My inflation light wont reset even though I've tried and my speed is off after i install a set of 18's..235/35/18 front... 255/35/18 rear... Is there a way i can fix this?
View 11 RepliesHow to re-set the tire inflation indicator. I just had the tires rotated and properly inflated but the light is still on.
View 1 RepliesBeen using the pressure listed on the door jamb which is 29psi since I own the car. But recently I noticed the tires seem to be wearing on the outside part of the tread. I believe this is usually an under- inflation symptom. Am I right to be using 29 psi as the proper amount or should it be higher? The tire says MAX inflation is 44 lbs. which I know would be way over what it should be.
View 9 RepliesABS and Brake light coming on and staying on with an '04 Camry 4cyl XLE? I've found posts here of it flashing and wheel speed sensor codes etc, but nothing on it staying on and not re-seting.My code reader is not picking up any codes, I tried jumping pins 4 and 13 on the OBD port to read the code that way, and get no flashes from either ABS or Brake light, and tried the 8 pedal press method to reset the lights with no luck.
Before this, I was starting to get a little noise vibration at around 50mph which seemed to be from right front wheel, so on the wild guess that the bearing had gone bad and damaged the wheel speed sensor or tone ring, I pulled the sensor and it physically looked ok, and tested out at ~ 1kOhm.I checked all the fuses for the ABS system and they all tested ok.
So I just got my new wheels today without sensors. The light was on after driving awhile. How to reset the light? I did try step by step in the manual book but didn't work.
View 2 RepliesI have a 2006 camry xle v6 and recently my wife got a oil change and after a week the maint.required light stays on how do you reset this they must have forgot?
View 1 RepliesI have a 2014 Honda CR-V with two possibly related problems.
1. The tire inflation light comes on often even though the pressure is just fine.
2. The ABS brakes don't seem to be working correctly.
Last winter, they seemed to engage much too easily. As soon as I touched the brake pedal, it begins to chatter. I've had ABS brakes before, of course. The ABS brake light has not come on.The kicker is that I think the two problems might be related. As I understand it, the tire pressure light comes on if one wheel spins faster than its partner - say if one of the ABS sensors on one of the wheels was defective.I've had it to the dealer, but they won't even look since the ABS light doesn't come on. They claim that if there was a problem, the light would come on.Frankly, the vehicle feels unsafe on slightly slippery roads.
How do you rest the low tire warning light on a 2014 1/2 Camry ?
View 8 RepliesI have a 2005 Camry with 110,000 miles on it. Bought Toyota because I thought they were supposed to last and be such good cars...speedometer, tachometer intermittently going out along with ABS light coming on...took it to dealer, they said it was the combo meter and oh by the way the water pump needs to be replaced. Then get a call that it isn't the combo meter but the ECU that needs to be replaced and that the part is $1982.00. I have serviced the car religiously at the dealer and am very disappointed to have such problems in a car that is only 5 years old and has been taken care of...
View 1 RepliesHow do you reset the tire pressure sensor 2013 Camry. Could find the reset button.
View 5 RepliesWhile driving my 2009 Camry the abs light and break light pop on and the speedometer stops working as well as the tacomitor and the odomitor stops ticking off miles as well, also the ac fan will run but the compressor stops.
View 2 RepliesI have a Camry 2007, V6 and 3 weeks ago speedometer stop working and brake light, ABS light and check engine light came ON.
I had the car checked and P0500 code saying speedometer malfunction. All 4 speed sensors has been checked OK, computer engine replaced nothing change, all 3 lights are on and speedometer is not working.
I also noticed if I pull the connector from SKID control ECU I do have the same lights ON so with or without the connector plugged the same lights are on. Looks like no communication between SKID control ECU and....
I can't find the button to reset the TPMS light on my dash. It's not even in the glove compartment.
View 7 RepliesI'm about to leave on a road trip. I noticed last trip, the car pulled to the right. Can that be improved by tire pressure? If so, would I need more front driver or passenger side and/or rear tires?
View 3 RepliesI have a 2005 Camry, 3.0 litre, 6 cylinder. How do I reset the car maintenance light, ASB and oxygen sensor lights that are on. Just recently changed an oxygen sensor.
View 1 RepliesI just bought my 09' LE a couple weeks ago and today had a "Maintenance req'd" light pop up.
Being certified and I had just got the car 2 weeks earlier, I began panicking. I read the owner's manual and saw it just means an oil change needed.
I read there's a reset button, any way to disable it? I know how to reset but I mean permanently disable it.
The temperature has dropped to low single digits.
My RC F tire inflation has dropped to 26 -27 lbs. due to the extreme cold, after it has been outside for a while.
After driving for a while the tires heat up and the pressure goes up, returning to normal range.
From the day I got my '04 Treg, the tire inflation indicator on the dash has been a problem. For the first year or so, whenever it would indicate a tire inflation problem I would scroll the thumb wheel and get the MFI window with the diagram of the car and indicator as to which tire was low or the problem and would adjust till the indicator went off. Then I guess I got lazy and I noticed I could just go to "reset" in the same window and hold the thumb wheel down and the treg would then accept whatever the pressures happens to be as the new "standard". Not a good idea, I know.
Now here is my problem. Somehow, and much to my eternal consternation, I can no longer get the window in MFI that has tire inflation levels. That's right, it seems to be gone. I get "units" and "lights" and "comfort" and "speed warning" and "time" but no tire inflation category. What could have happened to it? I suppose that while get oil changes at the dealership they may, without my knowing, have reprogrammed my computer but I don't think the change coincided with any service. I've looked in the manual and it's useless on the subject. How I can re-attain the tire inflation window short of taking into the dealership for re-programming?
I have a 1999 Ford Ranger XLT using the Futura GLS 225/70/R15 tires. The vehicle decal in the driver side door listed the recommended tire pressure to be 30 PSI. I have tried to maintain religiously along with proper balance and alignment. However, I've always had the experience of the tires wearing out more along the middle which seemed to indicate over inflation. The sections on either side of the center line seemed to wear out normally. For this reason I've had to turn in the tire prematurely as they become unsafe. These tires were made by Coopers Tire and distributed by Pep Boys. Have i been using poor quality tires all along? Do I need to lower my tire pressure below the 30 PSI recommended? If I do that wouldn't I be risking overheating and/or affecting my gas mileage?
View 13 Replies2010 Camry 4 cylinder XLE. Manual, page 385, shows reset button at glove compartment. It is not there. I'm guessing it's under the dash somewhere, where only a contortionist can see or get to it.
View 6 RepliesHow to reset 2012 camry head unit?
View 2 Replies