Camry :: Changed Upper And Lower O2 Sensors But Sill Getting P1036 Code
Mar 25, 2013
I've changed the upper and lower O2 sensors the Manifold/Cat and still getting the code. Was wondering if the the valve guide seals would give off this code.
View 3 Replies
Advertisement
Ok I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. What should I do next FYI heat worked great until 5 days ago.
View 14 Replies
I have a 2005 Impala with the 3.4 engine and 118,000 miles. About 2 years ago I had a code P0141 and since we didn't know for sure which oxygen sensor was out we replaced both of them. The P0141 code did not stop occurring after both sensors were changed. I read on an Impala forum that if you didn't replace the sensors with AC Delco the codes would continue so I didn't worry about it until my gas mileage starting going down recently. I ordered new AC Delco oxygen sensors and my husband replaced them Saturday, the old ones were sooted up pretty badly. Today a new code appeared, it is P0140, O2 sensor circuit no activity. What the problem might be now.
View 7 Replies
I have a 1998 Explorer XLT with the 5.0L V8. My check engine light has been on and off sporadically for the past two months. Lately, it has been on more than off. I brought it to a local place to diagnose the problem. Both upper O2 sensors are shot. What kind of difficulty level am I looking at if I tackle this myself?
View 14 Replies
Still getting p0174 error after upsteam downstream, checked everything.
View 1 Replies
I changed both oxygen sensors yesterday on my 1997 Accord.
Check Engine Light was on and I was getting codes:
P0135 - O2 Sensor Heater Malfunction Bank 1 Sensor 1
P0141 - O2 Sensor Heater Malfunction Bank 1 Sensor 2
Also, after clearing the codes, if I started the vehicle the codes would come on instantly. So it wasn't some kind of flaky electrical issue, it was consistent.
View 1 Replies
On a level-of-difficulty-scale from 1 to 10. 10 being the most difficult. How difficult is it to change the upper control arm and the lower ball joint?
View 3 Replies
For some reason My car won't boost like it used to in the upper gears. 1st, 2nd and even 3rd I can still boost around 18 but once I go 4th, 5th, 6th my boost get lower and lower to the point the I get only 10psi in 6th gear. The car also seems slower a doesn't spool that fast like it used. i checked most of the hoses, even my intercooler pipes which were leaking before and everything is tight. Could it be my DV which is still stock or should I look someplace else?
View 13 Replies
Our 2000 explorer xls 4x4 with 4.0 ohv just pop the code for the intake gasket leaking. My question is, would there be any way to tell if it is the upper or lower that is leaking? It has 188k on it but still runs good. I think I can feel a miss in it at idle but it is not a steady miss.
View 1 Replies
I have a 2007 f-150 4X4 with bad upper ball joints, should I replace the lowers also or just the uppers and how do I check lowers?
View 3 Replies
I'm in the process of changing my upper and lower intake gaskets. my question is, the upper intake along with the tubing on the fuel rail are caked with oil/carbon, along with the back side of throttle body. What would be the best way to clean them?
View 2 Replies
Have just about 1,600 miles on tuck born on 12/14/11. Love it, but.. When going slow in subdivision I am getting some hesitation/bucking when going in the upper 20s/lower 30s. When I feel it I look down and I am usually in 3rd. Is this the transmissible thing? When it happened Sunday it felt like it was going to die. If I start off with a quicker start (to get to highway speed) it shifts fine. It just started the last few weekends......
View 14 Replies
On my 2004 s-cab the steering is starting go 'notchy'?
I have considered, tight upper or lower ball joints, pump, rack or even a sticking rear diff, but not carried out any checks yet except oil level
View 4 Replies
Mounting the shock with the boot up or down? I know it doesn't matter according to Bilstein but one way has to be better than the other.
Second. What are the torque specs for the upper and lower bolts? I know the lower front is around 350lbs but haven't found anything for the rest. found out the rear bolts are torqued to 66lb.
Third. The front shocks didn't come with a boot to protect the shaft. Is one needed when the shock is installed?
Truck is a 2012 F150 FX4.
View 4 Replies
I have recently replaced both tie rod ends and found out when I took my truck for an alignment the mechanic stated that I had bad driver side ball joints (upper & lower) I confirmed this with SEARS and they stated that it was all the ball joints upper & lowers! the Haynes repair manual (1999-2010) states "ball joints on 1999 through 2013 2WD models were not replaceable".
View 4 Replies
I have a 1999 XLT and i had a bad moment yesterday. I always put the toolbox in the back side of the cabin, while doing maintenance i tried to open the rear door and I couldn't. I noticed its locked from the upper because the lower looks free. The other thing i noticed the two wires going to the handle to open it feels loose. First time happened to me and i really use that door often.
View 2 Replies
I have a 2004 Camry XLE V6 with about 70k with a CEL P0171 that came on yesterday. Looks like that code is for a lean condition. Could it be a bad O2 sensor or is that a different code and what should I look for to fix this code?
Also, I'm not sure if this is related but for the past few months my engine has sounded different. When I first start it up and at low RPM like 2,000 and under the engine sounds like a go kart, not necessarily louder it's just a different lower tone that it never used to have. It has sounded like this for 6 months but the light just came on yesterday.
View 2 Replies
Just noticed the other day when when rolling up or down the window on my 2010 corolla, when the window reaches the upper / lower stop and the switch is held down, the idle speed drops and the engine stumbles. Alternator ?
View 6 Replies
I have a 2001 f350 7.3 diesel and want some info... I am switching out the air intake and thinking about the Banks package.. How does it can be compared? Also, I am dealing with an issue of a dual generator upper and lower fault codes.. I only have a single generator system and it is running strong as far as I can see.. When I start it shows 12.9 and then raises to 14 when running.. Stays there the entire run...
View 6 Replies
What this code is about it?? 5784 sporadic 001-upper limit exceed
View 9 Replies
I have a 2008 Camry SE with JBL. I was wondering how do you remove the front upper speakers that are in the dash. I looked around but everyone show the front door removal not the upper speakers.
View 4 Replies