As i kid i hated seeing people make there turn signals blink faster but know as i got older I like it, so on my 2011 camry and i want to make the turn signals blink faster. Not too fast but a little faster. I know I need a flasher but i can't find one for the Camry. I know I have to remove the instrument cluster.
View 14 RepliesHow to make the 2012 Camry SEV6 turn signals do the little 3 blink for changing lanes, llike the newer ones, or the corollas do... Is it impossible???
View 14 Replies2004 Prius here. The turn signals and hazard lights stopped working a few days ago. I found a disconnection in the grounding and repaired it. Also replaced the fuse and the flasher switch. Now the lights work, and I can hear the flasher switch clicking, but they don't blink!
View 13 RepliesNo B5 posts since the variant has been running well....'til today, when I noticed irregular turn signal operations. This is for a B5.5, 2002. Occasionally they'd work as they should, but much of the time they'd blink a few times then stay off.
Continues to happen after shutting down the engine and restarting (was wondering if that would reset anything). I recall some sort of relay problem with the turn signals. Does this sound like what's going on?
Car is 2000 Corolla with 58k miles. Today, I had my hazard signals on while parked when suddenly....they stopped blinking. The signal lights in the dash just stay on...they do not blink. I also verified that both front and rear lights also turns on...it just doesn't blink.
The corolla has a fuse box under the hood in the drivers side. Here is the schematic for the fusebox: [URL] .....
From what little I know about mechanics/electricity, can I just pull the wiper fuse and put it into the turn signal fuse while I wait for a new fuse? Do I need to disconnect the battery?
How to confirm this is the part I'm suppose to install: [URL] ....
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 RepliesRhe problem is that both sides blink fast the left one used to blink normally sometimes and fast again. All the light bulbs work and are not led. I found the problem on the right side : in the front the side light blinks but the drl doesn't blink with it. Now both sides blink fast. What part of the car i should check ?
View 3 RepliesI did my research and it turns out I need a relay switch for my blinkers. these bulbs are bright but flash too fast..
How do the relay switches work, what do i plug them into and do I need one relay switch per blinker?
I used the volt meter wrong while testing my turn signal bulbs for power and not they do not work (or hazard lights).
View 3 RepliesHow would I go about wiring the turn signals to be DRL instead of the high beams?
View 8 RepliesI have an '03 Ranger and the guys have figured out how to make the front side marker lights function as turn signal indicators..... I haven't tried it yet myself, but wonder if I could do the same thing with my Dually's fender clearance lights? I am currently running LEDs in there in amber for front and red for rear....they are nice and bright, but I think they would offer some added safety as well as looking neat too. May be I'll re-read the info on the Ranger site......
View 5 RepliesI have a 7.3 2003 Excursion. Should I change the gearing in the rear differential to make the truck go faster at lower RPMs? I know that will decrease my towing capability.
View 12 RepliesTurn signal lights into parking/turn signals (6th gen 2011 Camry LE)? I replaced my parking lights with a bright led that matches my headlights, but I would like my turn signals to be on when my parking lights are on.
For some reason I thought they turned on with the parking lights (my other cars do), so I bought some switchback led's and after I installed them I realized that my turn signals don't come on with the parking lights. Is this something I can do by swapping out a relay or with some minor wiring changes?
I am planning on getting the relay below to stop the hyper-flashing and am curious if it would do anything else, common sense makes be believe it will not since the lights don't currently don't turn on, but I am not 100% sure. Also, is 1 relay better than another? They all seem to be the same with the exception of some have controls to adjust the flash speed.
[URL] ....
Just bought my 5th Camry... a 2011 LE model.
Hate the LED tails, but I can live with them if I must.
Very disappointed the tails have red turn signals.
how to modify for yellow turn signals?
A few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 RepliesBelow in this photo-shopped picture the camry headlights have clear reflectors for the turn signals ..
I am going to be doing a HID retro , and I want to swap out my reflectors for some clear ones. Anything or anyplace I can get large non-vehicle specific reflectors and i can manufacture my own ? I want to keep the car as legal as possible, after my illegal retro (all retro's are illegal )
So i cave a Clunking noise and feeling coming from the steering column every time i make a slow turn or when i am driving trow ruff roads. I can feel it through the steering wheel.
View 9 RepliesJust to start off im new to the camry family.I have a 2007 camry se. Well the the problem I am having is when i make a sharp turn or hit on the brakes hard my oil light flashes. Didn't know if this is a big problem or something small. the light flashes and goes rite back off.
View 14 RepliesI bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 RepliesHow to fix or solve front turn signals that are not working? I just realized that both the front signals on my Prius doesn't light or flash when making a turn, the rear are working fine. Is this an easy fix or should I bring it to the dealer?
View 4 RepliesI have a 99 gmc jimmy. Head lights and tails lights work. But not the Hazard and or turn signals. I checked fuses. I'm thinking it might be the plug under the ash tray. But I don't want to pull off the dash to find out it isn't that.
View 4 Replies