Chevrolet - Malibu :: Car Running Sluggish / Making Noise And Check Engine Light On
Sep 28, 2014
I have a 2006 Chevy Malibu 125,000 miles, 2.2 Engine that was running sluggish, noisy like needed oil (checked didn't) and check engine light was on. Took it to a repair shop and told needed an oil change, car still ran sluggish, told to drive it a day or so. Two days later, car wouldn't go over 50 mph, took it back and told needed air filter and mass air flow cleaned. After they did that, they told me the Catalytic converter needed replaced however they don't do that work. Within a week car would not run so had the cat replaced.
Car ran better but still not great. Took it to another place, spark plugs replaced, throttle body cleaned and fuel injector cleaner added to gas.Still the car ran sluggish and was making noise and check engine light was on. Took it to parts store to have code checked on check engine and said error in bank one of oxygen sensor. I replaced that, reset the light and am sure you know, it still runs bad and noisy and check engine light came back on. I am losing power on hills and big hills the engine rattles.
View 5 Replies
Advertisement
2005 Malibu 2.2L 4 cyl.109,000 miles
If I hit a bump too hard the Check Engine light comes on because the gas cap pops out. Dealer told me this is a common problem with many of the Chevy models earlier than 2007. GM doesn't have a solution, either.
Since none of these cars have a locking mechanism I decided to get a locking cap at NAPA because the locking mechanism would hold the cap in place. Nope! The locking cap is even worse.
View 13 Replies
After filling the gas tank yesterday, as I was on my way to work, the check engine light came on. For the last couple of days the temperatures outside have reached 118 degrees. I have checked the oil and coolant and have resealed the gas cap as well, yet the light still remains. The research I have done leads me to believe the problem may be the catalytic converter, but I'm wondering if there is any further troubleshooting I can do without heading to a mechanic.
View 7 Replies
I recently replaced the head gaskets in my 2003 Malibu. First time and all seems other than it runs rough at stop lights. The check engine came back on and so I had it read and there is an air flow issue. Is there anywhere that I can get a schematic for the vacum lines? I have all over and cannot seem to find a loose or broken one.
View 3 Replies
When I tried to turn left yesterday, my car suddenly stopped with both the "check engine" light and "battery" light on, but the heat, headlights and radio were working just fine. I turned off the engine, and waiting a few minutes, ad then restarted the car, and everything is fine. I do not drive the car today. My question: is this a problem with the battery or the electric line? When the "battery" light is on, can i conclude it's a problem limited to the electric line only rather than a fuel line. My car is Chevy Malibu, 1999, with 90,000 mileages on it.
View 12 Replies
My 2008 Malibu service manual states that the check engine light should briefly come on when I start my engine. When the engine is cold this does not happen. Also, it happens infrequently when the engine is warm. My Chevrolet dealer says this is normal as the light checks out when tested. Chevrolet has not given me a difinitive answer on this. My concern is that if this is a problem it may surface at another time when the light should go on and cause damage if not attended to. If the manual says the check engine light should go on when the engine is started and it doesn't, doesn't this mean something is wrong?
View 14 Replies
I have a 2011 F250 6.7 that I bought in August of 2010. I have 35K miles on it and it has pretty much been trouble free once I got the firmware update for the shifting issues. I have the local dealership do all of my service work and all updates and service bulletins have been applied. Unfortunately on my way to work this morning the stupid Check Engine Light came on. The dealership has it now - hopefully I will know tomorrow.... I do think it has been running a little sluggish but I am not sure if that is the winter grade diesel (I use PM22-A in every single tank).
View 2 Replies
When I brake I get a rhythmic noise that starts like a quiet chirp and by the time I have completely put the brake pedal down it sounds like a loud grinding noise. It is a rhythmic pulsing noise, not continuous. I recently got new rear drum brakes, and 2 garages said my front brakes were fine. One guy said it could be the wheel bearing but I looked online and it says that happens when you accelerate, not when you brake. It only happens when I brake at relatively low speeds. In other words if I'm on the hiway and brake to slow down from 70 to 60 or 40 to 30, it won't happen. I also feel vibration in the brake pedal, but only when I have almost completely stopped.
View 1 Replies
2004 chevy malibu classic... My blinkers make weird sounds and does not work half the time unless i hit the hazard lights. problem two theft system light comes on and stays on. problem three shut off car to re-start i think i can i think i can then start no problem after words. fourth problem the seat belt buzzer wont stop have to play with key in ignition.
View 1 Replies
My 2003 Malibu engine will stop running all of a sudden while I'm driving. It has happened four times and I need to know why before the car kills me. The accelerator pedal goes limp and within ten seconds the check oil light comes on, the check engine light comes on, the power steering quits and then the engine dies. AAA mechanics had this car for four days and couldn't figure it out. My local mechanic has had it for five days and hasn't figured it out. I have looked on the internet and I am not alone. But there is no definitive solution to this problem. BTW, it's not the fuel pump.
View 7 Replies
Started having problems with my Chevy Malibu (1999, with 95,000 miles on it) while driving two times this week. Both times an alert warning flashed on my dashboard. The first time, flashed the brake check and ABS warning on the left side of the dashboard, and the second time the check oil and check battery warning on the right side. In both cases, after the warnings flashed, the car was still running, but stepping on the gas pedal resulted in no acceleration, but brakes still worked. The steering wheel also locks-up to the point where I can't turn any more. Both times, I stopped and shut off the engine, waited about 30 seconds and restarted, after which everything is fine and normal. The brake pads were changed recently, but not the rotors which may not be in very good shape.
View 14 Replies
I went to start my car this morning and it seemed my battery was dead. I then had my car jumped. It started fine, but the trip meter was reset. As i was driving it seemed fine. I then came to a stop at a traffic light and the engine started failing. I parked and the guages started going nuts, the engine was making a high whining noise, it sputtered a bit and then shut off. What is going on? Is it something i can do myself having little experience working on cars?
View 1 Replies
I have a 2001 malibu , my cars engine light has been for about a week. This is the second time it has happened. lately I have been having trouble starting my car. Does this have anything to do with my car , or because of the cold weather? How important is it for me to get my car checked out?
View 2 Replies
I have a 98 f-150 with a 4.2 and my check engine light is on and when I'm traveling down the road i notice that when i give it gas the engine feels sluggish and my check engine Light is now flashing.
View 6 Replies
My wife called to tell me that her Camry would barely pull away from a standstill this morning. Very sluggish until about 2500 rpm, at which point she said it took off normally. This accompanied by the Check Engine light, which just appeared this morning. I haven't been home yet to check fluid levels or take a test drive. Anything in particular I should be looking for?
View 6 Replies
I have 2005 Chevy Malibu that has been making slightly metallic thud noises while turning. The car does not need to be in motion, but will make the noise in both forward or reverse in both directions. The noise is gradually increasing in loudness. I have inspected the CV boots and verified that this car has electric power steering assist. The dealer would not look at it, stating that the "Malibu's do this". Additionally the service rep stated that "if he had it checked out they would not find anything anyway." This noise does not sound like anything that should be ignored and sounds like major failure / safety issue pending. I can find no consensus on what might be wrong?
View 4 Replies
2005 F-150 4.6L 2WD, 268,000 miles....
Recently I got a flashing 'Check Engine' light and a rough running engine (along with a tapping noise) when I was passing someone (and pulling a trailer). I retrieved codes 300, 304, & 305. I can't swear to it, but I think the tapping noise started at the same time as the coil problem.
I replaced coils #4 & #5 (later that same day) and the engine smoothed back out but the tapping noise is still hanging around. The noise speeds up at higher RPM's and doesn't go away if I shift into neutral. Oil level and pressure are fine and I only use Motorcraft 5W-20 and Motorcraft filters (and change the oil every 5K miles).
Not sure if this is relevant: I think I have bad valve guide seals (blue smoke after long idles) but no other problems that I am aware of. It sort of sounds like a lifter, but is there a good way to pin it down? Is it possible that this tapping is related to the bad coils?
View 5 Replies
I have a 1999 Chevy Suburban K1500 4 wheel drive. It has a 5.7 liter engine and has 360,000 miles. I recently had a fuel pump put in last year. It is now running sluggish when I accelerate it will not go. This happens after it seems to warm up about 15 minutes of driving. I just replaced the fuel filter thinking that it may have been plugged up but it is still running poorly. When I put the fuel pressure gauge on it, it read 61-62 during start up and then dropped down to 57-59 (pulsates rapidly) after I started it.
View 2 Replies
2001 with the 3.1 6cyl. First thing that started this nightmare is I was noticing a bit of a hiccup after driving for a couple miles. We've only had the car a few months and not sure what maintenance was done so we thought maybe it needed a tune up. Before I got the parts the check engine light came on so I went to parts store to get it read, it was P0302.
Did the wires and plugs and it got worse, the code wasn't p0302 now its just p0300. But after the plugs it also started idling really rough and would be slow to shift. Once it tacked up high and wasn't speeding up. That was only once tho. Also now it has no power its like driving a 2cyl ...
Anyway we decided since the first code said 2 we replaced coil 2, no luck..ok, fuel filter and fuel injector 2, no luck. Also has cleaned various things Im not sure of the technical name for..sensors and air filters and other things.
None of this has worked the car still idles very bad and doesn't have the power it should have. Also cleaned things on fuel rail(?). He is in the process of replacing the crank sensor as someone said if it was all the way bad it would throw a different code but it may just be faulty.
View 10 Replies
Well I just set the timing on my rebuilt chevy 5.7 1999 suburban. It still runs sluggish when I accelerate and idles nice when it'd parked. I rebuilt the whole part part of engine. This is what I did notice when I cleaned under the lower intake manifold where the fuel injectors plug in. Here is a attached picture.
View 1 Replies
I have been dealing w/ a broken gas gauge for a while and have been monitoring my mileage and fill-ups and have been able to calculate my gas usage pretty well, however sometimes I may get a little lost on where my level is at. I just recently have been using a long plastic tie strap that reaches the end (I think) of the gas intake and I believe hits the gas tank. (Its goes in about 4' and I cannot push it any further at that point)
My question is when it comes up w/ no gasoline on it I am wondering how many gallons are remaining. Looking at a diagram of the gas tank it looks concave, where some of the gas may sit lower that where my tie hits. But I am almost certain that I have at least a few gallons remaining. For safety and other reasons this is not something that I am doing often, its just in this case I am a few miles from a gas station so I do not want to risk it.
View 5 Replies