I have a 6-cyl, 2000 Camry that is making a scraping noise from the right rear brake. After driving it for a while I put my hand near the rotor and it was hot. The other side wasn't. I changed the pads and rotors yesterday and it's still making the noise. I'm guessing that there's something wrong with the caliper. Do I need to buy a new one? Can I rebuild the current one?
View 6 RepliesBackground: 2003 jetta; just changed rotors and pads on rear wheels a month ago, they are disc brakes
So the other day I was driving in a school zone at about 20 mph when I heard a VERY loud sound, like I'm dragging metal. i might also describe it as two rusty metal plates being rubbed against each other, but really really loud.
The noise is related to speed, it sounds cyclical and speeds up as the wheel turns faster. It occurs when I am NOT braking.
I parked the car and came back to it a few days later move it and the sound disappeared for the first 100 feet and then came back.
We did 2 things - we changed the caliper, and we also noticed that a caliper bolt was missing. I am pretty sure the noise was coming from that missing bolt - i think the caliper became dislodged and was making contact with the rotor. The caliper also seemed to be dragging a little bit so we went ahead and changed it too.
The wipers on my Camry windshield are making a scraping sound as they sweep. I replaced the factory motor & transmission four years ago with one from a wreck. Working fine til now. How can I deduce it's the motor and not the trans - or the other way around. I did remove the complete unit and oiled it up. The problem remains. The motor hums nicely. The transmission arms do not rotate easily by hand.
View 4 RepliesI have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 RepliesMy right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
This is going to sound odd but here is the case: When accelerating in car from 0 mph to about 10-15 mph there is a noise coming from the rear. It sounds as if it is coming from the axial or something because it does it once every revolution. But the wierd thing is is that it does it louder when it rains or any moisture is in the air!
We had back right bearing replaced. But still makes noise. Don't think it is rock or tire because it only does it sometimes when speeding up. And does it very loud when raining or humid
05 Camry, 2.4L, 47K. Replaced the front brake pads two months ago. I put in Akebono pads and did nothing with the rotors as the original pads were not completely worn out and there is no vibration whatsoever in the pedal.
The pads have recently started making noise on brake application. I'm getting ready to take them back apart and re-lube everything. Should I take some sandpaper to the pads & rotors to knock off any glazing? Do I hit it with a course or fine grit? I have not had this problem happen in the past and was thinking that maybe it is the quality of the pads but I believe these are oem...
I have a 2012 dodge caravan bought new. After about 6000 miles the left rear brake began making a grinding noise, only when applied, every time the car sat more than a few hours, that goes away after about 2-3 miles. It began in winter and continues into the warm and dry days of spring now with 9000 miles total. Had it to dealer twice and inspection found no malfunction so they say its from rust build up because it goes away all the time and is nothing to worry about. It does not occur with the other wheels. My niece has the same van, in same geographic area and does not have this problem. Does this selective rust build up explanation make sense? Previously burned with bad brakes on a caravan, so am skeptical.
View 7 RepliesOur 2010 Toyota Camry makes a squealing noise as we back out of our garage.Does this mean we new rear brakes?
View 15 RepliesI've recently noticed that on my 2005 Gen 2, after starting the car, the first few miles I drive produce a gentle metallic rhythmic scraping sound coming from the right rear wheel.
It's only audible when driving at low speeds (<30 mph), and seems to disappear after the car has been driven for a few miles. But when I start the car fresh the next day, it has reappeared.
The rate of the scraping noise varies directly with the speed I'm driving. I think it only happens when I'm coasting (in Drive), and possibly also when I'm braking.
My guess is something is slightly misaligned or rusty - a disc brake? And the noise "disappears" when the metal gets warmed up?
Recently my 2001 Solara started emitting a scraping noise from one of the rear wheels. Mechanic says its a frozen caliper, and suggested a complete brake job (rotar, pads, etc). My question is, I've got reasonable skills, by buddy has major skills when it comes to working on cars, is that something that a shade-tree mechanic can safely do ? Also, as its a frozen caliper, does that imply I need to replace the caliper, or could it have frozen due to the pads ?
View 5 RepliesI just bought this camry recently, it's an 2008 SE 4-cylinder with about 95k on it. Everything is fine on the car with the exception of one thing. Whenever I start it after a prolonged period of it being off, say in the morning or sometimes even having it off for an hour and then starting it again, when I start it, a loud grinding/scrapping noise comes from the front of the car.
This noise lasts for a good 30-60 seconds and as the car picks up speed it disappears. It just happens whenever I start it. Now I'm not sure that if the brakes or jammed or is it something to do with the transmission. I mention the transmission because during the drive, the car seems under a lot of pressure as if towing a large trailer and has trouble accelerating. At times when going downhill, it actually is slowing down as opposed to picking up speed and as soon as I let off the gas the speed drop from significantly.
I know this isn't normal because I used to an 2005 Camry LE 4-cylinder. So I know how the engine and transmission behave.
I took it the dealer recommended mechanic and he said that everything is fine. He's a nincompoop really. I took it to my mechanic and he said that the axle and bearing need to be changed on the passenger side and just the axle on the drivers side. My mechanic is a family friend and is skilled in his trade so I know he's not trying to shaft me.
My rear brake makes a whining noise when I go on reverse. I know is brake related because while on reverse, if I barely touch the brake pedal the noise goes away. But without touching the brake pedal whines and sometimes loud and is embarrassing.
View 5 RepliesSo...I just took my car in last week to replace the TPS and noticed that the car is now making a weird sound when I reverse (out of parking spaces, etc). The sounds seems to be coming from the rear of the car the sound is similar to metal scraping concrete and happens intermittently. I'm wondering if this is a random coincidence or if this could be related to the recent work done on the TPS. If my brakes hadn't been completely replaced a year ago, I'd suspect it might be those. What could cause this sound?
View 5 Replies99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
I noticed that the driver side front wheel makes a metallic scraping noise while the car is turning right. It sounds like something scraping the rotor or shield behind the rotor ( a rotational/moving kind of scraping noise)
This only happens on a relatively sharp turn (wheel is turned 70~80% to the right). I don't suspect the power steering as there is no noise if the car is not moving even when wheel is turned to extremes. The scraping noise happens at any speed, as long as the car is moving. does not happen when car is turning left.
Note that I am 90% certain it is from the front... my ears may be playing a trick on me (kind of hard to listen precisely while driving). Where to start looking?
Was about three blocks from home when the front of the car started making a horrific metallic scraping sound as the front wheel turned. I mean LOUD. Did a quick look for something stuck in the wheels somewhere but nothing. It's not like a branch stuck in the wheel sound, but scraping a shovel on a steel beam kind of sound. Braking seems to change the makeup of the sound, but did not stop it. Parked it in the garage.
I pulled the left wheel off, looked and looked, and looked. Nothing. Fear and sadness setting in. Everything looked normal....except....a faint line on the rotor very near the inside edge. Got a mirror and looked some more, and there, wedged on the inside edge of the pad's metal part and the rotor, was a rock the size of a bb. At most. Got a small screwdriver and hammer and popped it out. Done. Sheesh.
Seriously it was so loud it was amazing. So store in file folder for future reference if needed.
The line can be felt barely with a fingernail and is half the width of a pencil lead, and goes under the innermost 1/8" of the pad. I'm thinking do I want the dealer to pull and turn it, or is it going to affect my braking at all. Pretty much gonna leave it be I think.
I have an electrical problem with the rear brake lights on my 03 Camry. The fuse keeps blowing the instant I step on the brake. I replace it and it blows immediately. So now i can't drive it because I have no brake lights. I'm thinking there is a short somewhere, where to start my troubleshooting?
View 4 RepliesGen 5.5 (2006 LE (57K miles), Rear brake drums and parking brake.
I want to get my parking brake lubricated and rear drums cleaned and adjusted. Is is difficult to lubricate the parking brake?
I plan on getting this done with a Mobile One oil change at a local garage.
I have a '05 Corolla with around 80,000 miles on it.I've noticed for the past few weeks that it makes a weird noise when I brake. It's what I would describe as a gurgling or almost groaning sound coming from under the hood. This only happens about every other day, and only when I've slowing pressing the brake to coast to a stop or slowing on a downward slope.
Took it to one mechanic who couldn't duplicate the sound and gave up.The brake pads are relatively new and the sound is definitely not coming from the tires.
My brake booster is making noise for a few months now. It works ok and brakes are strong but the noise is there. Any way to quiet it down? Or how much the replacement might cost?
View 1 Replies