Camry :: Loud Popping Noise When Put Car Into Reverse And Accelerate Then Apply Brakes
Jan 2, 2012
I have a 2010 Toyota Camry SE with just under 51,000 miles on it. Every time I put the car into reverse and accelerate to apprx. 2-4 MPH then apply the brakes, I hear a loud popping noise, and it sounds like it is coming from the passenger front wheel. Slight noise from the drivers front as well. This doesn't happen in Drive, only in reverse at a low rate of speed. My father and I have taken the front wheels off and tested it, seems to be a motor mount, curious if this seems rational or common in a newer car.
View 11 Replies
Advertisement
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 Replies
I have a dry metal on metal squawk noise when I reverse, I have taken it to a VW dealer, and they say "there is nothing wrong", or that they "cannot find anything". The noise is not constant, just when I apply the brakes in reverse.
View 2 Replies
I get this loud click noise coming from the front end of my vehicle when I apply the brakes. It seems to happen much more often than not, especially at low speeds. I can only describe it as some sort of loud clicky clanky sound, it's also a single sound, it doesn't go on and on and it only happens when I apply the brakes.
View 2 Replies
I have a 2015 F250 6.7L and I am having problems with the brakes. When you first start the truck and put it in reverse and hit the brakes there is a continuous popping noise coming from the floor board and it can be felt in the brake pedal. It feels like the brake pedal is kicking back, once you drive the truck a little ways down the road the brakes work fine but if you hit the brakes a few times in a row like coming to a red light the noise is there again and it can be felt in the pedal.
View 3 Replies
Not sure if this is a normal characteristics of our Fsport brakes, but when I am in reverse and I apply the brakes I hear a squealing sound. Is that normal? By the way my car just hit 20k miles
View 9 Replies
Having this problem on ride, clicking noise when you apply brakes in reverse? ( I had this problem as well on my previous toyota ) it's annoying that I have to hear this sound again. My car is 6 mo old and I just put 5000km so far on my ride, I guess i can let the dealer handle it ?
View 14 Replies
I just installed new brake pads in my 2WD 2009 Santa Fe. I bought the cheapest AutoZone pads. Now I have a loud squeal sound when I apply the brakes. If I apply a hard brake the squeal goes away. Until I apply the brakes again. Now, after install...I have been researching and noticed that the stock pads are ceramic. I did apply (Not once but twice) break grease on the pads. What the problem might be? Oh yeah, I did see that after 2007, oiling the caliper springs is required and might be the problem too. But I do not know where the spring in question is and how to oil it.
View 4 Replies
My 2007 Camry has developed a loud popping noise when sliding the sunroof open. It's as though the sunroof is getting caught under the vehicle roof before it moves to slide open. The motor labors pushing the sunroof past vehicle roof. I see no obvious obstruction. The sunroof makes no noise when going to the tilt position. I have tried the initialize process, but the problem persists.
View 14 Replies
I noticed recently that my car started this popping noise when braking in reverse gear. I never ran over anything and babied it for all the 6000 miles it has on the ODO. 2015 Camry
View 4 Replies
2003 toyota Camry. when coming to a stop and hitting brakes there is a poping sound. It almost sounds like metal hitting each other. What is this or causing this!?!? Also it is a 4cylinder automatic with 100000miles.
View 2 Replies
Ive got a 04 f350 that after u shift into 4hi or 4lo when u accelerate it it makes loud clunk noise in fwd or reverse hi or lo. With hubs unlocked it still clunks. Have checked, wheel bearings, axle U-joints, and driveshaft joints all good. So I am thinking I've got issues in t-case. Popped drain plug out and wow that dex merc 4 looks nasty. So thinking I need exploded view of transfer case.
View 4 Replies
When I put my 2008 Highlander in reverse and put on the brakes, it makes a very loud and obvious clicking noise. What this might be? I'm very concerned.
View 1 Replies
I just got a 2009 lexus gs 350 everything is perfect except when i go into reverse and back up slowly the brakes make a loud squeaking noise!! Its really annoying and embarrassing. I got the rotors resurfaced and nothing.
View 3 Replies
Intermittently, when I apply the brakes my car makes a wet, gurgling sound, as if I'm driving over wet rocks. My husband jacked up the car and said he sees something on the front axle CV on the right side, not on left, and said it looks like a bushing bearing. He said the brakes have zero grit and he let them spin under power (I'm relating what he told me as best I can, he's mechanical, I am not). I also have a rack and pinion leak, though small, he's worried about the hydroloic (sp?) assist going out. I can't say I know what any of this means, but he can't figure out why my car occasionally makes this terrible sound. I haven't noted any specific condition for the noise.
View 4 Replies
I have a 1995 Lexus ES300 with 130,000 miles on it. When I reverse, I get a low-pitch growling and as as soon as I apply the brakes by a high-pitch, ungodly screech. This noise is definitely coming from the rear wheel areas. I'm not sure which tire is the culprit (I hear both sides from while listening from both the inside and outside). It happens frequently but is particularly bad on rainy, snowy, misty, or high humidity days. Two years ago I replaced the pads and rotors. At this point, the pads look to have about 40% life on them yet. This problem started happening about a year ago.
My initial thoughts were that it was just rusting because of the frequency on high moisture days. But both noises are way too loud for that. My second speculation was that the emergency brake was catching, but after examining it I think not. I've taken the entire assembly (brakes, rotors calipers, and emergency brake) at each tire apart and looked for any obvious issues that look incorrect. No luck. I've also applied brake quiet with similar results. Now my thoughts are that the low pitch is the rotors being warped. But that doesn't explain the screech and why it only occurs in reverse.
View 1 Replies
My AM radio has terrible reception. There is humming noise that goes away when I apply the brakes. I will bring it to the dealer, but I know what they will say, "cannot duplicate problem" or "radio operation found to be normal".
View 14 Replies
It happens quite often, when i start the car, and apply brakes, then there is some sort of knocking sound coming from the rear. It sounds like someone knocking on the door... But the sound will disappear after a while. The car drives fine, could it be the brakes?
View 2 Replies
I have a 2007 Honda Civic with about 46,000 miles on it. I purchased the car "certified used" about 1 1/1 years ago. For the past several months I've been experiencing a grinding/crunching noise when I apply the brake in reverse. I've taken it to a Honda dealer and they more or less told me that it sounds like something could have been wrong with the brakes. They ended up telling me they couldn't find anything wrong and that my brakes are fine. I've called the dealer to see if they could look at it again, but now my car isn't under warranty and they'll charge me to look at it. What could be causing this noise? At this point in time it's more annoying than anything - I'm afraid if I let it go it might end up hurting something in the long run.
View 1 Replies
I just bought this camry recently, it's an 2008 SE 4-cylinder with about 95k on it. Everything is fine on the car with the exception of one thing. Whenever I start it after a prolonged period of it being off, say in the morning or sometimes even having it off for an hour and then starting it again, when I start it, a loud grinding/scrapping noise comes from the front of the car.
This noise lasts for a good 30-60 seconds and as the car picks up speed it disappears. It just happens whenever I start it. Now I'm not sure that if the brakes or jammed or is it something to do with the transmission. I mention the transmission because during the drive, the car seems under a lot of pressure as if towing a large trailer and has trouble accelerating. At times when going downhill, it actually is slowing down as opposed to picking up speed and as soon as I let off the gas the speed drop from significantly.
I know this isn't normal because I used to an 2005 Camry LE 4-cylinder. So I know how the engine and transmission behave.
I took it the dealer recommended mechanic and he said that everything is fine. He's a nincompoop really. I took it to my mechanic and he said that the axle and bearing need to be changed on the passenger side and just the axle on the drivers side. My mechanic is a family friend and is skilled in his trade so I know he's not trying to shaft me.
View 3 Replies
When I apply the brakes on and off while in park, I hear a "fluttering squeaking" noise. I examined the brake pads and calipers, and everything seems to be fine. I greased up all the brake hardware and no luck.
Also, I have a popping noise while making turns while I am not braking. I really doubt there is any connection with the brakes? I recently went testing in a parking lot, and while slightly turning from left to right I noticed the popping constantly. Keep in mind no brakes were applied.
Last year the dealer replaced the brake actuator and all arms were replaced. BTW, I am past my extended 100K warranty!!
View 7 Replies
