Camry :: Check Engine Light Came Up On 2006 Toyota LE (P0011 / P0101 And P0113)
Nov 26, 2013
The check engine light on my 2006 Toyota Camry LE with 95,300 miles came up. The codes that came up on my diagnostic tool were p0011, p0101, and p0113. The code meanings are as follows:
p0011: refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car's power control module
p0101: problem with the Mass Air Flow (MAF) sensor or circuit
p0113: possibly issues with the Intake Air Temperature Sensor
How to solve the issue and get that annoying check engine light off?
View 2 Replies
Advertisement
I have a 2006 Sonata with an intermittent check engine light. The light will be on for a few days then goes out for a day or two. This pattern has been going on for about 3 months now. A scan tool was used and showed the code P0011. I know this code has to do with the camshaft timing. My question is should the light be going out on its own if there was a problem with the camshaft timing? Does the engine correct itself and then experience the problem again. Is it normal for check engine lights to go on and off with out being manually reset? Could this be a faulty sensor or loose wire causing the light to go on and off? The car has about 75,000 miles, mostly Hwy, and is driven just about everyday.
View 36 Replies
I had the 2010 Camry I-4 in the dealer last week for the 40K service. They told me I needed fuel injector cleaning and a throttle body housing cleaning which I had done. This afternoon the check engine light came on and at the same time the Slip Indicator light came on.
I ran by Auto-Zone to have them pull the code for the check engine light and it was P0101 which AZ says is Mass or Volume Airflow circuit range and listed probable causes as:Open or short circuit condition, MAF/VAF sensor failure, or Faulty ECM. I called the dealer for an appointment Thursday morning and told him the story and asked if the throttle body or injector cleaning could cause the mass air flow problem. He said "probably not". He also told me that when the Check Engine light comes on the Slip indicator light automatically comes on to show that the VSC is not working while the check engine light is on.
My question is, could the cleaning cause the P0101 and if so what info do I need to argue the case with the dealer? Or, are they unrelated systems?
View 2 Replies
I have a 2006 Toyota Solara V-6. I was driving down the street with no indication of what was about to happen. All of the sudden my check engine light came on and the car lost all power. I had the car towed home and had a mechanic look at it he put his scanner on it and I'm not sure what codes if any came up but he decided it was the ECM so he found a used one with a warranty and ordered it, he put it in and it did the same thing it turns over but wont start. What could it be ?
View 13 Replies
2008 Toyota Prius Touring. I got a Check Engine Light while at a drive-thru, and my "Automatic" adapter reports this:
I drove the remaining ~60 miles home without incident, and the engine seems to be running smoothly and I don't notice any loss of power or rough idling or anything along those lines.
Going by the first few Google results, a P0011 error could indicate a few things:
-Incorrect camshaft timing
-Wiring problems (harness/wiring) in intake timing control valve control solenoid system
-Continuous oil flow to VCT piston chamber
-Failed timing valve control solenoid (stuck open)
I've had this car for ~3 years and have always been super careful about regular oil changes and maintenance, including dropping an ungodly amount of money getting the "full 100,000 mile service package" at the dealership ~6 months ago.
Suddenly getting a P0011 error code and Check Engine light on a well-maintained 2008 Prius w/ 112,000 miles.
View 7 Replies
Check engine light and P0010 code in my Gen III 2010 Prius...
View 2 Replies
I have a 2003 Elantra GLS. I am intermittently Check Engine light and error code is P0113 - Air Intake sensor issue. I can't locate where the sensor is. I don't see any wire coming of the tubing that connects the air filter to the engine.
View 18 Replies
I have a 2003 20th ann. GTI, it shut off on me on my way to work. It would turn on but only for a sec and turn back off. I turned it on and tried to move it over out the way of traffic and wouldnt move and turn back off. Got the check engine light checked and the codes P1007 which is coolant temp sensor and P0011 which is camshaft sensor. I replaced both and problem not solved car will start but wont go and turns back off, black smoke and a strong smell of gas comes out the exhaust.
View 3 Replies
I have a 2007 Yaris, 180,000 miles, The check engine light comes on. With a P0011 code. I know that that could mean either:
blocked oil passage
Mechanical timing fault
Camshaft position a timing over advance
Failed OCV
Or VVT controller assembly fault
Since it's been really cold out I figured maybe it was a blocked oil passage, but after an oil change and quick check - I no longer think that's the problem.
The car runs great and it doesn't seem anything is wrong at all ...
View 3 Replies
Alright, so I was driving along and everything was fine, I had no error lights and the car was running perfectly. I accidentally went over a lip of this parking lot a little too fast and all of a sudden the check engine light came on!!! I took it to Jiffy Lube and the codes I got were : c1253, c1311, p0011, and p0012. Is my car safe to drive tomarrow? Are these super expensive to fix? Could they have been set off from the curb?
View 2 Replies
This past Sunday, I replaced the spark plugs on my 2008 Toyota Camry CE, following one of the sticky DIYs. My car has approximately 107,xxx miles.
Last night on my drive home from work my CEL came on. First time seeing a CEL light since my BMW days, . Luckily, I have a OBDII scanner at home and after running the scanner, it gave me the following trouble codes:
- P0101
- P0172
I went ahead cleaned the air filter (I have an Injen SRI installed).
After doing some research on the interwebs, I have concluded that this code has to do with the MAF. Time permitting, I am going to clean the MAF sensor later tonight. In the meantime I reset the CEL, to see if it will come on again.
My only question, which I am unable to find an answer to, is:
Can there be a possibility that the P0101 and P0172 trouble codes be related to me replacing the spark plugs, or is this just a mere coincidence?
View 5 Replies
I have a 2000 Toyota Camry that has a unique problem. The Check Engine light NEVER comes on even when first starting the car. I have access to a scanner and know that the car periodically throws a catalyst code but the light never comes on. I just assumed that the bulb was burned out.
Today while solving a non-working clock issue I had to take the instrument cluster to get to the clock. While I had it out I decided to check the Check Engine Light bulb. It looked fine so I took I replaced it with a bulb that I knew worked fine. Again, nothing. The bulb doesn't light at all. About 4 weeks ago my timing belt broke while driving (non-interference motor) and it threw a code for the camshaft position sensor but again the light never came on.
Why the light never comes on?
View 19 Replies
Car: Toyota Camry 2002 .. Mileage: 150K
Symptom:Check Engine light went on a few days ago.
Checked codes and got these (3):
1) P0420
2) P1310 and
3) P0420 P ("Pending" ?)
I also checked I/M Readiness and got these suspicious-looking values:CAT: NOT RDYEVAP: NOT RDYO2S: NOT RDYH02S: NOT RDY
NOTE all the other I/M values were N/A
Researching the Codes, it sounded like Ignition, and possibly the O2 sensor on the Catalytic Convertor. I had just had some engine work done by the dealer -- actually, replaced spark plugs -- so I figured to go back and bitch him out for screwing up my car.
A few days later, before I could engage my Rage, I went back and re-scanned. First I noticed the CEL was now OFF. Scanning, I now I get "NO CODES", and all the I/M values are now N/A; No more "NOT RDY".
What do you all make of this? Should I be concerned now that the CEL is Off, and I get No Codes with a scan?Or maybe I should take it to AutoZone for their free CEL diagnosis -- would their machine be more thorough than mine (Autel MaxioScan 300)??
View 4 Replies
I had my 2000 Toyota Camry with 133,921 miles on it seen because of the check engine light.The codes obtained at the repair shop were:
P0136: Oxygen Sensor CKT Malfunction Bank 1 Sensor 2
P0446: Evap Control system Vent CKT Malfunction
They then ran a smoke test and found that the charcoal canister was leaking and needed replacement. The mechanic said that not doing the above would not affect the car's performance or its safety but it would not pass inspection with the check engine light on and with those codes.
View 5 Replies
2001 Camry 4 cylinder. Check engine light came on yesterday. Advance Auto pulled out the code P0446 for the evap. emissions system vent circuit.
The car has no symptoms other than this and is current on all maintenance, but obviously it is a 10-year old car and so it goes.
View 9 Replies
My check engine light kicked on about 6 months ago. The code was for the catalytic converter, which I did not replace because it is less than 2yrs old. It would go on and off intermittently, and for the last week it has remained off. All the other dash lights work fine, and I know it's not the fuse...
'97 Toyota Camry, 231,000 miles.
View 10 Replies
So I have a 2012 Toyota Camry SE V6. Back in december I got into a front end accident, had the front repaired, (they did remove the coolant container and refilled it etch) Got my car back on December 22, coolant was full. A few days ago, checked again and i noticed the white coolant container was empty (there were some pink at a corner, i guess because the hose doesn't reach that low), i checked the metal cap, it was not "completely" empty just had a very very low layer of pink coolant. (i would say just some coolant at the surface)
I do recall a sweet burning smell maybe a month or 2 ago, but my engine light did not ever come on. When i refilled it, (my dad recommended to refill just half) I did that, a day later, i checked the levels again, it was empty again. so i refilled it to half again. i drove this morning for about 10 mins, its still at the same level (maybe i didn't drive it long enough?)
I'm freaking out whether i have been driving the car without coolant for that long, and whether there were any engine damage done (even though the engine light didn't come on) I have driven the car alittle over 5k since i got the car back.
View 8 Replies
My check engine light came on about 4 days ago on my 2014 toyota camry. Found the gas cap was loose that same day it came on and tightened but light is still on and Eco mode not coming on. Is it possible the problem is something else or does it take longer for the light to turn off.
View 12 Replies
I have a 2000 Toyota Camry with about 136,000 miles on it. Recently because it was making a loud noise and because the check engine light was on we got the exhaust system changed at Coles and this made the car silent as before.The mechanic there checked the check engine light code and reset it and he said it was an Evap code.He checked the fuel cap and found it to be OK. He said that if it comes back again I have to get it checked by some one who has a smoke machine to detect the leak and this could cost me about $100/- to set it right.The check engine light has come back again.
View 4 Replies
I had my local garage do their electronic check when my check engine light came on. They said the code they got indicated a failed catalytic converter and quoted me $720.00 for a California compliant replacement, including labor. I live in Connecticut. I'd like to take a few days to get a second opinion and second quote, but the garage manager said that driving it in this condition would risk fouling the oxygen sensor, which I recently replaced for a couple hundred bucks.
Should I be concerned about fouling the oxygen sensor by continuing to drive the car? 2000 Toyota Camry...
I looked under the car and the rear attachment bolts to the converter are rusted beyond recognition. I'm tempted to try replacing it myself but it may be a bit beyond my skills.
View 7 Replies
Check engine light was on for some time when I had filler neck and cap replaced. Computer sensors did not re-set until 501 mile mark, when light came on again. Checking the web, I find that some who appear to have knowledge of problem say it could be hoses, sensors, valves, or evap canister--the charcoal canister.
Mechanic who did original smoke test and recommended replacement of filler tube wants to replace evap canister without checking anything else. What should I do? At wits end, and car needed to pass inspection 2 days ago. Car has 157,000 miles or so...
View 9 Replies
