Cherokee :: 2001 Gremlins No Codes And Won't Start
Dec 27, 2011
I have a 2001 cherokee with the 4.0l I6, I have a gremlin or two i think... It all started with the heater blower resistor, then the blower......
It had a intermittent starting issue where it wouldn't start on the first try, but always on the second.... What is that?
I replaced the crankshaft position sensor.... Still starts the same.....
Then the water pump went out last week, replaced it, still leaks....
parked it before christmas so i could fix it yesterday.... NOW IT WONT START.
I just wasted $45 on a Cam position sensor that did not fix the problem. Merry Christmas.
So now, i am back at square one, No start. What next?
btw, no codes after the "hold odometer and turn key" procedure....
View 8 Replies
Advertisement
There was one message that I found like my problem, but a little different. When I turn the key it won't start, just sounds like it is going to start. I turn the key the second time it will usually start. sometimes it takes 3 times.
View 14 Replies
I have a 2006 Santa Fe with the 3.5l, AWD, 5 speed auto, and 65,000 miles. Its a daily drive. Out of the blue it won't start. It cranks, but it won't start. The battery is strong and it has 1/2 tank of gas. I figured my code reader would solve the mystery, but it's doesn't produce any error codes. With no codes I don't even know where to begin.
View 4 Replies
I have a well-maintained 2001 Honda Odyssey EX with about 162k miles. It's had all of it's recommended maintenance at the recommended intervals. And until lately all of that maintenance was done at the dealership. Of note, the transmission was replaced by the dealer at around 100k miles. Other than fit-and-finish issues it runs great.
Over the past few months, I've had issues with it starting. The key will turn, everything "lights-up" as it should, I hear the engine crank normally, but it just won't start. I do this 2, 3, 4, 5 times over a few minutes and finally, it starts. When it does start it runs fine. Sometimes this happens several times in a single day. Sometimes it goes for 1-2 weeks without it happening at all. I've tried to make a note of when this occurs to see if there is a pattern. Unfortunately, I've not come across anything obvious. The engine can be cold or hot. Rainy weather, dry weather. (I opened the hood and sprayed it down with the hose, it started no problem at all.) I've paid attention for the "immobilizer" indicators and I don't see that either. No check engine light. No codes.
A friend suggested that when this occurs to sniff for uncombusted fuel in the exhaust -- I did not smell anything. I suppose this suggests that it's a fuel issue and not a spark issue. I've taken it to my trustworthy local mechanic, and they a) couldn't recreate the problem, and b) couldn't find anything wrong. For good measure, they removed and cleaned the throttle body, but that didn't work.
View 1 Replies
My parents' Gen 1 2003 Prius, at 99,030 miles, wouldn't start, and I thought I'd share the problem description and the fix that worked for me, for others who see the same symptoms.
View 6 Replies
I am the second owner of a 97 Cherokee 4.0 2wd. My overdrive works now and then. my check engine light is on. I had it scanned it throws 2 codes. p0700 and p0705. It has 147k and we already replaced the entire cooling system including flushing the engine and system thoroughly . Now it has been sitting for nearly 2yrs. just not sure what direction to go.
View 3 Replies
Often, when starting it will run rough and throw different misfire codes. Most of the time it smooths out in short order (a minute or less). When it doesn't smooth out quickly, it smooths out when I clear the code. Also, rarely it will start very hard. I have to wimd out the starter pretty good to get it to start. All that I have done is cleaned the MAF sensor.
View 3 Replies
My truck, the aforementioned 01 f150 5.4 has been running fine but has had the codes p0401 and p1740. I know what they both mean I just haven't fixed them yet. Today I went to move my truck and it wouldnt start. It turned over fine and would hit some but wouldn't start. Would the tcc solenoid be the cause of that? Also the reason my egr is throwing is because there is a line that is not connected but I have no clue where it connects to... Where is the best place to get diagrams for the egr system.
View 3 Replies
I purchased this unit, non running, was told the HPOP was bad, after going through the unit top to bottom, Im stumped, below is a list of items serviced and or replaced with OEM parts.
0. changed oil and oil filter
1. Terminator 500 Hpop
2. New ICP
3. New HPOP lines.
4. New starter and solenoid
5. Serviced Turbo (rebuilt with new parts and WW wheel)
6. Serviced Injectors (shimmed) all test good.
7. new pass and driver harness, UVHC replaced, glow plugs replaced.
8. new heavy duty GPR
9. Tested IDM no issues.
10. Hutch mod on tank (re-circulator was stopped up) deleted it, added inline filter.
11. serviced fuel bowl with new parts, upgraded parts on fuel bowl new blow off valve, new drain valve, tested heater all good no blown fuses.
12 replaced faulty fuel pump
Might be leaving something out of this list, the truck has run but only for very short periods of time, (hence the dropping of the fuel tank)
fuel pressure at 70 psi, some white smoke, connected to on board computer, checked every conceivable possibility No DTC codes, my gut tells me it has to be fuel related but at this point I just have run out of things to check.
I have tested everything with a fluke multimeter, including the IDM and all the circuits to the 42 as well as all the way to the injectors and glow plugs and find nothing wrong all tests yield valid readings,
There may be other information available but my after market scanner does not show any issue, KOEO buzz test results good.
The three times I have had this unit running it was dumping lots of white smoke, however after the last round of dropping the fuel tank and replacing the fuel pump the white smoke has dropped to a minimum, but cannot get the truck to run, cranks, wants to start, almost starts, got it up to 800 RPM last try but just will not go beyond that point.
I cannot find anything wrong, must be something I am either missing or its something my cheap scanner can't pick up on.
View 7 Replies
I got a 2001 Escape XLT (V6) a couple of months ago. Its in great condition, only 82k miles on it too. It had the notorious door handle issues which I have had fixed. It also had the wet weather stuttering problem, which I had fixed by having all 6 spark plugs replaced (Motorcraft OEM plugs), the back 3 coils replaced, upper intake gaskets replaced, Valve cover gasket replaced, PCV valve replaced (motorcraft).
It runs great when its warm, the problem I am having is when its cold outside and the engine is cold, it starts up fine but idles like crap and if its really cold outside, it starts and dies 3 or 4 times before it can even get to the crappy, stuttering idle. I have to intermittently feed it gas to keep the cold idle going long enough (3 or 4 minutes) before I can drive it. Once the engine is warm it drives like a champ. The only warm engine issue, is occasionally after driving it and putting it in park, the engine will rev up to 2000, 3000+ rpms, and just keep going up until I shut the engine off.
The codes read P0171 and P0174, which are lean on bank 1 and bank 2. It had also thrown a misfire on cyl 6 but once I cleared that it hasn't come back, just the lean codes are still present.
From what Ive been reading, this can be a number of issues, ranging from the IAC valve, EGR valve, MAF or the lower intake gaskets. I'm very much a rookie when it comes to car mechanics, but I think I can handle changing the IAC, EGR and MAF since they are all on top of the engine. However I don't know if I could handle the lower intake gaskets. Ironically, the gaskets are the cheapest part, but the most labor if I paid someone else to do it.
If I replace the EGR, do I also need to replace the EGR Modulator as well? Looking for brand names that are best bang for the buck when it comes to these other parts I have mentioned?
View 14 Replies
I've been battling this truck for over a month now and starting to go a little crazy, It's a 2001 f350 7.3L, with a "used" 7.3L engine from a 1997. Transferred all the necessary parts to make it happen. Keep getting the evil p1316 idm codes detected coming back upon start up. Anywhere between 5-30seconds after starting the left bank dies. I've gone threw and replaced the IDM with a reman unit. New valve cover gaskets (with new harness). even went the extra mile and put in a new power wire (for the driver side) running directly from the new valve cover into the IDM bypassing a connector above the left valve cover. All injectors are checking out around 3ohms. With glow plugs all around 1-2ohms. What's interesting about this is, I can disable any one of the injectors on the left bank (doesn't matter which one) and the engine runs great considering it's down on one cylinder. But when I hook up that last injector it will kill the whole left bank again.
View 13 Replies
I have a 2001 Jeep Grand Cherokee I cant get the engine light to stay off. It kept saying misfire 234 and 5 I have replaced coil pack, plugs , had the head taken to a head shop, replaced the gas cap and fuel injectors. light went off for a couple days and keeps coming on Jeep is getting good gas mileage and is not shaking when driving it.
View 14 Replies
I have a 2001 JGC Limited with the 4.7 v8 quadra drive 4x4. Since it got cold out, my blower motor for heat will not come on until the vehicle has been running for a while. Sometimes as long as 30 minutes. Eventually it does come on and seems to work OK. It works the same way if its on auto or on manual- high or low speed settings.
View 1 Replies
I own a 2001 Jeep Cherokee with 104,000+ miles. It runs great and doesn't have any issues. However, i started it up this morning and the check engine light came on. Should this be concerning? I haven't done any real maintenance on it since it runs so well. And i guess that's my other question - what should i do to the Jeep to keep it running for another 100,000+ miles? Spark plugs? Timing belt??
View 2 Replies
I have had no problems out of my jeep except my check engine light came on and it was a bad 02 Sensor and I was told I didn't need to replace it. Well I was driving down the highway and all of a sudden my jeep died. The radio cut off my air and I put it in neutral and I tried to start it and it would not crank. I coasted in a drive way and it cranked and them died. Now it acts like it wants to start but it wont. Replaced the fuel filter. I am getting fuel to the fuel rail. It will not start with starter fluid. I took the crank sensor off and it replaced it and it still wouldn't crank. My fuel pump makes a whinning sound. My lights come on..My windshield wipers won't. My radio doesn't work and the inside lights well I couldn't get them to go off before I before my vehicle died on me, about 3 weeks before I just took the bulbs out. Would the 02 sensor make it not start?
View 14 Replies
I have a 2001 Jeep Cherokee Sport (128,000 miles) that has a groaning sound when ever you turn the steering wheel (and front wheels, of course). We were told by the former owner that it was the front wheel u-joints. I do not think that is the problem since it makes the sound when the Jeep is not moving forward or reverse. Is it typical for the u-joints or spindle joint (ball joints?) to make noise when they get older?
It makes a similar sound when I stand in front of it and try to push it up and down. When that happens, the car is not running and the wheels are stationary in all respects.
View 12 Replies
After I start up and drive my jeep around town and then shut the engin off. Then I get back inside the jeep, start it up the engin idels rough. Some times the engin light comes on. I had a coil pack installed and still the same symptoms. What do you think?
View 2 Replies
2001 Jeep Grand Cherokee with a hard steering problem. I've changed the power steering pump, high pressure hose and gearbox.... the fan spins slow and it still steers hard ... could this be a hydrolic fan problem ???
View 10 Replies
Pretty soon this thing's gonna have ALL new parts and STILL running rough! The Jeep has about 40K on a Jasper motor, 175K on everything else. I was experiencing starting issues (crank for 20-30 seconds), and noticed a P0171 code on my odometer (O2 sensor?) so off to my mechanic. He replaced two O2 sensors, no change. New code read MAP sensor, replaced, no change.
Finally, changed Fuel Pump in tank (Fuel filter was changed 2 months ago), still no change. I tried starting it tonight by turning the key 5-10 sec. to prime gas, started but still rough at idle. Runs strong above idle 1500-2000RPM. Mechanic can't check fuel pressure at rails? for some reason. My next thoughts were spark plugs and vacuum lines...
View 12 Replies
I have a 2001 Jeep Cherokee Sport edition, automatic transmission, about 100k miles. Recently, when I turn on the engine -- sometimes -- it is very loud, and the car really shakes back and forth (in place) with the engine. It almost feels like the car is going to die. It feels like a very bad idle. If I wait, nothing changes. If I turn the car off, wait, and turn it back on, nothing changes. If I hit the gas, it continues, but decreases very quickly and by the time I hit a stop sign or red light (let's say 100 yards away), the car is more or less fine; no more fear that it's going to die, although there's still some noise that seems like it's coming from somewhere between the transmission and engine. I had the starter replaced last June (when it went kaput) and replaced the idle control valve a couple of months ago (the car kept dying when I came to a complete stop). I mainly drive it to/from work, about 50 miles each way, going 45-80 mph on a hilly freeway, and there have been no problems while driving.
View 2 Replies
2001 Jeep Cherokee sport ... Just bought this Jeep with 145K miles. Had radiator and all hoses replaced. The overflow tank is boiling over but the engine is not overheating. Safe to drive? What should I be checking for?
View 13 Replies
