1989 2.8L FI Celebrity Wagon. Normally runs fine (for 190K miles) but occasionally won't start. Turns over fine but make no attempt to start - like no fuel or spark. I'm guessing an electrical problem as it will start instantly and just fine a day or two later. Where to start looking for the problem?
View 2 RepliesChevy Celebrity ... Engine is 2.8 mpfi and I have been able to get it to start by pumping the gas pedal while cranking and keeping it running by having the gas pedal depressed slightly but as soon as I let off the gas the car will die. It has a new starter, new fuel filter, half a tank of gas, new battery...
Check engine light came on and i did the paperclip trick and it showed code 43 which was knock sensor.
2001 explorer, SOHC. Sometimes just lately (5 times in the past three weeks) the engine just does not start. It turns over just fine but makes no attempt to actually start. When it does this it will after a few attempts start right up like nothing was ever wrong. It doesn't seem to matter whether it is cold or warm. Intermittent problems are very hard to diagnose .....
View 10 RepliesIt was running fine. tried to start and it just turns over. Also the fuel gauge doesn't move from an 1/8th of a tank. I took the filter line off, turned the key, and gas shoots out but the injectors don't spray at all. I poured some gas in the tbi and still just turns over without even trying to start.
View 16 RepliesVehicle: 1995 960 wagon
Background: Exhibits intermittent no-start behavior in both warm and cold weather, wet and dry weather, having sat overnight, or only sitting a few minutes. Turns over fine, but won't start. Sunday, it started fine several times, went to Home Depot, wouldn't start. Called a friend to pick me up. When he was almost there, I tried it again and it started back fine. Been in shop a few times, they played around with a few electrical connections, battery cables and grounds to injectors. Also replaced fuel pump. I have not verified if it is a fuel or spark problem, I just bought a FI fuel pressure gauge last night.
Once started, it does fine. It never stalls or cuts out. That is why I am leaning toward a CPS (that's what jeep people call it.) Sometimes, under the slow cranking speed (relative to idle) the signal is too weak to be useful. However, during idle and normal operation, the flywheel is moving fast enough that the signal is much stronger (being a magnetic pickup). Thus, the reason it only happens during starting, not during running.
Here's my current working theory: Bad crank position sensor (is that Volvo people call it?)
This is the only part I can think of that would cause this. A fuel pump problem would probably show up during running. I think the pump also receives a signal from the cam sensor, so if that sensor were the problem, it would happen during running too, not just starting. It the cam sensor an optical sensor? Shouldn't cause it to not start, although it might cause a difficult start.
I have a 1987 Chevy Celebrity w/a 2.5l automatic engine. Physically its in really good shape and only has 64k original miles. Consistent issue is it will crank (sometimes very hard to get it to do so, then run smooth, sometimes for days, sometimes for only minutes, then stall out. It usually stalls after the engine is good and warm. If you let it sit for about 5-10 minutes, it will restart and idle smooth and then go into stalling out again, sometimes within minutes, sometimes days. I have replaced the fuel tank, fuel filter, sending unit/fuel pump, fuel injector, throttle body, the computer, exhaust/muffler, mass air flow sensor, several other sensors and it has not improved or worsened the problem. I have sunk $1700.00 into this car in replacement parts. I can't believe that there's much else left that could be the cause, and I suspect its bound to be something simple, like a sensor or something, because pretty much all of the expensive stuff's been replaced.
View 1 RepliesI have a 1989 Toyota Camry station wagon. I was driving it tonight on a slow neighborhood street and it just died. When I tried to start it back up, it won't start. I have power, all lights and things at full strength. When trying to start it it makes a high-pitched whirring screeching sound. I don't know where the starter is located, but the sound seems to be coming from around the spark plugs or behind/under them.
View 2 RepliesI have an '89 740 wagon, Bosch ignition. It will not start. If I spray starter fluid, it will fire, then immediately die. I have replaced already both fuel pumps, noise suppressor/fuel injector relay, fuel pump relays.
I installed a fuse in the fuse box, which was empty when I purchased the car. And the engine instantly died. It did start up when the fuse was removed, and I drove it back across country. The idle got worse until it died and would not start back home.
I recently bought this car in its current no start condition after sitting 3 years. Initially I jumped it off and it just cranked, no attempt to start and no noise from either fuel pump.
I checked the fuses and the fuel pump relay behind/under the radio and it clicked and was dated 2006 so it had been replaced. I assumed it was replaced when the under car fuel pump was replaced at it was a replacement.
I sprayed a little starting fluid and it fired right up and ran until used up.
I ordered both pumps and strainer and installed the under car pump earlier this week. The in tank pump and strainer looked horrible and original. There was a small issue with the return line on the in tank fuel pump sending unit when I removed it that required brazing which I got back from the shop today.
This afternoon I installed the in tank pump & strainer on the sending unit and installed all that stuff. I spliced in a quick disconnect in the wiring harness for easy separation/installation next time.
Jumped the car again [yeah needs a battery] after everything was hooked back up and no in tank pump heard with key on to prime several times and no start although I hear the under car pump quit after attempting to start and they turned off.
Is there any other fuse/relay to check? If the under car fuel pump is evidently working, wouldn't it pull fuel without the in tank pump coming on? There's about 3 gallons in the tank. I'm going to test if there's current to the in tank pump tomorrow.
Yesterday I went out in the AM, got in car, depressed the brake, and pushed the start button. I heard normal electrical sounds, then the red triangle of death came on, and it stopped it usual start up sounds, and nothing happened. I could not do anything. I couldn't take it out of park, couldn't push start button again. The electrical system was on cause a bunch of the lights in the dash were lit ( the only one i remember that was lit was the brake word in the dash, but there were others) I sat there a few minutes trying to push the start button or get it to shut off somehow, and eventually it all just shut off.
I depressed the brake and pushed the start button again and it started up just fine, and off to work I went. It started up fine on my way home from work, and running errands after work.
Then this morning - same thing! First time, no start, and the red triangle of death came on. I let off the brake and just sat there hoping that like yesterday it would eventually shut off and I could try again. The only difference today was that on the display monitor a warning notice came up it said something like: Caution: Problem with Transmission "P" brake system. Park car on flat surface, and fully apply the parking brake. When this happens though, I cannot event put the car in neutral or anything. I continued to sit there about 4 minutes, then everything shut off, and I started the car right up like normal. and off to work I went.
What could be my issue?? My driveway in on an incline, would this have anything with it not starting?
I have a 1990 Chevy Celebrity wagon with a vent problem. The air will only blow out the dashboard vents, so I'm getting no heat down below, or air to the defroster.
View 2 RepliesI bought a 1987 Chevy Celebrity for $700.00. Initially it ran fine after just a slight hesitation when the accelerator was first pressed. With a little more gas applied it smoothed out and ran well. Yesterday I took a drive to the library. On the way the engine stalled. After a minute or so I was able to restart the engine and proceeded to the library. On the way home the engine again stalled. I was able to restart the engine but it idled roughly and stalled as soon as the accelerator was pressed even slightly. I tried varying the amount of gas applied from very little to pressing the pedal to the floor to rocking the gas pedal to no avail. So; idles roughly, stalls when gas is applied.
View 8 RepliesI've had my car die twice on me lately. There is absolutely no warning - no sputtering, rough-running- just dies completely. I am still able to crank the engine after this happens, but it won't start immediately. After five or ten minutes, it will start and then run fine. 1990 Celebrity. what this could be and how to fix it?
View 1 Replies92 tercel will not start. Replaced plugs, wires, rotor, cap. Turns over ok.
View 2 RepliesMy son's Ranger wouldn't start today, turns over fine, added gas to make sure it wasn't out still no hit.
Other than fuel pump (he said he couldn't hear it) what things should he check? I'll check back in the morning.
1994 Ranger 2.3 4 Speed ....
So my wife drove her car all day yesterday, everything fine. This morning went to start and it wouldn't. It turns over fine just not firing.
Now during the summer I had replace the fuel pump/filter before discovering that was not the issue.
I know you are already thinking CPS!.. I replaced that over the summer.
I have not checked the spark yet, kinda hard to do that one by yourself.
Beyond spark I am not sure what else could be wrong, especially because it was running fine last night. Is it common for accents to have issues in 20 degree weather?
I have an 89 Chevy Van. It has been sitting for 4 weeks without being started. I went to start it and no lights or radio and didn't even try to roll over. I figured the battery was dead so I went to jump it. With the cables connected the van started but once I removed a cable the van turn off! Is it the battery or is there another problem?
View 13 RepliesI bought a 99F350 with a 7.3, it was not running when I bought it. Batteries good, new starter, turns over just fine, fuel pump works, but now I don't know what to look for.
Was testing ohms for my injectors and at the plug on top of the driver side valve cover, couldn't get a reading at all, tested the ohms at the pass. Side valve cover plug and got good ohm readings.
I have a '89 Chevy 350 v8 in my boat. It starts fine, but then stalled when decelerating, and would not start. I smelled some gas fumes when trying to start it after it had died. It started up fine the next day without problems. The distributor was just replaced so I know that is good. Not sure if this is related, but occasionally it will diesel a couple cycles when I turn it off. Could this be the carburetor, or something else?
View 9 RepliesMy truck hasn't run for over a year and no one seems to be able to tell me why. The fuel pump supposedly has 10 lbs of pressure, it has new fuel pump relay, new throttle body, and probably more new things (can't remember exactly). It will start up normally and then it will act like it's not getting fuel and within seconds die. If I keep my foot on the gas and kind of pump it (I know it's EFI) it will try to keep running, but will die, and it really gets rough toward the end like the whole engine's going to fall out. The truck has 300K+ on it but the engine was replaced about 10,000 miles ago. It still has a lot of original equipment.
View 14 RepliesThis S10 has 4 wheel drive and the V6 engine and has 88,000 miles on it. Just about everything except the engine has been replaced because it was a work and plow car and took a beating. It is a great plow car, by the way. Recently a cloud of smoke comes out of the exhaust when you start the engine that has been sitting overnight. Mechanic says it is just old, but someone said that replacing the umbrella seals might do the trick. Stopped at my local auto parts store and they had never heard of umbrella seals.
View 7 Replies