Camry :: Steering Seems To Be A Bit Heavy
Jul 17, 2014
Just bought Camry 2011 XLE /37.500 Miles.
When driving this first day everything ran very smooth and very light. After I took it to get State Inspections and Emissions, for the last couple days, the car has been feeling somewhat heavier. I ran it by the shop I went to and they test drove it and said it was fine. The steering seems to be a bit heavy no when I turn. The wheel doesn't set back smoothly at all/stays stuck. The car doesn't seem to run as "light anymore" The wheel feels very heavy/dragging at times when steering from right to left.
I heard that spraying Tri-Flow lube with teflon on the Universal (U-Joint)/steering column will work wonders in making it smoother.
View 14 Replies
Advertisement
Recently had superpro Lca, koni yellows, Pilot super sports and a solid alignment done.
Over the last 2 days it seems that my steering that felt very light after the superpros were installed, has become very sluggish and heavy. There is a bit of "heavy" play in the wheel as well which under the same effort after putting on the PSS, would have tossed me around playfully.
One piece of info I should include is that I took her on a windy road pretty hard on Saturday. Tight hairpin turns that last a couple miles but I ran it 3 times.
Would running her hard though turns make the steering become dead? Is my power steering fluid in need of a change?
View 9 Replies
Have a heavy steering feel on their 2010's with the 215 45/17 tires? It seems much heavier than previous Prius's and also have noticed that mine when it is really cold the steering wheel gets a little twitchy until it is fully warmed up.
View 12 Replies
It has been there for about 6 months....i own a 3rd gen and i feel the steering bit heavy (actually not soft) to steer compared to other toyota models...the tire is 215 45 r17...can the steering tightness be adjusted technically at some point....
View 8 Replies
1-My Ex steering is very heavy and some times kicking, I don't have any fluid leaks and my steering shock looks nice and clean, I did check and lubricate the ball joints.
2- how did the big 3 wire upgrade in v10, I need some pictures for grounding wires locations like engine to body, battery to body, chassis to body. Because I got a new 300 amp alternator to juicing my truck stuff and to power up the 3000w power inverter.
3- The engine exhaust fumes is so strong making my eyes burning ← . What I did is new coils pack, spark plugs, air filter, fuel filter , cleaned the injectors , checked the exhaust for leaks, cleaned the throttle.
But it's no different, I had this problem sense Day1 .
View 8 Replies
I've owned my IS F for a little over two weeks now, and I have noticed under several occasions under heavy breaking (close to 70-80% breaking capacity) that I have to fight the steering wheel to keep the car tracking straight. This is anywhere from speeds of 80-90 mph coming down to 40-50 mph. Could this be an issue related to the front control arm bushings? My F only has ~41,xxx miles and tires are brand new (OEM Spec) Continental ExtremeContact DWS. No other alignment issues known as the car doesn't track left or right either.
View 14 Replies
santa fe 2009 - 77000KM - AWD
Few months ago , I notice that the steering getting heavy after driving like 15Kms. At the morning it's normal , and while driving also normal , Just heavy when the vehicle at low speed. I checked the Fluid , it was very dark , SO i changed it with new oil , but after like week , it be heavy all the times , also some noise sound at the power steering bump when move the steering .
I check at work shop, the advice me to change the fluid again, since they assumed that the fluid not suitable for the vehicle.
View 1 Replies
Less than a week of driving the GS, the power steering suddenly seemed to stop working. After starting the car, the steering felt heavy (actually a good thing) but near impossible to turn during a standing stop.
Good thing I still have warranty. What turned out to be causing this?
View 14 Replies
I have a 2013 es 300h.
To make a long story short, i had to have my front bumper replaced in May due to an accident but there was no mechanical damage to the car. They did an alignment to the car just to be safe.
Earlier this week, I'm not sure why I noticed that the steering was a little tight/heavy when turning left or right sometimes. It wasn't a major challenge just a little more strength then when driving straight.
Today, I took the car to the dealer and they ran all of the tests and everything came up fine except there was a code that the hybrid battery had been disconnected during the repair while sitting at the shop which created some sort of code that they cleared. The tech mentioned that this may have created the steering issues since the car may have thought their was low power.
After, I did notice it was a little better but still a little tight at times. I took the car back to the dealer and had the tech drive the car and he said the steering was normal for the car. Are they missing something or is it that I forgot how the car drives?
View 4 Replies
Lexus es 350 steering wheel is heavy/tight when turning?
View 2 Replies
I felt a sudden heavy vibration in steering wheel on my gen 7 Celica. At first, I thought it was wheel balancing or uneven road surface (which is very bad in my area); but discovered later, burning smell from nearside (left) front wheel, all 5 lug nuts loose, whole wheel very hot, break binding. I had driven about 15 miles on 2 occasions when I experienced the vibration. But the vibration wasn't there all the time - only at certain speeds and road surface, which made me think it was just wheel balancing; (checked other wheels everything ok). Don’t know how long brake was binding for.
It seems the piston is not retracting under normal operation so causing the binding. As to the nuts coming loose; I think it is because of the heat from the wheel; as if you apply heat to tight nuts and bolts they would normally come loose - that is what mechanics seems to do when they find nuts and bolts are difficult to undo.
Piston hard to push back into cylinder when bleed nut is locked, but easy to go back (all the way) without any resistance when bleed nut is released. But when applied brake again and again pads stays on; but when I tap caliper with a piece of wood the pads releases. I’m puzzled...as caliper is free and slides as it should when checked against opposite wheel. The opposite wheel is ok - pads on that still 6mm thick; while pads on problem brake are only 3mm thick. I noticed there’s a block under the bonnet where brake pipes are connected to. What is it, and its purpose? Could it be that something is wrong with that hence the problem? The disc/rotor is not warped.
View 5 Replies
2007 SF SE 3.3, approaching 60,000 miles. I'm feeling a front steering wheel shimmy on "heavy" braking, as in a recent trip into the Adirondack mountains with twisty roads.
View 5 Replies
I drove a '97 with the 5.0 and AWD. I noticed that when I turned around in the neighborhood, the steering started to feel a little heavy during a U-turn. I was pretty close to full steering input to the left, but not quite at the lock. Also, it seemed like the tires might be scrubbing the pavement a little bit. No real binding or hopping, just that feel you get when you have the transfer case locked in your old-school 4X4 and make sharps turns. Is this typical for the AWD?
View 7 Replies
I've got an '06 F150 and the steering isn't right with it. It has had a heavy feel and is almost like the power assist is only working half as good as it should. It's been like this for a couple months. I 've had all four ball joints and the steering rack replaced in the last month. It had the heavy steering feel before and after everything was replaced. It also doesn't recover itself on sharp turns, I have to turn the wheel back as I complete the turn. Could it be the power steering pump? I thought it was a mechanical device and it either worked or it didn't, maybe they get weak?
View 14 Replies
My 2013 Corolla drove 10 minutes with heavy steering after starting. The slip indicator turned on and stays on after. Would OBD II show the problem? Can one read OBD II without scanner? How to turn off the slip indicator?
View 1 Replies
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
View 13 Replies
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 Replies
The steering on my truck has become a little heavy after making a turn and bringing the steering wheel back to center. The steering feels heavy like I had a front tire half way down. There's a lot of drag then once on center it's gone. Could it be the beginning of the end for my ball joints?
View 10 Replies
I have a 2000 Toyota Camry LE with 106K miles. It?s getting a little clunky but works perfectly. I do regular maintenance like oil changes every 3 or 4 months, breaks, tires. Last year one day during very have down pour rain I noticed something banging/hitting under the seats while driving in this heavy rain & car losing power (slowing down). Something (I am guessing the exhaust pipe? hitting the body. The more gas I gave to gain speed the violent the banging. I slowed down to almost 15MPH but never stop & the car started to work normal. It happened 3 or 4 times before I got home. I check all fluids etc? All normal. Drove later in sunny, cloudy & even in light rain the car runs perfectly fine. Then it happened again in heavy rain.
I told my car mechanic & he checked all even tightened the main belts (not timing belt). No change. Now it?s so predictable when ever its rains heavy & even slushy snow/rain. Lately it started to not only lose power but sometime instead of banging I hear grinding noise when pressing the gas paddle. Some time banging followed by grinding but every time after slowing down the car recoups power and I drive normally. It never ever happens in dry day. My wife who drives ?Buick Century 2004? thinks my car is dyeing and should buy a new. When I describe this situation to any mechanic they points to transmission & want to perform brain surgery to diagnose.
View 15 Replies
The speakers themselves are not rattling, but the door panels themselves are. What kind of cheap material did Toyota use on the Gen 5s to cause door 6x9s rattles on the panel when listening to bass heavy music
View 14 Replies
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 Replies
