Where Gen5 Camry heater control tab/valve is located? I can't seem to find in engine bay. Is it in cabin under dash? Under drivers side dash, I can only see heater control valve cable. I have got a hot coolant coming to heater core, so heater control valve must have gone bad.
View 6 RepliesI cannot find the Oil Control Valve Screen location for my engine. I have also seen one post that said this engine doesn't have one, but I thought that was odd.
View 14 RepliesWhat is the location of the idle air control valve by telling me where its at or a picture location?
View 10 RepliesReplacing a heater control valve for a 2004 Jetta? My car's vents only blow hot, and I checked the cables and saw that the control arm was disconnected. I tried to put the cylinder piece back in and had some luck, but I can't get it to sit tightly in there and it keeps falling out. Also, it still wont change the temperature coming out of the vents. I assume that something broke on the inside piece that the cylinder connected to.
[URL] ......
Here is an example of what mine kind of looks like, but mine is way more loose.
While diagnosing a problem with my rear AC not working, I pulled the rear plenum apart. I noticed the rear heater coil was really hot even though I did not turn the heat on at all that day.
I suspect a bad heater control valve. The one that stops hot coolant from going to the core when the AC is on. I have manual temp controls so I assumen it is vacuum controlled. All data does not give me a location or vacuum routing specs for the valve so I am asking here.
1) Where do I find the heater control valve?
2) Does it shut off the coolant to both the front and rear heater cores or just the front?
Bought my Ranger brand new, and I try to maintain it well. Most of the 90,000 miles are highway. Anyway, the OEM coolant was supposed to be good for 100K miles, but since I hadn't done anything in 89K, i have a lengthy commute and the coolant was getting discolored, I figured that no harm would come in having a drain/refill. This was approx. The heat worked flawlessly. Fast forward two weeks, and my local shop performed an oil change (not the quick lube that did the coolant replacement). I was informed of three things:
1) my coolant was low,
2) my heater control valve was leaking (which I was shown), and
3) when hoisted I was shown that a slight residue of coolant -- not necessarily fresh -- was on my water pump.
I was told that 'down the road sometime a water pump could be in my future'. Again, the heat worked flawlessly, and I didn't want to be out-and-about in winter and run out of coolant. So, the shop replaced my heater control valve and topped off the coolant (approx. 1/2 - 1 gallon). Heat worked flawlessly. The last couple days, I noticed two things.
First, heat trickles out on low and medium setting, and second, it takes a long time to warm the vehicle. So, my limited research tells me two things. If coolant is present, and I have heat (of some sort), then, the water pump and heater core are probably fine. Diagnosis says to check the thermostat first, correct?
02 F150, 5.4 gas motor, about 338k miles. Bought this truck well used so I would have a truck when I needed one. Someone has removed the heater control valve. I've got a new one, but there is a port on the top for a vacuum line, but where this line plugs into.
View 1 RepliesI just bought a used 98 Acura 3.0CL. I've noticed that when the heat is cranked, it doesn't blow hot at all. I did some quick research and came up with two answers thus far; check the antifreeze coolant and that I may need to replace the heater control valve. Am I "warm" on the area?
View 19 RepliesI have an emissions test coming up. I have 3 P codes that I'd like to eliminate before then. I don't want to "fix" the issues they are telling me about. Just make the codes go away. I know why they're there I just need to get rid of them.
What I have coming up is:
P0475 Exhaust Pressure Circuit Valve (result of EBPV delete)
P0541 Intake air heater A circuit low (result of aih delete)
P0640 Intake air heater control circuit (also result of aih delete)
What resistors I'll need and where to put them in?
Swapping a 2004 2.4 motor and trans into my 03 that has a locked up motor. Pulled the motor out of the 2004 yesterday and started tearing into my 2003 today and noticed that the 2004 motor and harness doesn't have the provision for the vacuum control valve mounted in the air cleaner lid like the 2003 has. Since I'll be using the harness and ECM from the 2004 into the 2003, wondering if I can just either use the lid from the 2003 and keep the VCV(hook lines back up) but not have electrical connection going to it. It will basically be pulling the vapors 100% of the time since there is no power going to it and it's a naturally open valve.
Using the harness from the 2004 that I pulled with the engine, there is no way of hooking up to the VCV since the 2004 didn't have one(hence no electrical connector).
Where is the Door Lock Control Relay located on an '02 Camry? I have intermittent issues with all 4 doors at the same time (will not lock with key fob, door switches, or shifter switch). No issues with doors unlocking.
View 4 Replies2010 camry 4 cylinder, Heater/ac air flow control not working. Only blows air to defroster which it has no temp control.
View 1 RepliesThe check engine light came on yesterday. 2004 with 115K. Auto Zone read the codes and they are as follows:
Definition:
Idle Air Control Valve control circuit.
Probable Cause:
Open or short circuit condition.
Poor Electrical Connection
Failed IAC motor
Just have a quick question. Where exactly is the pcv valve on our R32s? My R is starting to burn oil and that's the only thing that I can think of is causing it. Looking for a pic of current pcv valve on the car so I can replace mine.
View 7 RepliesWhere is this diverter valve located at ? Is it under the car?
View 10 RepliesI have a 2004 Santa Fe with 2.4L 4 Cylinder engine. I have the inexpensive Duralast CV1139DL PCV valve but cannot figure out where to install it.
View 1 RepliesElantra 2011 1.8 engine ... Where is the PCV valve located?
View 1 RepliesWhere is the PCV valve on passat 99?
View 3 RepliesWhere the EGR Valve is located on a 2001 Chevy Venture? Pics of its location would be nice, if possible...
View 7 RepliesWhere is the PCV valve is located?
View 1 RepliesI have a 2013 Elantra with 145,000 miles. The A/C isn't working--just blows out warm air. I checked and the compressor turns on when I hit the A/C button. I'd like to try refilling it. I can't find the low pressure valve location (only high). No luck on Google.
View 4 Replies