I have a 99' GC and just changed out the EGR valve. Now the engine cuts out when you brake or get to a low speed. Idles a little rough also.
View 7 RepliesMY gc started cutting out a few weeks ago while idling in gear. I changed out the four plugs I could get the wires off. It's a v6. It started running better for a couple of days. I need to know of any way to get the stuck boot off. I also have a feeling there is something else wrong. Anything else that might be causing it to cut out. It has progressed to cutting out while going down the highway.
View 4 RepliesMy T&C strikes again... Now it shakes when braking at highway speeds (thinking rotors are warped and need changed), but today the brake light, traction control, and ABS lights all come on and stay on when I drive...
View 4 RepliesI was riding down the interstate this morning and had my cruise control set at 70mph. all of a sudden the cruise just turn off. I went to hit the gas pedal and there was nothing. No check engine light or anything, no spit, no sputter. I pulled off the side of the interstate and attempted to start the van. the engine turns over fine, but no start. all lights, radio work fine. car has fuel. it did not run hot.
View 1 RepliesBack in June I replaced all 4 brakes and rotors. Now all of sudden I hear a loud grinding noise in the front end only when I'm braking to a complete stop.
I took all 4 tires off and then took off the pads. The pads and rotors are all still brand new and have very minor normal wear. Also the calipers still look good.
I then put everything back together and went for a test drive. The grinding noise is still there. It's very loud and only when I come to a complete stop.
Intermittent problem, occurred 4 times during past 4 weeks, always during wet/rainy/damp weather. Three times when car was sitting overnight, once at work in parking lot after a 12 hour work shift. Each time, the engine started 5 or 6 times then died like someone turned the key off two seconds after the engine started. Then the engine would not crank or turn over, just some clicking near the relay box under the hood. Lights, power windows, etc. all work fine. Battery voltage OK. Jump starting or battery charger makes no difference. Note: With key in "run" position, no display to odometer though all idiot lights light up like normal.
1st time, after about 15-20 minutes, car started. 2nd time, towed to my mechanic (who thought security system lock out) then a second tow to dealer. Dealer found power into power distribution center but none out. Replaced PDC. Car worked fine for 1 week. Same problem twice since repair. First post repair failure I had van re-towed to dealer. Of course, it started for them. Left overnight 2 more nights. Started for them every time. They say it is a "problem with computers" but they don't know exactly what. They also say the Alarm set Dash light is coming on with the rest of the dash lights and that is a no-no. 2nd post repair failure happened this morning. Tried locking door to reset alarm. No change. Locked doors, opened rear hatch. Lights flashed but horn did not sound. When car is working and I do that (open hatch with other doors locked), in addition to lights flashing, horn beeps! I also disconnected the positive battery terminal, waited 10 minutes, reconnected and attempted restart. No change. Car still won't start and odometer display does not work.
Van has 110,000 miles. Otherwise in fantastic shape and runs great (though only gets about 20MPG). Owned van for 2 months and have driven about 7,000 miles. 1st problem I've encountered (other than a very uncomfortable drivers seat - feels like a spring is sprung!)
Service Engine light came on couple days later turned off, came back on today & vehicle stopped shifting into 3rd. Later this evening was driving it and power steering went out, ABS light came on, temp gauge jumping from hot then cold. When Service Engine light came on originally took to autozone. these are the codes given:
P0700
P1776
P0420
I have read problem could be input or output sensor which are $17 bucks each. Going to try those...
Mileage is 145,000
Dealer replaced rack,twice. Still thumping,they installed new struts and 4 sway bar links and bushings same thump still there. I unhooked swap bar links and tied them to brake line and backed it out is my shop and thump is still there and sounds like both sides. This van has 56,000 miles on it and the ball joints and control arms feel and look tight. Is there anything about how frame mounts that might cause this?
View 2 RepliesMy van just started to have this issue today with jerking real hard like its dropping a couple of gears while going between 50-60mph. It is a 2000 with the flex fuel 3.3L 4 speed auto.When this happens the spedo will go from 55mph to 40 instantly while keeping a steady speed and it feels like the tranny is going to rip right out. This will happen every 5 to 10 min but go back to normal driving after 3 sec and has not popped any codes. It runs like a top and all fluids are at the correct levels. I have to commute 50 miles a day to work so i really need to figure this out!!!
View 1 RepliesI start my van and open the hood to check Coolant and I notice gas spilling out engine and running down the side close to my power steering pump. So I stop the vehicle and notice gas sprayed on different parts by the back spark plugs and a little area by sensor.
View 3 RepliesI have a 2005 dodge caravan and today after taking my kids kids to school, I noticed white smoke coming from the hood of the engine. I managed to get home and check it out. With further inspection, smelled like some type of fluid is burning off I can't tell if it's oil or anti freeze. There seems to be some type of condensation in the inside of my van on the passenger windshield. I looked to check to see any leaks inside on the floor mat and underneath the van itself and nothing. What seems to be the issue?
View 6 RepliesMy transmission is slipping when the engine is cold. Fluid levels seem fine. I do have a fluid leak that I monitor and add fluid when needed. It's an 05 touring with 167k miles.
View 1 RepliesI have a 1998 Caravan and the engine cooling fans wont go on. Ive replaced the relay and the temp sensor. When I pull the connector off the temp sensor the fans go on so I know the fans and fuses are fine. For some reason it seems the computer module isnt sending a signal to the relay to turn the fan on. I get the trouble codes P1491(radiator fan relay circuit fault) and P0118(engine coolant temp circuit high input).
I am also having a problem with the air conditioning not working. When I do the self diagnostic test on the A/C the results are that it fails the cool-down test. Why the computer module isn't sending a signal to the relay? Could the A/C problem be causing the cooling fans not to come on?
I have to over rev the engine to get the van to move. After that the tranny seems to work fine. Tranny fluid level is OK, and it does not smell burnt. After I over rev the engine to get moving, the engine revs seem to get back into sync for the speed I'm doing - usually just as the van starts moving, the over-revving is no longer there. Do I need to adjust the bands??
View 2 RepliesMy 1999 Plymouth grand voyager SE 3.3 liter engine has developed a tach and speed. Odometer problem. At various times the tach will surge@ 200 rpm and at the same time the speedometer will top out and then they will return to where they should be. I can make this happen also bye driving in reverse, stopping and putting it in overdrive and the tach and speedometer will surge without the car ever moving...
View 2 RepliesWe have a 2012 Dodge Grand Caravan and has a whistling noise when starting up? We are in Wisconsin and its damn cold. It only does it when its cold out. Once the engine warms up it goes away. But my wife is freaking out about it. I am thinking it might be something with the air intake but not sure.
View 3 RepliesI did a tune up on my 3.3L Dodge Grand Caravan only to find the engine is vibrating heavily. This tune up included a new coil pack, plugs and wires.
I did happen to notice a separate thing when looking at the Crankshaft Pulley that it seemed to be wobbling while the engine was running.
Working on a 2001 caravan. Been sitting for about 6 months with no battery installed. decided to work on it. Got a new battery, and when I connected it the alarm went off. I dont have panic button for it so I unhooked the bat.
I think I hooked the bat back up with the thicker gray key in the ignition. I think that is the key with the chip.
The alarm did not sound but the engine will not crank, seems like it it in some security mode blocking start up. I tried cycling the key in the driver door but that did not work.
I have a 1997 Voyager that I am having a thumping noise that is coming from a black module that is mounted in the engine compartment over the passenger side fenderwell. It has 2 vacuum lines and an electrical connection coming off of it, one of the vacuum lines has a tag on it that says EVAP. The engine seems to be running fine, although every now and then it seems like it might idle a bit rough, and there are no CEL on or codes in the computer. Don't know what is this module called.
View 3 RepliesA friend has a 1999 Caravan with the 3.0L engine. He couldn't get it to start and to make a long story short, I checked the fuel pump relay and fuse and they were good but there was no pressure on the fuel rail. Turning the key I couldn't here the fuel pump come on and determined the fuel pump was bad.
I changed the fuel pump and fuel filter put in 1/4 tank of gas and turned the key, and it turned over but wouldn't start. I can audibly hear the fuel pump come on for a second or so, and feel the vibration when I put my hand on it, but there is still no pressure at the fuel rail.
I have a 99 voyager that has started making a whirring sound this last week. The water pump, serpentine belt, tensioner have all been replace several months ago. The battery light came on for about a minute and then went off the last night. I checked the voltage with the engine running and it measured 12.5, the same as when it is off. When I revved it up the voltage went up to 14.4 volts. Is this normal? What could be making the whirring sound?
View 2 Replies