I have some rectangular weights bonded to my rims just behind the spokes. Are these to balance the rim before a tire is installed or is this how the tire and rim are balanced on the alloy wheels? Maybe to keep from putting the normal wheel weights on the outside of the rim?
View 3 RepliesThis is the 4th/5th/6th Gen Camry TRD four pot BBK setup. Theses are lightweight racing-inspired four pistons aluminum calipers. They will need Iconman's custom brackets to fit on Toyota models. Based on the cheap Highlander BBK thread, the caliper mounting bolts are in the same location so this setup will likely also work for 4th, 5th and 6th gen Camry as well. I have them on the 2003 Camry.
The OEM 2003 Camry caliper, bracket and bolts weights in at 8lbs. The TRD caliper with mounting bracket and bolts weights in at 6lbs. I know this doesn't sound impressive but consider the 4 pot calipers are larger in every aspects compare to the twin pistons Highlander caliper which weights 12lbs.As you can see the clearance between the edge of the caliper and the balanced wheel weights are very tight, and even with the 10mm spacer, the inside spokes of the Solara 17'' rim to face of the caliper have little room for play. 17'' rim are smallest size you can run with this setup. I also had to use extended studs and 10mm slip on spacer.
I just got 4 new tires fitted and as soon as I got home and went to check the pressures, I notice that the way they've fitted the balance weights on the edge of the tires prevents the wheel trims from clipping in correctly.
View 3 RepliesI am planning to lower my car a little to eliminate the wheel gap. I've been doing research and I heard lowering springs is better than coilover, and more affordable too.What's the best way to lower my car?
View 2 RepliesWill the center caps pop out with the wheel mounted? Or do you have to push them out from the backside of wheel? It's the 17" SE wheel.
View 5 RepliesThe lights on the steering wheel controls are too dim? I find it hard to see them at night.
Any mod that brightens them up a bit (and creates a cooler look at the same time)???
Tonight I went out to get something out of my car, I had not driven the car in about 5 hrs. As I opened the back driver side door, I noticed a noise coming from the wheel well area. It was a quiet noise almost like a very quiet motor running, but it was very prevalent. I went to the passenger side back wheel and could hear it there also. I've never heard anything like this. Opened the trunk and listened for the noise but could not hear it there. After a few mins, I started the car and let it run, then shut it off and the noise disappeared. Only thing I could think of was a fuel pump malfunction?? I honestly don't know.
View 11 RepliesMy 2016 Camry SE Special Edition has 300 miles on its odometer now, and I just noticed the front right wheel has two spots where the alloy wheel has a plastic film that appears to be peeling back.
View 6 RepliesSo I've had the 2016 Camry SE for a couple months now, however I was wondering to clean the interior of the car, specifically the steering wheel. I do drive a lot long distance and city driving as well and sweating on a hot day is practically inevitable even if its just a bit. But how to clean the leather/steering wheel of the interior.
View 11 RepliesRust proofing the rear wheel well: I was trying to rust proof/coat the rear wheel well and surrounding area to make sure i get the bolts under it. Back of the car is where most of the salt sits as the undercurrents with wind tend to drive the salt deep in the quarter panels and around tank area. I wanted to confirm if these cars still have the wheel well bolt securing the bumper to the quarter panel with a rust prone steel bolt.
When weather gets better i'll take to get sprayed somewhere. But for now i wanted to leave something on it of a coat after a good cleaning. Hate dam salt or whatever they are using these days.
I also noticed that the SE's wheel well internal sheathing was much stronger looking, solid than what's on my LE - a felt type material. Besides the wheel well rim on SE has a band of silicone type substance overlaid on it. Right?
I just bought a 2015 Camry LE 2 weeks ago and noticed a slight annoying steering wheel vibration when you hit 40 kph and above. You can also feel it on the floor and when you hold the door. Brought it to the dealership and they balanced the wheel. It seemed to have made a difference and you can now feel the vibrations from 80 kph and above. Did a road test with the mechanic and the service manager but they couldn't feel anything and told me it was normal road vibrations. Was advised to go to another dealership for a 2nd opinion. 2nd dealership found a slight excessive loaded runout on the LF tire and road force balanced it.
After 2 days i can again feel a vibration, but this time now at 115 kph and above.I thought I was just being paranoid so I drove a Maxima for 2 days and never felt a vibration.
I own a 2012 Toyota Camry SE and I am trying to figure out why I can't skip songs using the controls on my steering wheel when my phone(Samsung Galaxy Note 4) is connected to the car via Bluetooth. The car connects to my phone via Bluetooth without a hitch, but every time I play music from my phone and I try and skip a song by pressing the right arrow on the steering wheel, it doesn't respond. The odd thing is, every once in a while when I do try skipping songs, it works! The problem is, I have to press the arrow key multiple times and almost a once in a blue moon type of deal.
View 6 RepliesBrand new 2015 Camry SE and I think the steering wheel is slightly off centre... basically driving straight on most roads you need to hold the wheel a bit to the right... and if you hold the wheel completely straight the car will slowly veer to the left.
I checked tire pressure (fine) and I don't think its road crown (most roads are angled a bit right but this car veers left when wheel is held straight). Mostly noticed it once I started doing some highway driving.
I don't think the alignment is bad really but it seems like it might have been done at the factory without the wheel being fully straight.
I've owned my 14.5 camry se 4 cyl since may and a few weeks into owning it i noticed a pop/clunk coming from the front passenger side while reversing and turning the wheel. So, finally got some free time to take it into the dealer today and dropped it off. Also, when letting off the brakes you can hear like a creaking noise, almost like the brakes are metal to metal but it only happens LETTING OFF the brakes?
My service advisor says supposedly the "creaking" noise when letting off the brakes is normal. I told him i really don't believe that lol and asked to test drive another new camry on the lot which is being arranged for tomorrow. In the meantime he says they're gonna look at it either way.
The owner's manual for my 2012 Toyota Camry does not give a very good description about what the MODE/HOLD button on the steering wheel is for. At first, from what I had read in the manual, I thought it was like a mute button for the radio, cd, etc. when I wanted to use my hands free cell phone. When I first tried to do this, it took me a while to realize it but I was actually muting my cell phone.
View 3 RepliesSo I have a 2012 camry SE I4. When i backup and about to start going the steering wheel get stuck, the steering wheel light came on the dash, and the radio shut down and restart by itself. It happened really quick about 5-8s and then everything back to normal, the steering wheel light is gone as well. I doubt the electric has problem, but i am unsure.
View 9 RepliesI just bought a 2012 Camry SE V6 about 2 weeks ago. This week, I have noticed a steady clicking or ticking sound coming from the passengers side front wheel (or so it sounds to be from there). Not feeling any vibrations or anything like that and I have checked the tire(s) for rocks or nails to no avail. The sound is not present at speeds lower than 50mph (that I can hear anyways) and seems to get slightly louder in volume as speed increases from 50mph (though there is no increase seemingly in frequency of the sound) and if the passengers side window is up it cannot be heard at all. What was the ultimate solution? I want to be able to drive my Camry with pride but it's hard when all I can hear is the ticking noise with my windows down.
View 3 RepliesI have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
My car's about 1.5 years old and 10k miles. About a week ago I started noticing that the power steering got a fair amount heavier/stiffer: it's suddenly a bit harder to turn the wheel. It came out of nowhere and I can't identify a cause, and the local dealership couldn't find anything wrong with the car. (2012 SE I4)
Since it's electric power steering I'm not sure what could have gone wrong here... and while it doesn't make the car un-driveable, it is rather annoying. The tire pressure is still around 37 PSI (according to the sensors) and they're Michelin.
So I was searching around online and it seems this thing happens to some ppl after lowering their cars. I'm getting a loud pop/clunk noise from the front left side only. Seems that's the most common place ppl are having this type of issue with. What it could be? My mechanic wont be able to look at it till Friday. So not sure on what to do. The sound only happens when I'm hitting bumps on the road.
View 6 RepliesHeard an noise coming from the front of the car when in reverse turning wheel and braking only happens when im braking and make some turns not all turns.
View 9 Replies