Camry :: Power Window Regulator Replacement
Aug 17, 2013
This procedure explains how to remove the driver side, rear door panel, test the power window motor and switch and replace the power window regulator assembly.
Tools Required: #2 Philips screwdriver, small slot screwdriver, 10mm socket wrench, jumper cables, set of test leads with alligator clips, DC voltmeter.
Cost: In the end, I did not end up buying a new window regulator assembly, but I think a "Dorman 741-356 Rear Driver Side Replacement Power Window Regulator with Motor for Toyota Camry" would work.
1. Locate the anchor (red arrow). Push the center in and then pry the anchor out with a slot screwdriver.
2. Remove ashtray, pry and remove the rubber liner and remove the #2 Phillips screw.
3. While pulling the door handle, carefully pry the plastic trim piece away from the door handle bezel and remove the #2 Phillips screw.
4. Pushing the door trim piece forward, pry the rear upward. Note that there is a plastic tab (red arrow) at the front of this trim piece, so it is necessary to lift it from the back to avoid breaking it.
5. Squeeze the electrical connector to remove it from the socket and then set the trim piece/switch assembly aside.
6. Remove #2 Phillips screw (red arrow).
7. Remove two #2 Philips screws (circled in red) at the bottom of the door.
8. Grasp the bottom of the door panel with your fingertips and gently, but firmly pull outward to disengage the 9 snaps on the door.
9. Lift the door panel upward to unhook it from the door. Carefully set the door panel on the ground.
10.Pull the white plastic cable guide out of the sheet metal holder and rotate the cable housing to disengage the cable from the mechanism. Pull the green plastic cable guide out of the sheet metal holder and rotate the cable housing to disengage the cable from the mechanism. Gently set the door panel aside. %
View 14 Replies
Advertisement
It looks like I am going to have to replace my front driver's side power window regulator soon - it is making a bad sound when I power the window down and also the window glass seems to be loose and clunking when I close the door with the window partially or all the way down. These may be two separate issues. I think the motor itself is fine.
In looking at replacement window regulators I see two options. The lower cost option ($50-70) is to just by the regulator cable/pulley/gear assembly.
Like this: [URL]
But I also see options to buy that assembly pre-installed on the metal door plate that it attaches to: [URL]
So, my question is, once I have the door apart and the glass out, is it relatively easy to install a new cable/pulley/gear regulator assembly, or would I be better off buying a pre-installed regulator on a new metal plate?
I know how to take the door apart as I have done this before to change out the door lock/latch module.
View 2 Replies
Can the power window regulator motor on a 96 Explorer be repaired? I can hear the motor make a thump noise but it is bound. I have seen videos on earlier model Fords where the motor can be taken apart and the plastic spheres can be replaced but I didn't know if that can be done on a 96 model.
View 1 Replies
Where I could get a front driver side window regulator I am having a problem finding one and tired of the window going up and down slow due to the window ending up on the wrong side of the rubber.
View 6 Replies
I just picked the car up at the dealer, after having had the new window regulator installed.
They were just closing service and I didn't think to test the window before I left the lot, but on the way home I put the window down... nice and smooth and quiet.
Then I put it up and there was a loud thunk at the top of the travel. I tried to capture it in the attached video but it isn't nearly as "bass-y" as it is in person. Crappy mic on the phone I guess.
My other three windows have a very soft sound as they reach the top of the travel, nothing like this thunk. What it might indicate?
Video here: [URL] ....
View 4 Replies
2006 LS V8: Looks like the driver's side window regulator broke this morning. On the way up, it made a couple of "crackling" noises and stopped. Window goes down but not up. I hear a slight hum of the motor when pushing the up button.
Looking at replacement parts, some offer with motor and some without. There is a youtube video showing the procedure for a 2000 LS Passenger Side. I assume the procedure for mine is similar.
View 1 Replies
I was away from the Phaeton for 2 weeks and managed to let the battery run down to totally dead (left Radar detector on). Started her up on the secondary battery and everything seemed fine, but, a few days later, I had occasion to put down the drivers window - no joy. Tried the passengers window - again no joy. The rear windows were fine. When I try to operate the window I hear a short sound like the window is starting to open, but nothing happens and the glass does not move. Because it is so unlikely that both front windows would fail simultaneously, I suspect a controller may need to be reset. Is there any way to trouble shoot this without a VAG COM?
View 24 Replies
What do I need to do to replace the drivers side window motor in my 97 f150? Do you need special tools? or just pull the panel loose from the door replace and motor and push the panel back on. Or is there plastic clips that are going to break off?
View 7 Replies
I would like to replace my drivers side window. It has some deep scratches and with the windows tinted it really shows. Been looking for place to buy from but can't seem to find one.
The only one I found was on Amazon but was trying to find one cheaper or with no shipping charge.
View 10 Replies
My 2006 F350 has a nasty air leak/whistle coming from the rear power sliding window, unfortunately I found the one of the vertical seals laying in the cab. Looking for some insight on if there is a replacement seal kit, where I can find one and how difficult is it to install?
View 2 Replies
My wife's 2006 Camry left rear power window motor is bad.
I already checked the plug and there is voltage when I use the switch.
View 2 Replies
Went looking at replacing the fuse for both power outlets, Couldn't find it. Checked under dash and engine compartment. Checked them all since I didn't know which one was it. Where to look? Everything else works fine on the car. radio, lights, all
View 2 Replies
My left rear window is stuck in the down position. I thought the motor was burnt out because it was very hot, so I got a new one and replaced it and the symptom was the same. So I plugged the old "bad" motor into the harness and when I turn the key on it starts spinning, which would explain why it was so hot when I took it out. I'm guessing I've got a bad relay or something but where do I look now?
View 8 Replies
What are the symtoms of a bad fuel regulator?
View 1 Replies
2005 camry ... How do i replace the dash power outlet? I have the heating and air panel out and the bottom of the outlet panel unsnapped. I can't figure out how the top comes loose.
View 1 Replies
I have a 2006 Toyota Camry LE. The power outlet is busted. It works just fine (it does have power), its just that the spring inside it has broken. Consequently, it doesn't hold my ipod car adapters or car chargers. What are my options? Will I be able to get an OEM part? Is it worth it or will a generic part suffice?
View 1 Replies
2003 Camry XLE - Power Window/Door Lock. does these switches have back lighting? None of the four door switch controls light up even with the dimmer turned up full.
View 5 Replies
I have a 2004 camry with 107k miles. The power drivers window makes a pop when leaving the seal. I have cleaned out the track, lubricated with silicone spray, but this did not solve the problem.
When I put a little pressure on the top of the window with my hand it comes down fine without popping.
I am thinking it may be a track issue. It appears the window is shifting 1/4-1/2 " to the front just before it contacts the seal.
View 2 Replies
I have a leak in the fuel pressure regulator housing. Seems like a common problem. I ordered the new kit from FICMrepair.
While I wait for the new kit to arrive, is there any risk other than loosing a few mm of diesel fuel driving the van? Will the leak damage injectors?
It's not gushing out. I have smelled diesel fuel for the past 3 months and could not locate it until last weekend.
The kit is coming next week and I like driving the diesel van over my under powered 6 cylinder E150.
I want to clean out the EGR while I have everything apart. I have heard that some people just disconnect it. There is a write up about in the tech folder and it went way over my head.
View 4 Replies
What is the procedure for changing the passenger side boot on the power steering? I've read the Chilton repair manual, looks too easy.
View 6 Replies
After fixing my fuel pressure regulator leak, I found the fuel soaked track bar bushing coming apart.
The whole thing is available, but do the bushings are available? I've seen some poly kits for the '04 and older but nothing for the newer trucks. It's not a budget breaker either way, but it seem silly to throw away the giant bar because the bushing is shot.
If these will fit? 99-04 F250 Track Bar Bushings Red....
View 14 Replies