Camry :: Noise Coming From Left Front Wheel At Low Speeds
Oct 11, 2011
I have a mystery noise coming from the left front wheel.
I have a 2002 Toyota Camry, 4 cylinder, SE Model, 150,000 miles
It sounds like metal on metal. It only happens at low speeds (less than 20mph). Only happens when I turn the steering wheel right. While I am driving straight, the noise is not there.
Here is what I have changed on my car in the last 3 months:
-New Brake rotors
-New Brake Pads
-New sway bar link
-New sway bar bushing
-New outer tie rod end
-New lower ball joint
More Observations:
-CV joint is not leaking
-Checked the struts for proper movement
-The strut seems properly seated in the bearing plated, nothing broken (under the hood)
-I confirmed that the disc brake shield is not in contact with anything
Am I missing anything? What else could be causing this?
View 8 Replies
Advertisement
Over the past few months I'd noticed an intermittent grinding noise coming from my left front wheel at low speeds. I took it in once but it refused to play along so I finally managed to catch it on camera and let the dealership listen to it. They booked me for today, saying it sounded like a wheel bearing (to which I agreed) and I dropped her off around ten, not expecting it to cooperate for the second time.
I got a call from the dealer around 2 PM saying that they were able to duplicate the noise and that when they took the left front wheel off and ran the car on the lift with the rest of the wheels off the ground, the noise went away. Even stranger still, when they put the wheel on the tire balancing machine and spun it, gronch, gronch...gronch, gronch....gronch, gronch. It was coming from inside the wheel! I gave them permission to dismount the tire from the wheel and about ten minutes later I got another call saying they'd found a handful of tiny hard rubber balls inside the mounted wheel/tire assembly that were rolling down the inside of the wheel and causing the grumbling at low speed.
Here's the kicker: they were in all four wheels! The tech even saved them for me so I could take a look and they don't look like anything mass-produced; some are larger than others, some are round and some are oval-shaped but when I dropped one on the glass advisor desk, it made a very clear 'Clink!'.
View 29 Replies
I've been having a lot of noise coming from the front left tire, and I finally had it diagnosed as a bad wheel bearing today.
I noticed that the front wheel bearings are sold individually while the rear wheel bearings are sold as hub assemblies. Is there a certain way that the front wheel bearings have to be removed and pressed on? I'm trying to see if this is a DIY repair.
View 14 Replies
I just put on some new wheels and tires (19" VMR RS4 reps) and there is a weird clanking noise coming from the front left wheel when I am going around 10 mph. It doesn't happen when I'm moving faster, but I have checked it out and don't see anything rubbing or hitting any metal pieces. Could it be the suspension or something else? I haven't heard it around any of the other wheels.
View 12 Replies
Ok at 40 mph and above I have a loud humming noise coming from my left front wheel. I replaced my rotor and pads due to normal wear. I also replaced the bearing. No fix. Tires were rotated a month ago. Could it be my CV joint? The boots are fine.
View 3 Replies
So whenever I brake while reversing (and rarely while moving forwards) I hear this odd grinding noise coming from the front left wheel and can feel it through the brake. Im not a petrol head but I decided to replace a wheel bearing hub myself recently to save money. I am pretty sure I reconnected the anti lock brakes correctly though I doubt it's that. My brakes are good.
View 4 Replies
I have a 1999 VW and i have this grinding, wobbling noise coming from the left front wheel side. I brought it to the dealer and two other mechanics and they can not find why there is that noise.
View 1 Replies
Noticed a clicking noise when only turning left out of a parking lot today? What this could be? Sounds like it was coming from the driver side front wheel?
View 2 Replies
2013 Camry SE; I am experiencing a plastic buzzing noise coming from the left side of the steering wheel, the noise seems to be coming from the small compartment area (below the AC vent). If I press my hand against it, then the noise stops.
View 3 Replies
I have a stick shift Camry 2004 with 160K miles on it and I hear a popping noise (not clicking cv joint noise) coming from the front left side . I hear the noise when I drive off from a stop regardless of whether I am turning or not but mostly when I release the clutch after changing gears on second and sometimes third gear. I was told by a mechanic and a ntb tires and a former toyota mechanic it had to be the struts.
I figured what the heck ordered new mounts and struts had and I installed them and had the car aligned. That did not solve the problem. My next guess was the engine mount by the transmission so i changed that and still no success. The former toyota mechanic told me he now thinks it's the transmission but I am skeptical. How to diagnose this? BTW 95 % sure the problem started when my wife hit the sidewalk really hard (so hard I had to change the rim).
View 1 Replies
I have developed a sounds that sounds like metal on metal. Not a grinding but more of a "swish swish swish" light metal rubbing when the truck has been running a mile or two. I can barely hear it over the radio but its very noticeable when the window is down. It is not affected by the pressing the brakes and it gets louder and faster in direct portion to speed. It will occasionally leave and start right back up. I touched the front rim around the hub and it was hotter than I wanted to hold onto. It didn't burn but it was hot. It was 105 degrees that day. Here is what I have done.
I replaced that front hub in 2010 and probably have 50K miles on it. I did the 3-9 test and there was no noticeable play. I spun the hub and while it seems to spin ok it does seem a little dry.... I will pull it tomorrow and see what it looks like.
I pulled the calipers off and the brakes pads are at half way and there is no burnt smell. I spun the rotor and it seemed flat and straight. I do have a small tiny lip all the way around them on both sides but I figured that's normal with 265K. I pulled the pins and they were dry but they didn't seem to be sticking. I cleaned them up with the boots and am going to replace them when I get some brake grease tomorrow. I have not looked real hard at the caliper but I plan on pressing that with a C-Clamp tomorrow to check it. Since the rotors and pads looked OK, I assumed there was not a stuck caliper although haven't ruled it out. The axle behind the hub seem to spin freely before I removed all this stuff and the hubs are not locked.
I think I covered it all .. I also thought it could be a rock or stick but nothing came out of my caliper or rotor when I took them off ..
View 14 Replies
My 99 F250 has just recently started making a "rattling" noise. The noise sounds like its coming from the front left wheel area. The noise is constant while driving down the road, its NOT created by bumps or anything, its a constant noise while moving.
View 3 Replies
My '98 Honda CRV with 190k miles has begun to make a curious sort of noise. I noticed a sort of humming noise coming from in front and somewhat to the left of the steering wheel a couple weeks ago, but could never get it to happen while I had the hood up in my driveway. The other day I rolled down the window and drove slowly around my neighborhood to figure out what made the noise happen.
First thing I learned is that it is much louder than I initially thought. And it sounds like a sort of screeching metal on metal sound, with a sort of humming. It always starts when I am moving slowly, such as when starting from a stop at a stop light, or going very slowly around the neighborhood. Turning the steering wheel seems to aggravate it, and make it more likely to start screeching. It will begin while driving straight, however. Once the noise begins, it stays until I come back to a complete stop.
I even tried stopping it by putting it in neutral and using the parking brake, and no difference, so nothing to do with the brakes. The brake rotors were also turned by the previous owner before selling it. My first guess would be a CV joint, because the boot on that wheel is not sealed properly. But my father, in his experience, says bad CV joints could make the steering feel more loose, and when starting and stopping you could feel some slop, neither of which he could detect when driving it. Steering feels tight, there is no play, and I have not been able to detect any other deficiency besides that awful noise.
So, is this a CV joint? A wheel bearing? Is it something else I have not thought of? And, how difficult are these to replace yourself with a good set of tools?
View 11 Replies
I have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 Replies
2007 camry le with 85k miles, there is a bad vibration in the front end, the steering wheel rocks, and when you turn right or left at slow speeds there is one knock, not a clicking, just one knock, also noticed the front driver side wheel has heavy wear on the outside corner of the tire, cv joint, bearings...
View 3 Replies
So I was searching around online and it seems this thing happens to some ppl after lowering their cars. I'm getting a loud pop/clunk noise from the front left side only. Seems that's the most common place ppl are having this type of issue with. What it could be? My mechanic wont be able to look at it till Friday. So not sure on what to do. The sound only happens when I'm hitting bumps on the road.
View 6 Replies
Heard an noise coming from the front of the car when in reverse turning wheel and braking only happens when im braking and make some turns not all turns.
View 9 Replies
I have a pulsating shh shh shh noise from my front left at low speeds. The front pads are brand new, so im ruling worn pads out. Also, it stops when the brakes are applied.
View 5 Replies
So... Took my car into a tire shop (tire pros) to get a screw pulled out of my front left tire... And after they finish the job - the guy comes up to me and says "your front brakes don't have much life left." I said, "I know I'm planning to change them in the next couple of weeks"...
He then said, "well I think your sensor just went off, when I pulled the car around.." I said "okay", got in the car and drove off - no brake light what so ever.
Anyways, A few hours later when pulling my car around the corner on the way home - I noticed that I am all of the sudden getting a random scraping sound from the front-right rotor anytime I turn the well all the way to the left at slow speeds...
I'm not too worried about it - just want to make sure these guys aren't trying to sabotage my car! The only thing that kills me, is that I didn't have the sound before and no all of the sudden I do? I'm assuming they somehow slightly moved the pad, causing it to somehow squeal - I'm just not exactly sure what they did...
View 13 Replies
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 Replies
So while my wife was driving down the highway, something rattled under my Camry, possibly front around the left wheel, under the engine or the like, then it came off. She said it looked like a circle, cut in half (or like a horseshoe of something). She didn't notice any strange behavior or drivability issue. She got home fine. She just said, it could have looked like a brake shoe also. Because it's wet here, I can't get under the car to check, so before I get a chance to do that.
View 7 Replies
