The other day I heard a massive snap as I pulled out of the driveway. I drove to work and everything handled fine but if I drove over a bump I noticed a horrible sound under my car. Smaller bumbs just caused a ting. My gfs dad looked at it and said everything was fine. I surely didn't believe that so I just jacked up my car and right away I noticed my spring snapped!
View 14 RepliesJust had a front spring snap on my front drivers side on a road trip to the cottage. Found a place one hour away that can do new replacement front springs. The question that I have is that he can get F450 equivalent springs a lot cheaper than F350 springs. I do plan on adding an aftermarket bumper at some point in the future. What should I order?
View 14 RepliesI just realized my driver's side front leaf spring on my 2002 F250 has snapped. I checked the weight sticker on my truck and it weighs 5200lbs in the front. My question is the heaviest springs I found only support 2630lbs a piece, so being a 7.3 is 5200lbs a correct weight for the front of this truck? also why would Ford make springs that support only 60lbs more than the front weight? Hell I weight more than 60lbs.... Did I snap the damn thing just by climbing into the cab?!?!
View 6 RepliesLast night, I replaced both front struts with Monroe complete sets (new springs, mounts, boots, struts, etc) and I had my front rotors smoothed out. That cleared up about 75% of the noises coming from the front of my car Except for one.
Whenever I'm braking, there is a noise coming from my front left wheel. It's not a brake squeal, but more like a creaking sounds that comes around with each rotation of the wheel. It slows down with the car, and I can make it last longer by doing a slow roll with the brakes one. So when I'm fast it sounds like "Crk! Crk! Crk!" When I'm going slow it's "Creeeeeak... Creeeeeeak... Creeeeeak..."
Last night, I also replaced the sway bar link on that side. The brakes are smooth and the tires were balanced a couple months ago (no steering wobbles at any speed)
Took a recently purchased 2004 Civic EX to a mechanic to have it diagnosed. The diagnosis (separate discussion) was such that I decided to get a second opinion. On driving away, I noticed a constant spring-squeaky sound that had not been there before, so I took the car back. The mechanic explained that the front struts were bad (not part of their original diagnosis) and therefore, when they put the car up on the frame lift, air entered the struts hydraulic whatevers and that was causing the squeak. Several weeks ago, I had had the oversize wheels and tires that came with the car replaced - why wouldn't the problem have surfaced then, or in the 1000 miles I'd driven since? Btw, the tire place that had changed the tires and wheels had said nothing about struts needing replacing.
View 6 RepliesThe car has begun making a horrible clanking sound when going over small bumps. It sounds like it did when the control arm bushings were bad on my old mkIV. There are less than 5kmi on the car, so I can't imagine any mounts are worn out. It's still under warranty, so I know that it's just a dealer visit, but I'm wondering anyway. It sounds like crap.
View 8 RepliesWhile driving over bumps my front end makes horrible rattling sounds. The car also bounces somewhat wildly when i push down while it's parked. I figure its time to replace the suspension as it's got 125k miles on it. My question is exactly what parts do i need to buy? I am going to do both the front and back. I see names of parts thrown around all over. bushings, struts, springs, bearings etc... so what parts do i need to buy?
1997 pontiac sunfire 2.4L coupe
I am experiencing an annoying noise from the front struts when passing over bumps. I do not believe that the front end is bottoming, but it seems to give a deep thud sound. It is not a tin sound, but more like something loose and insulated. What is a jounce bushing? Are these something in the strut assembly and susceptible to getting loose? I have read about the springs could be the culprit, but could it be that the front spring is bottoming and the strut is hitting a bottoming rubber ? Jounce bushing?
View 2 RepliesEver since I had Quickstruts installed on the front I have been getting a tapping sound going over the bumps and such. I think it happens when going over something combined with the steering input, such as pulling out of a parking lot onto the main road. If I just go over a bump with wheels straight, no sound.
Can't replicate the noise by rocking the front end by hand.
The sway links appear tight, no vertical movement. I have a reman rack and pinion since last year along with new outer tie rods. Sway bar bushings maybe?
2002 Camry, 140K miles.
While I don't have any leaky struts etc, I have been planning to change struts proactively when I find time. (NOT Quick struts, have monroe OE Spectrum struts).
I understand I have to do them in pairs.
Which one takes more time? Fronts or rears?
And I am guessing alignment won't be way off if I first say do the front set then weeks later the rear?
So I finally installed my brand new coils in yesterday. I took it for a test drive and noticed a noise coming from the rear struts. It sounds as if the spring is wobbling around, almost like a clicking sound. When I first installed them I installed them without the rear perch, then when I heard the noise I thought it was because I didn't install the perch so I ended up taking my wheels off and installing the perch back in. No luck. It's still making a clicking sound when I'm driving, constantly. I had my friend push down on the rear of the car several times while I look under it, I don't know what it could be.... I also cut my rear bump stop in half. Could that be the issue? I have about 10 threads left on the rear perch before I max out.. The spring is compressed half way. Once again, These coils are brand new.
View 5 RepliesWhen I push down (to test the suspension) on the front left part of my car, it depresses and comes up. The car stabilizes (stops shaking) nearly instantly. However, when I press it down, it makes a squeaky sound. Sort of a short lived, high pitch sound. The sound comes from the area where the struts/coil springs are located. I drive a 1998 Honda Civic DX 2-door.
View 2 RepliesI just finished replacing front and rear struts on my 2003 Camry SE. I decided to use Gabriel Ready Struts because I needed Boots, and Mounts. My Car has 150,000 miles, I noticed some mild nose diving during hard braking, and I wanted to improve this.
The Ready Struts did improve the nose diving, but I think the car had a better ride with original struts with 150,000.
The Car is lower in the front with the new struts, and higher in the back. Its obvious when you look at the car. I have a regular parking place at work, and the first day I parked I scraped the curb. I have parked there every day since the car was new without problems.
I am considering returning the struts, and buying KYB and using my original struts. I was concerned about using my springs with 150,000.
My husband noticed that our 2001 Camry was driving strange. He thought it was a problem with the brakes locking up. When I drove it, I felt like the front of the car was a little wiggly and thought we might need an alignment. When we took it in, they said that the brakes are okay, but that the front struts are "soft." They said that the front struts need to be replaced, which includes an alignment, and we should replace the rear struts at the same time. They said we should get new tires at the same time.
I've been trying to research it some, and we don't have a lot of the problems associated with bad struts. We haven't noticed any bouncing or anything like that. I think they are honest mechanics, but my husband doesn't trust them. We don't have enough money to get all that work done right now, so my question is, can we wait until we notice bouncing or the tires get worse to have the work done? (We would be trying to save up the money in the meantime.) Or, can we just take care of the front struts and wait on the tires and rear struts? Should we just get a second opinion? (The car does have 145,000 miles on it, and I've never had the struts replaced. I bought it with about 65,000 miles on it.)
I have 2007 Camry CE, 4 cyl, 102,500 miles. The rubber boots on both front and rear struts can be easily lifted with a screw driver to reveal the shiny shaft. Strut seems be pass the 'fast brake' test (no bounciness). There is oily residue on the strut body. Is that normal? If replacement is needed, should I go with Monroe or other brand. I want the original Camry ride.
Brake pads seem to have 3/16"-1/4" thickness left. All equipment is original.
We have a 2005 Camry XLE, with 102,00 miles on it. It has been very well cared for, and only serviced by our Dealer. We would like to keep the vehicle for another 50,000 miles. We have had an assessment of the vehicle done by the Dealer, because our brakes were very soft.
He found a great deal of air in the lines and flushed them out. He also found:
1.) Leaks in the power steering rack, which he graded as a level 8 severity on a 10 point scale. Repair estimate is $1100 to replace and align.
2.) Both front struts are cracked and graded for severity as an 8 on a scale of 10.
What do you think:
A.) Are these safety issues ?
B.) What are the consequences of delay ?
C.) Are these problems indicative of other likely problems ?
D.) Is it better to have a Dealer perform the repairs ?
Boston winter roads got the best of my 2009 Camry LE, and now I have a broken spring on the driver's side front tire. I have yet to find a trusted mechanic in the area. Do I need to go to a dealer, or is it basic enough to do?
View 5 RepliesI just recently replaced all 4 struts on a 2003 Nissan maxima with 144k and the front are fine its just the back drivers side it makes a clunk every time I hit a big pot hole or a medium sized bump the shocks are doing there job the car feels great its just I have excessive noise the top strut mount nuts were torqued in place and so was the bottom. When I put my hands on the rear driver side quarter panel and start bouncing the car it makes no sounds its only when I start driving. The strut came with the bump stop the only thing I reused was the spring and mount and bushings in between but I took pics of the strut before I compressed it and took it a apart everything is where it supposed to be I'm puzzled...
View 1 RepliesSo I have an 06 Sonata with 56k miles on it. A few months back it started squeaking by the struts. It got worse last month and was pretty loud when going over speed bumps. Especially in the mornings
During my research on replacing them I came across a you tube video of a guy using AT-205 resealer to fix the squeak. Of course I bought some and was about to try it out but noticed that there was a lot of dirt and grime around the struts and other rubber mounts.
I decided before using the AT-205 I should clean everything first. Took some degreaser and sprayed everything I could see, including any other rubber mounts in the area. Rinsed thoroughly with water. Let it dry overnight and before applying the AT-205 decided to see if there was any change. To my surprise, there is no more squeaking. (It has only been 2 days though).
Hopefully it will not come back otherwise will use the AT-205 and failing that, will have to take the plunge and replace the struts.
Changed the struts on my 2004 passat and the back end still fishtails when hitting bumps! And when the roads are wet the back end slides! So if the struts were changed what could be causing this?
View 5 RepliesEvery time I go over a bump I hear a tap. It comes from both sides, on the left it feels like it's coming from the wheel well area.
I hear it going over speed bumps, usually those wide and gentle ones, but not small and sharp bumps that jar the entire car.
I associate it with that instant when the suspension gets unloaded, i.e. going over a smooth bump I'd hear it around the time the bump slopes down and the suspension gets unloaded for an instant.
I have new Quickstruts with retrofitted oem springs. The ride height is normal. New swaybar bushings and no apparent play when the car is on the lift. Also, the car is in near perfect alignment, did it a couple of days ago.
So...what is the likely culprit. Sway bar links perhaps? They do have ball-joint like ends, perhaps these are worn. Could it be that they appear solid on a lift because they are under load at that time?