The problem I am having with my 2009 Grand Caravan SE is the drivers door controls stopped working. I cant use the power windows locks or door locks and the background light is off also, the front passenger side and middle row locks etc work. On the driver door the only things that work are the 2 back vent windows.
View 6 RepliesI have a 1998 Plymouth Grand Voyager SE. It has 122000 mi. I just bought it a few months ago and have came across a few minor problems and all have been easy DIY projects (couple of blown fuses, wiper replacement etc..) Recently, I noticed the AC stopped working (it was only tested once when I bought it, but have not used it since)
Where to begin the diagnosis. Is there a fuse connected to the functioning of the AC? I really don't know a whole lot about cars, but I am pretty good at fixing things in general.
I've fixed one source of water that was leaking into the passenger side footwell via the insulation surrounding the A/D drain line, but I still have a leak on the drivers side after a rain, and it's strange. Unlike the leak on the passenger side, this one is not coming along the firewall - the firewall is bone dry. The water seems to be coming vertically straight down, landing on the floor mat, but I can't tell where it's coming from. Not only is the firewall dry, but so is the carpet on all sides of the puddle that collects in the rubber floor mat.
Also, I haven't been able to create the leak by spraying water on the van - I washed it today, for example, and not a drop came in. But we had a light rain last night, and there was a puddle on the floor mat (good thing it's rubber) when I opened the door this morning. I've stuck my head up under the dash immediately after I had found water on the floor mat, but can't for the life of me see any sign of wetness above the location of the water on the floor mat.
And yes, I've cleaned out the drain lines under the cowl in front of the windshield. Where this mystery leak may be coming from?
I have a 2008 Dodge Grand Caravan SXT with 58000 miles. The rear blower won't run with either the front controls or rear controls. I have checked the fuses and they looked ok.
View 14 Replies96 plymouth voyger se 3.3 6cly motor cut off while driving down highway or when stopped no check engine light...
View 1 RepliesI have a 2002 Town and Country LX with the 3.3L V6. Recently the check engine light went on and later the transmission stopped shifting from 3rd to 4th gear. All the gears work properly except for 4th. It doesn't seem like anything is wrong with the transmission, would this be a sensor problem? If so which sensor would need to be replaced?
View 14 RepliesService Engine light came on couple days later turned off, came back on today & vehicle stopped shifting into 3rd. Later this evening was driving it and power steering went out, ABS light came on, temp gauge jumping from hot then cold. When Service Engine light came on originally took to autozone. these are the codes given:
P0700
P1776
P0420
I have read problem could be input or output sensor which are $17 bucks each. Going to try those...
Mileage is 145,000
My door ajar warning light stays on and at the same time the warning bell/noise keeps going off. Is there something that I can disconnect to make the noise stop?
View 4 RepliesI have a 2005 Dodge Caravan with a heater blower that doesn't seem to be working. Whether the heater knob is on low or high, it does nothing, but you can feel a little heat coming out, though. I was told it may be a resistor behind the glove box. I've already checked the fuse, and it seems OK. What do I do?
View 6 RepliesRecently disconnected the battery, now rear window switch flashes whenever the door is opened and the hvac switches will not work for around 30 seconds, how to recalibrate the door/hvac system...
View 1 RepliesMy 1996 Caravan gauges do not work at all. I have checked the fuse(s), and thay are all fine.The rest of the van works just fine. The fuel, temp,tach, and speed gauges do not work. The odo does not show up either. What to do?
View 14 RepliesI have a 2000 Dodge Caravan. The power lock switches are no longer working (both driver and front passenger). They worked fine the last time I drove the vehicle and both switches stopped working at the same time. The power locks themselves still function with the remote and still lock when speed reaches 25km. Just the actual switches on the doors are not functioning.
View 5 Replies98 dodge caravan 3.3L v6 ..... All lights work including driver's side tail lights. only problem is that when pressing brake pedal, the driver's side brake light does not light up. i changed the bulb and checked the brake light fuse under the hood, but it was fine (as i guessed since the passenger side and middle brake lights work). I took the assembly off and reseated the connector to the tail light assembly, but same issue.
View 2 RepliesI'm having trouble with my 2000 Grand Caravan 3.3L. The gauge cluster was working intermittently & recently quit. I have the P1698 trouble code & looked up info online. I of course found out about the solder joint problem & figured that would be the culprit. I took the dash apart & found the solder joints were fine, but when coming apart, the wire plug on the back side came out on it's own. The retaining clip was broke & I thought maybe that was my problem. There's enough room to install a zip tie to hold the plug in & I put it back together. It still doesn't work though.
Here's the symptoms- I turn the key to ignition & nothing in the instrument cluster comes on. When I start the engine, everything lights & works as normal except for the trans indicator- the letters light, but no position shown (regardless of any gear selection). This continues for about 5-10 seconds & the trans position indicator lights up around EVERY letter. A few seconds later the entire dash goes down. I then shut off the engine by only turning the key back 1 notch. At this key position the odometer & trans indicator come on & the trans indicator will properly display every selected position correctly. It is consistently working this way every time now. The heat is also stuck on hot & the rear window wiper/ washer is not working.
I've also pulled the body module to check for connection problems & don't find anything with that. I've pulled the fuse under the hood too. So far no luck.
Back in June I replaced all 4 brakes and rotors. Now all of sudden I hear a loud grinding noise in the front end only when I'm braking to a complete stop.
I took all 4 tires off and then took off the pads. The pads and rotors are all still brand new and have very minor normal wear. Also the calipers still look good.
I then put everything back together and went for a test drive. The grinding noise is still there. It's very loud and only when I come to a complete stop.
I have a 2013 Corolla with about 6000 miles on it. The drivers side door mysteriously locks after my wife gets home in the evenings. We do not lock it at the house, but when we get into it after she gets home to go somewhere, the driver side door is locked, but none of the rest of the doors. Is there a recall for this problem? Or is it something new that Toyota has not discovered yet? It's the only problem I've had so far with this car, so far it has done this four times in the last month. I just turned in an 07 Tundra with 250,000 miles and had only one problem with where it went into " Limp" mode because of water in some emissions control box at around 160,000 miles, so I hope to get as good service out of the Corolla. It is not the auto relock feature, as I'm familiar with that function on the Tundra.
View 5 RepliesI had two 12" subs running in my 09 corolla. The front right door speaker and little tweeter speaker stopped working so I took the subs out. I figured the speaker was blown so I ordered new ones. When I installed the new door speakers, they didn't work.
I know for a fact it is not the speaker that's faulty because I tried them on the driver- side door and they worked. So my passenger side door and tweeter speakers aren't working. Do I need to order a new tweeter speaker as well? Like does the tweeter need to be working for the door speaker to work? And vice-versa?
Two weeks ago my airbag light came on and I got an airbag fault message. A week later the MFD controls on the steering wheel and the DSG paddles just stopped working. I had searched around and found that some people had issues with the clock spring. I brought the car to the dealership and they mentioned that maybe it was the clock spring, but after checking everything out they told me that the horn buttons needed to be replaced and that they were causing the issue. I have a hard time believing that this is the issue because the airbag fault popped up a week before the MFD controls and DSG paddles stopped working.
View 1 RepliesThe controls on my steering wheel stopped working. Last Saturday I brought car into dealer for an oil change and they did a recall on the ECM module. I wonder if this is a coincidence or if the programming messed up the wheel.
View 2 RepliesBackground (not sure if it's relevant): My car was in the body shop for 13 days. I got it back on 8/24. Damage was too the bottom right side, doors and adjacent body.
When i picked up the car and drove it, it seemed fine except that the MPG average was only 25mpg. Normally for me, it's around 38 to 40. It has gradually come back up. for this reason, i was frequently pressing the Info button on the steering wheel to bring up the screen that shows the current mpg average.
Yesterday the horn on my 2007 Passat has stopped working completely. I have read the owner's manual from cover to cover and the fuse for the horn is not listed anywhere in any of the fuse diagrams - either for the engine compartment cover, or on the fuses listed in the interior by the driver's side.
In addition the MFD steering wheel controls have also stopped working, and there is also no night time illumination on those buttons. I'm guessing as these are also located on the steering wheel that the two problems might be linked. I can live without the MFD controls, but the horn is a safety issue.