I have a 2009 Chevy Malibu that gives through rotors every 6 months. I have replaced them 3 times now in 102,000 miles and had them turned multiple times. What happens is about 6,000 miles after I put new rotors on they warp and I get a violent vibration when braking at high speeds. I have been to 3 different dealerships and none of them can figure out why they continue to warp.
View 12 RepliesMy wife has an Acura, and when braking at higher speeds, she is getting a really bad "vibration". I am assuming the rotors are warped. We had both axles (rotors/pads) done last year (about 40k ago) at Midas. After they did them, we had to take the car back about 3 times for squeaky pads, and I swear a slight vibration, but they didn't fix them. Anyway, even though they offer "lifetime pads," I refuse to go back there.
So, her pads now started squeaking again. We were dealing with the warped rotors until we had some extra money and time to take it in. At this point, I am wondering where I should take it. I have no clue if the pads are good, and I'm guessing the rotors just need to be turned since they were just put on last brake job.
I have a 2007 dodge Dakota with 112K miles. At 105K I had the front brake rotors and pads replaced. The rear brakes were fine. There was a problem with one of the rotors and I returned a week or two later and one, which was warped, was replaced. Ever since that second visit I have had an intermittent vibration from the vehicle. When I brake the whole truck vibrates. And by vibrating, I mean some pretty heavy shaking. It is not the steering wheel vibrating. I took this back to the mechanic where they were unable to find any issues with the brakes. Also, we could not (of course) re-create the issue while it was in the shop. I have not been able to find the pattern. It happens when I am braking at high speeds, but not every time. It also happens at lower speed, but again, not every time.
View 2 RepliesI had my rotors turned and pads replaced 2 years and approx. 11k miles ago, now I have a violent vibration when I brake. The new mechanic is saying the rotors are warped. Can this be so? I'm very easy on brakes...really. The car is an 2005 Honda Civic with 74k miles. Did I get ripped off by the last mechanic?
View 7 RepliesI have a 2004 Honda Accord EX (4 cyl) with 102k miles. I bought it brand new and kept it completely in shape with regular service. For the past few months I start getting front end vibration at braking, mostly when slowing from high speeds and without any repair this vibration has now became common at all speed.... my diagnosis - I need to replace to turn disk/rotors....
While I have not remedy the rotor issue yet, I started getting this new vibration at 60 to 80 mph.... Below and above this range of speed i have no vibrations - the car will drive fine. This type of vibration in my experience for front wheel drives is mostly due to balancing or bad tires. so i took the easy way ..... and as i already needed tires well i dished out the dough and replaced all four with Michelin Primacy hoping that it will resolve the speed related vibration.... Well it did not?
I continue to drive as-is without addressing the real problem - coz I'm not sure what is causing the vibration.... now new additional vibration started on acceleration; any time I hit the gas pedal (normal acceleration or kick-down) I get vibration very similar to when a stick shift's gearbox required replacement/repair of the worn out pressure plate's (fingers/springs gets bent or weak) or the thrust bearing needs replacements/repair/grease packing. I'm from the old school stickshift transmission, my knowledge in automatic is very little - I have repaired Acura's automatic transmission before but I don't think repairing once will make me an expert in automatic.
So to summarize my issues or current state:
Issue# 1 front end vibration on braking
Issue# 2 front end vibration 60 to 80 mph speed only
Issue# 3 front end vibration on acceleration at all speed
The list above is in sequential order as I have experienced.
So my 07 with 125k miles has had new rotors for about 50k miles or so, but for a while now when the brakes get hot it gets a violent shudder on braking at highway speeds....the odd part to me is nothing at lower speeds, and not always at higher speeds....do I just have warped rotors again? The rest of the front end I good and tight....
View 9 RepliesI have a 2008 Chevrolet Trailblazer. I have had 4 of these vehicles and have been very pleased. This latest one has 61000 miles and occasionally has a very strange vibration at speeds above 60 mph. It only happens occasionally and most often occurs at these higher speeds and worsens with increased speed (of 70-73 mph). The vibration is so alarming, that I will press my brakes to slow down, because it feels like the vehicle is starting to lose control. The problem is that when I press the brakes, the vibration intensifies about 3-4 fold! It feel as if the wheels are going to come off. It's a very frightening feeling. I have taken it to the shop and no one seems to know what it is. The tires are fine. Brakes are fine. Interestingly enough, if I lower the speed to 50-55 mph, the vibration lessens and eventually completely goes away.
View 1 RepliesI just bought a 2009 Toyota Camry with 78K miles on it. Everything is great except at highway speeds it shakes and vibrates when braking. The higher the speed the worse it is. Steering wheel shakes as well. I pulled both front tires off and the rotors appear to be smoothe on both sides with no grooves, etc. However, I'm due for new front brake pads. There's some pad left but could that be why it shakes and vibrates when braking? How do you tell if rotors are warped? Rotors are smooth but could they still be warped?
View 16 RepliesSo when i hit ~80km/h (50 miles) some weird extremely small vibration is coming on. You cannot feel it from anywhere but when u touch something, like handbrake then its there. Tho the sound is kinda loud. So the pattern is like, 0.3 seconds it is vibrating and 0.3 is quiet, it does not matter on which road i drive.
This problem cannot be caused by wheels (got other alloys and same problem), also already got alignment and have balanced my wheels. So, what to do?
When I brake I get a rhythmic noise that starts like a quiet chirp and by the time I have completely put the brake pedal down it sounds like a loud grinding noise. It is a rhythmic pulsing noise, not continuous. I recently got new rear drum brakes, and 2 garages said my front brakes were fine. One guy said it could be the wheel bearing but I looked online and it says that happens when you accelerate, not when you brake. It only happens when I brake at relatively low speeds. In other words if I'm on the hiway and brake to slow down from 70 to 60 or 40 to 30, it won't happen. I also feel vibration in the brake pedal, but only when I have almost completely stopped.
View 1 RepliesI am the proud owner of a P.O.S it’s a 2001 Chevrolet Malibu, the trouble is with my ABS braking system. I replaced both hubs a year ago they have the ABS sensor built into them. The light has started coming on so I checked the voltage on both sides of the car the reading are, driver side at 169mv-320mv and the ohm reading is 1.02K, on the passenger side it reads 140mv-240mv the ohm reads 1.01K, one is a bit lower but well above the 50mv minimum. When I restart my car sometimes the light is out until the ABS kicks in on a wet or gravel road. Then the dash light comes on and the ABS system shuts down again, the only thing a code reader states is low voltage in the system but does not call out what side or where the low voltage is coming from…
View 2 RepliesI have a 2004 chevy malibu LT V6. Got it in 2009 from a dealership near where I live. During the road test I did not notice the vibration, may be because I did not drive it on a freeway. Point to be noted that it came with 2 brand new front tires. I called the dealership and they did balanced the wheels for free of charge. But the problem did not go away. This time I took my car to pepboys for wheel balancing. It is better now but I still feel the vibration on the wheel @ the speed of 60 or over. I have done wheel balancing and replaced back tires. Problem still remains. I own some other cars and they don't have this issue.
View 7 RepliesNoticing excessive vibration when braking after 50-60 mph speeds.
View 4 RepliesWhat do I need to do about the high pitched noise I hear when turning the steering wheel right or left?
View 2 RepliesI recently purchased the rims from another member here on Club Lexus.
Ever since installation, I have been experiencing a vibration at highway speeds and while braking. The wheels are correctly balanced.
My technician has told me that I need to buy a hub ring/spacer (not too sure what that is) but nonetheless, a grommet of such that fits between the backside of the rim and the frontside of the hub. I'm not too sure where to begin from there or what to even look for.
2003 7.3 Excursion, 130k, stock suspension with newer bushings, etc.
Vibration when braking at higher speeds - not felt as pulses through brake pedal or shimmy through steering wheel - rather, a "body" vibration. Stops as soon as the TC unlocks. Being a diesel I can't tap the brake to allow it to unlock like on the gasser 4R100's - its locked until it shifts down into 3rd. Turning off OD puts it into 3rd but locks TC (no way to "single out" TC). Only felt when braking in OD (though I haven't tried running up to highway speeds with OD off/trans in 3rd) - braking is completely smooth at all other times/gears/speeds and at all braking force (light, mod, heavy).
Front and rear pads are good with even wear and sufficient material, lugs evenly torqued, tires good/balanced, no sign of a stuck caliper or rotor warping, MM manual hubs unlocked. No driveshaft carrier on the Ex's, just a regular two joint shaft with recent Neapco Gold u-joints, no slip yoke play. Trans filter replaced 4k miles ago, 6 +/- qts DexIII/Merc exchanged when I did the filter, fluid smelt and looked fine. Transfer case fluid changed about 5k miles ago. Factory LSD rear diff not serviced recently but fluid suctioned from fill hole looks acceptable.
I'm afraid that something is going on with torque converter/shudder but I don't get any shudder or slip under acceleration or at any other time and gear shifts are smooth. I know that the 4R100's can be sketchy, especially with 130k, but want to get suggestions before digging into it. I've also got a very slow hydroboost leak/weep but the power steering fluid is properly filled. Steering is smooth and proper, brake pedal movement is normal so I assume there is no air in the lines.
Sometimes the locks in the doors do not lock or unlock and I have to use a key or do it manually if its not the drivers door. Only in a certain range of temperatures does this problem occur. It happens when it is roughly between 65 and 85 degrees out.
It will not have this issue when it is cold nor will it happen when it is beastly hot, just when its a bit warm. I press the lock button on the fob and all but the drivers door or the door right behind it will lock. It is frustrating and I want to know if there is something I can do to prevent this from persisting and to know if the locks will eventually fail completely if it goes unchecked.
it has never been in an accident, but shes had her doors slammed a few times in the past by my passengers.
When braking at very slow speeds(less than 5 mph), my ABS system engages. It can be startling and the truck keeps rolling forward unless I pump the brakes to get it to stop. The truck is drivable, I just have to be careful when pulling into our garage or slowing behind someone at a traffic stop. What could be causing this?
View 2 RepliesI replaced my tires yesterday with Bridgestone Turanza ER33 (245/45/19).
After replacing the tires, there is is an extreme vibration in the front end of the car when braking at highway speeds (60+ mph). Braking at sub 50mph speeds is completely normal. No lights, no vibration while driving. What could be the reason?
Also while removing the lug nut locks, the locks key broke apart (the black piece came out of the key). After like 45mins of trying, finally we got the locks out. I threw them away.
I searched online for regular lug nuts, but couldn't find any beside ebay. The local dealer says I need to wait for 3 weeks to get them from Japan! Where can I get a set of 4 regular lug nuts online?
I'm now running on 4 lug nuts on each wheel. Could this cause a problem? Could the vibration be caused by not having a 5th lug nut in place?
My Prius c has always made a high speed whirling noise when braking but now at speeds of 42 to 46 MPH this high speed whirling noise is there and when you are just coasting have a noisy transmission or is this something I should be getting to the dealer with.
EVCT transmission noise ....
I have been getting a little wobble at high speeds(80MPH) when i brake the car. I am guessing those are the front disk brakes (had similar experience with my old 2002 Galant which i fixed with the brakes). My Sonata has 67,000 miles. Is it ok if i replace just the pads ?
2011 2.4L Hyundai Sonata SE