Camry :: Reverse Light Wire Location Under Dash?
Sep 2, 2013
[2008 SE I4 no JBL no factory nav]
Picked up a new head unit from ottonavi and am trying to finalize the install, but I can't figure out how to connect the unit to the reverse light wire so the backup camera comes on automatically when you shift to reverse. I've searched the forum and seems like the answers were PM'ed and emailed in most cases... Someone mentioned behind the glovebox?
What I've tried so far:
There are two white connectors at the base of the shifter, and while in reverse, I unplugged each (individually and together), and the reverse lights were still on! I tried the connectors I could get to behind the glovebox (on the side and middle top) with the same result.
View 14 Replies
Advertisement
I am installing a rear view camera and I need a location of a reverse signal wire. In the 2007 Camry that wire can be found at the e48 junction. Unfortunately the 2009 e48 does not match in either wire color or pin location. Any wiring diagram for the 2009 e48 junction, or another location where I can find the reverse wire?
View 2 Replies
I'm getting ready to put in my new double din and it said to hook the wire for the camera up to the reverse light wire. Which one this is on the harness coming out of the column?
View 14 Replies
I'm wiring up a backup camera, which comes with a voltage sense lead so it automatically turns on/off with the backup lights. What is the fuse location for the backup/reverse lights, or the physical location (and color) of the hot wire for the backup lights, so I can tap into that?
View 16 Replies
Started my car up this morning and it felt like it was running on 5 cylinders and the check engine light came on.
I looked and a Rat had made a nest with foam insulation and chewed through a fuel injector wire.
2008 Camry V6 77,000 miles.
View 12 Replies
My reverse camera goes over the mirror, its a mirror when not in use and a camera when in reverse. The way this one is set up, the camera taps switched 12 volts at the rear of the car (tapped trailer connector for these) and the video signal runs forward (ran under headliner to center console to mirror). The monitor needs 12 volts, ground, and + 12 volts when I shift into reverse. I just read a half dozen threads where people suggested tapping into a black wire with pink stripe in the driver's kick panel. Just checked, no such wire on mine. I do not want to run a wire back from the taillight, this seems backwards since the power goes from the front of the truck to the reverse light in the taillight I just need to find the right wire. I checked the reverse relay and the fuse in the fusebox and they are both 12 volts when the truck is on, so they must be prior to the reverse switch.
View 14 Replies
where the reverse wire at in the front of a 2012 camry se .
i got my otocam3 from adc mobile and will be adding a backup camera to but need to connect the (+) reverse wire from the radio.
View 3 Replies
What is the domelight wire color and location in an 07 LS460?
View 5 Replies
The right side seems plugged up with glove box components.
View 1 Replies
I've searched all over and can't seem to find the answer. When I pull the tail light out of my 12 F150 there is a blue/wht wire and a black wire going to the back up light. I assume the blue wire is the positive and black is the ground. Is that correct?
View 8 Replies
Looking for a diagram which wire to tap so I can trigger/run my aux back up light? I tried tapping the existing wire behind the tail light and it didn't work, made the truck do funny stuff like killing the ignition. I had read on here on white knights web site that on the newer trucks you cannot use the back up circuit from the seven pin so I didn't try that. I don't have up-fitters and really didn't want to run a wire to the front but will if that is the best solution.
View 8 Replies
I would like to hook up some auxiliary reverse lights, I want to use a relay. And activate the relay when I put my truck in reverse. I would like the relay to be in my custom relay/fuse box under my hood near my battery. I'm looking for a wire I can tap into, to use to active the relay as close to the battery as possible. Or at least a wire on the outside of the cab near the engine compartment. Maybe there's one coming from the tranny? I have a 2011 f250 super duty. XL, I think, its a very base model truck no power windows or locks, only fm/am radio, no NAV system, no remote unlock, no nothing, 2 wheel drive.
View 9 Replies
My dash light fuse blew. I checked with a meter and I have a short to ground somewhere in the wiring for the lights. Everything else seems to be working fine.
Is there a copy of the wiring diagram somewhere?
I have the big ford shop manual but I't doesn't have any diagrams. (might be missing pages, I got it off Ebay and the index is missing T-Z).
I have the Haynes but it doesn't have the diagram for the dash lights.
View 4 Replies
My trailer has surge brakes so I need to tap into the reverse light circuit to convert the 4 wire trailer harness to 5 wire. The reverse light wiring runs in the lower cargo area anywhere...trying to avoid having to trace it from the hatch into the headliner.
View 11 Replies
Im currently installing a remote starter on my 07 camry and it wants me to tie into the "parking light" fuse or wire. It is a Bulldog system, on the website it describes it as "Black (-) wire" located at "BodyECU in vehicle fuse box 26 pin plug pin 23" The fuse box cover does not identify fuses by number and i do not see anything that looks to be parking light related.
View 1 Replies
I have a 2013 Accent and have installing driving lights. I am looking for the correct high beam wire on the driver's side on the headlight assembly. I will then run this to a relay so that when I turn on my highs, the driving lights will come on. I have tried to locate the correct wire but the one wire that is hot when the highs are on, is still hot when the car is off as well as the lights.
View 6 Replies
2012 F350 Lariat - want to install cab lights. Can't locate correct wire to tap for power. I want to use the same power that powers the parking lights so these come on as they should. Is the best connect on the driver or passenger side, and what color wire is it? I've read yellow with green stripe (and found about 4 of them) and a brown wire I couldn't find.
View 1 Replies
I have a 99 f150 XL 4.6, 5 speed. I spent some time tracing the leads around the ignition system to find the EDIS module. The purpose of this is to install a aftermarket tach coming off the EDIS. This seems to be a simple approach and I have a pin diagram handy for it. I am initially shying away from tapping into the EEC. Maybe better yet, what wire color to splice behind the gauge cluster that would be useful too.
View 1 Replies
It looks like my door lock wire looms go under the hood but I haven't had any luck finding them. Install an alarm with negative 500Ma pulse to operate them ? I have relays but am also wondering if the truck has its own somewhere that I can piggyback onto. I know the colors are Pink with a yellow stripe and Pink with a light green stripe.
View 7 Replies
Trying to find ground wire location on my 99 f250 super duty with the 5.4 triton I didn't unbolt it myself. Going to be doing the big 3 upgrade soon and would like to use the factory ground spots.
View 13 Replies
I am putting work lights and LED warning lights on the back rack of the 2014 F350 diesel in work. Where are the wires for the upfitter switches, and are they prewired into the fuse box, or do i have to hook them up?
View 7 Replies
