Cherokee :: 1994 Loud Grinding Noise/ Removing Drive Shafts Would Be Feasible?
Sep 6, 2013
My buddy's 94 Grand Cherokee with 5.1 L has developed a loud grinding noise. I thought it sounded like a wheel bearing but the shop said, "front differential, transfer case, and possibly drive shaft."
Does it sound feasible to remove the drive shafts to and from the transfer case, to see if the noise disappears (indicating transfer case and/or shafts)?
If it is the front differential, how big of a job is it to change the whole unit out? Could it be a bearing in the differential; inner axle bearing, or carrier bearing or something?
It is a work vehicle, and he doesn't want to sink big repair into it.
View 1 Replies
Advertisement
My mechanic just informed me that because of my extreme drop, the drive shafts are at an angle that is stressing the final drive bearing on the transmission. I am leaking very small amount of fluid, he said it might not be a big deal.
View 3 Replies
I would seem that my Neon has started a very small leak seems to be coming from the drive shafts. You may call the differentials. You may also call it a transaxle. I prefer to call them driveshafts and transmissions. I took it to a service place to take a free look at it. I do not have the equipment that they have. They put it on the hoist and when you walk under there it does look like it is coming from one of the driveshafts. They were not Tranny experts and said they could not fix it, but said it would need to be rebuilt or changed. My question is, since they are not tranny experts. Does something like this really need to be rebuilt? Is there not just a seal leaking that can be changed without a rebuild? Why would they make something like that? Just to make you pay more money to get it fixed? I did try some Lucas and then Trans X hoping that would seal it up. Lucas seemed to do nothing. Just put in the Trans X today.
View 9 Replies
My 94' Jeep cherokee 4.0l 2wd has had an issue that the steering over the course of several years has get some play in it now. It also makes sounds as documented in the video. I should also note it doesn't seem to do it when it's warm, but when it gets around 50ºF or lower the problem is there. [URL] ....
View 2 Replies
I'm getting a loud gurgling type pump noise when removing the fuel cap. It is really something I have never heard before on any vehicle. It's not a quick hissing noise. It is a constant motor type noise coming from the fuel filler. I tried it again today because the dealer was there, but since I have a 1/2 tank of gas it did not happen.
Each time I have needed to fuel up, I've heard it. So I suspect this noise occurs when the tank is low...within 3-4 gallons left.
View 4 Replies
My '03 Jeep Grand Cherokee seems to be having an array of problems lately, I think they might be related. Almost 100,000 and its falling apart on me. When I start it up on cold mornings it has a loud whining noise. The check gauges light comes on and shows the oil temp as being cold. After leaving it idle for a bit, I will go to drive it and the heater will shut itself off. Later in the day after the first cold start, the loud whining and check gauges light don't happen again. But the heat shuts off every now and then. Is it all related?
View 9 Replies
We were flagged down on the highway by a very nice fellow motorist because we were gushing coolant. It was gushing. My passenger was a guy friend who used to work as an aircraft mechanic and works on his own vehicles, so I deferred to his supposedly greater automotive knowledge when he said I didn't need to call a tow truck. We got to within 100 feet of my mechanic (about 5 miles away) when my poor Jeep conked out after losing power and making an increasingly loud clunking noise for the last 500 or so feet. We pushed it in to the auto repair bay. The engine was smoking and would not start. The mechanic replaced a worn out radiator hose, which had become disconnected from the radiator (due to swelling, I think he said?), and the truck runs. There isn't a discernible difference in the engine performance after driving it around town for the day. My question is this: is the engine likely to be FUBAR and am I just playing a waiting game until it croaks?
View 8 Replies
I have a 1994 ford ranger 4 cylinder manuel transmission regular cab. I am hearing a grinding noise when I push and hold my clutch down. It doesn't make any noise when my foot is off the clutch. It makes the noise off and on when i stop at a light or stop signs. I have also noticed a vibration at certain speeds around 30 and then again around 70. What is the cause of these noises? Could it be my U joint?
View 5 Replies
I have a 1994 F-150 extended cab electronically activated 4x4, with the 302 V8 and an e4od transmission.
When the truck is running and it is in park or neutral it makes a grinding/whining noise and when it is in gear it doesn't engage, or occasionally will barely engage, but only enough to move it a little ways.
I've read a couple of post that suggested bad connections to the transmission could cause the transfer case to be in neutral which could cause a similar problem to this. I checked all the connection the best I could and the only thing I found that gave me any concern was one of the wires connected to the transfer case shift motor had some of the insulation melted or rubbed of and the wire was a bit corroded.
Is there any chance that this could be causing my overall problem with the truck not driving? Or what might be going on with it? Or any way I might be able to fix it without having to hand over a significant chunk of change for the full rebuild.
View 4 Replies
I recently bought a 94 Ford Ranger XL 2.3L. This is a Mazda engine built for Ford. There was a slight ticking noise from the engine. Two months later it has became worse and louder. I bought a mechanic stethoscope and found the noise was coming from two or more of the fuel injectors. New plugs and wires, fuel filter, air filter was done when I bought it. Cleaner has been added to the gas a few times now. I am about to replace the belts and hoses, Bosch platinum plugs and fuel injector O-Rings. I just don't know if it will be enough.
View 17 Replies
I have a '94 Aztek that sounds like a small plane engine when driving. What is causing the noise?
View 10 Replies
1994 Chevrolet silverado 2WD 350/V8 ... I've been too focused on the loose steering and now there is a grinding noise feel on the steering wheel when I'm driving straight and above 20 mph. I jacked up the front end of the truck and after wiggling the front tires at 12:00 and 6:00, I can feel a slight movement at both front wheels. Is it a telltale sign the wheel bearings has failed. Note that I am deaf and can't hear any growling/grinding but I certainly can feel the grinding feel on my steering wheel. Wheel bearings it is?
View 19 Replies
When the car is idle it makes a loud noise,also it revs like 1500 and accelerates on its own. What the problem could be? 1994 mercury cougar 3.8 ....
View 12 Replies
I replaced the front hubs and bearings on my brothers 2002 Camry today. He drove less than a block and developed awful grinding noise and it won't move in reverse or drive. It rolls when I put it in park. I had to pull it back into my shop. Is it possible the inner CV came loose and i didn't realize it? It all seemed to go back together fine. The new CV axle nuts were quite tight and slow to put on with my impact gun.
What else could possible go kaput when I re & re hub/bearings? And what a long ugly job to replace those bearings. Don't even think about doing this without a good hydraulic press. Up to the point of getting knuckle off, it was easy job.
View 10 Replies
Experiencing a grinding noise when applying the brakes and the transmission engaged in Drive and applying power left or right on the steering wheel? For example, I am going through drive thru and and wheel are slightly turned to the the left and a grinding/buzzing sound starts..
View 2 Replies
Whenever I start my car, there is about 20 seconds of loud grinding coming from the glove box. It's sort of a tak-tak-tak-grrr-tak-tak-tak-grrr over and over. I've opened the glove box and noticed that with each start, the Navi box spits out the DVD, makes an awful grinding noise, then self-reinserts the navi DVD. I'm guessing this isn't normal, as it jars the normally whisper-smooth operation of my Phaeton. Is there an easy fix, or is this something to take the car into the dealer for? It would my first time taking it in for anything.
View 5 Replies
I have a 2000 grand am with 189000 miles and i have replaced both front wheel bearings and all of the struts. I put new brake pads on and rotated tires. I still have a horribly loud grinding noise in the front end of the car. I jacked it up off the ground and took the front wheels off and put the car in drive and the noise is still present. It gets louder the faster i go.
View 1 Replies
I drive a 94 Saturn SL1 as a part-time delivery driver for a pizza shop. Recently I bottomed out on someone's driveway. I could hear the bottom of my car scraping against the asphalt. It took several tries (in my 5-speed) to free myself from this trap. Since then I've been hearing a pretty loud "clicking" noise from the passenger side of the car every time I make a turn, where a small turn or a big turn. My mechanic replaced the left axle and the right boot, saying that both were defective. However I still hear the noise. What can I do??
View 3 Replies
I have a 1995 850. About a year ago, I suddenly had a loud grinding noise coming from my brakes. It only happened in hot weather and when the brakes seemed to be hot. Also, it only happened when I was coming to a final stop, like the last 10-20 feet. I took my car to my "trusted" mechanic. They diagnosed it as being my front pads and rotors, so they replaced them (they also felt the front vibrating.) NOW the brakes seemed okay after I got it back the second time (no loud grinding noise.)
When I got the car back, the weather was starting to cool since it was nearing winter. My winter weather is like 70's during the day, and during this time, there was no grinding. It's now starting to get hot again, and sure enough, that grinding noise is back, but not as bad as the first time a year ago. Again, it is only when the brakes heat up and I come to a final stop (the last 10-20 feet.) If I break lightly, it won't make that noise, and it takes me driving for about 15 minutes for the grinding noise to start (it sounds like metal on metal and loud.) Also, I don't feel the vibration like I did a year ago. I only drive the streets, and have not been on the freeway since I got the new brakes.
View 5 Replies
Having issues with sunroof. Purchased my 2011 gti last month 3300 miles later sunroof broke like a corrado .....making loud gear grinding noises ....whole assembly wants to bust out of the headliner !
View 5 Replies
I have a 2009 Hyundai sonata, 2.4, 5 speed manual, gls, when I press down on clutch whether from a stop or when shifting, I get a loud grinding noise and the radio goes dead at same time!, I know it is the starter attempting to "engage", at least that's what I believe it to be, it also "'starts "from, the "on " position when I press on clutch.
View 8 Replies
