My Camry XLS have pulsation when brake pedal is applied. The pulsation get increased with the speed and very noticeable at 60 -70 mph.
Is it front or rear break issue ? If you think rotors has to be re-surfacesd should I also change pads ?
My car is a 2004 Toyota Camry LE 2.4L. I've been having a brake pulsation problem with my car for few months. I feel the vibration on the pedal and also on the steering wheel when I brake at high speeds. And also I feel like the pedal goes too low and not responsive enough.
So I took the car to a local shop 3 days ago and they told me that the front rotors are bad and have to be replaced. They installed new Wagner front brake rotors and pads. But still I get the same problems described above. Today I drove on the highway and got the same vibration both on pedal and steering when I apply brakes.
I have a 2007 Toyota Camry 4 cylinder and the ABS light comes on intermittently. Not only does the light come on, but sometimes when I apply the brakes, the brake pedal makes a grinding, vibrating sound that I can hear and feel under my foot, and feels as if the brake pedal is going to go all the way to the floorboard. If I quickly pump the brake, it stops that sound and the brake works fine.
I have taken the car to O'Rileys and Firestone and they put it on the analyzer. Two codes come up which indicate that the right front ABS was bad and/or an open circuit. I replaced the ABS sensor, but the problem described above persists. I took it back to Firestone and the same codes displayed. Firestone said it was an open circuit and that I should take it to the Toyota Dealer. I called the Dealer and they want $135 to analyze the car. They won't tell me what they will do in the analysis. I also took it to Just Brakes and they kept it for 3 days and could not or did not do much other than suggest I take it to the Dealership. I have read that the Dealership will probably say the ABS computer needs to be replaced ($1,000). I have also read that the 2007 Camry Hybrid ABS brake system has been recalled, although my Camry is NOT the hybrid.
There has had two fender benders on the left front side and the right front passenger tire hit a curb which bent the tire, but the tire has been balanced (not sure if the wheels were damaged in these minor accidents or if the wheels could be causing this?) Other thing that occurred right before the ABS light started coming on, and the brake issue, is that the air conditioner went toes up, and there were small metal fragments within the air condition housing unit. I replaced the whole A/C unit. I haven't been able to assess if one would have anything to do with the other, but it is interesting that the ABS and brake issue all started within a few days of the A/C unit being replaced.
I noticed a pulsating feeling when I applied the brakes in my 2001 Ford Focus. I figure that it might be warped rotors, but after driving the car for a while, it seems to have dissipated. The car was sitting around for a few weeks. I read that it could just be rust buildup, but I feel that would require more than a few weeks of sitting around. Is there any way to check for myself, short of taking off the rotor?
View 3 RepliesI have two Hyundais - 2011 Sonata SE and a 2008 Santa Fe Limited. here is my problem with the Santa Fe.
Brakes: Changed front rotors and pads - rear had the rotors resurfaced and installed new pads. Still get a lot of pulsation when stepping on brake pedal. Is there anything else I should be checking?
Ever since I took my 18" wheels off for the winter and put the stock VW 16's with snow tires I have on multiple occasions almost rear ended the car in front of me when I experienced what seemed like a loss of brake pressure. The brake pedal did not feel spongy or anything but often in this situation the abs brakes seem to kick in for no reason. I feel a slight pulsation in the brake pedal which I can only assume is an activation of abs. I'm wondering if this slight pulsation (1 second duration ) is causing my brakes to be less effective. The pavement has been completely dry and I was not traveling fast enough, nor pressing the brakes hard enough to cause the tires to lock and trip the abs.
View 4 RepliesI had a front brake job done on a 2002 Dodge Dakota pickup at 85000 miles. When I stepped on the brake, I felt pulsation in the pedal and a sort of wobbly feeling in the steering wheel. Also the brakes were making noises while driving. Classical sign of a warped rotor?! Long story short brand new rotors, brake pads and calipers, later the pulsation is mostly gone but the braking is still not smooth at one point while the tires are turning. Now i do have to older tires on the front but i just bought two brand new tires for the rear. Would it be wise to put the new tires on front to see if there might be some unevenness caused by the old tires before i take it back to the shop?
Also the feeling of the brakes catching on one point seems non existent or so minimal I can not be sure if the road surface interfering while driving slow of applying the brakes gently. But slowing down from higher speeds (above 40 mph) and using more then gentle braking ( not standing on the pedal with both feet) it is definitely there. Before the brake job braking caused the steering turning right. (sign of more braking action on the right - right?). Now with new stuff still pulls to the right but not as strongly. Should not this disappear with the brake job? Or get the new tires on front and see what gives?
I just put new disc and pads on my girlfriend 2007 elentra and all four little screws broke off the hold the disc so you can work on it but they aren't important apparently.
Heres the problem now the pedal jumps like i have super warped discs on the car doesn't shake or vibrate while driving but then i brake the pedal jumps up and down.
I figured it might have a stuck caliper pin, which I did so I cleaned and lubed them and I have the same problem?
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 RepliesI'm the only owner. Since new the rear brakes have never generated even a fraction of the dust of the front brakes. I have replaced the front and rear pads but never had the rotors turned. The rotors aren't perfectly smooth but they don't have any deep ruts.
Anyway, my brake pedal vibrates when I apply the brakes. And the rear brakes squeak randomly when braking even though there are new pads. I always felt they squeaked because there is not much braking power in the rear.
My Durango stops okay. I'm worried about catastrophic failure because of the vibrating.
I have only 42k km or 26 k miles. Brake stops but soft. The brake pedal sink if you apply pressure after a stop. Feels like someone open a valve. The pedal go to very low. I am find the stopping power is poor. Brake fluid is brownish. I hope it is not the master cylinder.
View 20 Replies2001 F-350 / 7.3L / 147K ... What are some symptoms of the master cylinder going out? And is there a such thing as a rebuild kit anymore? The pedal has been getting spongier & spongier over the past months. Truck still stops O.K. but you have to brake earlier than I used to. Pedal can go almost to the floor. Pedal continues to go to floor as pressure is applied. Does not go to floor though.
View 4 RepliesI have a 2013 sonata gls and I bought it new, it only has 4,000 km on it. I don't know if this has always happened and I am just noticing now or just all of a sudden occurred but when I was stopped at a red light today and I had my defrost on, (heat fan on) it felt like my gas pedal there was a slight pulsation that I could feel. I also noticed earlier in the summer when the ac is on it seems like the car pulsates as well or the engine just sounds rougher. It seems to go away when the ac or heater fan is on 0. Is this an issue or serious problem? Why this is occurring?
View 2 RepliesI have been having troubles with my 2016 GTI clutch. There has always been a gritty/sandy feeling while disengaging/engaging from the first day.
On top of it, this weekend I noticed that there is a vibration/pulsation in the pedal at higher rpm (3000+), as this weekend my car was close to the break-in 1000 miles, so wanted to take it out for some spirited driving.
While shifting 2-3, 3-4 at 3000-4000 rpm, I can feel a rough pulsation in the pedal (no noise) when the pedal is around mid-way pressed.
I further experimented, to see if this happens in neutral, so parked the car with E-brakes, and then pressed gas pedal, and pumped the clutch. Have the same rough pulsation/vibration.
I took it to the dealer (right infront of my workplace), and they said this is normal, "you are just feeling the engine from your clutch"...
One tech wanted to replace both rotors and sanding down the pads to re-use (he said my brake pads can last up to one year). The guy in auto part said the surface of brake pads having hard spots could cause the pulsation, replace the pads. Of course, replace both rotors and pads is recommended but I have tight budget! What options do I have? can I just machine the rotors?
View 12 Replies2008 F250 Crew Cab 5.4, 79K miles, had new brake pads installed at 40K miles. Recently, I noticed front end shudder and some pedal pulsation while braking. It started kind of sudden. My first thought was a warped rotor.
When I took things apart, I found passenger side front rotor was cracked and the caliper pistons were rusted and falling apart, the old pads were only worn about half way. My thoughts on a bad rotor were confirmed, and then some.
I replaced the broken caliper, both front rotors, installed new pads on all four wheels, and bled the brakes. To my surprise, the brake shuddering did not go away. I'm stumped.
I have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 RepliesI have a 2007 Camry CE 4 Cyl automatic with 50K miles. I noticed when I have the air conditioner on and I put the car in reverse there is a pulsation feeling while I have the foot on the brake aslmost like a rough idle as I am backing up. When I turn the air conditioner off the pulsation stops. Not sure if its the brakes , air conditioner, tranny. The shift of the tranny seems smooth, upon accelaration. This also happens when I come to a complete stop waiting for light to change. Again when I turn the air conditioner off the idle seems quiet while I have foot on the brake..
View 2 RepliesThe brake pedal is a little too high for my tastes, and I'd like to lower it a good inch. How I can do this.
I'm not sure if any Camrys come with adjustable brake pedals, but mine appears to not, and it's an XLE, which leads me to think they don't.
My 04 Camry is having brake issues. It has 205k miles. The front pads are great and the back shoes are great. (Drums in back) I've had them adjusted multiple times but my pedal still goes almost to the floor. It's not the master cylinder cause I've already replaced that. The pedal doesn't bleed off either. But I have bled the brake lines and there is no air left in the lines.
View 14 RepliesMy mother went out 2 days ago to go run errands, she stepped on the brake pedal and it went to the floor (car still in garage and in park, low mileage car 81,xxx garage kept). I have not been able to duplicate the issue. The fluid has been changed twice since new, no signs of fluid loss, undercarriage inspection revealed nothing. I am thinking maybe a vacuum hose issue.
View 2 Replies