Caprice :: 1994 Chevy - Motor Turn Over Like 3 Or 4 Seconds Before It Fire Up
Jun 27, 2012
94 Chevy Caprice. LT1 turn over too long before it crank. The motor turn over like 3 or 4 seconds before it fire up. What's the problem?
View 5 Replies
Jun 27, 2012
Advertisement
GMC - Suburban :: 1994 - 30 Seconds Of Loud Clicking Coming From Blower Motor On Startup And Shutdown
First bit of cold weather and I'm getting thirty seconds of loud clicking (or clacking) coming from the immediate vicinity of the blower motor on start up and shut down. Doesn't matter whether my climate control is on or off, it still makes the noise. I'm assuming it's stripped out teeth on one of the blend door actuator gears and I'll probably just end up replacing it. My problem: Where exactly is the offending actuator? I've removed the glove box and noted one located on the left side. I unplugged this but am still getting the ratcheting sound so it obviously isn't the culprit. I had this happen a few years back (same time of year) and out of ignorance and frustration solved it with a well aimed kick but the way it's acting this time I don't think I've got a big enough boot.
View 4 RepliesCaprice :: Whenever Switch Off Chevy 2006 LTZ After Running With AC On Does Not Start
I have chevorlet caprice 2006 LTZ, whenever I switch off my car after running with AC on (means heat shows 50%) does not start. It simply cranks up but does not start,I try 3-4 times it starts, everything works fine . It starts perfectly in morning or after idle for long time. What stops the start, is it the fuel pump? I did computer scan but nothing detected.
View 6 RepliesCaprice :: 1992 Chevy Wagon Transmission Will Not Accelerate At All When In Reverse
I am having an issue with my transmission. Mine will not accelerate when in reverse, at all. When I take off in overdrive, the car revs up really high until about 30mph and then finally shifts and seems to drive normal at about 45-65mph,after that the car revs really high up to about 70mph (then i slow down). No problems with gear 1 and 2.
View 1 RepliesChevy - Caprice :: 1989 Transmission Slips Completely In All The Forward Gears
Last night transmission in my beloved '89 Caprice Wagon let go, it slips completely in all the forward gears. I was coming down a long hill using low gear for several minutes and when I put it back into OD at the bottom it seemed to skip a little but it was still making power well enough. I got off the freeway at my exit and stopped at a red light, when the light changed I was revving high but barely creeping through the intersection. I pulled over and this is what I figured out:-All the forward gears make essentially no power any more.-Reverse seems to work normally.-The fluid is at a normal level and not discolored or burnt smelling.
I don't know if this is related or just an amazing coincidence but the water pump also seems to have blown the gasket at the same time. I must have just happened within a few minutes of me pulling over because there was still a ton of coolant left and the temp was still in the normal range. I don't see how they're related but, like I said, the timing is too coincidental. Earlier this week but just a few miles ago I also topped the power steering fluid and oil.
It's a 200-R4 transmission, is it toast? Why does reverse work but all the forward gears slip completely? Is the water pump just a red herring? I did drive the rest of the way home in reverse.
Caprice :: 1994 Doesn't Start At All Just Cranks
I got a caprice 94 l99 it was driving perfect. i was on my way home then it started to put put then the engine cut. gave it like 3 mins it started drove 1 block started to put then the engine cut. now doesnt start at all just cranks the gas gauge says it has 1/4 tank of gas.
View 5 RepliesCaprice :: 1994 Engine Cuts Off After Driving For A While
I am having problems with my 94 Caprice. It will start right up when cold. After driving for awhile (not too long) then engine cuts off. Electric power is on but the engine is off (like it ran out of gas, or the gas was shut off). At first, it would take a few minutes for the engine to restart. Now that I have replaced the Fuel Pump Relay, it will start right back up, but when driving it still cuts off.
Could it be the ECM? Where is it located? Is it a "do-it-yourself" job?
What other problems might it be (besides the fuel pump)? Could it be the power distribution box under the hood? I also have fog lamps hooked up to the panel that wont work. The switch light comes on but the lamps do not. I am going to try to hook the (+) up to the battery and see if the lamps get power, if so, the box is fried (or the stud) But if the main power distribution wasnt working would the car still run, start? If the stud is damaged would it cause the gas to shut off?
Chevrolet - Caprice :: 1994 - Leaking Coolant From Heater Hose?
The leak looked like it was coming from a heater hose. The individual I bought it from said he fixed it and it wasn't leaking the day I bought it. Upon driving it home...cranked the heat up and windows fogged, switched to defog with no luck. Added some coolant and still the same thing and leak began again.
It smells like antifreeze inside and fog has oily feeling when wiping it off the window. Got in on the lift and no luck seeing where it was leaking from, even with it running. My previous experience with bad heater cores is that it leaks on the inside and smells like coolant... is it leaking on the outside or is it something else?
It's NOT overheating or blowing any kind of smoke. Temp gauge read normal! It's a 4.3L, 1994 Caprice LS .....
Ford Super Duty (1999-2016) :: Motor And Exhaust Bog Down For A Few Seconds When Turn On Heat
I have a 2001 f250 5.4 that when you turn the heat on the trucks motor and exhaust bog down for a few seconds then comes right back up...
View 4 RepliesChevrolet :: 1994 - Chevy S10 Leaking Oil
I have a 1994 Chevy S10 truck. I been having some problems with it.I was having transmission issues with it (I posted on that one before) , but now it has started leaking oil and I would like to know why. The color of the oil in the oil leak is dark brown and oil gauge is giving me odd readings. For example, when I start the truck the oil gauge says it is half full (40), but it warms up and I am in stop and go traffic it drops to 20. But, If I step on the gas the reading goes back to 40 again for a while and then drops back down again. I thinking about just getting a different truck because this one is becoming a pain to fix, but I would still like to know what could be wrong with it.
View 3 RepliesC/K :: Code 43 On 1994 1500 Chevy - Rough Idle
I am doing a side job and this thing has a rough idle. I put the scanner on it and pulled code 43 ESC and a ritch and lean code from the O2 sensors. I know the O2 codes are probably from running rough. It has been a while but could the knock sen be the problem or the ESC itself? I looked for the ESC by the throttle body but didn't see it. I remember what they look like but this is a late model 94 are they some where else?
View 4 RepliesSilverado :: 1994 Chevy - AC Compressor Engages But No Cooling Really At All
The issue I'm having is the A/C. When I got the truck the A/C was completely freezing. Recently however, the compressor was having issues not engaging and I fixed that by simply plugging the cord to the accumulator thing. . Now the compressor engages, but is not cooling really at all. It is an old truck and the compressor is a little worn from what I see maybe 2mm space when not engaged. I checked the levels of freon/coolant with a gauge and the amount is perfectly fine. Plus there seems to be no leaks.
View 1 RepliesLumina :: 1994 Chevy 3.1 Stalls When Put In Gear While Engine Warm
A week ago, driving home, the tech started to drop quickly to zero then recover, like the ignition was turned off and then back on. I was able to make it home. The car was due a tune up. I replaced the crank position sensor (OEM), replaced sparkplugs (Autolite Iridium), air filter, fuel filter, no luck. I ohmed the coil packs, secondary resistance showed good, replaced the ignition control module (aftermarket). After this, engine would stall after it was at temp, could restart, once put in gear it would stall, but I could go in reverse and drive home backwards.
Reinstalled original OEM ignition control module. Towed to GM Dealership, mechanic said fuel pump was bad, ignition wires needed replaced, one injector ohmed bad. I took car home, replaced fuel pump (OEM), ignition wires (OEM), no luck. Removed plenum, found pcv valve clogged, and hose kinked, replaced both, ohmed all 6 injectors, 5 injectors read 12.3 ohms, 1 injector was 11.6. Replaced all 6 injectors, (Napa), plenum gasket, still same problem.
GM dealership said computer said no data, they though perhaps ignition control module was bad, but I don't think so. I hooked up my Actron shorting plug, reads code 12 which means no faults, no other codes. I noticed EGR valve has a lot of carbon in the hole, thought about changing it, but I'm really not sure where to go now. The car is a 1994 Chevy Lumina with 230,000 miles, spent about $500 the last week doing brakes, and trying to fix this engine. Where to go from here.
Caprice :: Replace The Turn Signal Switch On 91?
needed to replace the turn signal switch on my 91 caprice. when reassembling i could not seem to get the steering locking mech to engage the way it should. I would like a diagram or photo illustration of the correct position of those parts.
View 7 Replies95 Chevy S10 TBI (Z Motor) Intermittent No Start When Cold
I have a 95 Chevy S10 pickup with the TBI motor, Z engine code, that has begun to not start on occasion. The engine cranks but does not fire at all everything else seems normal. This only seems to happen in the morning so might be cold related. If the truck starts I can drive it all day without any starting issues.
View 9 RepliesCorolla / Matrix 2009-13 :: Fire Up / Run For A Couple Of Seconds And Cut Off
I have a 2009 corolla with about 125,00. I bought it used about two years ago and it has been trouble free. This morning when I went to start it, about 29F with heavy frost on the windows, it would fire up run for a couple of seconds and cut off. I id this probably 20 times and gave up. I called a neighbor to take me to my bus and thought I would try it one more time. fired right up and stayed running. Also started right up when I tried it later when I got back from work.
View 2 RepliesPassat (B5) :: Small Fire Appeared On The Side Of Motor
Battery died, i jumped it, couldn't keep it idle, revved it for a little while, a small fire appeared on the side of the motor. the fire died on it's own and im not going to start it again. If you are facing the motor it was on the left hand side by the passenger side wheel. I don't know whats down there or what could have happened but I'm just weighing my options at this point.
1999 Passat Auto V6 165k all options...
Ford - Mountaineer :: 2000 - Engine Cranks Normally But Taking 5 - 15 Seconds To Fire Up
My problem is with a 2000 Mountaineer V8. Once a year I have to replace the battery after the first cold snap due to low cranking amps. I can simply hook up a battery charger and it will crank and fire. My second problem is most likely related. When I replace the battery it will kick off like a brand new car with no hesitation. After a few starts it takes 5-15 seconds for the engine to fire while the engine cranks normally, and that's how it operates all year. After having this problem again this year (I've owned it 4 years) I've realized the underlying problem is not the battery. All the connections are good, and it has a good ground. No lights or warnings, and when tested with a handheld scanner there are no error codes.
View 11 RepliesVenture :: 1999 Chevy Motor Gets No Power And Lacks Force To Accelerate
The 1999 Chevy Venture I have doesn't get enough power from the motor and lacks the force to accelerate, was told it could be with the sensors? Which sensors and where could they be located?
View 2 RepliesSanta Fe (DM - 2013+) :: 2016 - Hard Starting / Taking 3 To 4 Seconds Of Cranking Before It Will Fire
On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
Ford Escape / Hybrid :: 2006 - Hard To Start Now Takes Between 3 To 8 Seconds To Actually Fire
Wifes Escape with the 3.0 has been progressively getting harder to start. It spins over just fine, but now takes between 3 to 8 seconds to actually fire. In the last six months the alternator, spark plugs, air filter have all been replaced. Engine runs perfectly, never stalls and seems fine in every other way. I've cleaned the throttle body and the IAC is working fine.
Did some troubleshooting and sure enough, we are getting no spark for a few seconds and the engine runs fine when it finally gets spark. Would this be the crank position sensor? Cam position sensor causing this? Not sure what is supposed to happen during the starting sequence in regards to what sensors are in being read by the PCM and then enabling spark.