700 miles ago I got new brake pads on all 4 wheels and new rotors on the rear wheels. 700 miles later the steering wheel still shakes when braking at above 60mph speeds. Also there is still a squeak sound coming when braking. Do I need to give the new brakes and rotors more time to adjust or were they installed wrong?
View 7 RepliesMy 2002 v6 camry is shaking while braking on a downhill at highway speed 60mph. This started yesterday. Afterwards on level surface and lower speed no shaking. Late yesterday, again on highway downhill, more shaking.
I live on a mountain and do not notice the shaking coming down at 30mph, including yesterday.
A couple of months ago the pads were 75% and the rotors were resurfaced approx 4000 miles ago. And the rotors are the third pair if i remember correctly.
I bought the car new and it has 121000 miles on it.
I am currently running 8mm ECS spacers in the front and 17.5mm ECS spacers in the rear. My Summer set up is still stock BBS RC's, but my winter wheels are Lenso's.
Last winter was my first winter running with the Lenso's and had no issues. This past weekend I swapped out the BBS's for the Lenso's, and now I am feeling vibration above 60MPH. I felt no vibration with the BBS's. I just took them in to get balanced (maybe a weight fell off-idk), and they were within 1/4 of 100% balanced. They then thought it may be the spacers I'm running so they cleaned them up, but said that it didn't work.
My alignment is also spot on-so that's not an issue either. I am at a loss as to what would make me feel that vibration after just changing out the wheels.
I had a problem with my steering wheel shaking at various speeds. Eventually I found a bad inner tie rod and replaced it. The shaking is gone, but whenever I get over 70 mph there is still a very small vibration. I had all 4 wheels aligned after changing the tie rod. Tires are brand new, less than a week old. The mechanic checked my ball joints while doing the alignment and said they were good. Could my struts be causing the vibration? They need replaced, not sure if the previous owner ever replaced them and the car has 225,000 miles.
View 3 RepliesI'm getting some vibration and steering wheel shake with my '04 GX... I have a 2004 GX with the differential dynamic damper installed. About 55-60mph it starts, and shakes the steering wheel back and forth. Sometimes it's completely smooth, but on other road surfaces it shakes. On full "comfort mode," the shake is much worse, but on Sport mode it dampens the shake to about 10% intensity, but it's sometimes still there. This is not bump steer, by the way.
So far, I've done:
-Brakes
-Alignment
-Front hubs
-2x wheel balancing with 2 different sets of wheels/tires
-lubed the drive shaft and prop shaft to fix the clunk (Clunk TSB has not been done)
-changed the power steering fluid
-checked all control arm bushings, ball joints, tie rod ends, and sway bar bushings. All are solid.
I recently jacked up the front end and moved the wheels back and forth by hand. It seems like there is some looseness coming front the inner tie rods. However, I pushed and pulled and can't get a clunk or anything. I think it's coming from inside the steering gearbox. My VIN says it's before ST002-05, so that TSB aka "Steering Flutter" would apply, if it is that.
After 104k, are the front shocks due for a change? It does seem to nose-dive a bit on braking, but the shocks aren't leaking or anything. Would worn shocks cause steering wheel flutter on these trucks?
Just had my prius for a little over a month now and I ran over a nail, had the tire patched. Once I started to get back on the road, the wheels would shake when I go over 60mph. Ive had the tire balanced plenty of times and replaced the hubcentric ring since I have after market wheels on them. The wheels are 17" drag dr31 wheels. I am still having the issues, will replacing the tire fix the issue? The tire is located in the front drivers side.
View 6 RepliesMy 1.8t gli is giving me this issue, when braking (specially hard) my steering wheel shakes side to side, my rotors got changed less than 20,000 miles ago (all of them) and they seem fine right now.
Could this be my Tie Rod ends? The car has 110,000 miles on it, and i know some bushings if not all need to be changed, which I am gonna be installing when i put on the Raxles i just got.
I have a 2007 Acura TSX with 117k miles. We had the rotors and pads replaced in July of 2014 at Midas (won't go back there again!). Anyway, we are getting a pulsating in the steering wheel (shaking) when braking at times. Sometimes it is much more noticeable than others. This started shortly after having the pads/rotors installed. I took it back to Midas, and of course they couldn't duplicate the issue.
So, here's my question, can we continue to drive the car until it needs new pads (then I'll change the pads and rotors)? I know that the steering vibration can be annoying at times (it's not AWFUL, but you can tell that they're warped). I really hate to have to replace both right now as money is pretty tight with buying a house.
Lately my 2007 GX470's steering wheel has a shaking/vibrating problem whenever I apply the brake at speed above 50 mph or so. Without braking or with braking at slower speed, there is no problem at all -- everything is glass smooth.
1. I assume the front brake rotor is warped?
2. Will I need to change the rotor or is there a way to fix the warp (it that's the problem) without changing the rotor?
3. Approximate part & labor cost?
I plan to bring to dealer for a check up but would like to know ahead of time what to expect.
My Ford F250 XLT (HD) 2 wheel drive has recently developed a shimmy; a shaking of the steering wheel that usually occurs at medium speeds, and seems worse when going around a curve. But since it doesn't seem safe to drive, I dropped by a local shop for a diagnosis. Their thought was that I had a caliper sticking, since it pulled to the left when they test drove it and applied the brakes, and maybe rotors since the vibration indicated warped rotors. Since I hadn't mentioned shaking during braking, I paid the diagnostic and moved on.
Upon leaving, the shaking started up again going around the first curve, at about 35-40 mph. Shortly after that I took it to a dry, flat, unbusy stretch of road, and applied the brakes at about 60 mph, and brought it to a stop in it's lane with my hands off the wheel; no pull either way. Now I have it up on stands, and have visually and physically checked the parts I know and recognize, i.e., ball joints, tie rods, wheel bearings, etc. I don't know how to inspect gear box, or steering shaft issues, but steering wheel play is minimal.
I own a 1997 Honda Civic EX. Automatic. 160,000 miles. I have had the front disk rotors and pads replaced five (5) times within the past two years due to "warped" rotor issue. I recently changed the two front calipers as well to rule out caliper issues. Yet I continually end up with a warped right front rotor weeks after putting on new rotors. Here is what happens. Car brakes fine for a week or two with the new rotors. Then shortly afterwards, the right front rotor (passenger side) quickly develops a rubbing -like noise (not a grinding noise) when braking at a low speed. It's not a constant rubbing noise but a rhythmic swoosh swoosh swoosh noise as the tire rotates and the brake is softly applied. You can feel it in the brake pedal. This noise eventually gets louder and louder the more I use the brakes (or, the hotter they get?). It can also cause the steering wheel to vibrate at certain speeds when braking.
I have had it into four different mechanics.
Mechanic 1: Your rotor is warped.
Mechanic 2: You are too hard on your brakes causing the rotor to warp.
Mechanic 3: Did you go through a puddle of water lately?
Mechanic 4: You need new brakes. Period.
This is getting ridiculous. In all my years of driving, I have never encountered this problem. I am not hard on my brakes. I do not believe the "water puddle" theory at all. I should mention, although these are not oem rotors. they are not some cheap Chinese ones either. Something must be causing this rotor to "warp" if it's really warping at all. I have had the tires rotated to rule out a bent rim. It happens no matter what tire is on the right front car. What could be causing this? A bad front end alignment... bad wheel bearing... (although no mechanic ever indicated that as a problem)... bent splash guard... bad master cylinder? Air in the brake lines... old brake fluid???
My GX470 steering wheel shakes/vibrates when I hit speeds over 50mph. What is causing it?
View 12 RepliesI bought a new 2010 (Gen III) Prius IV one week ago. I have driven it less than 200 miles. Last night, I experienced a few seconds of steering wheel shaking while driving at highways speeds. I assumed I had hit uneven pavement. At no point was it difficult to turn the wheel. But after the shaking, the car seemed to sometimes drift to one or the other edge of the lane. I chalked that up to unfamiliarity with the car and to rain and darkness. Today, I read Forum posts that described the lighter touch that usually works and the importance of wheel alignment.
After the shaking, another 45 minutes of driving, and a half hour parked, I headed home on a slower road. That is when my wife noticed that the Electric Power Steering warning light was on. We are both pretty sure it was off before that. This morning, I pulled out of the garage and back in, and turned the wheel both ways as it moved. The light did not come on.
I called the dealer to discuss what had occurred. I made a service appointment for Monday so they can check it out. Someone in a Gen II forum (where I mistakenly posted this at first) advised me to pull over and take an evidence photo of the light if it comes on again.
The PS warning light wouldn't be too surprising to see in a Prius driven tens of thousands of miles. If yours ever came on when your Prius had low mileage, I'd be curious to know the outcome. I misidentified a benign icon as the EPS warning light.
The mechanic became suspicious when he couldn't find any code or any trouble. We sketched the icon we remembered seeing for the service supervisor. He explained that it was the cruise control light. I either forgot I had turned cc on or I had pushed it accidentally when I operated the wipers.
I bought 09 GX-470 4K miles ago..has 50K on it. Ran perfect when we bought it. wife said it started doing it 1 week later. I drove it and felt like warped rotors to me. replaced front rotors and pads with cheap wearever brand...I Know...I was sort of trouble shooting..did nothing ...did the back rotors and pads and seemed to fix it..did proper bed-in of new parts but, never checked at speeds above 55mph. recent trip got us up to speeds above 55... at these faster speeds when brakes are applied we get a nasty wheel wobble and a pulsing pedal...braking below 55 it feels fine.. thought's ?? last car was a 4runner which has the the same rotors and pads and never had a problem...could it be ABS ?? should I go with new oem rotors and pads ?
View 10 RepliesI was driving my mother's 05 GX (non-kdss suspension).
The steering seems to be quite loose at speeds above 100kph (60mph).
There is also a vibration at these speeds (likely relating to balance).
How tight is your steering?
If alignment/balance doesn't fix things, what other parts might be the culprit?
I have a 2006 Camry 4 cylinder that I turned the rotors on all four wheels and replaced all the brake pads on all four wheels with ceramic pads. I did this a year or two ago.
Now this doesn't happen every time you brake but sometimes you will get a vibration in the steering wheel when braking.
When I had the rotors turned at O'Reillys they said they were too thin. So I had them bring out a new one and that one was too thin as well according to whatever specs they were using. So they turned my old ones.
And the car doesn't pull to either side when braking. There are not grooves in the rotors and it doesn't make any screeching when braking. I did notice that there is a ridge on the edge of the rotor when you run your finger across it from the inside to the outside of the rim of it. My guess the rotors are warped.
And if the rotors need to be replaced is this rotor better than the stock ones and thicker? [URL] ....
I'm trying to find why my car's steering wheel vibrates. This happens at all speeds regardless or acceleration or breaking.
View 3 RepliesI have a 2011 Camry LE 24K miles and just now the car steering wheel moves to the left when braking. Can it be that the tires need balancing.
View 4 RepliesI have an 05 Camry LE & when ever I'm on the highway going around 50-80mph & need to break my steering wheel starts to shake until I either stop or put my foot back on the gas. Last year my power steering rack & one of my motor mounts got replaced, & for awhile it stopped & figured because that was going out that's what was causing it.
Well about a month later it started back up & still does it, I've taken it to the dealership & have told them & they test drove it, felt the same thing I felt but didn't find anything. Is there anything else that could be causing it ? Earlier last year my bearings were lose in the front, and I managed to get my brakes stuck & had that all fixed & since then that's when it started shaking . I took it back to that shop & mention every time I go in for oil changes at my dealership, is there something else I'm not aware about that I should ask them to look at ?
I got a 2006 Solara SLE. while braking from highway speeds, the steering wheel shakes VIOLENTLY. city driving its not noticable. cruising the car is silky smooth. The one front caliper was sticking and i replaced pads, pins, rotor. Still shakes. i tried swapping pins as one pin has a sleeve at the tip and i didnt remember which one went where. i did notice the pin with no sleeve fits loosely. the rotor is AZ Duralast brand. the car has 200k trouble free with no suspension work ever done.
I am lost what to do and need to make a long trip coming up. I was going to try in order- replace other rotor, spin the one rotor and replace guide pin with a sleeved one, then do lateral run out test/lathe, alignment, then if that dosnt work a stick of dynamite. Iheard a bad tie rod or ball joint can cause this, i find it unlikely as it would probably shake all the time. Other small issue is a loud thunk in the rear when it hits bumps. Rear swaybar mounts?
If the front rotors are warped would I not feel it when braking anytime and not just braking hard at high speed?
View 2 Replies