'97 Toyota Solara Convertible V6. Car starts fine, idles good. However, NO acceleration. When the gas pedal is pressed RPM gage moves up to 1200 from 1000 RPM. Car will move up to 5 mph. Engine lite is on full time. A/C if fine, radio is fine, all headlights fine, good dash lights. Have not checked the fuses because I assume to get this far they must be good.
View 1 RepliesOk, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
Right before Xmas our 09 Forester was hit while parked on the street. The whole front end of our car got wrecked. Was still driveable but we needed a new radiator, AC compressor, fenders, bumper, hood, lights, etc...over 5K worth of work.
As soon as we picked it up we noticed that when you press on the gas the car makes a high pitched whistling noise, almost like the noise when you'd try to tune in an old transistor radio. It only happens when the car is driving and the gas is pressed, not when parked or in neutral.
I know we should have probably brought it right back to the shop that day but I really did not like the shop at all and they are not at all convenient to where I live. I've read it could be a loose cat converter. I checked the air intake housing and that is secure.
I have a 99 Toyota Camry and recently the breaklight has been coming on and off sporadically. I assumed I had done some damage to my E-break, as the other week I tried to back out with it on (cut me some slack, I just moved to PA after having only really driven in FL lol). I wasn't worried about it since I didn't notice any issues with my breaks, however the last few days I randomly have to press the pedal down almost to the floor to come to a full stop. There doesn't seem to be any consistency to this, sometimes it happens when the light is on but usually not. It does it both when I am stopped (causing me to move forward slightly till I depress it farther), sometimes when I am stopping normally, both when I'm going straight and right after turning, ect.
I checked my break fluid level and it is at the minimum line so I doubt that is the issue. I did some research and saw many saying that it was likely just air in the lines and that the system needed to be bled. But some also mentioned replacing the master cylinder so I wanted to see what response I might get on here (I don't know very much about cars myself).
I have a 2011 Camry, and I noticed about 6 months ago that when I'm driving the car after its been at rest for several hours, within about a quarter of a mile into the drive, there is this slight rattle/click, simultaneously somewhere around the gas pedal it feels like something clicks into place. After that the rest of the drive is completely normal.
Recently this occurrence seems to happen more frequently, and not just when the car's been parked for awhile.
To me this car is still practically brand new, and I'd hate to think that there's something majorly wrong.
I have replaced the computer in a Honda Civic twice. The first time the car was acting like it wasn't getting power;the engine would rev when the gas pedal was pressed but the car would not go! so the computer was replaced, and two weeks later,t he same thing happened. They said it was a short and would not replace the computer-it was our problem. Finally, they agreed to replace the part. Got the car back, fixed a ouple of othere things and now, two weeks later, the same thing is happening. Car acts like it's not getting any power, and this time the check iengine light came on. The car has a new altenator, new battery, and the after-factory radio has been removed..
View 6 RepliesI was wondering if this problem is the "Barking" noise that keeps coming up the search or is it another problem. I will include a link to the video down below.
To start off, the Prius is 2010 Prius II and has 120k miles on it. Great Car. Only other problem was AC compressor dying at 90k.
The chirping noise happens when the brake pedal is pressed and does not go away until the release the pedal. It makes the noise regardless of whether the car is on or off.
It makes the noise when the car is stopped and or when the mechanical brake engage at between 0 and 6 mph.
Noise does not occur when the brake switch is removed. Not valid solution since the brake lights will stay on. It does not affect the performance of braking.
Here is the link to the video .... .... ....
If I'm at part throttle and i press the clutch pedal in about 2-3 inches, leaving the clutch still fully engaged, i can feel a really rough vibration in the clutch pedal. it stops vibrating as soon as i let off the gas. and i'm only giving it a little bit of gas, mind you.
If I'm at idle, and i have the clutch depressed all the way and rev the engine, I can feel vibration in the clutch pedal. My 6-speed MK4 did not do this, not in the slightest. Is this normal for MK6 or do I have a problem?
Today I faced another problem i just try to start my car but, due the dead 12v battery it didn't start so i pressed the BRAKE PEDAL until it reach the bottom, again i tried to press but its not going to the bottom why was that, is it due to dead battery? And last time i called an automobile expertise to jump start my car. They check the voltage with a digital multi-meter and he said me if you jump start even you will get this problem again until u replace the new battery. but i said him it doesn't matter do a jump start and finally it was ok . Now again I faced the same problem and this time i am going to change the battery.
View 1 RepliesGoing through the drive thru tonight and I heard a weird noise coming from the engine area. Get home and pull into the garage and here a flutter sound when my clutch pedal was pressed down, let go of the pedal no noise. While driving the car around clutch pressure seems fine and no slippage of any kind.
View 2 RepliesMy 02 BMW 525i engine starts to stop running when the gas pedal is pressed. The engine starts and drives fine when the engine is cold. However, after driving for a while like more than 20 miles, I mean when the engine warms up already, the engine suddenly stops when the gas pedal is pressed, like stopping in the traffic light or STOP sign and starts to drive. I replaced the idle air control valve, but it does not work. What should I check next?
View 7 RepliesWhen I press the pedal down the pedal vibrates and make an odd sound like errrrrrrrrrrrr best way I can explain it...
View 5 RepliesMalibu no start issue. It cranks, but will not start until she presses the gas pedal to floor. When it does start, it is a very low Idle but smooth. as soon as she lifts the gas, the car dies. Kinda like ran out of gas.
View 3 RepliesRequiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
I've bought a brand new 2012 Prius C 3.
This morning I was trying to back out of a parking spot and put it on a reverse after starting my car. As soon as I my car started moving forward and hit the curb right in front of the car. I couldn't believe my eyes so I put the gear back to Parking and back to reverse, and as soon as I touched gas, it again accelerated forward.
When brake pedal is fully pressed and my car is in drive the pedal vibrates. The only thing I thought of is that my intake is touching something, but I don't see anything.
View 8 RepliesI purchased a 2001 Prius with 123K miles about two weeks ago. I knew the HV battery was shot when i purchased it. I decided to see if I could rebuild the HV battery on my own.
I'm very mechanical but not the brightest bulb in the room when it comes to batteries and anything electrical.
So here is where I'm at so far:
- I removed the HV battery.
- safely rested it on 2 horses (I used horses because it would give me easy access to the bottom to remove the bottom screws)
- Removed all 38 modules from the battery pack
- cleaned the busses in vinegar
- inspected each wire that connects between buss and the nut.
- tested each battery ( one of the batteries tested at -0.1, the others tested at 6.8)
- I don't know how to load test the modules, so I couldn't tell if they would drop dramatically under load, so I ordered 38 used replacement batteries off of Ebay. (Gen II)
- these replacement modules were about a half inch longer than my original modules.
- The replacement modules arrived. I cleaned the terminals, tested each one and installed them.
- Connected the battery back into the prius.
- Installed new 12V battery from the Toyota dealer.
- The Prius started right up.
- Drove it around for the first time for about 10 minutes.
- When i was driving it, the monitor in the Prius would show the engine running most of the time but sometimes it would show it charging the HV and other times charging the 12V. the engine would shut off at stop lights and resume when I pressed on the gas pedal.
- while driving back into my driveway, all of the warning lights came on and the battery fan kicked into high gear,
- I can't remember the code I pulled but it was in reference to the cells being out of balance I think. I'll have to check it again tonight when I get home.
- I removed the HV and tightened the nuts around the busses hoping the issue would be resolved.
- I was able to drive it only a few minutes before the issue returned.
other issues I noticed.
While waiting for the replacement batteries to arrive, I did the following:
- changed the cabin filter
- did an oil change.
- changed the tranny fluid and removed the tranny pan to clean out the slime and clean off the magnet.)
- changed the rear brake shoes.
- changed the front brake rotors and pads. ( they were in awful condition due to sitting so long)
***when I pressed on the brakes, only the rear brakes seem to engage, not the front. I never attempted to bleed them because I know only the dealer can do that)
Sometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 RepliesI bought my SF 2013 Limited just less than 3 weeks ago. The car was fine but now all of sudden started to emit metallic grinding/friction noise when I press the gas pedal.
Dealer tech thought that it is bad drive shaft, but after changing it, it didn't solve the problem. Thought that rotor splash guards and maybe pads were to tight, that still didn't solve it.
To put this in perspective:
The sound comes only when I press the gas pedal and increases with the speed. It sound like cymbals and with speed it sound like a cricket. Noise comes from the bottom of the car and you can only hear it if your windows are down and car is passing sound reflection objects on the side, like other cars, concrete dividers, or parked vehicles.
This morning my brakes seized up on me on the freeway. I noticed it when I pressed the brake pedal and I it would barely go down. Then, I could smell the brakes. I pulled over and there was a strong smell from the brakes and I couldn't press the brake peddle down any. I waited a while and let the brakes cool off and then they were fine. I got the rear brakes replaced at the dealership earlier this year.
View 5 RepliesMy Sonata 2008 2.4 produces a single click as I press brake pedal, somewhere half way through. You can hear it and feel it with your foot. I think it clicks somewhere inside the hydraulic system of the brake.
View 13 Replies