Camry :: Remove / Replace Rear Bumper Cover On 2003 Vehicle?
May 15, 2005
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 RepliesHow to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 RepliesI have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 RepliesLooking for the sequence and clip locations on a 2010 Prius III rear bumper cover to be able to remove and install a new bumper cover. What is removed and how many clips are involved?
View 8 RepliesSo I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 RepliesI was searching for instruction how to replace the chrome trim that appears to be a seperate piece of trim on the rear of the Phaeton. Mine has some issues on the passenger side and would like to remove it to have it either repaired or replaced.
View 11 Replieshow to remove it.My wife backed into my truck and put a dent in the corner of it so I am hoping i can pop it out.
View 4 RepliesI need to replace the center mesh grill on the front bumper. Is there anything I need to be careful with or watch out for. when I pull on the old grill or when I push the new one back into place? Does it come out easily or is it tricky?
View 4 RepliesI have a 2013 FX4 with the 3.5 twin turbo engine. How to remove the right side valve cover to replace the gasket? I have loosened the perimeter bolts and was able to get it to move slightly but nothing more. I also removed the spark plugs thinking that they might be holding the tubes which are connected to the valve cover by round seals. I have not removed the seals since I was concerned that I might damage them. Do they need to come off? If so how do I do it? It's amazing how complicated this job is! Short of calling the dealer service, I have just about exhausted all my usual tech resources.
View 4 Replies2013 Prius IV.... I just noticed that my right side rear bumper cover has a 1/4 inch gap between the bumper and the quarter panel. I think it's from me sitting on the bumper while tying up my shoes or something. When I apply downward pressure on the rear bumper, the gap widens. The left side is tighter, but does gap out when downward pressure is applied. In any case, the gap is annoying.
View 19 RepliesLooking for a DIY for this part? It is part number 5 in the illustration.
View 5 RepliesI have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
I was recently in a fender bender where I was rear ended. My rear bumper cover became detached on the left side and the spoiler underneath it (left side and center parts) became detached. I lost several pieces of hardware in the crash. I was able to clip the bumper cover back in on the left side, and aside from that, I don't believe any bolts, screws, etc. are missing for the bumper cover. However, the spoiler seems to be missing about half of its hardware.
View 3 RepliesI have a 2013 Accent GLS and I have to replace the rear bumper cover. Any detailed instructions on how to do this?
View 2 RepliesThe red ones that are in the rear bumper, Do I have to take off the whole bumper?
View 22 RepliesI have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
How are you going to remove the chrome strip on the rear bumper. Mine got damaged and I need to replace them with a new one.
View 5 RepliesMy wife backed the truck into a pole and bent the driver's side bumper and one of the ears on the trailer hitch (the part that bolts to the frame). I bought all the parts that need to be replaced (the left bumper end, the hitch itself, and the plastic bumper cover), gut am hesitant to try to change it all myself. How hard is it to change out all these parts? Is there a write-up any where out there for this?
View 2 RepliesI have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 RepliesHow is the red marker light lens, located on either side of the rear bumper, removed to allow the bulb on the inside to be replaced?
View 2 RepliesCan I buy a replacement leather cover for the driver seat in my '04 LE Limited Ed.?
There is a tear in the outer side panel, right by the seam where it meets the back seating panel. I know there are companies that make leather interior kits where you pull off the fabric seat upholstery and pull on the leather, and that these kits are popular with new car dealers.
Where I can find an OEM replacement to match the rest of my interior, which is still in good shape? Would it make better sense to take the leather off of the setback and have a seamstress/upholstery shop set in a new side panel? Or, would I be best off to just find a complete seat that matches and just bolt it in?
Thinking about getting a used Camry. Is there any issues with any of the years in the seventh generation Camry? What are some of your likes and dislikes of your car? For example I have been told that on the sixth generation Camry you have to remove the bumper to change the turn signal bulb. I have never had to deal with this, just what I have been told.
View 14 Replies