Looking for the proper instructions in replacing timing belt and oil seal I have done this on a Honda accord before but I need to know how to properly align everything so I can do it right the first time.
View 2 RepliesI've got my sister's 1995 Dodge Neon with the 2.0L SOHC. While driving it recently I heard a horrible squeaking noise then a ZZZZZZzzzzzz sound. I immediately pulled over. The check engine light came on, and I shut the car off. Coolant was all over the place leading me to believe the water pump failed. I had it towed to my house, and now I will have it towed to the shop to get fixed. I would like to have them repair the timing belt and water pump. However, I am afraid that the valves were beaten to a pulp and now I will need a new engine. I was only going 35 mph when it happened. What are the odds that my valves were smashed up, and is there anything I can do to check them before I pay for a timing belt/water pump repair?
View 19 RepliesI have a 1995 Celica GT, 5sfe engine, 5 speed manual. Front main crank seal appears to be leaking. I've replaced transaxles before but no timing chains or oil seals. Is the access from the wheel well and fairly straightforward?
View 2 RepliesPassenger differential axle seal is leaking again. It was replaced twice already. My mechanic checked the seal...its not damaged. Its not a excessive leak. Both times, the seal were replaced with OEM. I don't want to buy another one and replace it.
Its a 1995 Celica, 5SFE, 5-speed MT. 98k miles.
Had the stem seals replaced on my 2004 toyota camry 4 cylinder (2az-fe engine). The job went quickly and the realigned both camshaft marks to the respective yellow link and #1 and #2 bearing marks per the manual. However, now getting a P0016 error indicating timing is a bit off. It is difficult to verify that the top camshafts are aligned correctly to the crankshaft without taking off the side cover. Doing that is a 6 hour job and requires an engine lift.
Is there any easier, surefire way to check and adjust the timing on this engine without having to take off the side cover? It is probably just a tooth off since it is running well.
The attached pictures show how it was aligned before buttoning up.
We just bought a 1995 Toyota 4Runner that has 195,000 miles. We bought it for a 4wd vehicle to take over the passes and go hunting, but we have been driving it regularly because we like it. I read in the manual that under heavy idling conditions the timing belt should be changed every 60,000 miles but it does not say for regular driving. The previous owners had work done on the timing belt at 96,000 miles.
View 2 RepliesI am looking for a link or instructions on replacing the timing belt on a 2.8 30V. I attempted to search and mostly came up w/ the info relating to the turbo.
View 2 RepliesMy 2004 Passat 1.8T GLS (station wagon) has 72,000 miles. I checked the manual which says that timing belt is to be replaced at 105,000 miles.
However, car is 8 years old - does the age matter or I should be fine until I get to 105,000 miles to replace the timing belt, tensioner, water pump etc.
I got 123000 km on my car. Manual says 144000 km is the right mileage to replace the belt, but I have heard opinions that it should be done earlier.
View 7 RepliesDoes VW have an official recommendation for replacing the timing belt?
None of the publications I've seen list the timing belt interval. My car is very close to 95k miles.
I was told that I must replace the timing belt every sixty thousand miles. Is this true?
View 24 RepliesHow do you replace the rear axle seal in a 1995 F150?
View 14 RepliesI just finished replacing my timing belt, water pump and all belts. I made sure to double check the timing marks lined up via this pic:
Timing belt diagram
I put everything back together and no go. I am not sure what to do now. Should the crank sprocket pulley be in a special starting position? I see is has a "1" engraved on it.
How to change the timing belt and water pump on a 2006 2.0t passat?
View 3 RepliesThe timing belt broke in my gf's '08 accent recently and I decided to have a crack at replacing the belt after getting a quote for $900 from the nearest mechanic (with no guarantee it would fix the problem).
When re-aligning the cam and crank to TDC, I wasn't sure if it mattered which revolution the crank was on (ie. 1st or 2nd revolution) when putting everything back together. I tested rotating the engine with the new belt on slowly to make sure there was no contact and everything seemed ok.
So basically now everything is back together, tried starting it up and it won't start and now i'm wondering if it would make a difference or not if the crank was rotated 1 additional revolution. Otherwise there is more significant damage.
2007 Santa Fe GLS 2.7 V6. T belt replaced by dealer at 62K. Noticed engine vibration when picked up vehicle. RPM is steady, engine runs smooth, no error codes, no strange noises. Mechanic who did the work confirmed vibration problem and recommended bringing it back - had no answer on the cause but mentioned lose motor mounts which I doubt - the car ran perfect until the dealer did the work.
View 3 RepliesMy 2001Honda Civic EX (manual) has only about 46,000 miles on the clock and runs very well. My mechanic says I should consider replacing the timing belt (the manual suggests after seven years). I plan on keeping the car for many more years -- should I replace the belt now? How devastating is it if the belt breaks while driving?
View 5 RepliesVehicle is an 08 Hyundai Accent 1.6L three door (hatchback) with 20,197 miles. This car was born on Oct. 16, 2007 and purchased in April of 2008. I told the owner to call the dealer and find out about when they should replace the timing belt as I had looked it up at the Gates site and found that it is an interference motor and also these Hyundai have some kind of lengthy warranty. When the tech or whoever she spoke to at the dealership asked about the mileage, they told her that she does not need to worry about the belt for about another five years, were rude and sounded inconvenienced by her calling. This leaves her with a bad taste in her mouth and more importantly, mis-informed.
I get the "Maintenance Log" out of the glove box and upon trying to decipher the timing belt interval, it states that the first course of action is an "inspection" at 30,000 miles or 24 months. How is a timing belt inspected? From what I have seen, a belt can look perfect today and snap tomorrow. But anyway, the next entry for severe service is replacement at 37,500 miles or 30 months which means this belt should have been replaced in October of 2010. Next entry is normal change at 60,000 miles or 48 months which puts us at April of 2012. After this it goes to 75,000 miles or 60 months.
I have already picked up the kit for changing the belt, tensioner, idler, and the two seals. How critical is it to change the spring as that was not included in the kit I got? I'm planning to do this job here in the next couple days as from what I can figure from the above log, It's way over due. I was reading some Hyundai forums and one stated that the 2011 model with the exact same engine calls for the first replacement due at 90,000 miles. How's this possible? Seems like these people (engineers) don't have all their stuff in one bag...
I recently replaced a timing belt in a 2003 ALH TDI & since it will not start. When I took everything apart I found the belt extremely worn & the engine had actually slightly jumped timing. When I replaced the pulleys & belt & reset the timing to the way it would be from factory. When I tried to start the vehicle it turns over fine but will not catch. I double checked all the timing, fuel pump, everything - all okay. I can get it running with ether but will not start with diesel fuel. I also replaced the fuel filter, checked to make sure there was fuel at the injection pump but nothing works.
View 4 RepliesI think I made a bad decision. Almost a year ago, I purchased my used Odyssey. I cannot remember if the timing belt had been changed. My check engine light came on, and the mechanic I took it to indicated it was the seal on the gas cap. He proceeded to tell me that I have an oil leak coming from the oil pump and that I should replace it and while I'm in there, I should replace the timing belt. There were a myriad of other things wrong with it, including broken engine mounts (which I can get fixed elsewhere from the man I purchased the car from) and some other things he said I can spread out and are basic maintenance, but I said to go forward with the oil pump and timing belt.
View 6 RepliesI just had the timing belt (water pump and thermostat) replaced in my 2004 V8. I drove it home from the dealer (75 miles or so) without incident. Drove it to and from work (4 miles) without incident for a few days.
Last night I drove ~5 miles, idled in a parking lot for ~10 min and then drove another 5 miles and it overheated. Once I shut off the car it would not come back on. I waited for it to drop below 200C and it still didn't start. Electric consumers would come on all was well....but no start.
Car was towed to the local VW dealer who do not have a phaeton tech. After the hour and half it took for the tow truck to arrive and half an hour to tow it....it started up.
I am now thinking about my next move. As I read through everyone's overheating experiences they are mostly
1. Failed thermostat (which one? does the bottom thermostat control water pump operation?)
2. Fan issues
3. Air in the coolant line following a flush (could be, but I drove it home in the cold on the first day with the heater on)
4. False readings due to a bum (upper?) thermostat.
I have a VCDS but have not been able to get out to the car to give it a shot.