Camry :: Installing XLE Bumper On LE For Fog Lights?
Apr 4, 2013
Is it easy, I see that LE Camrys are pre-wired for fogs.
View 14 Replies
Apr 4, 2013
Advertisement
Golf IV R32 :: Installing New Bumper - Screws And Nuts?
Brand new bumper came in without screws and nuts, it's ready for painting but i need the right hardware. (photos are simply for reference)
I want to keep the screws and nuts OEM meaning as close to as exact as possible without home depot or some lame arse hardware store, i'm talking about original VW if possible parts. Or at least the clips if anything at all. VW dealer hasn't supported much either, they just said go to Home Depot and buy some regular screws and u-nuts but I want everything as if it came straight off the dealership. I do not believe that all screws and nuts are created equal and where to get exact right hardware I need.
As far as I know the bottom needs 18 or so 5mm nuts and "u-nuts" that they screw into. And there's also the stock scoop, where to even start with screws on this one.
Prius C :: Installing Reverse Sensor On Bumper
I am installing aftermarket reverse sensors on my bumper , do i need to take off before drilling or should be ok if nothing is behind, how to remove the rear bumper.
View 5 RepliesCamry :: 2003 - Fog Lights Not Connected / Wires Dangling In Front Bumper
I see some wires dangling in the front bumper which looks like fog lights plugs but I don't get it so is it just plug and play buy a new bumper with fog lights or something? My car doesn't have fog lights but it looks like there is wires for fog lights.
View 10 RepliesCamry 2012+ :: Wiring Up Some LED Lights On The Bumper / Easy Place To Tap Ignition Power?
I bought a pair of LED strips that I would like to run instead of the DRLs. I want them to be on whenever the car is on. I don't have a wiring diagram, and I'm not sure where I can tap some power or wire up a relay to have them come on only when the car is on.
View 8 RepliesTouareg :: Installing Reflector On Right Rear Side Of Lower Rear Bumper?
How to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?
View 2 RepliesGolf IV / Jetta IV :: Installing Fog Lights
So i have been looking to get some new headlights with the projector housing but noticed that most of them have a fog light which my car does not have. I know in order to get them to work properly i would need the euro switch, but would i need to run additional wires through the firewall?
View 8 RepliesPassat (B6) :: Installing Bi-xenon Lights?
Putting factory bi xenon lights in new 2.0? Is it something that can be done?
View 11 RepliesPassat (B7) :: Installing LEDs On Dome Lights
I'm trying to install my leds on the dome lights. The back one was quick and everything but the front dome light cover doesn't want to come off. Only the passenger side one wants to pop out. While the driver side of the dome doesnt wanna budge. It seems like ts actually stuck to the inside of the compartment. It just doesn't wanna pop off all that i getting is scratches.
View 5 RepliesTiguan :: Signal Lights On The Front Bumper Are Not Working?
So I am looking at the signal lights (?) on my front bumper (2012 Tiguan SE). I see there are bulbs inside them but they are not functional. Is there any coding that needs to be done for this to work?
View 4 RepliesAvalon 2005-12 :: Lights For Buttons Won't Come On When Installing New Radio
Was installing my new radio and somehow the lights for the buttons wont come on when the headlights are on. Is there a fuse i can check? Where is it located? I checked under the hood but i didn't see a fuse for dash lights.
View 2 RepliesGolf/GTI VI :: City Lights Seems Dimmed After Installing LED Taillights
I had oem LED taillights installed to my car. Dealer coded the car to avoid error lights on dash. The problem is now the city lights under xenons look dimmed. Not as bright as before. I asked him why did it happen and he said that it's normal as it needs to balance the current flow to supply enough power to the LED taillights. I'm not satisfied with this answer though.
View 3 RepliesGolf/GTI VI :: 2011 - Installing Missing Footwell Lights
I just took delivery of a new 2011 golf and noticed the footwell lights were absent, presumably because Canadians always seem to get shafted. I would like to hear from other Canadian golf owners before going to the dealer.
If absent footwell lights are indeed standard for Canadian golfs, I'm thinking about installing them myself. I found a link on another site that details the install on an MKV : [URL]...
Sonata I45 (YF - 2011+) :: Clip Broke Off Installing HID Lights?
So I was installing my Hid's and the clip broke off, clip still in tact but the part that it's held in where the screw is at is gone. What can be done about this?
View 6 RepliesGolf V R32 :: After Installing Lights Getting Bulb Out Error Message?
I installed the lights and they work fine but everytime I turn them on they throw a bulb out error message. I have the cold diagnosis turned off for the fogs and I still have it. Whats next?
Here is my coding. F78F8F2700041500470F0000000000000018110B5C00010000 0000000000
Camry :: Installing HID In Headlights Low / High With DRL?
I am looking to install HID lights into my headlight. Successfully i have installed the regular hid into the headlamp for regular use lights. Now i have a question on the high beam which is together with the Drl. Do i have to get a bixenon kit for this socket to get the drl running and the high beam when selected? Or can i just install a regular lo/hi hid. And will it send low output for the drl and then when selected for the high beam it will function as it should?
View 14 RepliesCamry :: Installing Engine Air Filter?
I got a new frame engine air filter as recommended by the book, tried to install and the cover will not close properly.
View 2 RepliesLexus GX 2004-09 :: Black Out Tail Lights And Reflectors In Bumper?
Today i blacked out my tail lights and reflectors in my bumper using dia-wyde spray. Here are the results of this...
View 7 RepliesGolf IV R32 :: Front Parking Lights Won't Work After Installing Euroswitch
Installed the euroswitch yesterday because I want the parking lights to work in the front. All the lights work except for the front parking! In the second click I have the rear but no front. Am I missing something or do I have a bad euroswitch?
View 12 RepliesElantra XD (2001-06) :: 2004 GT Dashboard Lights Not Working After Installing Car Kit
Just install a car kit for buddy's 2004 Hyundai Elantra Gt. Installation went fine, later that night he noticed that his dashboard lights stopped working.
Checked all the fuses an they seem fine, checked to make sure we connected all the plugs, all connected. Even swapped out the cluster fuse with another new fuse an same results no lights.
What could cause the lights to stop all of a sudden?
Touareg :: Check Lights Warning After Installing Smoked Tails
Just installed the smoked tail lights on my '07 Treg. Installation was very easy per the instructions on OEMplus. I did a great job from that standpoint.
Got one issue, I check the 'Check Lights" warning and I think its due to the fact I tested the lights before I had all the new ones installed and hooked up. Do I need to take it to the dealer to have something reset via a computer or will the check light go away with some driving, which is what the dealer said.