning a piece of clay. There is NO cranking, clicking or any sound made. The accessories won't work either. The last time this happened, I heated the ignition tumbler with a heat gun and the truck started. It started one time after that. Then on a warm day it started once; then wouldn't restart. I turn the key and nothing. It had to be towed. I wondering if the problem is the ignition tumbler, where I put the key, or the ignition switch, which is located near the bottom of the steering column.
View 3 Replies
02 Chevy Impala with 177,000 miles has re-starting problems for last 20,000 miles. New Battery, cleaned throttle plate, new fuel pump, check engine light on (emission problem was told to me by mechanic). Whats going on?
When the car runs it runs very well...to get the car started, just wait, sometimes 5 minutes, sometimes longer than an hour. All the time periodically cranking the engine...just does not start. But when it does start, it runs very well.
This problems occurs only after the car has started and is warm. Let it sit for a while then restarting the problem occurs.
View 3 Replies
My wife has a 2004 Chevrolet Tahoe with abut 100K. She did something and doesn't know what but now the car beeps anytime you put it in reverse. No big deal, it's just annoying. I've checked the book and can't find out to disable. How to disable this on a tahoe or know what to look for in the owner's manual.
View 5 Replies
What is the embarrassing clickety sound my 2001 Tahoe makes when I accelerate with the AC on?
View 8 Replies
I have a 98 chevy tahoe and the truck seems to make a strange noise sometimes when applying the brakes. I can feel (sorta) the noise in the brake pedal. Is this something that needs a scan to find out where it's coming from?
View 11 Replies
My 99 Tahoe has started making a weird like clank noise when I shift into drive or reverse. It also has a light shake which was only if I took a sharp turn, but is becoming a little more common.
View 10 Replies
I have a '96 Chevy Silverado that twice (in about as many months) has had some trouble starting. When I turn the key the engine starts to crank, then there is a loud pop and the engine stops. When I crank it again the engine will start, although more slowly than usual. What could be wrong?
View 19 Replies
2002 Chevy Tahoe Z71 ... When I first turn my car on in the morning (or after an extended period of time - i.e. the car has completely cooled down) it makes a clicking / ticking noise that appears to be coming from the engine area. It lasts approximately 10 - 12 seconds and then simply goes away. This happens consistently. I recently had it serviced end-to-end: belts, plugs, total tune-up etc.
View 3 Replies
Sometimes when I start my car it makes a weird cranking/grinding noise for half a second. The closest thing I have to engine mods are my TWM short shifter, and my borla axle back exhaust.
The noise only happens after my car has been sitting there, parked for a few hours. So to bring it to Toyota/mechanic would be nearly impossible to replicate, unless I left it there for a while. And even then, the noise only happens sometimes.
Yes I'm pressing my clutch pedal all the way down. No I am not holding the key too long when starting the car. What it might be?
View 14 Replies
Truck has 190,000 miles. First, every now and then the truck won't start. Turn the ignition key to the start position and nothing happens - like the battery is dead. Turn the key back to the off position, wait maybe 10 - 15 sec. Try and start again - starts right up. This maybe happens about half the time I start the truck. Always seems to start first start attempt of the day. Only later does it start to behave this way.
I took it into a repair shop and they claimed it was the starter relay. After the repair (about two weeks) it seemed fixed - started all the time. Then a couple of days ago it began to do the same thing again. Only now, maybe 10 - 20% of the time doesn't want to crank (vice 50% or more before the repair). Doesn't seem to be the battery because when it cranks it cranks very strong and starts right up.
Now additionally, today, the truck just dies while driving. Doesn't stall or run rough just before dying - just dies - like turning the ignition switch to off. Interestingly, it starts right back up after this - no extended cranking, etc., just starts right up. I have tried "jiggling" the start switch to see if maybe it is failing, but it has no effect. That is, when the truck won't crank, "jiggling" the switch won't make it crank, and "jiggling" the switch while the truck is running doesn't cause it to die. Sometimes, the waiting 10 -15 secs or so between crank attempts doesn't work - that is, it doesn't crank, but if I open up the hood and take the starter relay out of its socket and put it back in, it cranks.
View 13 Replies
I've recently been hearing a grinding/vibration noise on takeoff. I only hear it pretty much as soon as my foot comes off the brake, when the car is in drive, and the car gets its first bit of forward engagement/movement. It seems to only happen when the DSG engages in drive, before I put my foot on the gas pedal.
The closest thing I can say it sounds like is an exhaust rattle, but way less violent/not metal on metal sounding.
View 2 Replies
I've noticed recently that on startup I'll hear a minor grinding noise after the engine has kicked over. Seems to happen more when the car is really cold.
View 24 Replies
