I'm having electrical issues in my 2006 Dodge Caravan. It started with the radio not working (even though the lights around the nobs and buttons light up) and the lock button doesn't work until the van is started. Now, the windshield wiper won't turn off, even after the van has been turned off.
View 1 RepliesAfter I changed to blade on the left wiper of my 2005 GC the blades hang up at the bottom of the return stroke. This pulls the end of the rubber from the holder on the end of the blade. Wrecks the blade and requires a new one. Happens with new blades so it must be the arm. I may have bent the arm a bit the first time I replaced the blade. Could this be the cause. Need a new arm?
View 1 RepliesMy 2004 Caravan lost power to windshield washer motor and headlights, after checking under fuse box, I swapped over the relay marked headlights washer , still nothing. I disconnected the power module at the front of the fuse box by removing four torx head screws. Removed it by rocking it a it out towards the front of the van. I cleaned the terminals and replaced it. Seems to have solved the problem .
View 1 RepliesI have a 2006 Dodge Caravan, My AC unit works great. With the heater, it will work for 2-3 minutes, at which point it starts to blow cool air. I can leave it running, but it never gets warm again, if I turn the fan off for 3-5 minutes, when I turn it back on, I get a good amount of heat that goes for about 2-3 minutes before blowing cold air again.
View 1 RepliesWhen I drive through large puddles, or in the rain, my car doesn't turn. I believe this may be because my Splash Guard is missing.
I keep looking online to get a replacement, and they have one that looks exact, and another I have no clue if this would be the same or if it is a different piece all together.
The picture attached at 1.jpg is the one that looks exactly as the one that is gone from my car.
The second, is the one that I keep finding when I type in replacement splash guard.
Can this one be a proper substitute?
I have a 2006 Dodge Grand Caravan SXT with the 3.8 and 135,000 miles. Whenever it is hot out and the engine has been running it is hard to shift either from park or back into park. Today it completely froze on me and I had to wait for it to cool down before it would shift into park. Temp out is about 80 today.
View 2 RepliesI have a 2006 Dodge Caravan that when I drive at highway speeds and it's wet out, my air bad light comes on and about 50% of the time, the radio, fan, windshield wipers, and 12v outlet stop working suggesting the fuse or some other wiring is getting wet. The dealer cannot replicate and will not suggest any fixes. What do I have my local mechanic replace or seal?
I know there's a Chrysler recall on 2005-2006 Caravans, #J38, but my Caravan falls outside the specs by 2 mths (it was for vehicles in service between Jan 2005 and April 2006).
I've been fighting with these vehicle for months, and I've only been able to narrow down the list of possible issues. Tried replacing the ignition switch, battery terminals and cables, starter, and even a PCM since according to the dealership it was bad. I've checked all the fuses and relays, and they're all ok.
I'm getting fuel and spark, but no crank from the starter. The voltage going to the hot post on the starter is 12.7, but the voltage from the igniton wire is only reading around .5-.6, fluctuating a bit. Before I spend the money on taking it to a mechanic I wanted to know what your opinions were on what the next step is. I know a bit about electrical systems in cars but I'm no expert.
I'm about to put a new tailgate on a 98 Dodge Caravan. I got hit in the back and I bought a new back door at the junk yard. It looks pretty easy, but I thought I would touch base here and there are a couple of potentially tricky parts...
Does that wire bundle have a block somewhere that you can plug, or am I going to be splicing them one by one? (I don't have power locks. I have windshield wiper, back door inside light, license plate light, heat wires in the glass.) The other tricky part..changing the lock.
I think that's all.. the bolts and star screws look pretty straightforward. I got it used with 48k miles a couple years ago and I only have 75k now. It was a government car.
I was riding down the interstate this morning and had my cruise control set at 70mph. all of a sudden the cruise just turn off. I went to hit the gas pedal and there was nothing. No check engine light or anything, no spit, no sputter. I pulled off the side of the interstate and attempted to start the van. the engine turns over fine, but no start. all lights, radio work fine. car has fuel. it did not run hot.
View 1 RepliesI have a 2005 dodge caravan and today after taking my kids kids to school, I noticed white smoke coming from the hood of the engine. I managed to get home and check it out. With further inspection, smelled like some type of fluid is burning off I can't tell if it's oil or anti freeze. There seems to be some type of condensation in the inside of my van on the passenger windshield. I looked to check to see any leaks inside on the floor mat and underneath the van itself and nothing. What seems to be the issue?
View 6 RepliesI have a 2003 Dodge Grand Caravan and while I was driving it stopped on me. It will turn on but once you put it in gear it will turn off and wont turn back on. I have replaced the fuel filter and fuel pump.
View 3 RepliesI have a 2008 Dodge Grand Caravan SXT with 58000 miles. The rear blower won't run with either the front controls or rear controls. I have checked the fuses and they looked ok.
View 14 RepliesI did a tune up on my 3.3L Dodge Grand Caravan only to find the engine is vibrating heavily. This tune up included a new coil pack, plugs and wires.
I did happen to notice a separate thing when looking at the Crankshaft Pulley that it seemed to be wobbling while the engine was running.
I have an 02' Dodge Grand Caravan 3.3L V6 (not flex fuel) .I have replaced the battery, alternator, sparkplugs/wires, fuel pump, fuel filter. All over time and now when i try to start the van it turns over strong sometimes starting then stalls out immediately. When I try to crank it sounds like metal on metal. Check engine light stays on,but i dont have an OBD reader.
View 7 RepliesAnti-theft alarm was triggered inadvertently and now won't allow vehicle to start. When ignition is turned there is just a click...does not turn over. Is there a reset???
View 7 RepliesDrivers side not bowing hot air? We changed the blower motor and the resister on the passenger side. We hadn't tried to use the heat until last night when we needed the defrost and that's when we realized only heat on passenger side.
View 1 RepliesI have a 97 dodge caravan engine 3.0. When I start to accelerate my engine fuse 20amp blows. I does not occur every time but yesterday, it did it 6 times and is now getting looked at. I am just curious on what causes this. I did recently have my spark plugs changed so I am thinking something may be arching.
I do have codes that previously came up for my fuel injectors (P0203, p0206). Another code I have is p1294 idle speed performance.
I have an engine noise on my 2000 Dodge Caravan with the 3.3 engine. It sounds a lot like the grinding of a rotating part. It occurs at start up, momentarily, then goes away. If I drop it in gear and start doing low speed maneuvering in the driveway, it comes back. If I turn on the AC it comes back. In all cases, the noise goes away at around 1200 rpm.
The noise occurs again, when I shut the engine down.The engine performs and runs smooth and normal otherwise. No stalling, stumbling, or bad gas mileage to report.
I can "feel" the noise with my hand, when I put my hand on the ac compressor bracket, or the intake manifold, or the valve cover. I've tried the listening through the stick method, and it seems to be coming from the front area of the engine. But I can't be sure. It is something internal. Let me describe:
I thought it was my AC compressor or clutch going bad. The fact that my AC had stopped working well, and was making jet engine noises at high rpm supported me decide this. I replaced the compressor. The AC works great now, and the jet engine noises went away. But the grinding noise is still there. As described.
I wishfully thought it was the belt tensioner or idler pulley. I replaced both of those. Noise still was there. I pulled off the serpentine belt, and started the engine. It made the noise, very briefly as it started, then went away completely. It made the noise again briefly as I shut the motor off. So it's still there without any of the accessories turning.
The noise is loud and obnoxious at idle when under load. It just can't be good. I've read theories about similar sounding problems, saying they could be loose timing chain, bad oil pump, slapping pistons, crank journals, flexplate/flywheels cracked.
I'm going to try doing an oil system flush, and then I'll change it out with a little thicker oil. See if that makes any difference in the noise. Currently I'm running 5w-30 Mobile 1. I think. I'll let you know if it changes anything. I'm also thinking I want to make a short video of the car idling and making the noise for my video camera. I'll post that on youtube and link it here.
So here I am with my 1996 Dodge grand caravan that I purchased new in 1995 for a whopping 30k. Yeah hind site is 20/20 skip forward to mile 102k transmission fails completely. Had to have it towed in to shop, rebuilt tranny put in... skip ahead another 4 years to mile 173k and transmission fails again. Again on a tow truck to the shop and ANOTHER tranny rebuild. So now I am at mile 182k and transmission is making a horrible shudder and I have moved across the country away from original shop that did last trans repair (who says they only warranty if I come back to them) and I am possibly looking at another repair or replacement. What is the deal with these vans?
View 4 RepliesI have an 2002 Dodge Grand Caravan that cut off shortly after starting the other night. Every time I try to start it, it will crank and then stall almost immediately. I tested the fuel pressure and it was strong so I hooked up a pocketscan and my van starts and runs normally while the pocketscan is hooked up. I even took it for a drive around the neighborhood. As soon as I unplug the pocketscan my engine shuts off. The only code on the scanner was for the O2 sensor(not something that would shut my engine off.)
View 1 Replies