Caravan/Voyager :: 1995 Plymouth SE Transmission - Only Go In First Gear And Never Come Out
Jul 24, 2012
I have a 1995 Plymouth Voyager se about a year ago the transmission started acting up, for no reason, it would just go it to First and never come out I would stop turn it off turn it back on again and it would be fine..then days later it would go by, it would do it again. it did this for a while and the good days would turn in to a mile or two then it just decided not to come out of first ever, during this, i took it to a trany shop and rebuilt the transmission it worked for a bout a half hour.
Final a mechanic friend checked the computer again and changed it out with another and it fixed it beautifully!!! ok well about a week ago a very odd loud obnoxious squeal started that sounded like a bottle rocket but not all the time, more often than not though. Before I got a chance to take it to my mechanic friend i was driving along and the transmission slipped in to first and wont that's it. i have been doing emergency trips in first gear and also the horrid squeal is gone. the thing have to be linked what should I try and i don't think its the computer, I really don't want to lose my van
View 2 Replies
Advertisement
I have a grand voger 1995 and my transmission is not shifting up it stay in one gear. Why does it not shift and is it a easy fix?
View 17 Replies
1st problem is shifting from 1st to 2nd and sometimes from 2nd to 3rd though, 2nd to 3rd is not as bad as from 1st to 2nd. It stumbles and gets really bad if I don't let up on the gas. After the initial shudder it will go into 2nd just fine. I also have to gun the gas a little bit when I first start the car, or it will just sit there and idle and never go into gear.
2nd and more annoying is that it stalls after driving around a bit. It happens on freeway or city. It doesn't stutter or anything the rpm's drop to 0 and it just stalls and won't start up for a 5 - 10 minutes or so.
Codes pulled are P0731, & P0736. The transmission was replaced about 2 years ago with a refurbished one. Could it be going out again already? The guy at Autozone suggested replacing the TSS (Transmission Speed Sensor?) to see if that was the problem. I have not done this yet, but plan to.
View 3 Replies
I recently bought a used 1994 Plymouth Grand Voyager. The other day I went to start the van, and nothing happened- it clicked, and all the lights and horn were functioning, but it wouldn't turn over. I got under the car and found that the starter was hot, so I went to the auto parts store and bought a new starter. I put it in, and drove it home, and all was well. The next day I got on the highway and discovered that the van would not get out of limp mode- it wouldn't shift into a higher gear and the RPMs were building higher. I got off and took side streets home.
I disconnected the battery for a good while and re-connected it, and things were fine for a short while, but it developed the problem again.
I intend on checking the relays under the hood, checking electrical connections, and getting a trans fluid change soon. Is replacing the starter at all related to the limp mode issue?
View 2 Replies
I have a 2002 Town and Country LX with the 3.3L V6. Recently the check engine light went on and later the transmission stopped shifting from 3rd to 4th gear. All the gears work properly except for 4th. It doesn't seem like anything is wrong with the transmission, would this be a sensor problem? If so which sensor would need to be replaced?
View 14 Replies
1997 Plymouth Grand Voyager SE 180K 3.3L
I read other threads about the connections under the hood, both sides, which I unplugged and replugged. I also pulled the IOD fuse for a little bit. Then I removed the cluster and looked it over. Looked good to me.
Got code P1698 for manufacturers assembly control or something to that effect. Thought I checked all the usual culprits. The dash lights work fine, so does everything else. The dash gauges just don't work. This is something that has been an intermittent problem with the dash gauges going out periodically when hitting a bump. It leads me to believe a connection. But I checked all those.
View 14 Replies
My boss bought me a van, so we could start a detailing business, anyways, we got the van for . Not bad inside, and ran ok, boss didnt notice it wasnt shifting i guess. So it went straight to the shop, got new brakes, rotors, belts, plugs, and oil change. Boss did transmission flush on it to see if it would work, he said it shifted into second for him, but when i was driving home. It would not shift outta first gear.Check engine light is on. It is an automatic. I dont know what to do now,
View 1 Replies
I am looking for some engine code one is 35,21,32,and 55 it a grand voger 1995. I been having transmission problem it will not shift up I been told it might be a speed sensor. My rpm seem to jump up down when it idle.
View 2 Replies
Changed input and output sensor, replaced solenoid pack, cam and crank sensor. Runs good code on odometer 1684 p700.
View 4 Replies
MY gc started cutting out a few weeks ago while idling in gear. I changed out the four plugs I could get the wires off. It's a v6. It started running better for a couple of days. I need to know of any way to get the stuck boot off. I also have a feeling there is something else wrong. Anything else that might be causing it to cut out. It has progressed to cutting out while going down the highway.
View 4 Replies
Since there is not dipstick for a 2008 GC with six speed transmission, how much transmission fluid goes back?
View 2 Replies
My transmission is slipping when the engine is cold. Fluid levels seem fine. I do have a fluid leak that I monitor and add fluid when needed. It's an 05 touring with 167k miles.
View 1 Replies
I have a 91 Grand voyager and it seems to be loosing transmission fluid somewhere but no puddles anywhere.It looses between 3/4 and 1 quart a month an shifts fine. Where could this be escaping at as I drive it? What do I need to look at since its not dripping anywhere an I snugged the pan an didn't see it there?
View 3 Replies
I just replaced the transmission in my 2000 3.3L Grand Voyager and now it won't start. It started fine when I drove it into the shop. The battery is good, the cables are ok. The starter worked good up to this point. I checked all the connections to make sure they are tight. I replaced the transmission because reverse went out.
When I turn on the key, the shift letters (PND32) appear on the instrument panel, but the little circle that shows what gear it is in does not appear. When you turn the key to the run position, the circle should be around the P to show it is in park.
When I turn the key to start, nothing happens. No clicks or anything. The next thing I am going to do is see if there is power to the starter when the key is in the start position. Where to start looking?
View 14 Replies
The gear shift works fine, and we lifted the hood and saw that the mech. arm IS working when we shift. However, the van will not move into any gear. won't go forward, reverse, etc... it acts like it isn't shifting.
i was driving down the highway, and noticed it wasn't accelerating and stepped on the gas.. .and nothing. I stopped the van, put in park, turned it off. Started it again, and put in D and wouldn't go, just engine revved. then put in reverse and same thing... didn't move but engine revved.
View 3 Replies
My 2000 dodge caravan with the 3.3 is shuddering while in gear and not moving especially in reverse . As soon as you start going it stops . No slipping whatsoever. The van only has 130'000 miles on it .
View 2 Replies
I am experiencing a very frustrating shift anomaly. 2003 T and C . Under certain throttle conditions ( usually light ) from a dead start I am feeling a bump/violent shudder between the 1-2 transmission shift. If I let off the gas, I can get the shudder to quit and then by continuing to accelerate , successfully complete the 1-2 shift.
Does not happen all the time and never under straight ahead med-hard acceleration. By nature , happens most of the time under light acceleration when turning a corner from a dead stop. Sort of feels like a loss of traction or something funky happening with the torque convertor. Have serviced the trans with new fluid and filter, new TPS, new plugs, wires, and coil pack.
View 1 Replies
I have a problem with our 97 Grand Caravan, (3.3L, 41TE tranny) Its a vibration that seems to be coming from the passenger side CV Axle.... the transmission side of the universal joint on the new axle.
We started having problems with this in December, I've done most of the work myself but still had the problem... Vibrations that seem to start and get worse at around 35 - 55 MPH. I've replaced rims, wheel bearings, both cv axles, tires, brake pads & rotors, sway bar links and bushings, tie rod ends, (inner & outer) and ball joints. (about $1,200. in new parts & tires)
In April, I finally took it to several transmission shops and talked to the operators.... The shop I chose because I could relate to the owner and felt I could trust him. The wife and I knew it was a vehicle we couldn't replace for the price of a transmission overhaul and when the shop called and told me all was fixed by replacing the new cv axle on the passenger side I was ecstatic that the problem would be fixed.... I go ahead and rebuild the transmission anyway, (now @ 289,000 miles!) .... The wife and I want to get as many miles out of this thing as we can at this point and our daughter will be driving it to high school next year.
Anyway, I get the car back late on a friday evening.... by the time I got it home I knew there was a big problem.... I put it up on jacks in the garage and saw the passenger side axle was "Slamming" in and out of the transmission!!! I test drove it on a few more short trips and took it back a week later.
About 1 1/2 weeks later I get a call and the shop owner says it is the CV axle thats bad.... AGAIIN??? Lets see, I replaced the original axles. Then "they" replaced both axles after I returned the ones I put in for warranty (Autozone) and now a 3rd axle is bad too? He insists on a different brand of axle (Napa). So when I get the car back, I again am feeling some vibrations.... not nearly as bad as it was before, and put the car up on jacks again.
This time, I don't see the axle slamming in and out of the tranny but I see the vibration comming from the trany side of the CV axle. (passenger side axle again) and I notice some grey goop on the housing fitting that wasn't there before on the trany.... This is when I started having my doubts about the shop and what they are telling me. They just replaced the axle, didn't do anything in the tranny. To beat all, theres now a fluid leak somewhere and its staining the garage floor.
Its been over two weeks now and the shop owner called me to tell me that its again the passenger side axle thats bad and that its a seal somewhere tha'ts leaking so he's gonna have to pull the tranny to get at it. I told him what I saw when I put it up on jacks in my garage.... the vibrating CV axle on the passenger side of the tranny.... He assures me that if it were a bearing it would be making some noises. He's even sent the car to a trusted tire shop and they turned the rim on the tire or something.... he's doing everything he can to make sure the problem is taken care of.
I know what I saw under the car. Just the "passenger side" axle as it is coming out of the transmission housing is moving up/down/around and that's where my vibration is coming from. The end of the axles (tire side) were running true. What's involved in repairing the differential side bearings in these tranny's? I'm going fully loaded to the Transmission shop when its ready and I'm going to insist we look at it while its on the rack. I just need to know how to check these differential side bearings.
View 14 Replies
So here I am with my 1996 Dodge grand caravan that I purchased new in 1995 for a whopping 30k. Yeah hind site is 20/20 skip forward to mile 102k transmission fails completely. Had to have it towed in to shop, rebuilt tranny put in... skip ahead another 4 years to mile 173k and transmission fails again. Again on a tow truck to the shop and ANOTHER tranny rebuild. So now I am at mile 182k and transmission is making a horrible shudder and I have moved across the country away from original shop that did last trans repair (who says they only warranty if I come back to them) and I am possibly looking at another repair or replacement. What is the deal with these vans?
View 4 Replies
I purchased a 2004 Chrysler Town & Country Dec 2003. I noticed an intermittent problem with my gear shift indicator lights PDRNL were all lighting up when I would start the vehicle in February 2004. I would have to play with the shift lever a few times to get it into gear.
On Feb 26, 2004 the vehicle would not start at all, would not even turn over. The vehicle had to be towed to the dealership. It had 3500 miles at the time. The error code was PO706 check shifter signal. They said it was the transmission range sensor and replaced it. I had no problems for 2000 miles until I was in northern Michigan and the gear shift indicator lights started doing the same thing.
I brought it to a local Chrysler dealership the next morning and they scanned the following codes PO1791 loss of prime PO705 check shifter signal BCM stored TCM message not received FCM stored TCM communication fault DSD stored incomplete power voltage. This dealership checked connections and wiring harness which were okay so advised me to take it back to my dealership at home since they would have to tear the whole van down to figure out what was wrong and any parts they would need would not get there before I left for home.
Luckily, I made it home with only one incident with these lights coming on. My dealership had the same error code PO706 and also PO444. Here is what their repair order states "DTC PO706 shift signal fault. Front pump allowing torque convertor to bleed down IPM internally shorted causing intermittent shift signal errors and PO444 and PO706. Scan and perform trans diag and fluid level full R & I the transmission R & I the pan and valve body replace the filter R & I the front pump and replace the front pump and torque convertor called STAR about intermittent loss of shift signal was told to replace the IPM. Replace the IPM (power distribution center) retest ok at this time."
So here is my question....I am very worried with all that I am reading about transmission problems and this van has only 6500 miles and all these parts that they have had to replace already is really scaring me!
View 14 Replies
I have a 2008 GC 6 speed transmission that has 55000 miles on it. When the engine and tranny is cold the transmission shifts very hard until it warms up. There are times when shifting from reverse to drive it shifts very hard. Also, the siding doors creak when driving over rough roads. Can they be adjusted?
View 2 Replies
