Caravan/Voyager :: 2003 - No Reverse After Starting And Now Won't Move
Nov 15, 2015
I have a 2003 Chrysler Town and Country and my problem started with no reverse after starting car. If I pushed it back and drove forward 10 or 15 feet then reverse would work fine and shift properly. As long as I could drive forward first then reverse would work. This was like this for a few days then the vehicle wouldn't move at all. There wasn't any error codes. The fluid is full and clean.
When the van was about a year old I took it to the dealer with harsh shifting and they said there was a broken wire to the trans, I am thinking this is when they came out with the 3 wire slice people where talking about.
I wasn't needing the van so it has been sitting now for almost a year. Now I want to get it working again...
View 1 Replies
Advertisement
The gear shift works fine, and we lifted the hood and saw that the mech. arm IS working when we shift. However, the van will not move into any gear. won't go forward, reverse, etc... it acts like it isn't shifting.
i was driving down the highway, and noticed it wasn't accelerating and stepped on the gas.. .and nothing. I stopped the van, put in park, turned it off. Started it again, and put in D and wouldn't go, just engine revved. then put in reverse and same thing... didn't move but engine revved.
View 3 Replies
I have to over rev the engine to get the van to move. After that the tranny seems to work fine. Tranny fluid level is OK, and it does not smell burnt. After I over rev the engine to get moving, the engine revs seem to get back into sync for the speed I'm doing - usually just as the van starts moving, the over-revving is no longer there. Do I need to adjust the bands??
View 2 Replies
My 2000 dodge caravan with the 3.3 is shuddering while in gear and not moving especially in reverse . As soon as you start going it stops . No slipping whatsoever. The van only has 130'000 miles on it .
View 2 Replies
So this is my wifes vehicle so I don't always get the whole story . I have seen this once or twice over the years. We have the 2008 T&C Touring 4.3L. Bought it brand new. Now we're up to 80k miles.
The problem is that sometimes after starting the van all off the accessories including lights gauges everything are completely dead. If I turn the van off and stay it again it will be fine. I'm thinking the electrical side of the ignition switch but its so random.
View 4 Replies
I have an 02' Dodge Grand Caravan 3.3L V6 (not flex fuel) .I have replaced the battery, alternator, sparkplugs/wires, fuel pump, fuel filter. All over time and now when i try to start the van it turns over strong sometimes starting then stalls out immediately. When I try to crank it sounds like metal on metal. Check engine light stays on,but i dont have an OBD reader.
View 7 Replies
Turn wipers on and motor growls but wipers do not move, checked 30 amp fuse and it is good, all other functions of the multifunction switch are good.
View 2 Replies
Changed input and output sensor, replaced solenoid pack, cam and crank sensor. Runs good code on odometer 1684 p700.
View 4 Replies
When we turn the wheel of the van sharply in either direction, it produces a distinct clunk from the rear. This isn't the AWD engagement symptom I've read about - it seems to be strictly connected to a sudden change of direction, and the noise is definitely coming from the rear. I can also get the noise to happen when going over a large bump, such as a speed bump, but a moderately sharp (so nothing you wouldn't do in normal driving) flick of the wheel produces the noise very easily and consistently.
I doubt it's the axles, because the way we drive this van, the AWD is actually seldom engaged, so the axles have seen very little wear. Could it be the rubber bushings that support the leaf springs? It's such a simple rear suspension design that there isn't a whole lot to go wrong/replace, but I don't want to start throwing parts at it without at least a stab at a diagnosis.
The van has 123,000 miles, and has been doing this for a long time, and it doesn't seem to be getting any worse, but I'd like to get to the bottom of it. Otherwise, the van has been amazingly trouble-free.
View 6 Replies
I have a 2003 Dodge Grand Caravan and while I was driving it stopped on me. It will turn on but once you put it in gear it will turn off and wont turn back on. I have replaced the fuel filter and fuel pump.
View 3 Replies
I've tried putting new batteries in my mini van and the battery goes dead after a day or 2. I've had it to the dealer before and they said it's a bad battery. which clearly it's not. I had a meter between the grounds on the battery and pulled all fuses under the hood and no change. I'm a quadriplegic and it's a nightmare when I go out with my aid to go to a doctors appointment and my van is dead. I don't have any money for the dealer again. I don't think the chrysler dealer even looked at it and took advantage of my situation. Its a 2003 Town country with only 29,000 miles. could it be the alternator drawing power when the car is off?
View 1 Replies
I have a 2003 Grand Caravan, 3.3L, 75,000 miles. The van suddenly will not attempt to start. The strange thing is that when the key is turned to RUN I cannot hear the fuel pump. The normal 2 or so second on growl at the initial key turn is not there. When turned to start the clock on the radio goes out and no crank. I have found that the start relay is not passing on the signal to the starter. If I jump across the two pins going to the starter, the starter cranks fine. The van will still not start because I believe it has no fuel,due to the fuel pump not running. I thought first that it must be the neutral safety switch but does that have any control of the fuel pump also? I have found that the neutral safety switch requires that I remove the valve body for access.
View 14 Replies
I've fixed one source of water that was leaking into the passenger side footwell via the insulation surrounding the A/D drain line, but I still have a leak on the drivers side after a rain, and it's strange. Unlike the leak on the passenger side, this one is not coming along the firewall - the firewall is bone dry. The water seems to be coming vertically straight down, landing on the floor mat, but I can't tell where it's coming from. Not only is the firewall dry, but so is the carpet on all sides of the puddle that collects in the rubber floor mat.
Also, I haven't been able to create the leak by spraying water on the van - I washed it today, for example, and not a drop came in. But we had a light rain last night, and there was a puddle on the floor mat (good thing it's rubber) when I opened the door this morning. I've stuck my head up under the dash immediately after I had found water on the floor mat, but can't for the life of me see any sign of wetness above the location of the water on the floor mat.
And yes, I've cleaned out the drain lines under the cowl in front of the windshield. Where this mystery leak may be coming from?
View 2 Replies
All the electrical components that are controlled by the ignition key/switch (radio, power windows, wipers, AC/fan) sometimes don't work when I turn the van on. However, when the key is turned back into accessories position, everything works - never a problem then. I had the ignition switch replaced a few months ago and that seemed to work (didn't occur as often) but now it's back to the way it was before. Just about every time I need the wipers (when it rains), they don't work nor do any of the other things I mentioned previously.
View 5 Replies
Vehicle: 2003 Dodge Grand Caravan 3.3 Litre
I also have my CE light on. Hooked up my reader and got the "P1491 Radiator Fan Control Relay" code. I have checked my rad fan fuse and it is okay. My attempt to locate the rad fan relay took me from the rad fan wire to a device that looks like a heat sink. It is located on the vehicle frame between the rad. and front grill. Is this the rad fan relay? If it is I'm not sure how I would replace it. It seems riveted to the frame.
View 7 Replies
I'm new here and I am having issues with my Lumina. It is a 93 Chevy Lumina Euro 3.1L 6 cylinder and has 192K miles on it. It has had one owner for the past ten years that I know for a fact.
Here's what happened. I was coming back home (2hr trip) The brakes had started making that roaring sound on the way down and had gotten worse when I got ready to make the trip home. Okay so I know the brake pads needed to be changed. No big deal. Well going down the road at 65mph I round a curve and my car starts making this REALLY LOUD grinding clattering noise. It took me forever to get it stopped. I will still in the road and I needed to get it out bc it was right around a curve. So I put it in drive and it wont move. So I put it in reverse and it moves just fine with no problems and no noises made. After backing it out of the road I tried to put it in drive. It moved forward a few inches and stopped like something was binding it up.
So here's the problem.. it will move in reverse with no problems at all and only creeps a couple of inches forward then stops. The harder you press on the gas the more it tries to lurch forward but will not move.. like it's caught on something.
We changed the rear brakes on it. Discovered that the driver side rear rotor and caliper were broke beyond repair so we replaced those too. Still the same.. moves forward a lil bit and stops but will go in reverse just fine. We don't seem to think its the tranny bc it pulls hard and seems to not have any problems pulling.. but its like something is bound up somewhere. That is the best way I know how to explain this situation.
View 8 Replies
My trailblazer will not move in reverse , and will barely move forward, i checked transmission fluid hot and it's not even on the dipstick but when it was cold. it was?? Do I add more or what?..
View 9 Replies
I have a 1998 f150 4x4, the truck has not been driven in a few years and it’s been outside in my driveway up on jack stands. I just rebuilt the front end and did a four wheel break job, after getting the truck off the jack stands, I can't get it to move in drive or reverse. I also noticed that when you go from reverse to park the gears grind and I can't even get it to shift into 4H. I checked the tranny fluid and it is fine, also the tranny was just rebuilt a few years before I stopped driving the truck.
View 6 Replies
We just purchased a 2012 Grand Caravan and was wondering where to get a key and program it. I know the key will be an arm and a leg if i get it from the dealer. Is there a tutorial that tells how to program it as well?
View 3 Replies
2006 Caravan. Heat comes and goes every minute or so. Also noticed the temp gauge goes from normal operating range to cold and back again frequently. Hasn't overheated. Does that sound like a thermostat problem?
View 2 Replies
On my 2005 3.3L Grand Caravan the ABS light keeping coming on. I inspected the sensors for the front and used my compressor to give them a quick puff of air to get rid of dust. The light went off for about 5 days. Now it is back on.
How does one read ABS codes? If I knew for sure that the problem is a speed sensor and which one I could clean or replace the faulty sensor.
If I clean to sensor are there any special precautions I need to take? As far as I could see they didn't look very dirty.
View 1 Replies
