Celica :: 1993 GTS 2.2L Transmission Leaking
Mar 7, 2014
1993 Celica GTS 2.2L N/a DOHC 5spd (S53 Trans)
My transmission is leaking. pretty badly apparently. I didn't think it was too bad, till it ran dry on me. Luckily I was about a mile from home, and most of it was downhill. so I limped it home where it sits now. I've ordered new seals for input, output, CVs, and shift shaft... am I missing anything? I also ordered a clutch kit, so if it's close to needing a clutch, it will get one, but it needed a throw out bearing, so I just went ahead and bought the kit (cause that made the bearing essentially free with the purchase of the clutch and pressure plates).
I have reason to believe that at least part of the leakage is at the input shaft, because my clutch seems perpetually dirty.
View 3 Replies
Advertisement
I took my 1993 Ford Explorer for an oil change they told me I also needed a rear differential service and a transmission service, so I told them to go ahead (this was on a wednesday). On friday the car broke down leaking transmission fluid (reddish oil). The clutch was making a sound when pushed in and we were not able to shift. I towed it back to the place where the oil was changed the gentelman open something under the car and he said that it had transmission fluid. He got on the car turned on and push the clutch when he did that a lot of fluid began coming out (reddish oil). He said it was the clutch that went out. We think they messed up the transmission. I towed the truck to a garage and the guy mentioned something about a plug related to the transmission. Could the oil people have done something wrong to the transmission that made the car break down???
View 4 Replies
My 93 Celica GT Convertible 2.2 (5s-fe?) won't stay running at idle. It starts up fine but is loping and dies unless I give it some gas. I really don't know that much about engines, but I tried disconnecting the PCV valve and the engine began to run more or less normally. I've replaced the PCV with a new one but it didn't fix the problem. The replacement PCV valve didn't seem to fit quite as tightly as the old one but that may have been due to the age of the old one. I assume there is an air flow issue of some kind, but don't know where to look next. I just want to get it running so I can sell it.
View 2 Replies
I have a '93 Toyota Celica Standard transmission. Recently it's been lagging in power. Only happens after it's warmed up. I'll be driving along and it just seems to lose power. Have to stomp on the gas to get it to kick in. Also, at the same time, when stopped it idles really low. Cold, no problem. Took it to Toyota dealer to have it diagnosed. I Stated that it might be the MAF sensor. They checked it out and said it needed a major tune up (to the tune of $700!) Now, I know it needs a tune up, but the symptoms don't seem to correlate to that being the problem. I asked about the MAF sensor and they said no diagnostic codes came up. Is it possible the air filter is clogged? Can the sensor malfunction intermittently?
View 14 Replies
Ok, I just bought myself some problems in the form of a '93 Celica GTS. (5S-FE)
Well, alright, that's a little dramatic. it just overheats. but here's my issue. it's got a new water pump, new radiator, and is still overheating. The guy I bought from says it's in the block, cuased by an attempt to plug a radiator leak with stop leak. He said it just had a minor leak in the radiator, so he put stop leak in it, and after that it started overheating. he's replaced the thermostat, water pump, and radiator since then.
My first question is, could he (and I) be overlooking something? could there be a clog somewhere easier to access? and then if there isn't, how should I go about cleaning out the block? are there areas I should check? anything I should do to try to unclog it? my current plan is to put cooling system flush in (he has some) and drive it home (about 55min. drive) with the flush in it, then empty it and hope for the best.
View 14 Replies
I've recently rebuilt my toyota celica gt and the engine management light was on , I wiped it and keep getting the same code 52 which I think is the knock sensor car drives terrible under load , idles up and down a little , I've actually replaced the sensor just now and wiped the ecu but as soon as I rev it , bang it's back and I'm getting the same code 52.
View 9 Replies
Toyota Celica 1993 has been in the shop for 7 weeks and now the shop says they have no idea how to fix the car. Car blows a fuse when the car is started. Replace fuse; try again and fuse blows.
View 6 Replies
I changed the radiator and thermostat, changed the coolant, and my fans work. however, whenever i take the car for a short drive, the temp goes up. I stop the car and shut it off, it steams near th coolant tank. it sounds like its almost boiling..
View 5 Replies
Just finished a timing belt job on my 93 celica 5sfe. Filled the coolant up and burped engine. All seems to be well. My question is related to the coolant overflow tank. The cap has a hose attached on one end coming from the radiator and another coming out the other side that is short and L shaped. The L shaped hose isn't attached to anything and is open allowing air to either vent out or vent in to the overflow tank. There isn't any place nearby where the hose might attach to. Is this hose supposed to be "unattached" as it is now or should it be closed to create vacuum for the overflow tank to allow coolant back in to the radiator?
View 4 Replies
So I've had a problem with my celica. I've changed the vsv and the vacuum switching air control valve (Vsacv) ... I think the Vsacv went out already. New timing belt.. Engine is timed 10btdc. Cleaned intake and checked all vacuum lines
So the problem is that my Car idles at 2200 and will not drop unless I adjust the dist. Then the car bogs out. Put a new tps on last year which fixed the crazy idling but didn't fix the high idle... And it only drives good when the idle is that high....
View 3 Replies
I have a 1993 Celica and replace the radiator about 2 years ago. Tonight I notice my temperature gauge going from the center up to the red, but then it would slowly come back down to the center. And this continue for about 30 minutes until I reach home. What this could be?
View 3 Replies
My 1993 Celica, 1.6, 5-speed manual left drive shaft failed and I am trying to replace it myself. I have the new part in hand, but for some reason, the inner splined shaft does not want to go all the way into the transaxle. I have tapped the rotor end of the shaft with a mallet and tried to force it in, but everything Ive tried wont work.
My car is down for the count until I can get this drive shaft back in.
View 2 Replies
I have a 1993 Celica GTS 2.2L manual trans. A hose blew on the way to work, got it towed home and repaired the hose. I also checked the Thermostat, it worked fine, replaced it anyways with a new one.
The problem is when it is under stress, in any gear, it will heat up past regular operating temp (all the way to red if left long enough) but as soon as I engage the clutch and put it in neutral, it drops back down to normal operating temp. It will never overheat at idle, only under stress.
I have checked the Radiator, done a flush, it seems to flow fine with no blockages. Also checked the rad cap, no issues. I have gotten the air bubbles out of the cooling system, that did not work either. The only other thing I can think it could be is a degrading water pump. It is still pushing coolant through, but not at a fast enough rate due to degraded blades??Or maybe I have missed something on the Radiator and it could be not cooling the water enough? By the way, this whole engine was re-built 42,000 kms ago, ran like a dream until this happened.
View 5 Replies
I have a 1993 Toyota Celica GT I removed the strut tower to replace the upper tower mount and replaced the wheel bearing. my problem is that when i torque the axle nut tight the tire can be moved by pushing it up or down.
View 2 Replies
93 Hyundai Excel 1.5L, 130k miles. Oil pan gasket leaking like crazy, took pan off and cleaned everything up real nice in preparation for new gasket.
Looked in the bottom of pan and noticed this thing sitting in it (the sleeve looking thing, not the nickel) it isn't a magnet, and looking up into the bottom end of my engine I couldn't see anything that looked like it. Here's a pic: [URL] .....
The inside is smooth, no threads or anything. It is metal.
View 19 Replies
I was driving back home from work and I happen to notice smoke. Oil is coming out of the top of the dipstick hole not the bottom o ring. It seems the crank is building too much pressure . It's a 1990 5sfe so it does not have a pcv valve,ithasa pcv system which is basically a hose from the valve cover to the throttle body.
This does not happen initially when I turn the car on from a cold start. I turn it on leave it at idle for a while and even rev it up and hold it high. It starts to leak after about a 2 mile drive and the car is at running temperature. I removed the hose on the valve cover when the car was at idle and a good amount if air blows out when at idle now when I rev the car up the air blowing out drops some.
View 1 Replies
I have a '92 Celica GT which runs perfect except for the Overheating problem, the Power Steering problem isn't a big deal for me, Before I owned a '88 Chevy Beretta GT and after that a 94' Pontiac Grand AM SE. They were both pretty crappy.
But I need to figure out why it's overheating like this, Me and my stepdad did a raidator flush on it and it didn't work at all, The fan works fine, but I will be driving it and will have to pull over quite often to let it cool down and put water in it, I've stopped using coolant because I'm wasting too much money on it, and it does the same as the water, I know for a fact it isn't leaking, it acts like it's burning it up or something. I'm not even speeding in it or anything, what's causing the overheating.
I thought it was the radiator but I was told it wasn't, then I noticed the radiator cap was spurting out water and took it to the auto parts store to get it replaced and it didn't work, They told me somebody before I owned it switched the radiator from a 91 Camry? or something like that. That is the cap he replaced it with anyways because the cap for a '92 Celica didn't fit, it was too big. But the car ran perfect when I first got it around December, no problems at all, It just started overheating like this about a month ago.
View 13 Replies
I have a 94 Celica 2.2. I'm having issues with power steering fluid leaking from reservoir cap. I replaced the cap due to the old ones seal had dry rotted and dip stick was broke off, also replaced the 2 small short hoses and new clamps. The return hose is working right and the high pressure hose seems to be working right. None of the hoses are leaking but pressure is building up and pushing fluid out the reservoir cap. What else could be the problem to cause this??
View 14 Replies
I have a 1995 Celica GT, 5sfe engine, 5 speed manual. Front main crank seal appears to be leaking. I've replaced transaxles before but no timing chains or oil seals. Is the access from the wheel well and fairly straightforward?
View 2 Replies
I am replacing my leaking power steering pump. I checked the hose connections and it doesn't appear that the leak is coming from there. I have removed the right front wheel and have the car on jack stands. It is really tight under there.
If I remove the cross member under the power steering pump will that allow me to get the old power steering pump out and the new one back in?
Will the removal and reinstall of the cross member affect alignment.
View 4 Replies
Passenger differential axle seal is leaking again. It was replaced twice already. My mechanic checked the seal...its not damaged. Its not a excessive leak. Both times, the seal were replaced with OEM. I don't want to buy another one and replace it.
Its a 1995 Celica, 5SFE, 5-speed MT. 98k miles.
View 4 Replies
