Camry :: Overflow For The Radiator Started Gurgling / Head Gasket Replacement
Apr 4, 2015
On my car which never overheated but one day the overflow for the radiator started gurgling and I turned off the car fast and brought to our mechanic and he advised that it was head gasket after changing hoses and water pump. when I first realized the gurgling and shut off the car and never ran it again did i save the engine and replacing the head gasket is a good thing. also did I save the head from warping by my actions?
View 13 Replies
Advertisement
A 2007 Toyota Camry 2.4 was brought into the shop I work at smoking badly and running terrible. The car had been run hot because the radiator was busted and it blew the head gasket. So I pulled the head and sent if off to the machine shop to have it checked. They said it was badly warped across three cylinder and they resurfaced it.
Now I have everything re assembled, but it simply will not start. All the timing marks on the timing chain line up where they should be. All four coils are firing. Injectors wires pulse noid lights. A few times it has hit and sputtered like it was trying to start but never successfully does.
View 9 Replies
The problem is my new-to-me 97 Ford F150 5.4L SOHC engine, auto transmission, is overheating after driving it for a short while. Seems to be fine at idle. I have read previous posts with the exact same issue, but the consistency seems to be all over the map from burping the system, head gasket, thermostat, and possibly a plugged radiator.
Backstory:200,000+ miles.
Truck sat for 6 months after previous owner broke the shift cable.
Truck was in a front end collision. Frame looks bent underneath the engine.
Previous owner had overheating problem. He said he changed the heater core. Looks like brand new coolant in the system so story probably checks out. Desperately needs an oil change. Very black oil.
Previous owner thought the system needed a burping. So I'm largely assuming the problem started after the heater core change, or he misdiagnosed an overheating problem and thought the heater core could cause it. I have found a radiator cap and thermostat in the truck which seems to indicate he tried many things to fix the overheating and was unsuccessful. Engine looks pretty clean for the miles.
Symptoms/Backyard Tests :
Blows cold air with heat on highest level and on defrost.
Blender door fuse intact.
Doesn't overheat at idle.
Ran the truck for 15 mins with the coolant bottle fill cap off on level ground to try to burp it after draining some coolant and checking the thermostat orientation. Coolant level increased in the bottle. Large air bubbles came out. (Another session before this one, I ran it for 30 minutes with no coolant cap, and eventually coolant overflowed the fill bottle. Normal or no?)
Seems to overheat after the thermostat opens. After doing the 15 minute warm up/burp, I took it for a test drive. I drove it about 20 blocks with the temperature gauge on the dash reading the same as the warmed-up idle temperature. Got to the 20th block and the gauge immediately spiked to overheat with the oil pressure dash light coming on. I could be mistaken as the oil pressure light almost looks exactly like the overheat dash light. But I'm pretty sure the temperature icon was on the right side of the oil can icon and not the left.
After the above drive: Upper rad hose too hot to touch.
After the above drive: Lower rad hose medium warm. Could hold on to it if I felt like it.
After the above drive: Upper part of rad pretty hot. Not Insta-burn but hot. Tempature decreases to warm to cool as you go lower down the rad.
After the above drive: Both heater core hoses going to the cab luke warm.
Coolant looks brand new.
Radiator looks slightly bowed. Probably from the accident? Otherwise looks clean and minimal bent fins.
Drained some coolant and pulled the upper rad hose to see if the thermostat was upside down. Looks installed correctly.
No signs of weep hole leaks from the water pump.
Fan seems solid. Has maybe 1-2mm of play in the bearings.
Something that looked like steam from the muffler at startup, that disappeared after getting closer to a normal range warm engine.
I have driven crap cars for many years and I've never seen a plugged radiator which makes me skeptical of it being that. All the radiators I have changed were because they were eventually leaking from cracks in the radiator.
I would also be interested in doing an informal poll if you have read this far and have had this era of F150 that overheated. Have you ever repaired the head gasket? And/or have you ever changed the radiator?
View 9 Replies
My dodge spirit has 80,000 miles on it. i love this little car, however, yesterday for some reason while driving my radiator reservoir started to overflow. I didn't notice at the time, but when i got home there was water in the engine compartment and it was obvious that it had come from the reservoir. This morning I went out to drive the car and at first the engine shook a little but then started running smoothly, when I backed out i noticed a rather large cloud of white smoke (water in the engine) I immediately turned off the car. I have a feeling I will need to rebuild this car's engine. What I should expect to pay for this repair?
View 6 Replies
My car blew a head gasket in the fall. A friend replaced it and rebuilt the head. The head was taken to a machine shop, was not warped but was planed just a little. The engine was put back together but it continues to gunk up the radiator with yellow gunk. We put block sealer in and it today there is gunk in the over flow bottle again. This is a 1998 Honda Accord with only 103,000 miles on it when the gasket blew.
View 2 Replies
I have a 2000 Ranger, V6 4L, and I believe my head gasket is blown, my radiator fluid goes straight to the oil pan. It has probably been leaking for a while, I did not realize it was leaking internally, I had been adding coolant for a few months but thought it was my radiator leaking because it had a crack in the housing, so I had that changed, but then a few weeks after that It gave out. I drained, and flushed the engine twice, and just parked it. My question is, should I just have the head gasket changed, or does it need a new engine because it had been leaking for a while and not sure what kind of damage it has done internally.
View 3 Replies
I have a 03 250 gas 5.4 trying to find out the cooling system problem. I've found what I've read to be common oil leaking from back of passenger head. I had never noticed this before but it started very slight now overflow started bubbling over.
There is no coolant in oil no white smoke. My cooling system leak is just head gasket and gasket change could solve the problem or should I did deeper?
View 9 Replies
I have a 2002 pontiac montana that needs the head gasket replace. Mileage is 152,000 miles with a v6 engine. I would like to get at least another 75,000 miles once the repair is done. Is it worth doing as alternative is to scrap the van and buy a new vehicle...
View 3 Replies
I have a 2007 Subaru Forester X Sport Model. I just passed 86,000 miles - much of that open road driving. My head gaskets need to be replaced. This seems somewhat early. I recently switched from using regular motor oil to a synthetic blend that the dealership suggested. Is there any history suggesting that switching lubricants might cause the head gaskets to deteriorate?
View 10 Replies
I recently replaced the head gasket on a 95 Geo Prizm. Now when I tried to start it, all I get is the starter clicking. I tried tapping the starter solenoid, to no effect. The only electrical that I messed with during the head gasket replacement was to disconnect the battery.
View 4 Replies
I have a 1997 Honda Civic that I was given by an elderly neighbor's daughter after the elderly lady went to the grocery and ended up 100 miles away when she could not figure out how to get home. The car was smogged at the beginning of the year but when I got it ran very rough and the temp went nearly to overheating on the drive home when I was stuck in stop and go traffic.I found the radiator fluid level low and an oily residue inside the radiator water bottle. I took it to a mechanic to check it out and was told it had a blown head gasket and maybe worse.
I am thinking of buying a rebuilt cylinder head and replacing it myself but I am not sure how to diagnose if any other damage could have been caused to the engine. It's hard to know but I am guessing that the engine was damaged during the 100 mile road trip due to low coolant level. It turns out short term memory loss was the diagnosis for my elderly neighbor. I filled the coolant level and ran the engine for a bit and the temp stayed normal but the rough running remains. The oil dip stick shows no signs of coolant in the oil and the coolant looks bright green when I looked in the radiator after topping it up with some water.
Any way to detect if I could be facing bigger issues like failed bearings? I am OK to do the head replacement but an engine replacement starts to get into the realm of what it would cost to get another car of the same age.
View 18 Replies
Vehicle 2007 Ford Explorer Sport Trac with 4.6L
Ok, just did a head gasket replacement. Everything is now hooked back up. Now when we try to restart the car, we get lights, but nothing from the starter. Also the OBDII code puller can't communicate with the car. Also the security light flashes very fast when you try to start.
View 9 Replies
So, I blew my head gasket and have been looking for what to replace it with. From what I've seen, just an OEM gasket would be best.? I'm also putting ARP studs in it, unless there's another brand I should put in it.
View 3 Replies
I need walked through the take down to replace the head gasket on an 05 mountaineer with a 4.0. I've never worked on one of these so I don't even know. I havent even seen the engine to know where to start.
View 3 Replies
While I was looking at my coolant level in the overflow tank yesterday I noticed pinkish coolant residue on the overflow tank cap and then looked at the radiator cap and it was covered in the same pinkish coolant residue.
2006 Cam LE 4 Cylinder, 52,000. Already done 2 coolant drain and fills--the Head bolt issue scares me.....
View 6 Replies
How much should it cost to have it replaced? car seems to be running just fine but leaking oil.
View 6 Replies
I'll start by saying that I have a 2004 GTI 1.8t. Picked the car up from a local junkyard around 2 months ago for a grand. They were unsure why it was running rough, so I took a chance and picked it up. Got it back to the house and the timing chain tensioner was shot. Ordered a new one up. Went to a friends house and he noticed it was producing some white smoke from the tail pipe and suggest I take a look into my head gasket. Replaced the head gasket about 2 weeks ago. Got everything buttoned back up and it smoked even worse.
Being my first head gasket change I accepted the fact that I may not have been thorough enough in my replacement and stripped her back down once again. Made sure I was extremely focused and replaced the head gasket again. I just got her back together and she is still smoking.
I know for a fact that coolant is getting into my pistons and causing my spark plugs to foul out. Too much moisture in the cylinder.
View 13 Replies
Ive had both the piston rings and head gasket replaced on my 96 civic. This isn't for high end upgrades or anything just because i need to pass smog and both needed replaced. I am being told that once i get my car i should drive slow for 100 miles before i take it to smog. Ive read many different opinions on seating the rings but all are for people upgrading their car. I am sure I just got normal replacements.
View 19 Replies
2007 Sports Trac .. Does the motor need to be removed to replace head gaskets? 4.0 sohc
View 1 Replies
I'm going to be doing head gaskets on my 2006 F350 6.0. I know I need the head bolt tool and head lifting fixture. I have the tool to release the injector wiring plug from the head. Are there any other specialty tools I need? I saw in Hot Rod magazine a few months ago there was a new head gasket for the 6.0. Unfortunately I don't have the magazine anymore. I can't remember the brand of gasket. I know everyone in the past has said use OEM Ford head gaskets. Lastly, can I do the head gasket job and put studs in without pulling the cab or HVAC box?
View 7 Replies
2000 Subaru Outback. The head gaskets have begun to leak slightly (oil and coolant), even though I brought it in for the recall at 80K and the dealer put in the additive. I recently (111,000 miles) put in another bottle of the additive coolant conditioner and the leak seems to have at least slowed to a trickle. Is it really essential to have the head gaskets replaced? Or could I just keep an eye on the oil and coolant levels and put a bit of kitty litter in my garage? Some of the information I googled indicates that the recall of this car is for an OUT leak and not an INNER leak--which would be worse. Is it true that an OUT leak is not as worrisome?
View 5 Replies
