Camry :: Leakage In Rubber Hose Attached To Power Steering Reservoir?
Aug 18, 2015
So the big rubber hose attached to my power steering reservoir is leaking and my mechanic told me to replace it. I went to a couple of different Autozone stores and they both couldn't identify the correct dimensions of it. They told me to take it out and then bring it to them. This is very hard for me since this is my only car and how to pull the bottom bit of the hose out from whatever it's attached to.
I've measured the length to be about 2.4 feet but I'm not sure on how thick it is. I've taken a pic of the hose here:
View 2 Replies
Advertisement
Just checked out at 2003 V6 LE with 120k miles for $5500. Car seems to be in excellent mechanical condition but I did notice quite a significant power steering fluid leak, seems to be coming from the reservoir. I see that there are two hoses for about $80 each listed on Partsgeek.
Is this a common problem, can the clamps just be tightened, Could it be the reservoir it's self or even the pump too high a pressure?
Seems to be quite a lot of fluid running down the side of the car but after taking it for a test drive I didn't see any signs of it squirting out so perhaps it's a slow leak and been leaking for a while.
View 6 Replies
So I've been noticing my power steering in the reservoir has been going down for quite some time. Now its more noticeable than ever. Just about a month ago I topped off the tank to the "max" line and now its at the "min" line. I also notice the fluid on the garage floor. I've always had a lot of grease (I assume the fluid) all around the body and under the reservoir under the hood. It seems to be leaking from the hose where it connects to the actual reservoir. Maybe the clamp is bad or something.
View 14 Replies
OK, I have developed a leak in the power steering hose that connects to the fluid reservoir (the smaller diameter hose). The dealer only sells this as an assembly (all the way to the pump, and very expensive). The hose is molded. Need to replace just this first hose section? AutoZone and several others I checked don't seem to have this (at least on line).
View 11 Replies
Either one of my power steering hoses or the gear box is leaking on my 93 Ranger. It appeared the return hose was leaking where the rubber meets the crimp. So I decided I would go ahead and change the return and pressure hose to see if it stops the leak. It was a disaster. It's 2.3L manual transmission 4x2. I got the return hose off ok. I put the wrong size wrench on the pressure hose fitting at the pump but thought it was loosening but it was rounding the nut off. So I couldn't even change that hose. I installed the new return hose and retightened the pressure hose at the gear box.
Well it was a pain getting the flare fittings of the hoses into the steering box so I could tightened the flare nut down. I finally got them tightened, I think, but then when I started the engine fluid shot out of there like a water hose. It's coming from the fittings at the gear box that I thought were tightened. I reloosened and retightened them again and still it's shooting out everywhere. There is so little room getting a wrench on the hose fittings, it was slow going. What do you need to remove in order to get a good straight shot and installing these flare nut fittings and tightening them down right? If I remove the pump will it be easier to install the hoses on the gear box? I have to remove the pump now to change the pressure hose.
View 1 Replies
I lost my power steering on the way home from work today (40 mile commute). Stopped at a gas station half way. About 5 miles after noticing the problem. Lifted the hood and noticed fluid along the line towards the radiator. Reservoir was empty. So I added a quart just purchased from the station and noticed the fluid level immediately began to drop. Decided to finish commute home. Stopped after 10 more miles, reservoir was empty so I added another quart and finished the drive home.
My camry has 150k miles so I am not surprised. So I parked it at my house and looked under the hood/car, I definitely have one hose leaking in the engine area. It is the hose located near the radiator on the passenger side that comes from the reservoir. The "U" portion is metal and has corroded away. It spits fluid when the steering wheel is turned. The pump actually is pretty clean with no leaks from it.
But when I was underneath the car, there is a hose completely severed. Roughly 2inches of exposed hose before it disappears into a manufactured hole in the car floor with a rubber gasket around it to hold in place. Where this hose is supposed to connect too. It drips P/S fluid, but nothing changed when turning the steering wheel.
View 6 Replies
just found out about this a few days ago. It seems that the leak is between the fluid container and the tube. I just used some zipper to tighten up the connector. Where to buy this tube and the steering wheel fluid, and how much are they? My car is a LE V6 2007.
View 13 Replies
My power steering fluid reservoir is a little low. Which type or brand of power steering fluid should I fill it up with?
I know that I should use Dextron III, but does the brand matter? Or can I mix the OEM fluid with an aftermarket fluid.
View 3 Replies
The Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?
View 7 Replies
I have a 2006 Camry 4 cylinder. The bigger rubber hose coming out from the power steering fluid reservoir has been leaking for quite some time now. I've tried putting a second clamp on it which has worked but hasn't stopped the leak completely. As far as I understand, the big hose has a certain bend to it so I can't just get any rubber hose from an auto parts store and chug it in.
It is leaking all over the nearby surface:
I need to identify the part number for that power steering rubber hose so that I can replace it once and for all. Once the power steering fluid leaks out, my steering starts groaning whenever I turn it.
View 3 Replies
I have a 2002 V6 Passat Wagon. I am hemorrhaging coolant out of my lower coolant pipe. I can reach it put my finger in a feel the coolant coming out as fast as I pour it in. I can't see any way to get at the pipe from the top and I can't see the hose that should be attached there from the top. I assume this means the front end will need to be jacked up and go at it from the bottom. Also note the intake and return from the heater in my car is mexi fixed and looped together (no heat).
View 2 Replies
I have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.
The hose was replaced at 110,000 miles. It's currently at 112,000 miles
View 14 Replies
2002 camry: my boyfriend just told me he accidentally added power steering fluid to the brake reservoir a couple monthes ago....while i floored it on highway, i only reached 40, when let off gas, car came to a quick stop. later i jacked up rear and was able to turn back tires to rule out e-brake being stuck,when car is in nuetral and pushed (forward or backward) it comes to a stop whithin a foot or so ( it seemed like the brakes were being depressed) possible transmission or brake issue?
View 2 Replies
Today I am getting a "squeaking rubber" sound coming inside the car from the steering wheel when its turned. Not from under the hood! We had a sudden temperature drop over night but this has never happened before. Car has over 180K on it. Power steering fluid is between the lines. I don't see any plastic that is rubbing.
View 2 Replies
Mine appears to be leaking where the rubber pipe meets the metal coupler. What actually secures the rubber to the metal? I will get a new 1 soon but will be a week or so as I'm all spent after a few other unnecessary car related items.
View 5 Replies
I have a 2000 Camry, 4 cyl. It was in an accident on the front right before I bought it. I took it to Sears for alignment and 4-6 adjustments were made to pull it to within spec. One evidently is not correctable (the caster). After I bought it and after the alignment, I replaced the sway bar link, as the upper ball and socket was very loose. The problem I am trying to solve now is when I turn at low speed, I get a sound like a plucking of a large rubber band. (BUNG) I jacked and blocked up both sides and turning both ways all the way made no sound or play, and nothing is touching like the wheel well plastic or other parts. Then, I lowered the front right (where the accident was) to put weight on it, and it no noise when turning. When I lowered the left side also, there was still no sound. No sounds or shaking at 50-60 mph.
View 5 Replies
2002 2wd, 4dr has a power steering fluid leak. I am losing fluid in the resevior and there is a mess at the bottom around the steering box, lines and sway bar and it's hard to find the origin. it is not leaking at rest with or without the engine running. What are the more common leak points in this system?
View 6 Replies
I am driving an accent crdi 2006. Facing some problem with power steering oil leakage.
View 1 Replies
what is this 1" half-tube rubber thingy that fell from steering column or gas pedal?
more importantly, where does it go back to?
I only wash/vacuum my 2007 Camry once a year. Found it while vacuuming the floor mat.
This rubber piece was caught between the carpet and the floor mat near the gas pedal and/or steering column that goes through the firewall.
View 1 Replies
I guess this would be covered by either power train warranty or certified warranty? I also have axle inner boot leakage. I am going in tomorrow for DSG and fuel filter, going to have them look at these issues...should be fun ... oh yeah and head gasket might show signs of leakage......
Detailed pics in link..... [URL] .....
View 9 Replies
Removing the old cracked rubber brake line hoses on my daughters 2003 Ford Escape. Front left no problem. Old off, new on in 5 minutes. All the other won't come free. Can break nut loose, but just spins & spins. What is going on here? Did search and should be very easy.
View 6 Replies
