Chevrolet - Caprice :: 1990 - AC Compressor Exploded / Front Seal Of Transmission Is Leaking
Jul 6, 2013
So I am on my way home after an honest 8, and I make it a mile down the road and goose the old girl a little off a stop light. Well next thing I know we have smoke rolling out under the hood, well it turns out the "smoke" was r134 refrigerant. The guy that recharged it said that the compressor failed and that its common with retrofits because 134a runs at a higher pressure.
Now I don't need a/c, and I might just leave it as is, but it would be nice to have the old girl working 100%. It also turns out that the front seal of the transmission is leaking, I am debating whether or not to just have the transmission rebuilt. it shifts fine but its gotta come out anyway. Its a 700r4 and the trans guy recommends stronger 3-4 clutches and a shift kit to make the holding pressure higher.
View 13 Replies
Advertisement
I've got a 1990 ford ranger 4.0 auto trans front transmission seal went bad, I've got everything unbolted abs ready to come put but the trans won't come over top of the front cross member, what could be the problem on why it won't come out?
View 3 Replies
I've got an E4OD trans out of my 1994 F150 4x4. It has 145,000 miles on it. The reason why it came out was because the front seal was leaking terrible. Also the electrical connector for the transmission melted and there is a hole right there now. Other than that the trans shifted fine and worked when I drove it. My question is what can I do with the trans?
View 1 Replies
1977 F150 4x4 C6 transmission 351M
I just changed the front seal on my transmission, but its is still leaking as if I never did a thing? Did I miss something or is there something else that could be causing my problem?
View 4 Replies
My Chevrolet 1992 Caprice Air conditioner is chilling but the compressor doesn't disengage when reach the right temperature inside cabin... There seems to be a temperature control or a sensor and I don't know where is it...
View 2 Replies
I had my truck at the shop today and it was determined that the transfer case front driveshaft seal is leaking and the gasket between the transmission and transfer case has also failed. The shop wants a reasonable amount to fix it but they need the truck for 2-3 days. It doesn't appear to be that difficult of a job to remove the transfer case. Am I missing something? Dropping off the truck and leaving it for a few days is the difficult portion......if they could do it in a day I'd just pay them and be done with it. So my thought was to pull it and just drop it off so they can replace the seals and fix any other issues.
View 1 Replies
The leak looked like it was coming from a heater hose. The individual I bought it from said he fixed it and it wasn't leaking the day I bought it. Upon driving it home...cranked the heat up and windows fogged, switched to defog with no luck. Added some coolant and still the same thing and leak began again.
It smells like antifreeze inside and fog has oily feeling when wiping it off the window. Got in on the lift and no luck seeing where it was leaking from, even with it running. My previous experience with bad heater cores is that it leaks on the inside and smells like coolant... is it leaking on the outside or is it something else?
It's NOT overheating or blowing any kind of smoke. Temp gauge read normal! It's a 4.3L, 1994 Caprice LS .....
View 4 Replies
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6
View 5 Replies
1990 f150
I have a leak in my rear fuel tank, the front tank has been blocked off and is not used, The leak is at the seam of the two part tank, once removed is there a way to seal this? or should I just replace it?
View 2 Replies
When the truck set's for a couple weeks the tranny leaks a preety good size spot on the floor, as long as its driven every couple days not 1 drop. I know the is converter drain back but what seal or O-ring is causing this?
View 2 Replies
I just had a leaking transmission seal replaced and I was told by the mechanic that the Freestyle was notorious for leaking. Is that correct?? Will this car need lots of repairs if I keep it.
View 5 Replies
I get my oil change at the Toyota dealership instead of Lexus and save quite a bit of money for my 2013 ES350. At the 30k service, Toyota technician said he noticed transmission fluid leaking at the axle seal." I was gonna show Lexus this at some point, or maybe get an oil change there at the 40k service.
View 3 Replies
When I took my Saturn L300 to the dealer recently for its regular oil change I was told that my right front axel seal was leaking and it will cost me $580 to replace. This seems awfully high to me. Am I getting fleeced by the GM dealer?
View 1 Replies
I have replaced my cv axle and seal, and now I have transmission fluid leaking from the axle seal. What could be the cause of this? The seal is brand new as is the cv axle. Could it be that it the seal isn't seated correctly? What could possibly went wrong to cause this?
View 3 Replies
I've got to replace a leaking front crankshaft oil seal. Haynes shows using a steering wheel puller with the two bolts installed, but without the center screw. Insert a socket and extension through the center screw hole. Hold the body of the puller with an adjustable to keep the crank pulley from turning while you loosen the pulley bolt. I've got an air impact. Would that hammer the pulley bolt loose without having to hold the pulley? I've also got a chain vise-grip, but I'm not sure yet if it would clear the other pulleys. Assuming I get this far, should I pry out the seal with a flat screwdriver wrapped in tape? Would it work to cut the rubber out of the seal first?
View 3 Replies
I have a 1995 Celica GT, 5sfe engine, 5 speed manual. Front main crank seal appears to be leaking. I've replaced transaxles before but no timing chains or oil seals. Is the access from the wheel well and fairly straightforward?
View 2 Replies
I replaced the front mail seal on my 2003 Hyundai Elantra. It was running beautifully until I put it gear to take a test drive. It dumped half the oil in about a minute. After reading online that there may be a problem with the thrust bearings, I pulled the oil pan and found a thrust bearing in the pan. Is this something I could fix without pulling the engine. Every thing looks good and there are no metal shavings or signs of wear. The car has 170k.
View 2 Replies
I have a 2006 gmc sierra, 4x4, 1/2 ton, has 155,000 miles on it. I recently changed both front hubs on my truck. They didn't have any play in them just noise. I had one new front hub that was leaking grease out of the rear seal. I took that one back off and got a new one. Must have had a bad rear seal. Now I'm getting a front end vibration at highway speeds. Between 70-75mph. It gets worse when turning left when highway turns. It goes completely away when turning right at highway speeds. It doesn't shake in the steering wheel. Feels like its coming from the left front area or left front tire. More in the floor boards. So i rotated my tires, and its not as bad but still is there in the same spot. I've checked everything.
Cv axles have no tears in the boots and aren't spinning out any grease. I turn the steering back and fourth while the truck was on the ground and I didn't notice any play in any of the front end components. The only thing I did notice was the passenger side inner tie rod boot had a bunch of grease built up on it. But the boot was actually full. Could one of the bad wheel bearings caused something else to go bad? Warped rotor? Truck doesn't shake or vibrate when braking either.
View 3 Replies
I haven't had time to take my truck to the dealer to actually be checked yet but it appears I might have a rear main seal going out from what I can see. I pressure washed the whole underside of my truck the other day and there is fresh oil where the engine connects to the transmission.
My truck is a 2011 with a 2013 engine in it. The truck has 103,900 miles on it. The engine has almost 60,000 miles on it. I have the extended warranty on it which is good. All this truck has to do is last 2 more lousy months and I'll replace it.
2011 Ford F-450 6.7L Diesel 12' Flatbed
View 5 Replies
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 Replies
Couple weeks ago found some oil drops in the drive way so I got Underneath to see this disappointment. Hope the pictures come through for you all to see. She's been in the shop since Monday.
front crank case seal gone bad! what a mess.
View 14 Replies
