Caravan/Voyager :: 3.3L Van Won't Accelerate (Code P0132)
Mar 7, 2012
142k, having some problems lately, the van won't accelerate now and again, moreso when the engine isn't up to temp, but lately it's gotten more and more prevalent. I have done some recent and needed maintenance in hopes of fixing the issue, but to no avail so far. I've replaced the plugs and wires, air and fuel filters, and both upper and lower O2 sensors (first replaced the upper with a Bosch, almost immediately had problems with P0134 code, so instead went with a Denso, hasn't come back yet). I checked fuel pressure, 60 psi sitting in the shop, the cat doesn't seem to be clogged, and it idles fine all day long.
Problem resembles running out of fuel, or more maybe like I'm letting off the gas, but my cheap scanner says the TPS is working fine, and I was watching the TPS percentage as I was driving it was reading normally. As I'm accelerating slowly from a stop, it'll start to cut out around 30 mph, but speed doesn't seem to matter, if I accelerate sharply it just bogs and slows down, if it does shift up a gear, the rpms will jump to about 5k, then slowly decrease even if I've got my foot on the floor. I keep coming back to the fuel pump, but I don't have a long enough hose to have it connected while test driving. Considering removing the hood so I can prop the gauge up so I can see it while driving. I am getting a P0132 code now, but I'm more concerned with the accelerating issue.
View 14 Replies
Advertisement
Changed oil on the 2014 grand caravan, replaced the filter. afterwards the oil light comes on at low rpm goes out when u accelerate, and the engine light is on. Took it to autozone, it is saying, that the oil sensor switch is stuck.
View 5 Replies
The other evening my 2006 Town & County 3.3L would not accelerate well and I though I detected a miss while trying to accelerate. Also, when I got it up to around 55mph and would try to accelerate to pass, the engine would kick clear up to over 4000rpm and barley accelerate. I checked the plugs, the were fine, changed the plug wires didn't make any difference. The van had about a half a tank of gas in it, so I went ahead and filled it up, and that didn't change anything. I let the van sit overnight and the next afternoon took it out on the road and it seems to accelerate fine now.
The only thing I'm still noticing at this point is that with the transmission in park, when I try to rev the engine up to around 3000 rpm, it starts cutting off/missing very badly at around 2800 rpm.
My 99 grand voyager with 3.3L does not do, so I'm wondering if still have some kind of issue on my 06 or is there something on the newer vans that limits the rpm in park, it doesn't seem to be cutting out or missing at that rpm range now while driving.
View 2 Replies
I have a 97 dodge caravan engine 3.0. When I start to accelerate my engine fuse 20amp blows. I does not occur every time but yesterday, it did it 6 times and is now getting looked at. I am just curious on what causes this. I did recently have my spark plugs changed so I am thinking something may be arching.
I do have codes that previously came up for my fuel injectors (P0203, p0206). Another code I have is p1294 idle speed performance.
View 4 Replies
I'm using an innova 3100/abs tester and that's the code it throws back. The company is zero support, claiming it is an internal Dodge code that they have no info for.
The code is : 50FE
Is that any use to me, or did I buy this tester for nothing..?
View 2 Replies
I bought some long beams at the local lumber yard. So drove home with the rear cargo door open. The ABS light went on brakes were pulsing mildly and making an odd sound. I cant see why the rear cargo door would have any connection with the ABS system so I assume that's a coincidence.I took the van to the local car store they scanned the code. It scanned code 4 indicating the passenger front sensor. I replaced the sensor but the ABS light is still on. Is there a reset function to clear the code disconnecting the battery didn't work? Or am I looking at another component failure?
View 2 Replies
I'm having trouble with my 2000 Grand Caravan 3.3L. The gauge cluster was working intermittently & recently quit. I have the P1698 trouble code & looked up info online. I of course found out about the solder joint problem & figured that would be the culprit. I took the dash apart & found the solder joints were fine, but when coming apart, the wire plug on the back side came out on it's own. The retaining clip was broke & I thought maybe that was my problem. There's enough room to install a zip tie to hold the plug in & I put it back together. It still doesn't work though.
Here's the symptoms- I turn the key to ignition & nothing in the instrument cluster comes on. When I start the engine, everything lights & works as normal except for the trans indicator- the letters light, but no position shown (regardless of any gear selection). This continues for about 5-10 seconds & the trans position indicator lights up around EVERY letter. A few seconds later the entire dash goes down. I then shut off the engine by only turning the key back 1 notch. At this key position the odometer & trans indicator come on & the trans indicator will properly display every selected position correctly. It is consistently working this way every time now. The heat is also stuck on hot & the rear window wiper/ washer is not working.
I've also pulled the body module to check for connection problems & don't find anything with that. I've pulled the fuse under the hood too. So far no luck.
View 4 Replies
Vehicle: 2003 Dodge Grand Caravan 3.3 Litre
I also have my CE light on. Hooked up my reader and got the "P1491 Radiator Fan Control Relay" code. I have checked my rad fan fuse and it is okay. My attempt to locate the rad fan relay took me from the rad fan wire to a device that looks like a heat sink. It is located on the vehicle frame between the rad. and front grill. Is this the rad fan relay? If it is I'm not sure how I would replace it. It seems riveted to the frame.
View 7 Replies
We just purchased a 2012 Grand Caravan and was wondering where to get a key and program it. I know the key will be an arm and a leg if i get it from the dealer. Is there a tutorial that tells how to program it as well?
View 3 Replies
2006 Caravan. Heat comes and goes every minute or so. Also noticed the temp gauge goes from normal operating range to cold and back again frequently. Hasn't overheated. Does that sound like a thermostat problem?
View 2 Replies
On my 2005 3.3L Grand Caravan the ABS light keeping coming on. I inspected the sensors for the front and used my compressor to give them a quick puff of air to get rid of dust. The light went off for about 5 days. Now it is back on.
How does one read ABS codes? If I knew for sure that the problem is a speed sensor and which one I could clean or replace the faulty sensor.
If I clean to sensor are there any special precautions I need to take? As far as I could see they didn't look very dirty.
View 1 Replies
What am i missing i have a terrible clunk in the front end when i hit bumps. I thought it was the struts and mounting plates so they are new . no change Stabilizer links were tight but i replaced them as well. Everything else seems tight but the noise has not changed with any of the above mentioned repairs.
View 13 Replies
I'm having trouble with my 96' 3.0L, its kind of crazy its intermittent and while driving the engines surges one or twice and then dies... when I try to crank it up again cranks but don't starts if I try again it wont even crank ( no starter winding up ) what I noticed is that is I'm driving when it dies my check engine light disappears for a while and if I connect my OBD 2 reader does not link up with the ECU if I wait a while and I crank it up again its starts and the while cranking up I can hear a bang noise from the engine compartment drives side and then after a couple of minutes dies again...
View 4 Replies
I have a 2006 Grand Caravan 3.8 that just stalled at a set of lights yesterday and have had it towed back to the shop here. I turns over and starts briefly then will die and then just turn over strongly. I cleaned the throttle body and IAC but this did not work. I connected fuel pressure tester and have no pressure when turn key on or turn it over.
The fuse and relay check out ok, so I'm thinking bad or clogged fuel pump.
I have a 2004 Caravan out back that I have used for other small parts to interchange before and was wondering whether or not the fuel pumps between these two are compatible. Be a lot of work to pull the one off the one in the yard, only to find out its not going to fit.
View 3 Replies
Intermittently the ABS Light is coming on. 84,000 miles.
Brakes have been changed once, 10,000 miles ago.
Minor clunk sound when light is on.
Light goes off after van has set, brakes work fine at that point.
View 3 Replies
I've been fighting with these vehicle for months, and I've only been able to narrow down the list of possible issues. Tried replacing the ignition switch, battery terminals and cables, starter, and even a PCM since according to the dealership it was bad. I've checked all the fuses and relays, and they're all ok.
I'm getting fuel and spark, but no crank from the starter. The voltage going to the hot post on the starter is 12.7, but the voltage from the igniton wire is only reading around .5-.6, fluctuating a bit. Before I spend the money on taking it to a mechanic I wanted to know what your opinions were on what the next step is. I know a bit about electrical systems in cars but I'm no expert.
View 3 Replies
Someone put sugar in my gas tank so I had it worked on at the Dodge place they replaced my fuel pump..fuel filter cleaned the tank..flushed the lines cleaned my injectors and replaced the plugs..I went to pick it up I barely made it a mile down the road I had no power and a lady flagged me down to tell me to pull over because I had sparks coming from the bottom of my van I looked under the van and the catalytic converter was red like hit coals the Dodge place is telling me its my flex plate? I think they are misdiagnosing the issue because before the sugar issue I had no problems with my van?
View 14 Replies
2005 town country, on interstate, cruise a 85, drives smooth, then vibrates pretty good, it will vibrate for a few seconds then smooth, then vibrate. the vibration is felt everywhere, steering wheel, seats, even the outside mirrors vibrate, at 60 we don't feel it much, at 45 nothing. we notice when coming to a slow stop or just scooting up in traffic that it seems to have a little wobble to it too.
All brakes and rotors and all motor and transmission mounts are new, struts, strut mounts, sway bar, sway bar end links and bushings are new, have had it checked and nobody can find anything wrong. no clunking noise moving the tires left to right and up and down. alignment is perfect. the tires are crappy but am thinking if it was a tire problem it would vibrate all the time and not on and off. its never been wrecked either. it is a 3.8, front and rear sway bars, long wheel base, nivomat rear.
Wheel bearings? I don't know but would think they'd make noise moving the tires back and forth and side to side. and hear no clunking over bumps at any speed.
View 5 Replies
Changed input and output sensor, replaced solenoid pack, cam and crank sensor. Runs good code on odometer 1684 p700.
View 4 Replies
ABS light is on and the auto trac is off and will not turn back on. What this could be?
View 2 Replies
I start my van and open the hood to check Coolant and I notice gas spilling out engine and running down the side close to my power steering pump. So I stop the vehicle and notice gas sprayed on different parts by the back spark plugs and a little area by sensor.
View 3 Replies
