Chevrolet - Silverado :: Shaking While In Idle / Check Engine Light Came On
Apr 28, 2016
I just bought this used truck, 2005 Chevrolet Silverado 1500 extended cab. I noticed some shaking while in idle when I got it back home. The check engine light came on a day or two later, and I recently had a diagnostic test ran on it at the local AutoZone. It came up that I had a P0135 o2 sensor (bank 1 sensor 1) malfunction and a P0101 Mass Air Flow Sensor signal performance issue. The check engine light comes and goes. I stopped by Walmart for about 10 or 15 minutes and when I got back into the truck, the issues reoccurred. For about a minute, the check engine light actually started blinking! And then went away and started running normal again. Its upper confusing. I bought some MAF cleaner to use on it tomorrow and figured that wouldn't definitely clear up my issues, but I'm still wondering if the MAF sensor is enough to warrant the CEL to blink like that?!
View 6 Replies
Advertisement
I have a 1998 chevy silverado z/71 4x4. I had a water leak and had the intake manifold gaskets replaced. Ever since then, the check engine light comes on and it soots up the o2 sensors and the 4 plugs on the right bank. It may run good for a month or so and then it starts all over again.
View 1 Replies
recently my check engine light came on, I had the codes read, the tech said that i had air getting into my fuel system, i replaced my gas cap. my light is still on, he also mentioned some kind of emissions sylinoid may need replaced, or a vent valve idk.
I recently drove up to Sandusky OH for the weekend, my light didnt come on til i refuled with gas containing 15% enthenol. the engine is running fine, no miss, has good power. I ran it down to a 1/4 of a tank and filled back up and the light is still on.
View 4 Replies
I have a 2003 silverado 1500 4x4. The check engine was on along with the abs light. I went to advance and let them tell me what was going on. I don't know the specific code but it said the passenger front abs speed sensor was bad so I replaced it along with new brakes, rotors and calipers. Now the abs, check engine and red brake light is on. There is also a message telling me that the brakes need serviced. I went back to advance and let them tell me once again why those lights were on and it was still the passenger speed sensor bad. What could be going on with it? Before it was replaced the red light never came on but now it is.
View 10 Replies
1996 Silverado 350 engine. When I turn ignition key on, all system check lights come on as they should except "check engine soon". If I connect code reader the light comes on and will come on the next time ignition is turned on but only one time. The second time you try it, it does not. What would cause this?
View 3 Replies
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 Replies
First of all, its 5.7L V8, it's been very well maintained, I've had my fair share of problems but nothing that has been that serious, except for the "check engine" light for the O2 sensor.
For about the last 4 months i've had the problem of the truck sometimes jerking while on the road. Once i started to speed up it seemed to not speed up which when it did, it jerked a bit. That was in the beginning.
AS OF NOW, the jerking has stopped but every now and then when i pull out of the garage and start to turn onto road it turns off, but all the status lights are left on. & when turn the key to turn it off and restart it starts again every time. Ive noticed that i was better off with the "check engine" light on then now because every time it is off it has these problems.
Also, when I barely start to tap the brake, again not all the time, sound skips on the radio. & this always happens when i tap on the brake & this happens more frequently when the "check engine" light is off.
View 3 Replies
Driving while in 4x4 HI up a hill the truck started to slip. I stopped, shifted to neutral, and engaged 4x4 Low. I shifted back to drive and started moving up the hill. The engine started to lose power and the "Service Engine Soon" light began to blink. I put the truck in park. As I let it run a little bit, the engine started to shake as if something was very imbalanced. I went to check under the hood, and confirmed that it was shaking quite noticeably. There was no grinding or clattering of any kind though.
I turned the truck off for a bit, and then restarted. There was no light or shaking upon starting up; but as soon as I put it in gear and started driving I could tell it was losing power, the light came back on, and the shaking ensued. This occurred in 2wd, and both 4wd lo and hi. I parked it at a neighbors place and there it sits for now.
I plan to try and get the codes read. My other vehicles can't make it through the snow we have right now, but it is suppose to get warm later today and might melt enough for me to get one out. I also live out in the country, so the nearest auto parts place is about 20 miles. Same with a dealership service shop. I'm hoping I can buy and return a code reader from an auto parts store to assess if this is something I can diagnose myself or not.
It is the 6.0l gas engine with the 4sp automatic transmission. The truck also has about 107,000 miles.
View 16 Replies
I have a 2001 chevy silverado 3500 6L gasoline engine.
I have been getting a P0307 random multiple misfire #7 on and off for a few months now, occasionally the P0300. Check engine light comes on when I am going up hills, often under heavy load and sometimes when the truck is cold in the morning and the truck starts to run rough until the code clears, which it does pretty quickly usually. I have replaced coil, crank sensor, cam sensor, fuel injectors. If I unplug the battery overnight the code will be cleared and the truck will be running just fine the next day.
View 6 Replies
I have a 2001 Silverado and for some reason all the dash lights on come from check engine to the abs light gas gauge goes to empty then back to normal 9 times out of 10 these lights come on. It has done this for a while and doesn't effect how it drives, I am possibly wanting to sell it and cannot explain hat it runs fine with this problem. Where do I start to figure this problem out .
View 4 Replies
I am still pretty new to the VW world. About 2 months ago I bought an 04 GLX 4Motion Passat with a 2.8 V6. On Saturday night my fiance (and primary driver of the VW) went to go start the car to go out for the night and the check engine light came on and she said the car was kind of shaking. She decided to take my car instead. I went out yesterday and today to try to start it and it wont crank over; it sounds like it wants to but just wont. She also said that on Sat. night that it smelled like gasoline outside of the car. What this could be? I dont know if the engine is flooded or what the hell is going on. The car has 93,xxx miles on it.
View 2 Replies
With a 100 k on the odometer, the wife reports that the car started shaking, trans was slipping and check engine light came on after driving about two miles. She drives it at low speed back to the house. Investigation under the hood shows trans fluid in the radiator and coming out of the overflow tank. Engine starts right up and we have not had any other driveline problems since owning the car in 2005.
View 1 Replies
My mechanic said one cylinder isnt working though we havent done any checking beyond wires. It's not worth putting money into but I cannot afford to get anything else. Will driving on just the 5 cylinders create increased damage or other issues that will get me stranded? it starts right up, is rough but levels out after a couple minutes It is smooth driving under 40mph, but acceleration above that creates shaking and check engine light flashing, no ominous ticking noises but can tell not firing on all cylinders. Problem is I will have to drive it highway speeds at some point-tried it before and made it-was able to eventually baby it up to the required traffic mph with the shaking diminishing and smoothing out but rattling started up again every time I had to hit the accelerator to increase the speed. What can I expect by continuing to drive it?
View 8 Replies
I bought my second used 2007 chevy silverado 2500hd classic LT 6.6l diesel and the cruise control and elevated idle wont work. have done tons of reserch. And have found nothing useful to my situation. have found everything from a simple fuse to a module which is expensive. i have checked that all my brake lights work, have checked all fuses and even bought a new column switch for the cruise control. That didn't fix it.
I am thinking the brake switch or possibly something with the trailer whirring might be shorted or installed incorrectly.the reason i think it has something to do with the brakes is it is a common denominator between the cruise control and the elevated idle. if elevated idle is on and you touch the brake pedal at all it shuts off and idles normal on a working system. which i know from my previous identical truck. the brakes also shut off the cruise if touched at all. i have had a hell of a time trying to figure this out.
View 1 Replies
About a week ago I was driving my Pontiac 2003 Grand Am V6 and it began to violently shake and the "check engine light" came on and started blinking. I then immediately took it to the mechanic It has been with the mechanic for 6 days and they were unable to locate the problem. They called me today and I was told that I have no compression in one of the cylinders (I have done business with them before and felt comfortable in that I wasn't being taken advantage of). Also, is there any problems in the future with getting a cylinder replaced i.e. other parts of the engine that might correlate?
View 17 Replies
I have a 2000 f150 4x2 5.4 168k... Check engine came on,started shaking, weather was really cold. RPM would be a little high then low then back up. Especially when I turned on heater. Felt like truck would die but never does nor does it have issue starting.
So far, I have replaced two oxygen sensors inside engine,all coils, spark plugs, fuel filter, had injectors cleaned, intake cleaned. Truck runs better but, light came on a day later again. I can feel the tiniest of shaking going on and, cold mornings still make RPMS a little unstable. I was driving truck on highway at about 60 mph when a slight tug was felt and Truck check engine came on. I feel truck heavy, once it warms up completely, a little lighter.
Codes came up at auto zone as P1151
But I'm running out of options and frankly, money to fix this truck.
Checked the MAF and looked okay.
I'm with minimal skills.
View 13 Replies
My 99 Explorer XLT V6 SOHC has been misfiring lately. In idle the RPM needle fluctuates a bit and the vehicle vibrates and shakes. At night when the lights are on I notice them dim a bit as the engine struggles in idle. It doesnt stall very often at all. Accelerating I notice way less power and the engine studders. Thats when the engine light comes on flashing. Then remains on solid afterwards.
I brought it to a mechanic friend who read the code and it was cylinder two misfire as well as O2 censor. I replaced the plugs and leads and censor. Noticed the plug in cylinder two had little to no gapping. Thought I had fixed the problem. Vehicle ran perfect. Three or four days later driving on the hwy same problem came back. Thinking it must be the coil pack I got one for a good price and replaced it.
Again, the truck ran great for four days and now the problem has returned. Same thing, shaking studdering and flashing engine light. I have verified the locations of the wires and plugs a few times so i believe they are all properly installed.
View 7 Replies
I have a 06 chevy 3500 express van with a 6.0 engine. The engine light came on about the O2 sensor bank 1 sensor 1 and bank 2 sensor 1 came up on the on the scan tool. It run great. how do I fix it
View 4 Replies
my 2002 chevy impala has had the check engine light on for a while now i took it to a shop and he said my engine was bad. I asked for the codes he got he said he just told me my engine was bad why do I need codes. I talked to another mechanic this week and he said he'd look at it, that it might not be that because I should of got a print out for what I paid for. SO I got a oil change today and when i left I saw in the comments that they put class 2 oil pan leak and a class 2 transmission leak. Could that be why my check engine light is on? How bad is a class 2 transmission leak?
View 10 Replies
2000 Chevy S10 pickup
Had the check engine light come on, and when I checked on the code it gave a 4th cylinder misfire. Autozone instructed me to simply replace my spark plug with a new oem plug.
I replaced the spark plug as instructed. After about an hour of driving, the check engine light goes off and I think, great! Problem solved. However, another hour of driving and the check engine light is back on again, without going away.
I headed back to autozone to get a readout, just to find that it's the same code. So I put another spark plug in. Same result - check engine light goes off after an hour, only to come back on again permanently after another hour.
Now, normally I would think, this must be the spark plug line that needs replacement,however I am sure there must be some clue in the fact that the check engine light turned off for an hour.
By the way, not sure if relevant, but I also found a lot of build up around the spark plug before I initially changed it.In fact, there was so much that I had to scrape around the plug with an awl, and blow out the crud with a compressor,just to get my socket into place without there being crud in the way.
Any clue what that check engine off/on clue might be?
View 6 Replies
2005 Malibu 2.2L 4 cyl.109,000 miles
If I hit a bump too hard the Check Engine light comes on because the gas cap pops out. Dealer told me this is a common problem with many of the Chevy models earlier than 2007. GM doesn't have a solution, either.
Since none of these cars have a locking mechanism I decided to get a locking cap at NAPA because the locking mechanism would hold the cap in place. Nope! The locking cap is even worse.
View 13 Replies
