Celica :: Headlights Losing Power - Shaking?
Dec 31, 2011
I can see this whenever i stop at a red light, once i accelerate the shaking is gone, and the headlights are really bright once again. I already replaced the alternator..
View 6 RepliesI can see this whenever i stop at a red light, once i accelerate the shaking is gone, and the headlights are really bright once again. I already replaced the alternator..
View 6 RepliesI own a 2010 Camry SE which I bought about 2 months ago with around 58k miles on it.
A few days ago, I noticed when I switched my headlights on auto, the car radio turned off. When I turned the knob from the auto light position to the to headlights, the radio comes on again and and goes off if I keep switching back and forth until it eventually stays on regardless of what position the knob is at.
What is even a stranger, yesterday, I started my car and turned the auto lights on, switched it to the headlights, and the radio turned off, but I also noticed that engine lost power (?). It didn't completely shut off, but it was noticeable when I was going back and forth between the light switches.
Just recently the front of of my car starts shaking violently when I reach speeds of about 57-60-mph. It also feels unstable when I make sharp turns. I've noticed my alignment has gotten worse since this issue has begun. Tire wear looks normal except for small indentation on side wall of front right tire.
View 1 RepliesI just bought our 1st. Toyota 03 celica GT 5speed.113000 well cared for miles. My biggest concern is the headlight adjustment. The high beams are similar to aircraft landing lights but the low beams seem to cross with the left side too far to the center. I found the up-down adjuster (wish it had the cab operated feature) but can't find the left-right adjustment.
View 3 RepliesI have had my 91 ST for about 6 years. Bought it with 55k miles on it and the motor blew up on me at 165k. I had the motor replaced and when I got it back one of the headlights was out (low beams). I replaced that and got nothing, replaced the other one and still nothing. Even tried swapping bulbs around and no luck. Checked fuses and all look fine.
Talking with my mechanic who did the engine work about this and he started thinking it might be the dimmer switch. I ended up getting one and replaced it, moving one wire at a time off the old one to the wiring connector. Got done and nothing still. Now my Hi-beam indicator doesn't come on either. He is looking at this again and thinks the switch might be bad but can't confirm the wiring either. The diagram he has from work shows all the wires being different colors from any of the wires in the connector, even from other pieces.
Looking for any diagram that would tell us what wire pins from the dimmer switch and other parts of the combination switch go into the connector block under the steering column.
I really need this car back soon. Having to drive my Silverado 1500 crew cab to work and that is a 90 mile round trip every day. Want my 35+mpg Celica back.
I have a customer that brought this in when he was pulled over by the police. The brake lights burn bright when turning on the headlights. When I unplug the the wiring harness at the left rear the right tail lamp lights up as regular tail lights the left turns off. The voltage at harness when tail light on is 10 wher as the voltage when the brake lights are on is 8.65.
View 1 RepliesHave noticed within the last month or so and also been brought to my attention by another ISF owner that when ever I go over any type of undulation/bump in the road that the lights (lowbeams) visibly can be seen vibrating and shaking on whatever they are shining on...
View 14 RepliesOur escape recently started loosing its power steering, once the engine is shut off the power steering is ok. Also some times you can feel a pulsing in the steering wheel. I've been doing some googling and it looks like the dealers are replacing the steering columns to fix the problem.
My question : is this the only fix or if something like some contacts being cleaned or maybe replacing a steering sensor of some kind is the fix.
I have a 1999 7.3 with 260k miles. It is all stock with the exception of straight pipe. I got the truck about 8 months ago and have put about 5k miles on it. Have never had any issues with it. I was driving from Dallas to Houston and about 45 minutes into the trip my truck lost power. I was going about 65-70 mph and the service engine line came on and I lost power. It was running rough and was blowing white smoke. I let it sit for a couple minutes and started it back up and ran fine until 30 minutes later. It did this 2 more times on the way to Houston. Oil is good, coolant is good. Not over heating. Threw a code the first time but didn't throw it the other times. I brought it to a mechanic and he thinks it's the Wastegate.
View 14 RepliesWhere I should start? My 7.3 is running but losing all power. Pumping the fuel pedle will get it started and it will run for a few then lose everything again. Should i just drop the tank and check the sending unit and intake and filters first then work my way up?
View 5 Replies2003 crank no start, 196k bone stock truck egr still in truck and stock head bolts. Replaced the icp sensor and ipr sensor, both from ford. What happened is I got fuel then about 15 minutes afterwards my truck acted like it was going up a hill and was just losing power and shut itself off. ficm tested 48.5 volts all 8 injectors tested good and there is oil pressure. Had an egr fault code but I'm at a loss.....
View 7 RepliesI have a 04 F30 4x4 with a sick 6.0 power stroke. It has 230k on the mileage and ran good. I was driving at speed when she started missing like it had lost an injector and loosing power. The RPM's dropped under 1000 so I had to pull over off the highway. When i pulled over and put it in park it shutoff. Tried several times to get to start but after 10 minutes it started up. I drove about 2 miles and it started the same process. This went on 2 more times before I was able to finally limp home the 40 miles.
It never shut off again but ran very poorly. I put a new valve in and when I tried to start it just mad a pound clunking/clacking noise. The repair shop put a starter in it because it had stopped engaging and was going to ruin the fly wheel. I looked at it and it was eaten up pretty bad from trying to get the engine to turn over. So now all it will do is a single clunk and will not turn over. He says it could be a bad injector that flooded a cylinder or blown up in the bottom end. He did take serpentine off and still no go.
this morning I started my 2004 f250 drove a mile and filled up my truck. Then drove another mile and my truck acted like it was running out of fuel. It was loosing power then stalled out and wouldn't start. About five hours later I tried to start it again and nothing. about five hours after that I tried it again and it started up and drove fine.
My thought was fuel filter or the water trap. I haven't had a chance to open the filters up and check them yet. Today while I was at work I got on here to see if I could figure out what was wrong with it. all I could think of was maybe the HPOP went out or the ICP sensor. Could one of these be the problem or was I right with my original thinking and it's just a fuel filter? First thing in the morning I'm going to pull the filters and replace them.
Could there be something else wrong with my truck that I don't know about? Like I said I filled up the fuel tank then it lost power within a mile and stalled out and wouldn't start back up. Then about 10 hours later it fires up and acts like nothing happened.
2004 f450 with 6.0. Was driving down the road when it started losing power like it was starving for fuel. It carried on for about a mile then died and will not start. No codes at all and we put a new fuel pump on but still wont start. Put a rag with gas in the air box and will run but rough.
View 6 RepliesI have a 2006 f250 6.0. the truck has 101k miles and to this point I have had zero issues. I am having trouble loosing power after running at highway speeds. Once I stop and begin to accelerate the truck looses power for a few seconds ,Belches smoke and begins to operate normally. I had an egr code, so I replaced egr and the problem persist. It is intermittent and does not happen if I stay under 50 mph.
View 12 Replies2011 F350 diesel with 10,000 miles. I have been experiencing problems with the truck loosing power, making rough running noise (pinging like an older diesel), and vibrating. As though the motor is bogging down. It usually occurs on small inclines or hills with the truck in higher gears and low rpms. It will also occur running on flat ground 65-70 mph. Had it occur once while turning the truck around in 1st gear and low rpms. Depressing the accelerator will bring the truck out of it.
This problem occurs randomly sometimes a couple of times a week to not at all. Took to dealer and they found no codes and of couse it didn't do it on the hour long test drive I took the mechanic on. However they did say they had two other owners come in with the same complaints, but could not get trucks to repeat the issue. Problem usually occurs in the hotter part of the day, maybe just coincidence. I had seen similar posts with this problem but no conclusions.
2011 6.7 with 3.55 gearing. Just got the truck. And it seems when its cold the truck will rev high in 3rd gear and then sort of fall into 4th gear sort of losing power for a split second. If I gas it hard, its not as bad. Usually only happens like I said when its cold. Check the trans fluid its full and looks clean. My guess is some sort of sensor or the computer???
View 7 RepliesI was driving my truck then all sudden truck started losing power then slowly died. I restarted it, it was a lil shacky then died again. Iunscrewed the fuel filter and looked in the housing and there was lil fuel in bowl i turned the key to on position and bowl did not fill with fuel looked as if it were shooting some bubbles up(air) could it be outta of fuel???
View 10 RepliesTruck started losing power then service engine light came on, drove about another mile then it just stalled ( almost home lees than a 1/4 mile). Got out open hood oil everywhere on top of motor. Looked under truck and oil all over the road. Looked back where I was driving a line of oil as far an I could see. Checked oil barely any on stick. Where should I start hpop or plug?
View 7 RepliesI have a 7.3 Excursion, 234K Miles, 4R100 Transmission. Today I was in a rush to take one of our dogs to the vet, when I hit overdrive going up a hill, it almost sounded like a clicking noise and I was steadily losing power. I came to a stop sign and put it in park and it started to develop a constant lope that was rough. Whenever I would step on the gas it would put out white smoke which it has never done before. I was able to take it a couple miles before it did the same thing except this time it shut itself off.
Recently I have been having transmission issues as it feels im losing first gear. A while back I noticed it would idle slightly in park every now and then. A couple days before this happened, I came to a stop and my truck started loping slightly and first gear IN DRIVE felt very very weak. I have recently replaced the cam position sensor as well as the ICP sensor. I'm at a loss, I plan to do a ZF6 transmission swap very soon and this is only making me panic even more.
I never dog the truck, take it mudding, etc. Oil is changed every 3-4,000 miles. I did however get it scanned a while back and I believe two codes came up for two pistons, also did an injector buzz test and they all sounded strong.
On the way to work, the truck seemed to have a miss at idle and the CE light came on. Long crank to start leaving work, and truck starts losing power and eventually died. No smoke while it was losing power. Towed it home and checked the fuel pump and lines for blockage and found nothing.
2003 7.3 F-250 430K miles
strong cranking but no start no smoke out exhaust
Oil changed recently
IPR changed
Both UVCH gaskets and pigtails have been repaired.
ICP sensor and harness changed, also disconnected no change in cranking.
fuel filter changed today (no oil in bowl)
3/4 tank of fuel
dash gauge for lpop goes up to normal range during cranking and oil light turns off.
WTS light comes on and turns off as normal
tach gauge moves up between 100-200 during cranking
fuel pump turns on and pressurizes system like normal and turns off.
Ordered AE for the truck, and it directed me to the passenger side bank high open. Fixed the harness on that side and still nothing.
Sent off the IDM and it passed with flying colors
So now i'm leaning towards the HPOP, but would hate to fork over the cash for it and still not get anywhere. I'm going to take the valve covers back off and check the discharge ports for the injectors tomorrow.