Chevrolet - Cobalt :: 2005 - Noise And Vibration In Steering Wheel And Gas Pedal
Oct 5, 2012
This started several months ago. I can feel it in steering wheel & gas pedal. I thought it was the tires so I put 2 new tires on front, but no change.Tires had no unusual wear. Happens at any speed, worse around curves, left or right. Worse when temp is colder, 55 degrees, better at 75 degrees. Not affected by braking or in coasting neutral. No problem with steering or pulling.
View 2 Replies
Advertisement
So 2 weeks ago I noticed that after 30 minutes of driving on the highway my steering wheel started making a loud growling noise and vibrating really hard! When I hit the brakes it got worse but got better as I slowed to 30 mph. It doesn't happen all the time and not right away, only after a while of driving and the dealership says without codes they can do nothing...
View 7 Replies
13.5k, 2.2 Ecotec, Automatic
The MAF had to be replaced, while the car was at the dealer the power steering motor was replaced (recall). When I got the car back the steering motor (reman) was making a lot of noise and I took it back. This time the motor and the steering column were replaced. After a week I got the car back last night.
This morning I noticed the steering wheel is off center (~1/2 to 3/4") to the right. The car tracks straight with no pull to either side.
View 11 Replies
I noticed this problem day as I was out and about, as I come out of a medium to hard turn (at least one wheel rotation) my wheel doesn't want to return fully to the center position. The wheel starts to slow down about half a turn in either position and I need to get it around the quarter turn position. I don't have to force it much, it feels more turning the wheel while in park.
I has winter tires put on in December and the mechanic told me they couldn't do an alignment because one of my rear coils was broken (planning on getting that fixed myself once I get a weekend where it's not at or below 0 outside) and my front ball-joints (I think that's what they said) was loose and that the front joint didn't need to be looked at immediately, but by spring should be replaced.
That front joint is what's giving me problems? Or is it something else?
View 5 Replies
I have driven my Hyundai for 79,880 miles. I brought it new in 2005. I had the front brakes replaced and afterwards felt a vibration through the gas pedal, steering wheel and seat. Both driver side and passenger sides had the vibration. You can feel the vibration at any speed. Sometimes it feels as if there is a part spinning unbalanced and bumping against something.
I replaced both front wheel bearings, both CV joints, and both front struts. These were all the original parts and they were all in need of replacement. The struts were so bad that they had no gas to resist a simple push at one end. I had all four tires high speed balanced.
I lifted the front end and stepped on the gas to get the tires going. I did it at high speed and my friend tells me he could hear a rattling of what he thinks are steel ball bearings coming from the drivers side of the automatic transmission. He thinks that there may be a bad bearing(s) in the transmission. I simply don't know. What the cause of the vibration might be? Could my warranty cover the repair?
View 1 Replies
I don't know how the story ended with the 07 4WD Avalanche with the unidentifiable noise - he said, "The noise always occurs between 45-60mph (not rpm-related) there is a groaning sound and it is accompanied by a vibration in the steering wheel. it is especially noticeable when going around turns.."He went on to say that he checked the hubs and they were fine, and decided that he would replace the tranny. I sure hope that fixed it.I had the same problem on my 07 4WD Avi, and the hubs checked just fine, smooth as silk, with no loose play at all. But on a 1000+ mile trip just a few days later, the groaning and vibration grew worse, but only when I went around a left curve. I barely made it to my destination - the right hub failed. If it had been groaning and vibrating when turning right, it would've been the left hub. I replaced both at the same time.
View 3 Replies
I have a stunning r32 2004 with an hpa ft450 turbo fitted,(also porsche cayenne discs , calipers , adj suspension , milltek high flow cat , strut brace front and rear, seat splitter, ) all receipts and work carried out bought car like this. On cold it runs good and boost is good , but as soon as its warm (about 4 mins ) in 3rd 4th 5th 6th gear when the boost kicks in I get a biggish vibration through acc pedal and steering wheel, but nothing untoward before boost apart from a slight misfire on idle, the car is running rich and using plenty fuel, the turbo was fitted at 18k and now done 23k, so its very low milage.
I have fitted 3 coil packs, new plugs (old ones were black), I have been told, that the car goes through o2 sensors for fun, just cant understand why, i have no lights coming on , and going for vagcom diagnostic in the morning.
View 12 Replies
I bought a 2010 toyota camry se. I have the most annoying vibration in the steering wheel, seats, gas pedal. Have taken it to several places, including a Toyota dealer.. They seem to not be able to find the cause. I've had wheels checked, balance, aligned, rotated. There is also an annoying clonking noise coming from the front passenger assembly. It's very sporadic as in only goes away when trying to have a technician hear it.
View 8 Replies
2009 FX4... Every once in a while, I'll feel a vibration in the gas pedal. It happens under acceleration, and typically if I'm pushing down and it has not downshifted yet. Then once it downshifts the vibration is less noticeable.
I have had the mechtronic unit replaced due to harsh shifting and the vibration was there before and after that was replaced. The drive shaft was also replaced due to a click/clinking noise and the vibration was there before and after as well. The harsh shifting and clinking noise was fixed with those repairs, but the vibration is still there. I notice it more when I am towing.
View 13 Replies
When I have to push on the brakes for a hard stop, I can feel the brake pedal and the steering wheel shake a whole lot. Also, he ABS light is on. Correlation between the 2 obviously?
View 10 Replies
Make: Chevy Model: Cobalt LS Year: 2005 Mileage: 120000
So I'm having this problem with my engine stalling at low RPM. The RPM goes to 0 and the engine shuts off.
This only happens when traveling at low speeds (e.g. slowly accelerating from a stop, braking, moving in stop and go traffic)
This NEVER happens when I'm traveling above 10 mph (e.g. if I'm coasting at 40 and let my foot off the gas, the RPM can go to 500 RPM but it will never stall in this case).
After the stall, I can always put the car in park, turn the ignition and it will turn back on again.
I have not noticed any electrical problems that occur when this happens (the radio stays on during the stall and the lights don't dim).
My car was part of that Chevy ignition switch recall, but I took it to the dealership which (hopefully) repaired it.
View 4 Replies
I have a 2005 Chevy Cobalt, 2.2L engine and am having a few problems. I believe I am losing coolant somewhere, but cannot ever see any leaks or anything on the ground where I park. I am having to top off the reservoir a couple times a month with water/coolant to keep the temperature from going up above normal (which I've found is around 190 degrees). I first noticed this when the temperature had reached 230 degrees! I also hear a sound like sloshing water in the front end when I first start and drive the vehicle. The sloshing usually subsides after I've been driving for several minutes. To top it all off I now have a bit of foam on the oil cap and the oil looks a tad bit cloudy.
View 10 Replies
My 2005 Chevy Cobalt is refusing to start on occasion. I turn the key, nothing. Its not the battery. I wait exactly 10 minutes and it starts no problem!The dealer wants me to take it in only when this is happening but in 10 minutes the tow truck driver won't even arrive. What is the problem? The computer?
View 4 Replies
I am on my 4th Avalon and have loved everyone. This newest one, however is experiencing a slight steering wheel vibration intermittently at 70-75 mph. It also does not seem to "track well" at this speed. I have to work harder to drive this than my wife's Suburban.
Neither one of these problems is "severe", but aggravating and worrisome. The vehicle has about 2000 miles on it. I am taking it to the dealer tomorrow and my fear is all he will do is the balance the tires (and maybe that will do it), but I am afraid the "tracking" issue may be more involved. It almost seems like there is a slight amount of play in the steering wheel.
View 2 Replies
My wife was about to pull off of our hill (facing uphill) to go to work. She said she stopped, held on the brake, and looked back and forth. She then went to press the gas and the pedal wouldn't respond (no rev either) but the engine WAS on. The car started drifting backward and she said that both the steering and the brakes were very difficult to control (power and brake assist had disappeared). She was able to guide it back into the driveway and get it parked. She said that when she got it parked, she turned it off and started it up again. She tried the gas and it worked and she tried the steering and brakes and both worked. She stayed home today while we try to figure out what's going on with it for fear that it will happen again.
I initially thought some sort of power loss but she said that the radio stayed on. There were no dash warning lights or sounds indicated to her and she said that there were no unusual sounds from the car during this whole thing.
View 4 Replies
Vibration in steering started in January soon after full brake job, new rotors, etc. on my 05AvyXLS. Pronounced between 60 and 70 mph where steering wheel shakes in my hands. Had tires balanced and rotated 3 or 4 times, alignment, checked tires/treadwear, in 3 diff stores (incl dealer)...same problem. Just bought new set of tires today, thought prob would go away since all pros thought was a tire prob...negative. Same prob, only even more pronounced!
I'm thinking I have a tie rod, wheel bearing, strut/shock, or some kinda suspension prob? I've spent considerable dough with exactly the same prob. And could there have been something related to the brake/rotor job? My pro says no, unless there is vibration when I brake, which there is not! Vibration occurs b/t 60 and 70, whether I'm in the gas or not, and does not happen when braking! What can this be??
View 4 Replies
In the past month our 2005 Subaru Legacy has had a vibration(intermittently) where the steering wheel going slightly back/forth 60-70 MPH. I understand a wheel balance can cause this. However intermittently does not make sense. My wife simply speeds up to 80MPH and it disappeared or less than 60. Any clues?
View 2 Replies
I have my 2005 F-250 6.0L Powerstroke. Thing is, I have this issue where when I turn the wheel at a dead stop or at low speeds. I get this weird feedback in my steering wheel of a shaky vibration, like it's skipping. And frankly, feels like the whole cab is shaking. I've replaced the power steering pump, and tightened the steering box. What could it be?
View 4 Replies
This just started this afternoon. I was leaving the store to come home, and as I cranked the car and shifted into reverse the power locks went down... then up... then down... then up... then up again... then up again... etc. So I pulled into the parking space and turned it off and then on again, hoping it was just some intermittent issue. No such luck.
Since I was just two miles from home I figured I'd suck it up until I got to the house. About halfway home my car decided it wanted to shift into neutral gear (it was making the same noise you'd get if you manually shifted the car into neutral)... then back into drive... then into neutral... then into drive...it was doing it with the same rhythm as the door locks.
Then the dinging started. As in, a "your door is ajar" ding rather than a "there's a loose bit of metal" ding. It would ding but then stop in mid-ding, kind of like a "DIN*stop* DING DING DING DIN*stop*". At about this time I started hearing a clicking noise coming from somewhere under my dashboard.
View 6 Replies
I have a 2009 cobolt when I put on the brakes slowly there's a rattle noise and some shaking. The ball joints are new and so are the bearings. Could it be bad brakes or a strut?
View 9 Replies
I have a 2007 Chevrolet Cobalt with 26700 miles on it and I have recently started hear some odd rattling noises from the back right tire area and I have looked under the car to make sure that there was not anything loose under there and I didn't see anything. The tires on getting pretty worn out and I have order a whole new set, but I am still very worried about that noise.
View 3 Replies