I have to over rev the engine to get the van to move. After that the tranny seems to work fine. Tranny fluid level is OK, and it does not smell burnt. After I over rev the engine to get moving, the engine revs seem to get back into sync for the speed I'm doing - usually just as the van starts moving, the over-revving is no longer there. Do I need to adjust the bands??
View 2 RepliesI have a 2003 Chrysler Town and Country and my problem started with no reverse after starting car. If I pushed it back and drove forward 10 or 15 feet then reverse would work fine and shift properly. As long as I could drive forward first then reverse would work. This was like this for a few days then the vehicle wouldn't move at all. There wasn't any error codes. The fluid is full and clean.
When the van was about a year old I took it to the dealer with harsh shifting and they said there was a broken wire to the trans, I am thinking this is when they came out with the 3 wire slice people where talking about.
I wasn't needing the van so it has been sitting now for almost a year. Now I want to get it working again...
The gear shift works fine, and we lifted the hood and saw that the mech. arm IS working when we shift. However, the van will not move into any gear. won't go forward, reverse, etc... it acts like it isn't shifting.
i was driving down the highway, and noticed it wasn't accelerating and stepped on the gas.. .and nothing. I stopped the van, put in park, turned it off. Started it again, and put in D and wouldn't go, just engine revved. then put in reverse and same thing... didn't move but engine revved.
I recently bought a used 1994 Plymouth Grand Voyager. The other day I went to start the van, and nothing happened- it clicked, and all the lights and horn were functioning, but it wouldn't turn over. I got under the car and found that the starter was hot, so I went to the auto parts store and bought a new starter. I put it in, and drove it home, and all was well. The next day I got on the highway and discovered that the van would not get out of limp mode- it wouldn't shift into a higher gear and the RPMs were building higher. I got off and took side streets home.
I disconnected the battery for a good while and re-connected it, and things were fine for a short while, but it developed the problem again.
I intend on checking the relays under the hood, checking electrical connections, and getting a trans fluid change soon. Is replacing the starter at all related to the limp mode issue?
I have a rather peculiar problem with My 1994 Dodge Grand Caravan 3.3L. This has happened multiple times spread out over the last 10 years. Every couple of years after a rather long drive, then a stop, it spits, sputters, has very little to no power, and will ultimately die. It will usually start right back up, idle fine, but when you shift into gear, it acts up as described. If you let it set for about 15-20 minutes, it will usually start up and run fine without the symptoms as described.
The First time it happened I was lucky enough to be within a mile of the dealer, who diagnosed a bad fuel pump before it was ever on the lift. He showed me what he said was the culprit, which was a fuel filter that was full of black particles and soot. He replaced both the pump and filter and it ran fine for a couple of years and it started doing the same thing. Another new fuel pump and filter and we're running again (all under warranty).
About three years ago it did it again and this time we went to a different dealer and since we were no longer under warranty, we wanted to know what was actually going wrong. Nothing was ever found, no codes, pressure was good, everything looked fine. No problems until today when it started again, no dash or check engine lights, it just wouldn't run. We let it sit for 20-30 minutes and started it right up and drove it home without incident.
Are these vehicles known for vapor locking? It sure acts like that is what it was doing. The temp wasn't that hot and was ruled out as a factor.
I am planning to put a new fuel filter in it?
Turn wipers on and motor growls but wipers do not move, checked 30 amp fuse and it is good, all other functions of the multifunction switch are good.
View 2 RepliesI start my van and open the hood to check Coolant and I notice gas spilling out engine and running down the side close to my power steering pump. So I stop the vehicle and notice gas sprayed on different parts by the back spark plugs and a little area by sensor.
View 3 RepliesI was riding down the interstate this morning and had my cruise control set at 70mph. all of a sudden the cruise just turn off. I went to hit the gas pedal and there was nothing. No check engine light or anything, no spit, no sputter. I pulled off the side of the interstate and attempted to start the van. the engine turns over fine, but no start. all lights, radio work fine. car has fuel. it did not run hot.
View 1 RepliesI have a 2005 dodge caravan and today after taking my kids kids to school, I noticed white smoke coming from the hood of the engine. I managed to get home and check it out. With further inspection, smelled like some type of fluid is burning off I can't tell if it's oil or anti freeze. There seems to be some type of condensation in the inside of my van on the passenger windshield. I looked to check to see any leaks inside on the floor mat and underneath the van itself and nothing. What seems to be the issue?
View 6 RepliesMy transmission is slipping when the engine is cold. Fluid levels seem fine. I do have a fluid leak that I monitor and add fluid when needed. It's an 05 touring with 167k miles.
View 1 RepliesI have a 1998 Caravan and the engine cooling fans wont go on. Ive replaced the relay and the temp sensor. When I pull the connector off the temp sensor the fans go on so I know the fans and fuses are fine. For some reason it seems the computer module isnt sending a signal to the relay to turn the fan on. I get the trouble codes P1491(radiator fan relay circuit fault) and P0118(engine coolant temp circuit high input).
I am also having a problem with the air conditioning not working. When I do the self diagnostic test on the A/C the results are that it fails the cool-down test. Why the computer module isn't sending a signal to the relay? Could the A/C problem be causing the cooling fans not to come on?
We have a 2012 Dodge Grand Caravan and has a whistling noise when starting up? We are in Wisconsin and its damn cold. It only does it when its cold out. Once the engine warms up it goes away. But my wife is freaking out about it. I am thinking it might be something with the air intake but not sure.
View 3 RepliesI did a tune up on my 3.3L Dodge Grand Caravan only to find the engine is vibrating heavily. This tune up included a new coil pack, plugs and wires.
I did happen to notice a separate thing when looking at the Crankshaft Pulley that it seemed to be wobbling while the engine was running.
I have a 99' GC and just changed out the EGR valve. Now the engine cuts out when you brake or get to a low speed. Idles a little rough also.
View 7 RepliesWorking on a 2001 caravan. Been sitting for about 6 months with no battery installed. decided to work on it. Got a new battery, and when I connected it the alarm went off. I dont have panic button for it so I unhooked the bat.
I think I hooked the bat back up with the thicker gray key in the ignition. I think that is the key with the chip.
The alarm did not sound but the engine will not crank, seems like it it in some security mode blocking start up. I tried cycling the key in the driver door but that did not work.
I have a 1997 Voyager that I am having a thumping noise that is coming from a black module that is mounted in the engine compartment over the passenger side fenderwell. It has 2 vacuum lines and an electrical connection coming off of it, one of the vacuum lines has a tag on it that says EVAP. The engine seems to be running fine, although every now and then it seems like it might idle a bit rough, and there are no CEL on or codes in the computer. Don't know what is this module called.
View 3 RepliesMy check engine light came on today and while driving, the idle (RPM's) were very high. At about 80KMs, it was about 3500 and when I accelerated, the engine would race along with the RPMs. While stopped, idling seems fine. I couldn't get over 80KMs/Hr without the idle going too high.
What it could be? Haven't had time to check codes as it is long weekend and garages are now closed till tuesday.
I had to replace the water pump on my dodge Grand Caravan, which was challenging, but I got it done. But now the engine light is on.... why would that happen? I did take off the filter hose, and unplugged the cord to move the air filter housing, but I plugged it back in when i re-hooked everything up. So now I am nervous that i did something wrong. Why the engine light would come on and stay on? water pump works, put coolant in etc.... no leaks.... so now i just need to figure out the engine light.
View 9 RepliesI was able to quickly diagnose the problem with our 99 T&C LXi w/3.8L.
Problem: No speedometer, wouldn't shift, check engine light came on.
Many posts suggested speed sensor. There are actually 2 of them. An input and an output. Both cost approx $20 each.
By removing the aircleaner box assembly, I had the best (relative word) access to the sensors. A 1" socket w/3" extension did the trick. I understand the access for 2000+ models is different.
Dodge Grand Caravan 2000 3.0L
First, sometimes the engine began shuts off. When the drive up to the traffic lights. When sharply throw gas pedal. When the engine speed is less than 2000. If you release the gas pedal, you will see that the tachometer needle drops below 500 rpm and the engine stalls. This happened happened two or three days all right. And sometimes a day, 3-4 times shuts off. Then ringing under the hood.
Was the flywheel. I remove the transmission and replace the flywheel. More repair parking brake pedal. So it turns analyzed under the panel. I have a new problem. After repair. I driving my Dodge week. And once. After an overnight stay the machine, on morning the engine not start. I checked the spark. The spark is. I removed the fuel hose. and there is no pressure. Just a little bit of fuel.
I decided that this is the fuel pump. I took off his tank, bought a new fuel pump. The pump has not changed. Today I decided to apply voltage to the old pump, it still stands in the tank. It works. Buzzing. Then I decided to check the voltage on the connector. I turned on the ignition. The instrument appears briefly on 12 volts. They are only momentary. Now I think there should always be 12 volts? Fuel tank removed. All hoses are disconnected. Not really the problem in the fuel pump? How to troubleshoot? Where can I get the wiring diagram?
I have a 97 dodge caravan engine 3.0. When I start to accelerate my engine fuse 20amp blows. I does not occur every time but yesterday, it did it 6 times and is now getting looked at. I am just curious on what causes this. I did recently have my spark plugs changed so I am thinking something may be arching.
I do have codes that previously came up for my fuel injectors (P0203, p0206). Another code I have is p1294 idle speed performance.