My 1993 Sundance with automatic transmission abruptly jammed. It won't go into park but will go into the other gears including reverse. Since the only way to stop and "park" the vehicle is to shift into neutral, the key is now permanently stuck in the ignition. What did I do or what happened?!!
View 1 RepliesI have just bought a 2001 Prius with 127,550 miles. Hybrid battery has been replaced with a used one and all systems seem to work fine except the shift lever in the "Park" position does not lock the transmission. No big problem as long as the Parking Brake works. Preliminary investigation does not reveal any easy fix.
View 6 Repliesi have a 1993 3/4 ton pickup 5.7 and it just started to shift rough it has to get up to 4000 rpm to shift from 1-2 and 2-3 someone told me to change the filter another person told me to check the vacume line i went under truck and found a vent tube out the side not sure what to do
View 1 RepliesI have had a 2000 Chevy Cavalier 2.2 liter 4 cyl Automatic for about 5 or 6 years now. I have noticed the whole time I have owned it that when I start the car and shift from Park to Drive I hear a clunk and the with the hood open the engine pivots back and forth one time more than it is supposed to. This only happens from park to drive, it does not do this from park to any other gears, and once the car is in drive everything is normal. The car has no shifting problems at all, no slips or clunking while driving or hitting the gas real fast on take off.
I changed the all three mounts on the car yesterday. Upper engine mount (still in decent shape), lower dogbone (tore to hell), and Transmission mount (decent). I really haven't noticed it get any worse over the years I just know its not right. I have never changed the fluid or the filter since I owned the car, and most likely it has never been changed in the cars life. Could a dirty filter, and dirty fluid cause this problem? Or could the linkage need adjusted or replaced?
I have a 93 Jeep Cherokee, I just replaced the thermostat and the radiator cap, it's not overheating, however the radiator cap isn't even warming up and the thermostat housing heats up quite a bit.
The hose from the radiator to the thermostat gets very hot, but I don't feel anything being pumped. The coolant is also being drained from the reservoir, but I see little to none leaking underneath the vehicle. I pop off the radiator cap while it's in idle and see no movement and the coolant stays cool.
I have a 93 tercel that has developed a weird engine problem. It starts fine and will drive fine for about half hour. If u stop after half hour and shut engine off and 5 minutes later try to restart and it will crank over for at least 10 seconds before it restarts. After it is running again it seems to have a serious stutter and doesnt want to idle. When u shift into drive it stalls and you have to crank engine for another 10 or more seconds before it will start again, and when it does start it still stuttering and wanting to stall. If you keep foot on brake and other foot on gas it can be driven and once the car is moving over 10 mph it runs fine. The wires have been changed and the rotor and the cap and also timing belt replaced. Plugs also were pulled and inspected. Showed sighns of wear but all were nice tan color and looked good.
View 8 RepliesMy car is a 93 Hyundai Excel with the automatic transmission. The donor car was a 94 Excel with a manual transmission. This instrument cluster had the rare tach so that is why it was to go in mine. Everything I have read on the Hyundai forums said it is 100% plug and play regardless of year or transmission. The upgraded instrument cluster worked in the donor car, but in mine nothing works. Fuel gauge goes to full but that's about it (my tank is almost empty). What would cause this? I've checked the printed circuit board, fuses, everything.
View 5 RepliesWhen I go to start my car it has a solid red light around park, as it should, but it has a flashing green light around drive also. When this happens my car will not start. I usually try it a few times, wait and try and try again until it finally starts up. Once it starts the drives light is still blinking so I turn the car off and back on, then it is good to go. This does not happen every time, it seem sporadic. The engine, battery and oil light stay on, but I think it may only be because the car is starting up, usually the lights come on when starting then go off once the car is ready. Btw it is a 1993 Honda Accord.
View 1 RepliesI just recently bought a used 1993 Toyota Corolla LE from a private individual. The guy said the vibration was caused by a crack in the front bumper but I think it is much more than that. The vibration is present all the time, but much worse when the car in in park or neutral. It has an automatic transmission. What could be causing the vibration?
View 4 RepliesMy park assist doesn't go on. It only peeps two times when I push The assist button and nothing happens. Before it works normally.
View 1 RepliesSo mine is a 2014 is250awd and I currently have 16,000 miles. Sometimes when I put my car into park the gear lever doesn't always go all the way into park. It kinda gets stuck, then the car under its own weight will pull the lever into park. I will see an obvious movement of the gear lever going even further into the park position.
Sometimes I try to be a little bit more forceful with it, to push the gear lever into park. So it doesn't get pulled or clicked into place by the weight of the car gently settling forward or backwards depending where I parked.
But The other day I pulled into and parked on a bit of an incline, put the car in park and got out. When I got back into the car from the store, when I sat in the car it rolled back what seemed like and inch and a loud click and I see the gear lever get forced into park as the car rolled back. So it seemed to me I left the car, and it wasn't quite in park or drive. Which seems a bit unsettling to me.
I have a 93 Aerostar 4.0 and it is displaying the blinking airbag light (3-2) and the horn doesn't work and the cruise control failed. I believe it is the clockspring ...
QUESTION: Can the clockspring be repaired or must it be replaced. I do not have a schematic of the electrical components of the clockspring ...
I recently purchased a 2005 Elantra Automatic, my question is, when shifting it out of park, the shifter doesn't stop at "D" but at "3" is there an adjustment or is it just a quirk of the car?
View 2 RepliesI have a 1993 Chevy G20 van that was starting intermittently and now won't start at all. It cranks but doesn't start. On one of the occasions that I actually got it started I went to have the battery and alternator tested and was told that the alternator was good but the battery was low.
I then bought a battery charger and attempted to charge it. It has not started since. It also will not jump. I have tried to listen for the fuel pump and I don't hear anything...of course that could be because I don't know what to listen for.
So my question is: what more should I check before I give up and get it towed? I just want to be sure that I'm not spending all that money for a tow when it was something easy like a relay or a battery issue. I have some mechanical knowledge but no where to apply it (i.e.: my vehicle is outdoors and I don't have a lot of tools or a decent jack).
My 98 PA ash tray doesn't stay up. I can't see what is wrong. I meet another PA owner that has the same thing. Is it in the dash, or is it in the door that flaps down? What do I need to do to fix it? What part can I get/do I need if I went to a wrecking yard?
View 6 RepliesThis morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
Car: 1993 Chevy C 1500 (2WD) manual transmission Background: The car sat unused in a garage for 2 weeks (no problems before this) the first drive after its break, the pickup almost felt like it was slipping and power was not getting to the wheels. The vibrating began the next day. The vibrating is very obvious and unpleasant under acceleration at approximately 2000 RPMs in any gear. Grease was injected via grease zerk into the center carrier bearing area and the vibrating was marginally better. Today the back end of the truck was lifted up and put into gear and brought up to 30 MPH. The pickup was then lowered and a test drive revealed that the vibrating was considerably diminished.
An inspection of the drive shaft reveals:no vibrating in neutral the U-joints are not loose or leaking; the drive shaft has 2 small dents which are countered on the opposite side by weights;the drive shaft will move up and down ~1 inch or less if pushed in bench press fashion near the carrier bearing;the drive shaft does not move in the direction of the length of the vehicle;the drive shaft will rotate freely 1/16th to 1/8th of a turn before it is stopped by the back of the transmission or the rear differential; no mud clods in wheel wells;new tires properly inflated.
I drive a 1993 Chevrolet 1500 v6, 2wd. I have changed every part I can think of related to the fuel system. When I try to accelerate, the engine hesitates, it gets louder, and my truck will jerk. Sometimes, however, it is responsive. Often times, it will be responsive for a few minutes and start to decelerate.
View 2 RepliesMy wife's '93 Chevy Lumina has a strange habit of not starting unless I charge the battery overnight. The lights don't dim when I turn the key which would normally tell me that the battery and connections are fine, but the solenoid won't energize. If I trickle charge the battery overnight it will start fine. Now this generally happens after the car has been sitting for an extended period of time. Computer maybe?
View 4 RepliesA friend of mine has a 93 Corsica with the 2.2 liter engine. His #4 cylinder has no spark. #1 and #4 share a coil and #1 has spark. Also #2 and #3 are ok. He has replaced the coil for 1&4 and also the ignition control module but still only has spark on #1. The wires are new and test ok. How you can have spark on one side of a waste spark system?
View 1 RepliesI own a Elantra 2011 and I have a major problem. I cannot shift from PARK to DRIVE and my electric windows doesn't work either ! Everything else working fine and the car start normally !! The dealer cannot find the trouble and the car just have 19802 KM on it!!
View 3 Replies