Camry :: Serpentine Belt Change On 2.5 Engine?
Jul 13, 2012
I have a 2010 camry SE & have found nothing about how to change the serpentine belt on the 2.5 engine.
View 1 Replies
Jul 13, 2012
Advertisement
Camry :: Engine Noise - Bad Serpentine Belt Tensioner Is Seized On
After finally identifying a bad serpentine belt tensioner for being the the culprit for my engine noises, my mechanic said that the 'thru-bolt' is siezed. Since the replacement job was at my budget limit he said he doesnt want to get into it in fear that he has to brake the bolt and drill it out (requiring 2-3x more labor cost according to him).
If this is the case, and the 'thru-bolt' is seized, is this in any way something I can make a an effort to tackle? I have a jack and jack stands, and plenty of time.
Lexus GX 2004-09 :: How To Change Serpentine Belt
I have changed belts on other cars just never a Lexs. how hard is it to do on or trucks?
View 7 RepliesPassat (B5) :: Serpentine Belt Slippage On Takeoff Or Throttle Change
I know the serp belts were done on my 1.8T passat 25k miles ago. The tensioners were not done, of course.
While the engine is still cool I sometimes hear belt slippage on take off or throttle change. I was thinking to just replace the serp belts but then it occurred to me that it could be one of the tensioners causing the problem.
Are the tensioners prone to failure? Or I should just change belts? Car has 92k miles on it total.
Camry :: Can't Get The Serpentine Belt Loose
I have troubles with what I thought would be a basic job: removing the belt on my 2004 Solara so that I can remove the alternator. I can't get the belt loose enough to slide it off, no matter how hard I try.
The wrench I'm using is about 12" long, I'm a big guy and I've done powerlifting in the past, meaning I can apply lots of strength on that wrench. I've just watched a youtube video of a guy with the same engine removing his belt, and he exerted a lot less effort for a lot more wrench travel. I thought that using a breaker bar is extreme.
Camry :: 2005 - Rattle Coming From Serpentine Belt Area
Got a nice rattle coming from the serpentine belt area of the camry, before I order some parts, I'm thinking the bearing in the tensioner is done, I just don't want to swap it out only to find out its my water pump barking or alternator bearing/bushing. doesn't seem to be emanating from the alternator.
Here's the short video : [URL] ....
Camry :: Idler Pulley Replacement On Serpentine Belt Tensioner
2002 Camry 4 cyl. Can the idler pulley alone be replaced on the serpentine belt tensioner? I noticed a very slight side to side play when I had the belt off. No noise from it. When I looked at rock auto, they sell the whole bracket with the pulley.
View 2 RepliesCamry :: Nut That Hold Pulley On Alternator Fallen Off - Serpentine Belt Will Not Stay On
The nut that holds the pulley in place on the alternator has fallen off, causing the pulley to become loose and now the serpentine belt will not stay on. What is the size and thread type for the nut that I need to replace?
Alternator Pulley Nut for 2004 Camry 4cyl
Toyota - Camry :: 2006 - Water Pump And Serpentine Belt Replacement
Is it possible to change the water pump and serpentine belt in a 2006 Toyota Camry with 4 cyl. engine in less than an hour?
View 4 RepliesHonda - Odyssey :: 2006 - Serpentine Belt Breaking The Timing Belt
Serpentine belt on a 2006 Honda Odyssey fraying and then ripping into the timing belt causing that belt to break? I recently had this scenario given to me as the cause of my recently replaced timing belt breaking.
View 11 RepliesFord - Taurus :: Serpentine Belt Squeaking And White Smoke Coming From Engine
I noticed my serpentine belt started squeaking about 3 days ago. And yesterday as I was driving to work I heard a clicking sound coming from the left side of the hood, then my car started to gradually shut down and white smoke was coming from the engine. When I got to the stoplight it completely turned off, but I was able to turn it back on again to turn into the parking lot before it shut off again. When I checked it there were no visible leaks, my reservoir for my coolant was still full, and my meter never went up indicating that my car was over heating. I'm not sure what's wrong with it, but after it sits for awhile it is able to turn back on again for a while.
View 3 RepliesFord Super Duty (1999-2016) :: 2006 - Serpentine Belt - How To Route The Belt Around Tensioner Pulley
2006 6.0l ... I've read all over for tips on routing this belt and everyone plays it off as being some simple '20-minute' task. I'm on my 4th hour on this now.
I can't figure out how to route the belt around the tensioner pulley, circled in the picture (from another thread). Everyone glosses over how to do this and I can't figure it out.
It seems like the only way to get it on is to bend the belt and slide it between the pulley and the block, but that I just can't reach the blasted thing.
Ford - Ranger :: 1997 - Vacuum Lines Coming Close To Hitting Serpentine Belt On The Front Of Engine
Ok, I have 1997 Ford Ranger, 4cyl, manual transmission, and more miles than I'd like to admit to.
Yesterday, I noticed that one of the vacuum lines was coming dangerously close to hitting the serpentine belt on the front of the engine. The clamp that normally holds the vacuum line in place rusted away a decade ago, so I decided to use some velcro ties to attach the line to the positive battery cable. I didn't twist or pull on the cable in any way and the vacuum line isn't applying any force to the cable.
I get in the truck a few hours later, hit the key and I get >click<, but nothing out of the starter. One click when the key is in the start position, nothing more (as opposed to click-click-click).
Not thinking about my repair earlier, I went down to Autozone and had them test the battery - 12.8V and 550CCA, no problem there.
So then, I thought well since the click is coming from the starter relay, maybe that's where the problem is. I read on another forum that sometimes the starter relay can be resurrected temporarily by hitting it with a hammer. Which I did. And it did work! Now the truck is starting up normally every time, but I'd like to replace whatever was bad.
My questions :
1. Did I prove anything by hitting the starter relay with a hammer and then starting the truck?
2. Should I still be looking at the battery cables?
3. Should I stop hitting random parts with a hammer and take this truck down to a real mechanic before I do serious damage?
Camry :: 2005 - Noticeable Knocking After Timing Belt Change
I have a 2005 Toyota Camry with 120K miles that was bought used with 110K. The previous owner did not have the vehicle long and did not know if or when the timing belt had been replaced. I have read several blogs that recommend replacing the timing belt at 60 or 90K. To err on the conservative side I decided just to do it at 120K. Now my problem. Before the timing belt change there was a slight knocking from one of the cylinders. After the belt change the knocking is more pronounced. Q. How concerned should I be that the knocking is more noticeable? Could this be a by-product of the new belt and as it loosens the knocking will subside somewhat? OR, am I looking at valve job or worse?
View 8 RepliesPrius (Gen 2) :: Found Engine Belt Cracking While Oil Change
I have a 2009 prius that I just took into the dealer for an oil change at 50K miles. They told me, the engine belt was "cracking" and it would be $145 to fix.
I wanted to take it to a mechanic I trust to fix. I called on my way over and he said he could replace the belt for $90 but when I brought it in he looked at the belt for a couple of minutes and said it looked fine to him. He didn't recommend any work now and said just check it again during my next oil change.
I don't want to be stranded if it breaks.
Prius (Gen 2) :: How Often Serpentine Belt Should Be Replaced
I am very concerned regarding how often my serpentine belt needs to be replaced. First time it was replaced at 104k, second time dealer replaced it at 126k, third time at 153k. Today I went for oil change (173k) and the dealer told me that it has little cracks and recommend replacing it. Is it normal? Could it be something else is affecting it?
View 11 RepliesTiguan :: Serpentine Belt Came Off When Driving
I have had my Tiguan S for almost 2 years and it seems that I keep having to get it towed. I just had it to today because the serpentine belt came off when I was driving. After I bought it the fuel line was loose and it had to get put back on and after about 12000 miles my tranny went out and had to get replaced.
View 2 RepliesPassat (B5) :: How To Access The Serpentine Belt
Pulled off front bumper today with no success, seems like the whole radiator and a/c unit must be removed?
View 5 RepliesGolf IV / Jetta IV :: Serpentine Belt Went Out
So the PO of my Jetta had the alternator replaced...awesome! One less job for me to do. My serpentine belt went out yesterday so I chalked it up to being old. When I got the new belt on it kept slipping off, I pulled the tensioner pulley off and saw that the wheel was all chewed up, I look down and saw that whoever put in the alternator didn't bother to screw in the bolt all the way and it chewed up the belt and everything else.
View 1 RepliesAccent LC (2000-05) :: Engine A Little Louder After Timing Belt Change
My mechanic just did the timing bet, water pump and other belts. Also changed the tensioner.
Car runs fine and everything seems great until I get to a red light. The engine sounds louder then before. Not very loud but its louder and maybe a very slight vibration, not sure yet. No noises while driving, seems like its running the same or better then before. Runs fine though
Cavalier :: 96 Squealing Noise From Serpentine Belt
My daughters 96 cav has a bad squeal coming from serpintine belt. I tried belt dressing and it threw the belt. I didn't notice any cracks/dry rotting on belt. I put the belt back on but it is still squealing.
View 1 Replies