I've noticed on first start up the RPMs go as high as 3000 for a couple of seconds and then drop to normal even at 68' degrees,is that normal? because if it is what will aspect when the temperature drops to 20 or even lower.It is a 2.5 liter 4.
View 1 RepliesI had my Honda Odyssey transmission replaced 2 years ago. The past few months, in the first mile that I drive the car on streets in our neighborhood, the car goes into high RPMs (about 3000) before it seems to drop into gear. It does this 2 or 3 times then works fine after that. The "Check engine" light is now on all the time. Sometimes, the car does one other weird thing--the high RPMs end with the drive/D4 light flashing on and off like a blinker (even if I change gears to D3. When this happens, if I turn the ignition off it comes back on and seems to function fine. I have had it back to the shop that did the work about 4-5 times to get it right. I like the guys but each time they return it to me, the problem remains. I took a 2000 mile trip with it and with the exception of this persistent problem, the van worked fine.
View 2 Replies I have a golf mk4 1.8T AGU, about one week after i had my k04-023 turbo on and all the Stuff that comes along it started "stall" (don't know if its the right word??) in the High gears, most 5th gear but it first start doing it when i hit boost (3000rpm)
I runs on Stock n75 valve.. I though i could be a boost problem, maybe the Stock system cant handle it? I did install a boost gauge to see if it was the was the problem, and it dont Seem like it. In first it runs from 1.4 bar and drops to 1.2. Same in second and third. But in 4 and 5th it goes to 1.7 bar and drops to 1.4.. I did wonder it maybe the n75 valve cant handle 1.7 bar??
I've made posts about a rough idle before now I noticed something new about it. I noticed when I approach a red light the vibrations don't start immediately. They start as soon as the RPMS would drop a little. They stay above 500 but it seems like it's below 750. As if the engine is slightly starved from power? Now i'm wondering if it could be related to another problem I have.
Whenever I start the car, the battery light flickers until the car is started all the way. This is on a 2007 Camry 4 cylinder. So far everything iv'e done is: New NGK Spark Plugs, NEW OEM mounts (all 4) Seafoamed the engine, Seafoamed the throttle body, cleaned the MAF sensor, New air filter, and cleaned the air filter box, replaced the PCV Vlave, new belt, new alternator (duralast), and a new battery (from autozone).
I was driving at 60mph and all of sudden rpm drop to zero went back to normal rpm after 5 seconds, pulled over thinking I blew some thing every thing seem normal is this a sensor problem.
2000 dodge ram 1500 5.9l 2wd
I have a 1997 Saturn, and have noticed for the past couple of months that when the car is idling at a stoplight, the engine seems to rev or almost skip a little bit. The RPMs go from about 1000 down to 500 for a couple of seconds, and this will happen once every 10 seconds or so. Otherwise, it runs fine...but this is happening more and more frequently than it used to.
I had the transmission rebuilt over the summer and its still under warranty. What might be causing this?
00 XLT 4.6 4x4 135k miles - New problem, on accelerating, truck hesitates for a couple of seconds before rpm's pick up. There is no stumble or bogging. It feels like I'm not giving it any throttle at all. And then it kicks in and takes off. It does this from a stop at idle, or at a steady cruise. Its an intermittent problem. No CEL. Air filter and fuel filter are about 3 months old. Haven't done any work to it since. Also, when there is less than a 1/4 tank of fuel, truck sometimes stumbles slightly off idle. Fuel pump starting to go?
View 6 Replies1997 escort lx wagon, manual, 173,000 miles... When I stop at a red light or stop sign, it takes 10-15 seconds for the idle to drop down to where it should be, and when I push clutch in to shift gears it doesn't drop down, it stays where it is. No codes are coming up. I'm thinking IAC....
View 9 RepliesI have done everything I can think of to this car. New; plugs, wires, distributor, battery, fuel pump, fuel filter, relay, and electrical lines to fuel pump. The timing belt is fine. The car has a rough idle and when I am stopped the RPM's drop below normal. Now it won't start. What can I try now?
View 1 RepliesI replaced my engine that had 155,000 miles with a newer used one with about 30,000 miles. since the swap my gas mileage is down by one third or more. Everything else seems fine except that my cold start idle is up to 2000rpm's until it drops to normal within 3 minutes.
View 2 RepliesWhen I start my 2003 Escape 3.0, the rpm's shoot up to about 3000rpms. After a few seconds they drop to about 2000 and slowly creep back up to 3000. When I put in gear, I don't even have to step on the gas and my vehicle goes. It maintains between 1500-2000rpms as I'm driving. When I come to a red light or stop sign, it lurches like it wants to go even though I have my foot on the brakes. I've replaced the IAC valve, TPS, had it checked for vacuum leaks, PCV valve replaced. I'm at a loss as to what it could be.
View 3 RepliesI have a code scanner which indicated that I should change the MAP sensor. I did that, and just for fun changed the idle air control valve and throttle position sensor. Now the idle is extremely smooth in park or neutral, but once I'm in a moving gear it's up to the same shenanigans, antics and tomfoolery I described in my original post: 96 Dakota SLT idles rough & stalls. So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drivebelt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 RepliesSo I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drive belt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 RepliesMy '03 7.3 is "surging" on idle. When warmed up, and idling, the RPMs will drop by 300 or 400 for a few seconds and then will correct and shoot back up. It cycles like this (every 5 seconds-ish) continually . I just put in a new IDM and checked the UVCH - is there a separate idle control mechanism that I need to have a look at? (2003, 7.3, 214K, stock).
View 14 RepliesIt was pretty warm this afternoon, had the AC on full blast. Drove into a left turn lane and stopped for the red arrow, the engine began spurring for a couple seconds. Then it caught itself but afterward felt the whole car shake for like a minute, drove off once it was a green arrow and nothing else happened. Has any one else had this or a similar experience happened to them? My Camry just hit 30k miles, I wonder if it just had a "spaz" (or whatever you want to call it) attack.
View 4 RepliesSummary of Events:
Lower radiator hose decided to disconnect itself.
Stopped and had car towed home.
Connected hose and filled coolant system.
Car is hesitant to start and takes a couple seconds of cranking.
Misfires in cylinder 3, and a few in cylinder 5, no other codes.
New OEM plugs, no change.
Swapped coil packs around, no change.
Idle is rough but at speed, everything is smooth.
My car has been having a cool start acceleration problem in the past couple weeks.
After I start the engine, switch to D ("Drive"), and step on the gas paddle half way, the car will go forward for about 1 feet. Then it will choke for couple seconds. If I release the gas paddle and then step on it again, it will do the same thing.
However, if I just slightly step on it and let it slowly accelerate, it will be fine. Also, it only happens on a cold start.
I have a 99 4.2L 5 speed reg. cab swb. It recently started idling high (which returns to normal at a stop after 3-5 seconds). While in neutral and in motion (coasting) the idle is around 1500-2k (idle=no throttle input from me). The first time it did this it took a while to start (7-10 seconds) and smoked like you wouldnt believe for about ten seconds. Smoke cleared, eyes returned to normal size, heart rate returned to "normal", but the high idle remains. Drives me nuts. No CEL, no codes, just a fat bald man scratching his head and a little nervousness.
View 5 RepliesI was preparing my sons 2004 escape (3.0L) for a vacation by changing out the spark plugs. When done, I noticed that the engine lacks power during acceleration and has a very high shifting point from normal (3500 rpm). There were no DTC's set so I took it all apart again, this time changing the intake manifold gaskets both upper and lower. I put it all back together and have the same issue. I have double checked (actually quadruple checked) all of the vacuum lines and electronic connections but to no avail. The truck still has very poor power, at idle it bottoms out around 500 rpm. From a start at a stop sign, with the pedal floored it takes a city block to get up to 35 mph. Where I can look next?
View 9 RepliesFor reasons I can't figure, the Temp gauge on the wife's Explorer is shooting from normal to high in just seconds. Then, it drops back to normal. When I looked at it this afternoon, I noted 2 things.
1) There was no sign of a coolant leak or overheating.
2) There wasn't ANY coolant in the tank!!!!!!!
The truck has evidently been running fine while this is going on.
At the beginning December I put my brand new winter tires (general altimax arctics) on the factory steelies and put them on the car gearing up for the snow. Not to long after the install I notice that I was getting a very strong engine vibration starting at 3,000 rpms and it stopped around 3,100 rpms no matter what gear I was in. At first I though it maybe just the cold affecting the engine. Well...
Last week I put my summer rims and tires back on for the 1,600 mile trip to MO and back, and like magic, no more heavy vibrations. Smooth acceleration throughout the normal driving rpm range. I just changed the oil and tranny fluids Tuesday after we got back and with the warmer weather the car is running smooth as silk. Still an awesome car with awesome mileage and couldn't be happier.