I want to install some LED turn signal bulbs and lights but the flasher will flash twice as quick because of the burnt-bulb detector.
I have taken the flasher apart and tried all the tricks on the book to isolate each pin on the IC and changed the timing resistor without avail. I do not want to put in load resistor on the bulb end to fool the detection circuit.
I want to modify/cut off the detection circuit?
Turn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
2015 prius package 5 w tech package and HUD display, I found a flasher mounted up between the fuse box/ module assembly mounted on a clip! I have a led replacement flasher, but clip mounts and pin locations don't line up? I watch the video but I have nothing in area! Or I just need to install the resistors? Or it could be a combination circuit assembly where multiple function module all in one ?
View 1 RepliesI towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesI have an '07 Azera and the turn signal sound is intermittent. The signals flash normally, but sometime I hear the flasher sound inside the car and sometime it is dead silent. Cannot seem to correlate it to temperature or other factors. Any way, I assume as the lights flash with no sound that either the flash or the sound is electronically generated, but cannot be like an old school mechanical flasher. What makes the flasher sound in the Azera and where is it located?
View 1 RepliesMy 97 F150 4X4 's turn signal flasher buzzes all the time except when brake is depressed or turn signals or hazard signals are active. The flasher is a 5 prong one. What to check?
View 9 RepliesI'd like to put in a louder turn signal flasher on my 2007 F150 - where is it located and where I can get a louder one ?
View 1 RepliesI picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesExactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 RepliesI have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 RepliesI'm having an electrical issue that is driving me nuts. I have an '01 F-250 Super Duty that I just put a new battery in today. The truck normally runs great, I drive it to work everyday with no issues. Today, there is a noise coming from under the dash that sounds like the turn signal flasher, and the clock on my radio flashes in time with the noise from under the dash. All my lights are working ok, and all the idiot lights come on as usual when I put the key in the ignition and turn it to the on position. However, my truck won't start. It won't even turn over. I get nothing but a dead switch when I turn it to the start position. The starter solenoid doesn't even click. Like I said, yesterday everything was just fine. I knew my battery was going bad (6 years old), so I changed it.
View 4 RepliesWhat is the easiest way to change the flasher?
View 6 RepliesSo with 172,000 miles my truck has started a new trick. When I turn on the turn signals theyll flash or interrupt normally for a few times then stop. After I turn the signal lever off and back on again they start to flash again only to stop after several times. This happens to both the left and right hand sides. The emergency flashers seem to work alright. Is this a function of the indicator flasher SF631? If so, were exactly is it located?
View 5 RepliesI'm trying to figure out what has failed on my 2008 Santa Fe.
After stopping at a gas station today, my right turn signal came on and stayed on. By this I mean that the right turn arrow on the dash is illuminated and both the front and rear right turn signal bulbs are illuminated. They are all on steady, not flashing. Moving the turn signal stalk/switch does nothing. They all stay on when the car is turned off and the key removed. I have to disconnect the battery to get them to shut off. I tried pulling the turn signal, hazard and cluster fuses in the dash, but they had no effect. The switch for headlamps/park lights has no effect on the right side bulbs.
The left turn signal works normally.
Also, it may be related to having unplugged the battery a couple of times, but now the CD player shows "initializing" and I can't use it. The am/fm stereo works normally.
I need detailed instructions for how to replace the right (passenger's side) rear turn signal bulb socket and the subassembly that holds the remaining bulbs and inserts into the tail light assembly. I've done this once before successfully but now can't seem to make it work now.
Without the subassembly inserted and locked into place with its locking tabs, the turn signal bulb locks into place in its socket, and that socket in turn easily inserts and locks into place in the hole in the outboard corner of the lens through the rear of the lens assembly. However, I can't seem to install both the turn signal bulb in its socket and the subassembly that holds the rest of the bulbs. The two contacts on the underside of the rim of the turn signal bulb socket would indicate that that the socket installs after the subassembly, but then it has nothing to plug into. When it's installed first, I don't see how the bulb would be energized.
The owner's manual of course says to have the dealer handle maintenance in this area.
My 2007 Hyundai Santa Fe right hand turn signal light bulbs flash rapidly both in the front and rear, the left hand side is normal. I am trying to locate the turn signal flasher module but without any luck, looked under the dash in the fuse box and under the hood in the relay box. Is it in the relay box...
View 7 RepliesI have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 RepliesOK, few months ago, I bought a conversion kit from ebay: [URL] ....
I also installed the relay harness thingy as well: [URL] .....
Everything worked out fine for about two weeks, and then problem started. The bulb on driver's side, sometimes would not turn on. It's like it doesn't have enough power to initiate it. I tried with and without the relay harness, same result. If I turn it off and then wait for a few seconds, turn the switch, sometimes it would turn on, sometimes it wouldn't. And this happens to only the driver side and it drives me crazy.
So I guess the ballast went stupid, so i exchanged a new one. Same thing. I tried to switch the bulbs, no better result.
But here is the strange thing, i popped the hood, have someone turn on/off the light too see what's happening. When the light (driver's side) turn on, everything seemed normal. But when it does not, it makes this little buzzing sound for like 1/3 of a second, and a little flash at the transparent wire from the ballast to the bulb.
I mean one bulb is probably brighter than both OEM bulbs, but this is just so annoying...
My passehger side front turn signal does not work. I am not getting power to the turn signal part of the bulb everything else works running light cornering light ect. except no power at the plug for the turn signal that plugs into light bucket assy. The arrow in the dash blinks fast as if the bulb was blown, getting power to the rear but not the front....
View 5 RepliesMy front left turn signal won't work, the signal on my dash board doesn't work, and the signal in the rear blinks rapidly. but the whole right side is fine. this is aggravating, I have changed the lightbulb in the front and nothing happened. It still doesn't work.
View 5 RepliesMy daughter recently bought a 2004 chevy malibu. she had it checked by a mechanic, who said it was a decent car for the price. the turn signal does not work when she has the brake on.
View 4 Replies